IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i2p703-d1028078.html
   My bibliography  Save this article

Advanced Exergy Analysis of Ultra-Low GWP Reversible Heat Pumps for Residential Applications

Author

Listed:
  • Volodymyr Voloshchuk

    (Department of Energy Processes Automation, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, 03056 Kyiv, Ukraine)

  • Paride Gullo

    (Department of Mechanical and Electrical Engineering, University of Southern Denmark (SDU), 6400 Sønderborg, Denmark)

  • Eugene Nikiforovich

    (Department of Nuclear Energy, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, 03056 Kyiv, Ukraine)

Abstract

Exergy-based methods provide engineers with the best information with respect to options for improving the overall thermodynamic efficiency of an energy conversion system. This paper presents the results of an advanced exergy analysis of an air-to-water reversible heat pump whose performance was analyzed with respect to different working fluids. Environmentally deleterious refrigerants, i.e., R410A and R134a (baselines), and their eco-friendly replacements (R290, R152a, R1234ze(E), and R1234yf) were selected. The evaluations were conducted under the same operating conditions (i.e., with the same cooling and heating demands and outdoor temperatures). Based on conventional exergy analysis, it was determined that different priorities should be given for the thermodynamic improvement of the components according to which heating and cooling modes of the system are in use. Therefore, integrated parameters, i.e., the annual values of exergy destruction, were applied for further analysis. The results obtained showed that the heat pump using R410A provided the largest degree of annual exergy destruction estimated on the basis of conventional exergy analysis (5913 kWh), whereas the heat pump using R290 offered the lowest one (4522 kWh). The annual exergy destruction of the R410A cycle with only unavoidable irreversibilities could be decreased by 50%. In this case, compared to R410A and R134a, R152a and R290 provided lower values of the total annual unavoidable aspects of exergy destruction. Considering technological limitations, when removing all the avoidable irreversibilities within the air exchanger, the largest decrease in the total exergy destruction within the system could be reached. The results obtained from the analysis of the removable irreversibilities showed that the mutual interactions between the compressor, evaporator, and condenser were weak. Finally, it was concluded that, from a thermodynamic point of view, the adoption of R152a and R290 in reversible air-to-water heat pumps as replacements for R410A and R134a is advisable.

