Pressure fluctuation and flow instability in S-shaped region of a reversible pump-turbine

To understand the pressure fluctuations occurring in S-shaped region of the pump-turbine and their relationships with rotor-stator interaction, rotating stall and vortex rope, the numerical and experimental studies of a reversible pump-turbine were conducted under turbine, runaway, turbine brake, small flow rate and reverse pump operating modes. The experimental results show that pressure fluctuations under turbine mode were most affected by the guide vane opening. This effect was weaker under turbine brake mode and weaker still under reverse pump mode. At a guide vane opening of 19 mm, the maximum fluctuation peak in the vaneless space is 5.7 times, 6.9 times and 2.0 times greater than that in the spiral casing inlet, draft tube cone and draft tube elbow, respectively. Unsteady simulation results for the whole flow passage of the pump-turbine show that asymmetric flow occurred in the runner under turbine, runaway and turbine brake operating modes. Meanwhile, an obvious rotating stall vortex with a frequency of 0.65fn was generated in turbine brake mode, resulting in relatively large pressure fluctuations in the vaneless space. At the small flow rate, flow separation in the vaneless space became very obvious, while that in the runner weakened, resulting in decreased pressure fluctuations in the vaneless space. Under reverse pump mode, pressure fluctuations in the vaneless space were relatively small because of obvious symmetrical flow separation in the runner. Pressure fluctuations in the draft tube were mainly attributed to the combined actions of rotating stall and vortex rope phenomena. What’s more, the fluctuation amplitudes at the rotating stall frequency of 0.65fn and the vortex rope frequencies of 0.30fn and 0.17fn were relatively large.