IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v229y2021ics0360544221008781.html
   My bibliography  Save this article

Thermal balancing and exergetic performance evaluation of a compression ignition engine fuelled with waste plastic pyrolytic oil and different fuel additives

Author

Listed:
  • Das, Amar Kumar
  • Hansdah, Dulari
  • Panda, Achyut Kumar

Abstract

This study aims at evaluating the heat energy and exergy values of waste plastic oil (WPO) blended diesel mixed with different fractions of fuel additives (ethanol as oxygenated fuel additive and nano graphene as nano additive) with a view to establish the thermal balancing of a diesel engine analytically taking experimental data and comparing with neat diesel oil. The research engine used was a four stroke, constant speed, stationary, direct injected, single cylinder, water-cooled compression ignition engine tested at different loading conditions. The thermal balance was prepared in respect of work output, heat loss in cooling, heat loss in exhaust gas, heat loss in lubrication and additional unaccounted heat losses in order to measure the efficiency of the engine in agreement with thermodynamics energy principles. Three test fuels with same plastic oil and different fuel additives concentration (comprising of 80% Diesel+20%WPO, 60% Diesel + 20%WPO+20% Ethanol and 80%Diesel +20% WPO+100 ppm nano graphene) are prepared for the engine test. The addition of ethanol in WPO blended diesel fuel mixture contributes marginal increase in brake thermal efficiency, decrease in brake specific fuel consumption, higher exhaust gas temperature and lower exergetic efficiency as compared to that of diesel. Nano graphene added to WPO blended diesel enhanced its energy along with exergy efficiency values as compared to other fuel mixtures under higher operating load condition. Fuel exergy for this fuel was increased by 18.57% in comparison to diesel at highest load. However, Exergy destruction and exhaust exergy were decreased by 34.97% and 14.03% respectively in comparison to diesel at highest load. Moreover, exergetic efficiency was enhanced by 18.9% than diesel at maximum load condition.