Suggested Citation

  • Volodymyr Voloshchuk & Paride Gullo & Eugene Nikiforovich, 2023. "Advanced Exergy Analysis of Ultra-Low GWP Reversible Heat Pumps for Residential Applications," Energies, MDPI, vol. 16(2), pages 1-17, January.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:2:p:703-:d:1028078
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/2/703/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/2/703/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Paolo Artuso & Giacomo Tosato & Antonio Rossetti & Sergio Marinetti & Armin Hafner & Krzysztof Banasiak & Silvia Minetto, 2021. "Dynamic Modelling and Validation of an Air-to-Water Reversible R744 Heat Pump for High Energy Demand Buildings," Energies, MDPI, vol. 14(24), pages 1-25, December.
    2. Wu, Di & Hu, Bin & Wang, R.Z. & Fan, Haibin & Wang, Rujin, 2020. "The performance comparison of high temperature heat pump among R718 and other refrigerants," Renewable Energy, Elsevier, vol. 154(C), pages 715-722.
    3. Morosuk, Tatiana & Tsatsaronis, George, 2019. "Advanced exergy-based methods used to understand and improve energy-conversion systems," Energy, Elsevier, vol. 169(C), pages 238-246.
    4. Voloshchuk, Volodymyr & Gullo, Paride & Sereda, Volodymyr, 2020. "Advanced exergy-based performance enhancement of heat pump space heating system," Energy, Elsevier, vol. 205(C).
    5. Paul Byrne, 2022. "Research Summary and Literature Review on Modelling and Simulation of Heat Pumps for Simultaneous Heating and Cooling for Buildings," Energies, MDPI, vol. 15(10), pages 1-43, May.
    6. Sanaye, Sepehr & Chahartaghi, Mahmood & Asgari, Hesam, 2013. "Dynamic modeling of Gas Engine driven Heat Pump system in cooling mode," Energy, Elsevier, vol. 55(C), pages 195-208.
    7. Sergio Bobbo & Laura Fedele & Marco Curcio & Anna Bet & Michele De Carli & Giuseppe Emmi & Fabio Poletto & Andrea Tarabotti & Dimitris Mendrinos & Giulia Mezzasalma & Adriana Bernardi, 2019. "Energetic and Exergetic Analysis of Low Global Warming Potential Refrigerants as Substitutes for R410A in Ground Source Heat Pumps," Energies, MDPI, vol. 12(18), pages 1-16, September.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Paul Byrne, 2022. "Modelling and Simulation of Heat Pumps for Simultaneous Heating and Cooling, a Special Issue," Energies, MDPI, vol. 15(16), pages 1-2, August.
    2. Li, Longquan & Liu, Zhiqiang & Deng, Chengwei & Ren, Jingzheng & Ji, Feng & Sun, Yi & Xiao, Zhenyu & Yang, Sheng, 2021. "Conventional and advanced exergy analyses of a vehicular proton exchange membrane fuel cell power system," Energy, Elsevier, vol. 222(C).
    3. Feng, Chao & Zhu, Rong & Wei, Guangsheng & Dong, Kai & Xia, Tao, 2023. "Typical case of CO2 capture in Chinese iron and steel enterprises: Exergy analysis," Applied Energy, Elsevier, vol. 336(C).
    4. Andrea Aquino & Pietro Poesio, 2021. "Off-Design Exergy Analysis of Convective Drying Using a Two-Phase Multispecies Model," Energies, MDPI, vol. 14(1), pages 1-36, January.
    5. Paul Byrne, 2022. "Research Summary and Literature Review on Modelling and Simulation of Heat Pumps for Simultaneous Heating and Cooling for Buildings," Energies, MDPI, vol. 15(10), pages 1-43, May.
    6. Zhong, Xiaohui & Chen, Tao & Sun, Xiangyu & Song, Juanjuan & Zeng, Jiajun, 2022. "Conventional and advanced exergy analysis of a novel wind-to-heat system," Energy, Elsevier, vol. 261(PA).
    7. Bartosz Pawela & Marek Jaszczur, 2022. "Review of Gas Engine Heat Pumps," Energies, MDPI, vol. 15(13), pages 1-16, July.
    8. Sheykhi, Mohammad & Chahartaghi, Mahmood & Safaei Pirooz, Amir Ali & Flay, Richard G.J., 2020. "Investigation of the effects of operating parameters of an internal combustion engine on the performance and fuel consumption of a CCHP system," Energy, Elsevier, vol. 211(C).
    9. Ibrahim, Oussama & Fardoun, Farouk & Younes, Rafic & Louahlia-Gualous, Hasna, 2014. "Air source heat pump water heater: Dynamic modeling, optimal energy management and mini-tubes condensers," Energy, Elsevier, vol. 64(C), pages 1102-1116.
    10. Jian Sun & Yinwu Wang & Yu Qin & Guoshun Wang & Ran Liu & Yongping Yang, 2023. "A Review of Super-High-Temperature Heat Pumps over 100 °C," Energies, MDPI, vol. 16(12), pages 1-18, June.
    11. Wu, Di & Wei, Junzhuo & Wang, R.Z., 2025. "Performance investigation of a new hybrid high-temperature heat PUMP with natural water medium," Energy, Elsevier, vol. 314(C).
    12. Liao, Gaoliang & E, Jiaqiang & Zhang, Feng & Chen, Jingwei & Leng, Erwei, 2020. "Advanced exergy analysis for Organic Rankine Cycle-based layout to recover waste heat of flue gas," Applied Energy, Elsevier, vol. 266(C).
    13. Vering, Christian & Kroppa, Hendrik & Venzik, Valerius & Streblow, Rita & Müller, Dirk, 2022. "Towards an integral decision-making process applied to the refrigerant selection in heat pumps," Renewable Energy, Elsevier, vol. 192(C), pages 815-827.
    14. Yang, Minbo & Li, Ting & Feng, Xiao & Wang, Yufei, 2020. "A simulation-based targeting method for heat pump placements in heat exchanger networks," Energy, Elsevier, vol. 203(C).
    15. Xiao, Yan & You, Huailiang & Chen, Daifen & Yuan, Ye & Hu, Bin & Li, Guoxiang & Han, Jitian, 2025. "Exergy, exergoeconomic, and exergoenvironmental analyses of a combined cooling, heating, power, and freshwater poly-generation system driven by methane-fueled solid oxide fuel cell," Energy, Elsevier, vol. 314(C).
    16. Liu, Changchun & Han, Wei & Xue, Xiaodong, 2022. "Experimental investigation of a high-temperature heat pump for industrial steam production," Applied Energy, Elsevier, vol. 312(C).
    17. Yu Huang & Weizhen Hou & Yiran Huang & Jiayu Li & Qixian Li & Dongfeng Wang & Yan Zhang, 2020. "Multi-Objective Optimal Operation for Steam Power Scheduling Based on Economic and Exergetic Analysis," Energies, MDPI, vol. 13(8), pages 1-18, April.
    18. Xu, Jing & Bi, Dapeng & Ma, Suxia & Bai, Jin, 2020. "A data-based approach for benchmark interval determination with varying operating conditions in the coal-fired power unit," Energy, Elsevier, vol. 211(C).
    19. Obrist, Michel D. & Kannan, Ramachandran & McKenna, Russell & Schmidt, Thomas J. & Kober, Tom, 2023. "High-temperature heat pumps in climate pathways for selected industry sectors in Switzerland," Energy Policy, Elsevier, vol. 173(C).
    20. Kosmadakis, George & Neofytou, Panagiotis, 2022. "Reversible high-temperature heat pump/ORC for waste heat recovery in various ships: A techno-economic assessment," Energy, Elsevier, vol. 256(C).

    More about this item

    Keywords

    ;
    ;
    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:2:p:703-:d:1028078. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.