IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i23p8960-d985438.html
   My bibliography  Save this article

Effect of Rotational Speed on the Structural, Morphological, and Optical Properties of Biosynthesized Nickel Oxide Thin Films for Selective Solar Absorber Nanocoatings

Author

Listed:
  • Henok G. Gebretinsae

    (Department of Physics, College of Natural and Computational Science, Adigrat University, Adigrat P.O. Box 50, Ethiopia
    UNESCO—UNISA Africa Chair in Nanoscience and Nanotechnology, College of Graduate Studies, Muckleneuk Ridge, Pretoria 0001, South Africa
    Nanosciences African Network-Materials Research Department, iThemba LABS-National Research Foundation, Cape Town 7129, South Africa)

  • Meresa G. Tsegay

    (Department of Physics, College of Natural and Computational Science, Adigrat University, Adigrat P.O. Box 50, Ethiopia
    UNESCO—UNISA Africa Chair in Nanoscience and Nanotechnology, College of Graduate Studies, Muckleneuk Ridge, Pretoria 0001, South Africa
    Nanosciences African Network-Materials Research Department, iThemba LABS-National Research Foundation, Cape Town 7129, South Africa)

  • Giday G. Welegergs

    (UNESCO—UNISA Africa Chair in Nanoscience and Nanotechnology, College of Graduate Studies, Muckleneuk Ridge, Pretoria 0001, South Africa
    Nanosciences African Network-Materials Research Department, iThemba LABS-National Research Foundation, Cape Town 7129, South Africa)

  • Malik Maaza

    (UNESCO—UNISA Africa Chair in Nanoscience and Nanotechnology, College of Graduate Studies, Muckleneuk Ridge, Pretoria 0001, South Africa
    Nanosciences African Network-Materials Research Department, iThemba LABS-National Research Foundation, Cape Town 7129, South Africa)

  • Zebib Y. Nuru

    (Department of Physics, College of Natural and Computational Science, Adigrat University, Adigrat P.O. Box 50, Ethiopia
    UNESCO—UNISA Africa Chair in Nanoscience and Nanotechnology, College of Graduate Studies, Muckleneuk Ridge, Pretoria 0001, South Africa
    Nanosciences African Network-Materials Research Department, iThemba LABS-National Research Foundation, Cape Town 7129, South Africa)

Abstract

This article presents a simple and low-cost green synthesized single-layer NiO selective solar absorber nanocoating prepared by spin coating on a Cu substrate at different rotational speeds (RS). The effects of substrate RS on the structural, morphological, chemical, and optical properties of the NiO nanocoatings were thoroughly investigated. The XRD results reveal the formation of pure diffraction peaks indexed to face-centered cubic NiO nanocoatings. SEM confirmed the uniform distribution of the NiO thin films with a nanosphere-like structure and the influence of RS variation on the formation of NiO nanostructures. EDS and XPS confirmed the presence of Ni and O in the green synthesized NiO coatings. AFM showed homogeneous nanopillar-like NiO thin films with the average surface roughness decreasing from 13.6 to 9.06 nm as the RS increased from 700 to 1300 RPM. Raman spectroscopy of the nanocoatings showed normal modes related to longitudinal optical and transverse optical phonons, and a combination of both, which implies the presence of a defect-rich or anti-ferromagnetically ordered NiO film responsible for the occurrence of more scattering peaks. UV–Vis–NIR and Fourier transform infrared spectroscopy (FTIR) were employed to characterize the optical properties of the nanocoatings. The green synthesized NiO nanocoatings deposited at 700 RPM exhibited excellent solar absorptance (α) of 0.92 and low thermal emittance (ɛ) of 0.11. The optical properties of the selective materials obtained in the present work were correlated with the non-stoichiometric nature of the spin-coated sample, multiple reflections, and interference-induced light absorption on the green synthesized surface. These results suggest that the NiO thin films prepared through this simple and environmentally benign green synthesis method can be promising candidates for efficient solar selective absorbers.