Suggested Citation

  • Das, Amar Kumar & Hansdah, Dulari & Panda, Achyut Kumar, 2021. "Thermal balancing and exergetic performance evaluation of a compression ignition engine fuelled with waste plastic pyrolytic oil and different fuel additives," Energy, Elsevier, vol. 229(C).
    • Handle: RePEc:eee:energy:v:229:y:2021:i:c:s0360544221008781
    DOI: 10.1016/j.energy.2021.120629
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544221008781
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2021.120629?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Ramos da Costa, Yoge Jerônimo & Barbosa de Lima, Antonio Gilson & Bezerra Filho, Celso Rosendo & de Araujo Lima, Laerte, 2012. "Energetic and exergetic analyses of a dual-fuel diesel engine," Renewable and Sustainable Energy Reviews, Elsevier, vol. 16(7), pages 4651-4660.
    2. Mani, M. & Nagarajan, G. & Sampath, S., 2011. "Characterisation and effect of using waste plastic oil and diesel fuel blends in compression ignition engine," Energy, Elsevier, vol. 36(1), pages 212-219.
    3. Yüksel, F. & Ceviz, M.A., 2003. "Thermal balance of a four stroke SI engine operating on hydrogen as a supplementary fuel," Energy, Elsevier, vol. 28(11), pages 1069-1080.
    4. Devaraj, J. & Robinson, Y. & Ganapathi, P., 2015. "Experimental investigation of performance, emission and combustion characteristics of waste plastic pyrolysis oil blended with diethyl ether used as fuel for diesel engine," Energy, Elsevier, vol. 85(C), pages 304-309.
    5. Ooi, Jong Boon & Ismail, Harun Mohamed & Tan, Boon Thong & Wang, Xin, 2018. "Effects of graphite oxide and single-walled carbon nanotubes as diesel additives on the performance, combustion, and emission characteristics of a light-duty diesel engine," Energy, Elsevier, vol. 161(C), pages 70-80.
    6. Mani, M. & Nagarajan, G., 2009. "Influence of injection timing on performance, emission and combustion characteristics of a DI diesel engine running on waste plastic oil," Energy, Elsevier, vol. 34(10), pages 1617-1623.
    7. EL-Seesy, Ahmed I. & Hassan, Hamdy, 2019. "Investigation of the effect of adding graphene oxide, graphene nanoplatelet, and multiwalled carbon nanotube additives with n-butanol-Jatropha methyl ester on a diesel engine performance," Renewable Energy, Elsevier, vol. 132(C), pages 558-574.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Mohan, Revu Krishna & Sarojini, Jajimoggala & Ağbulut, Ümit & Rajak, Upendra & Verma, Tikendra Nath & Reddy, K. Thirupathi, 2023. "Energy recovery from waste plastic oils as an alternative fuel source and comparative assessment of engine characteristics at varying fuel injection timings," Energy, Elsevier, vol. 275(C).
    2. Somkiat Maithomklang & Ekarong Sukjit & Jiraphon Srisertpol & Niti Klinkaew & Khatha Wathakit, 2023. "Pyrolysis Oil Derived from Plastic Bottle Caps: Characterization of Combustion and Emissions in a Diesel Engine," Energies, MDPI, vol. 16(5), pages 1-21, March.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Das, Amar Kumar & Sahu, Santosh Kumar & Panda, Achyut Kumar, 2022. "Current status and prospects of alternate liquid transportation fuels in compression ignition engines: A critical review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 161(C).
    2. Othman, Mohd Fahmi & Adam, Abdullah & Najafi, G. & Mamat, Rizalman, 2017. "Green fuel as alternative fuel for diesel engine: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 80(C), pages 694-709.
    3. Miranda, Miguel & Cabrita, I. & Pinto, Filomena & Gulyurtlu, I., 2013. "Mixtures of rubber tyre and plastic wastes pyrolysis: A kinetic study," Energy, Elsevier, vol. 58(C), pages 270-282.
    4. Khatha Wathakit & Ekarong Sukjit & Chalita Kaewbuddee & Somkiat Maithomklang & Niti Klinkaew & Pansa Liplap & Weerachai Arjharn & Jiraphon Srisertpol, 2021. "Characterization and Impact of Waste Plastic Oil in a Variable Compression Ratio Diesel Engine," Energies, MDPI, vol. 14(8), pages 1-18, April.
    5. Bujak, Janusz Wojciech, 2015. "Production of waste energy and heat in hospital facilities," Energy, Elsevier, vol. 91(C), pages 350-362.
    6. Bujak, Janusz Wojciech, 2015. "Heat recovery from thermal treatment of medical waste," Energy, Elsevier, vol. 90(P2), pages 1721-1732.
    7. Chaitanya, A.V. Krishna & Mohanty, Dillip Kumar, 2022. "Experimental investigation on the combustion, performance and emission characteristics of 1-pentanol blended waste plastic oil in a CRDI engine with EGR," Energy, Elsevier, vol. 256(C).
    8. Kalargaris, Ioannis & Tian, Guohong & Gu, Sai, 2017. "The utilisation of oils produced from plastic waste at different pyrolysis temperatures in a DI diesel engine," Energy, Elsevier, vol. 131(C), pages 179-185.
    9. Gad, M.S. & Panchal, Hitesh & Ağbulut, Ümit, 2022. "Waste to Energy: An experimental comparison of burning the waste-derived bio-oils produced by transesterification and pyrolysis methods," Energy, Elsevier, vol. 242(C).
    10. Vladimir Markov & Vyacheslav Kamaltdinov & Anatoliy Zherdev & Viktor Furman & Bowen Sa & Vsevolod Neverov, 2019. "Study on the Possibility of Improving the Environmental Performance of Diesel Engine Using Carbon Nanotubes as a Petroleum Diesel Fuel Additive," Energies, MDPI, vol. 12(22), pages 1-13, November.
    11. Heena Panchasara & Nanjappa Ashwath, 2021. "Effects of Pyrolysis Bio-Oils on Fuel Atomisation—A Review," Energies, MDPI, vol. 14(4), pages 1-22, February.
    12. Chonlakarn Wongkhorsub & Wantana Chaowasin & Kampanart Theinnoi, 2022. "Experimental Evaluation of Performance and Combustion Characteristics of Blended Plastic Pyrolysis Oil in Enhanced Diesel Engine," Energies, MDPI, vol. 15(23), pages 1-17, December.
    13. Bujak, Janusz Wojciech, 2015. "Thermal utilization (treatment) of plastic waste," Energy, Elsevier, vol. 90(P2), pages 1468-1477.
    14. Panneerselvam, N. & Murugesan, A. & Vijayakumar, C. & Kumaravel, A. & Subramaniam, D. & Avinash, A., 2015. "Effects of injection timing on bio-diesel fuelled engine characteristics—An overview," Renewable and Sustainable Energy Reviews, Elsevier, vol. 50(C), pages 17-31.
    15. Mirkarimi, S.M.R. & Bensaid, S. & Chiaramonti, D., 2022. "Conversion of mixed waste plastic into fuel for diesel engines through pyrolysis process: A review," Applied Energy, Elsevier, vol. 327(C).
    16. Alrazen, Hayder A. & Aminossadati, Saiied M. & Mahmood, Hussein A. & Hasan, M.M. & Abdulkreem-Alsultan, G. & Konarova, Muxina, 2023. "Theoretical investigation of combustion and emissions of CI engines fueled by various blends of depolymerized low-density polythene and diesel with co-solvent additives," Energy, Elsevier, vol. 282(C).
    17. Murugan, S. & Gu, Sai, 2015. "Research and development activities in pyrolysis – Contributions from Indian scientific community – A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 46(C), pages 282-295.
    18. Solmaz, Hamit & Ardebili, Seyed Mohammad Safieddin & Calam, Alper & Yılmaz, Emre & İpci, Duygu, 2021. "Prediction of performance and exhaust emissions of a CI engine fueled with multi-wall carbon nanotube doped biodiesel-diesel blends using response surface method," Energy, Elsevier, vol. 227(C).
    19. Obed M. Ali & Rizalman Mamat & Gholamhassan Najafi & Talal Yusaf & Seyed Mohammad Safieddin Ardebili, 2015. "Optimization of Biodiesel-Diesel Blended Fuel Properties and Engine Performance with Ether Additive Using Statistical Analysis and Response Surface Methods," Energies, MDPI, vol. 8(12), pages 1-15, December.
    20. Jou, Chih-Ju G. & Wu, Chung-Rung & Lee, Chien-Li, 2010. "Reduction of energy cost and CO2 emission for the furnace using energy recovered from waste tail-gas," Energy, Elsevier, vol. 35(3), pages 1232-1236.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:229:y:2021:i:c:s0360544221008781. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.