IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v16y2023i1p9-d1302965.html
   My bibliography  Save this article

The Optimization of Steam Generation in a Biomass-Fired Micro-Cogeneration Prototype Operating on a Modified Rankine Cycle

Author

Listed:
  • Krzysztof Sornek

    (Department of Sustainable Energy Development, Faculty of Energy and Fuels, AGH University of Krakow, Krakow, 30-059 Krakow, Poland)

  • Marcin Jankowski

    (Department of Sustainable Energy Development, Faculty of Energy and Fuels, AGH University of Krakow, Krakow, 30-059 Krakow, Poland)

  • Aleksandra Borsukiewicz

    (Department of Energy Technologies, Faculty of Mechanical Engineering and Mechatronics, West Pomeranian University of Technology, Szczecin, 70-310 Szczecin, Poland)

  • Mariusz Filipowicz

    (Department of Sustainable Energy Development, Faculty of Energy and Fuels, AGH University of Krakow, Krakow, 30-059 Krakow, Poland)

Abstract

According to the United Nations, one of the sustainable development goals is to ensure access to affordable, reliable, sustainable, and modern energy for all. Among other options, these goals can be achieved by developing and introducing micro-scale combined heat and power systems powered by renewable energy sources, including solar and biomass energy. Considering renewable energy-powered cogeneration technologies, the most promising are steam/vapor turbines, Stirling engines, and thermoelectric generators. This paper focuses on the selected operational aspects and retrofitting optimization of the prototypical micro-cogeneration system powered by a biomass-fired batch boiler and operating according to the modified Rankine cycle. The existing installation was tested, and the amount of energy transferred from the oil to the condensate and steam and the efficiency of the evaporator and the superheater were determined. A retrofitting optimization aimed at maximizing the piston engine’s power output was conducted based on the results. In particular, it was shown that the system’s power output might be as high as 9 kW e . Moreover, the analyzed system featured a high energy utilization factor of 97.9% at optimal operating conditions. In general, it was shown that the micro-scale steam Rankine system may successfully serve as an alternative technology for micro- and distributed cogeneration systems. As a technology supplied with renewable biomass energy and operating on a cheap and environmentally friendly working medium (water), it fits very well into the idea of sustainable energy system development.