Suggested Citation

  • Henok G. Gebretinsae & Meresa G. Tsegay & Giday G. Welegergs & Malik Maaza & Zebib Y. Nuru, 2022. "Effect of Rotational Speed on the Structural, Morphological, and Optical Properties of Biosynthesized Nickel Oxide Thin Films for Selective Solar Absorber Nanocoatings," Energies, MDPI, vol. 15(23), pages 1-18, November.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:23:p:8960-:d:985438
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/23/8960/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/23/8960/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Davide De Maio & Carmine D’Alessandro & Antonio Caldarelli & Daniela De Luca & Emiliano Di Gennaro & Roberto Russo & Marilena Musto, 2021. "A Selective Solar Absorber for Unconcentrated Solar Thermal Panels," Energies, MDPI, vol. 14(4), pages 1-13, February.
    2. Zhang, Ke & Hao, Lei & Du, Miao & Mi, Jing & Wang, Ji-Ning & Meng, Jian-ping, 2017. "A review on thermal stability and high temperature induced ageing mechanisms of solar absorber coatings," Renewable and Sustainable Energy Reviews, Elsevier, vol. 67(C), pages 1282-1299.
    3. Tabish Alam & Nagesh Babu Balam & Kishor Sitaram Kulkarni & Md Irfanul Haque Siddiqui & Nishant Raj Kapoor & Chandan Swaroop Meena & Ashok Kumar & Raffaello Cozzolino, 2021. "Performance Augmentation of the Flat Plate Solar Thermal Collector: A Review," Energies, MDPI, vol. 14(19), pages 1-23, September.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Ehab AlShamaileh & Iessa Sabbe Moosa & Heba Al-Fayyad & Bashar Lahlouh & Hussein A. Kazem & Qusay Abu-Afifeh & Bety S. Al-Saqarat & Muayad Esaifan & Imad Hamadneh, 2022. "Performance Comparison and Light Reflectance of Al, Cu, and Fe Metals in Direct Contact Flat Solar Heating Systems," Energies, MDPI, vol. 15(23), pages 1-15, November.
    2. Lei, Dongqiang & Fu, Xuqiang & Ren, Yucong & Yao, Fangyuan & Wang, Zhifeng, 2019. "Temperature and thermal stress analysis of parabolic trough receivers," Renewable Energy, Elsevier, vol. 136(C), pages 403-413.
    3. Łukasz Amanowicz, 2021. "Peak Power of Heat Source for Domestic Hot Water Preparation (DHW) for Residential Estate in Poland as a Representative Case Study for the Climate of Central Europe," Energies, MDPI, vol. 14(23), pages 1-15, December.
    4. Pavel G. Struchalin & Dmitrii M. Kuzmenkov & Vladimir S. Yunin & Xinzhi Wang & Yurong He & Boris V. Balakin, 2022. "Hybrid Nanofluid in a Direct Absorption Solar Collector: Magnetite vs. Carbon Nanotubes Compete for Thermal Performance," Energies, MDPI, vol. 15(5), pages 1-8, February.
    5. Manikandan, G.K. & Iniyan, S. & Goic, Ranko, 2019. "Enhancing the optical and thermal efficiency of a parabolic trough collector – A review," Applied Energy, Elsevier, vol. 235(C), pages 1524-1540.
    6. Gustavo Furtado Pereira & Aline da Silva Oliveira & Kelly Cristiane Gomes & José Félix Silva Neto & Thiago Araújo Simões & Antônio Farias Leal & Sandro Marden Torres & Marçal Rosas Florentino Lima Fil, 2022. "Selective Absorbing Surface Based on CrO 3 : Evaluation of Substrates Treatment Influence on the Films Optical Properties," Energies, MDPI, vol. 16(1), pages 1-17, December.
    7. Yifan Guo & Kaoru Tsuda & Sahar Hosseini & Yasushi Murakami & Antonio Tricoli & Joe Coventry & Wojciech Lipiński & Juan F. Torres, 2024. "Scalable nano-architecture for stable near-blackbody solar absorption at high temperatures," Nature Communications, Nature, vol. 15(1), pages 1-13, December.
    8. Karmveer & Naveen Kumar Gupta & Tabish Alam & Raffaello Cozzolino & Gino Bella, 2022. "A Descriptive Review to Access the Most Suitable Rib’s Configuration of Roughness for the Maximum Performance of Solar Air Heater," Energies, MDPI, vol. 15(8), pages 1-46, April.
    9. Wang, Chengbing & Li, Wei & Li, Zhengtong & Fang, Baizeng, 2020. "Solar thermal harvesting based on self-doped nanocermet: Structural merits, design strategies and applications," Renewable and Sustainable Energy Reviews, Elsevier, vol. 134(C).
    10. Hu, Mingke & Zhao, Bin & Ao, Xianze & Feng, Junsheng & Cao, Jingyu & Su, Yuehong & Pei, Gang, 2019. "Experimental study on a hybrid photo-thermal and radiative cooling collector using black acrylic paint as the panel coating," Renewable Energy, Elsevier, vol. 139(C), pages 1217-1226.
    11. Ashok Kumar & Pardeep Singh & Nishant Raj Kapoor & Chandan Swaroop Meena & Kshitij Jain & Kishor S. Kulkarni & Raffaello Cozzolino, 2021. "Ecological Footprint of Residential Buildings in Composite Climate of India—A Case Study," Sustainability, MDPI, vol. 13(21), pages 1-25, October.
    12. Hu, Mingke & Zhao, Bin & Ao, Xianze & Zhao, Pinghui & Su, Yuehong & Pei, Gang, 2018. "Field investigation of a hybrid photovoltaic-photothermic-radiative cooling system," Applied Energy, Elsevier, vol. 231(C), pages 288-300.
    13. Osorio, Julian D. & Rivera-Alvarez, Alejandro, 2019. "Performance analysis of Parabolic Trough Collectors with Double Glass Envelope," Renewable Energy, Elsevier, vol. 130(C), pages 1092-1107.
    14. Wang, Wen-Qi & He, Ya-Ling & Jiang, Rui, 2022. "A multi-scale solar receiver with peak receiver efficiency over 90% at 720 °C for the next-generation solar power tower," Renewable Energy, Elsevier, vol. 200(C), pages 714-723.
    15. Song, Jifeng & Tong, Kai & Luo, Geng & Li, Lei, 2017. "Influence of non-ideal optical factors in actual engineering on the safety and stability of a parabolic trough collector," Renewable Energy, Elsevier, vol. 113(C), pages 1293-1301.
    16. De Luca, Daniela & Strazzullo, Paolo & Di Gennaro, Emiliano & Caldarelli, Antonio & Gaudino, Eliana & Musto, Marilena & Russo, Roberto, 2023. "High vacuum flat plate photovoltaic-thermal (HV PV-T) collectors: Efficiency analysis," Applied Energy, Elsevier, vol. 352(C).
    17. Caron, Simon & Garrido, Jorge & Ballestrín, Jesus & Sutter, Florian & Röger, Marc & Manzano-Agugliaro, Francisco, 2022. "A comparative analysis of opto-thermal figures of merit for high temperature solar thermal absorber coatings," Renewable and Sustainable Energy Reviews, Elsevier, vol. 154(C).
    18. Balaji, K. & Ganesh Kumar, P. & Sakthivadivel, D. & Vigneswaran, V.S. & Iniyan, S., 2019. "Experimental investigation on flat plate solar collector using frictionally engaged thermal performance enhancer in the absorber tube," Renewable Energy, Elsevier, vol. 142(C), pages 62-72.
    19. Chen, Xue & Lyu, Jinxin & Sun, Chuang & Xia, Xinlin & Wang, Fuqiang, 2023. "Pore-scale evaluation on a volumetric solar receiver with different optical property control strategies," Energy, Elsevier, vol. 278(PB).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:23:p:8960-:d:985438. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.