Suggested Citation

  • Krzysztof Sornek & Marcin Jankowski & Aleksandra Borsukiewicz & Mariusz Filipowicz, 2023. "The Optimization of Steam Generation in a Biomass-Fired Micro-Cogeneration Prototype Operating on a Modified Rankine Cycle," Sustainability, MDPI, vol. 16(1), pages 1-22, December.
    • Handle: RePEc:gam:jsusta:v:16:y:2023:i:1:p:9-:d:1302965
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/16/1/9/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/16/1/9/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Azwifunimunwe Tshikovhi & Tshwafo Ellias Motaung, 2023. "Technologies and Innovations for Biomass Energy Production," Sustainability, MDPI, vol. 15(16), pages 1-21, August.
    2. Qiu, K. & Hayden, A.C.S., 2012. "Integrated thermoelectric and organic Rankine cycles for micro-CHP systems," Applied Energy, Elsevier, vol. 97(C), pages 667-672.
    3. Hawkes, A.D. & Leach, M.A., 2007. "Cost-effective operating strategy for residential micro-combined heat and power," Energy, Elsevier, vol. 32(5), pages 711-723.
    4. Qiuyi Wu, 2023. "Theoretical Evaluation of Photovoltaic Thermal Water Source Heat Pump, Application Potential and Policy Implications: Evidence from Yangtze River Economic Belt, China," Sustainability, MDPI, vol. 15(18), pages 1-22, September.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Maghanki, Maryam Mohammadi & Ghobadian, Barat & Najafi, Gholamhassan & Galogah, Reza Janzadeh, 2013. "Micro combined heat and power (MCHP) technologies and applications," Renewable and Sustainable Energy Reviews, Elsevier, vol. 28(C), pages 510-524.
    2. Krzysztof Sornek, 2020. "Prototypical Biomass-Fired Micro-Cogeneration Systems—Energy and Ecological Analysis," Energies, MDPI, vol. 13(15), pages 1-16, July.
    3. Adam, Alexandros & Fraga, Eric S. & Brett, Dan J.L., 2015. "Options for residential building services design using fuel cell based micro-CHP and the potential for heat integration," Applied Energy, Elsevier, vol. 138(C), pages 685-694.
    4. Murugan, S. & Horák, Bohumil, 2016. "A review of micro combined heat and power systems for residential applications," Renewable and Sustainable Energy Reviews, Elsevier, vol. 64(C), pages 144-162.
    5. khanmohammadi, Shoaib & Saadat-Targhi, Morteza, 2019. "Performance enhancement of an integrated system with solar flat plate collector for hydrogen production using waste heat recovery," Energy, Elsevier, vol. 171(C), pages 1066-1076.
    6. Abolhosseini, Shahrouz & Heshmati, Almas & Altmann, Jörn, 2014. "A Review of Renewable Energy Supply and Energy Efficiency Technologies," IZA Discussion Papers 8145, Institute of Labor Economics (IZA).
    7. Gao, Datong & Zhao, Bin & Kwan, Trevor Hocksun & Hao, Yong & Pei, Gang, 2022. "The spatial and temporal mismatch phenomenon in solar space heating applications: status and solutions," Applied Energy, Elsevier, vol. 321(C).
    8. Hadžiselimović, Miralem & Srpčič, Gregor & Brinovar, Iztok & Praunseis, Zdravko & Seme, Sebastijan & Štumberger, Bojan, 2019. "A novel concept of linear oscillatory synchronous generator designed for a stirling engine," Energy, Elsevier, vol. 180(C), pages 19-27.
    9. Jean de Dieu Marcel Ufitikirezi & Martin Filip & Mohammad Ghorbani & Tomáš Zoubek & Pavel Olšan & Roman Bumbálek & Miroslav Strob & Petr Bartoš & Sandra Nicole Umurungi & Yves Theoneste Murindangabo &, 2024. "Agricultural Waste Valorization: Exploring Environmentally Friendly Approaches to Bioenergy Conversion," Sustainability, MDPI, vol. 16(9), pages 1-24, April.
    10. Entchev, E. & Yang, L. & Ghorab, M. & Lee, E.J., 2013. "Simulation of hybrid renewable microgeneration systems in load sharing applications," Energy, Elsevier, vol. 50(C), pages 252-261.
    11. Xiaofeng Liu & Shijun Wang & Jiawen Sun, 2018. "Energy Management for Community Energy Network with CHP Based on Cooperative Game," Energies, MDPI, vol. 11(5), pages 1-18, April.
    12. Shen, Rong & Gou, Xiaolong & Xu, Haoyu & Qiu, Kuanrong, 2017. "Dynamic performance analysis of a cascaded thermoelectric generator," Applied Energy, Elsevier, vol. 203(C), pages 808-815.
    13. Kazemdehdashti, A. & Mohammadi, M. & Seifi, A.R. & Rastegar, M., 2020. "Stochastic energy management in multi-carrier residential energy systems," Energy, Elsevier, vol. 202(C).
    14. Poolla, Chaitanya & Ishihara, Abraham K. & Milito, Rodolfo, 2019. "Designing near-optimal policies for energy management in a stochastic environment," Applied Energy, Elsevier, vol. 242(C), pages 1725-1737.
    15. Nader, Wissam Bou & Chamoun, Joy & Dumand, Clément, 2020. "Optimization of the thermodynamic configurations of a thermoacoustic engine auxiliary power unit for range extended hybrid electric vehicles," Energy, Elsevier, vol. 195(C).
    16. Facci, Andrea L. & Cigolotti, Viviana & Jannelli, Elio & Ubertini, Stefano, 2017. "Technical and economic assessment of a SOFC-based energy system for combined cooling, heating and power," Applied Energy, Elsevier, vol. 192(C), pages 563-574.
    17. Di Somma, M. & Graditi, G. & Heydarian-Forushani, E. & Shafie-khah, M. & Siano, P., 2018. "Stochastic optimal scheduling of distributed energy resources with renewables considering economic and environmental aspects," Renewable Energy, Elsevier, vol. 116(PA), pages 272-287.
    18. Pellegrino, Sandro & Lanzini, Andrea & Leone, Pierluigi, 2015. "Techno-economic and policy requirements for the market-entry of the fuel cell micro-CHP system in the residential sector," Applied Energy, Elsevier, vol. 143(C), pages 370-382.
    19. Brouwer, Anne Sjoerd & Kuramochi, Takeshi & van den Broek, Machteld & Faaij, André, 2013. "Fulfilling the electricity demand of electric vehicles in the long term future: An evaluation of centralized and decentralized power supply systems," Applied Energy, Elsevier, vol. 107(C), pages 33-51.
    20. Amin Mohammadi & Akbar Maleki, 2024. "Performance Improvement of the LNG Regasification Process Based on Geothermal Energy Using a Thermoelectric Generator and Energy and Exergy Analyses," Sustainability, MDPI, vol. 16(24), pages 1-22, December.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:16:y:2023:i:1:p:9-:d:1302965. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.