IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v13y2020i3p704-d317178.html
   My bibliography  Save this article

Online Determining Heat Transfer Coefficient for Monitoring Transient Thermal Stresses

Author

Listed:
  • Magdalena Jaremkiewicz

    (Department of Energy, Cracow University of Technology, Al. Jana Pawła II 37, 31-864 Cracow, Poland)

  • Jan Taler

    (Department of Energy, Cracow University of Technology, Al. Jana Pawła II 37, 31-864 Cracow, Poland)

Abstract

This paper proposes an effective method for determining thermal stresses in structural elements with a three-dimensional transient temperature field. This is the situation in the case of pressure elements of complex shapes. When the thermal stresses are determined by the finite element method (FEM), the temperature of the fluid and the heat transfer coefficient on the internal surface must be known. Both values are very difficult to determine under industrial conditions. In this paper, an inverse space marching method was proposed for the determination of the heat transfer coefficient on the active surface of the thick-walled plate. The temperature and heat flux on the exposed surface were obtained by measuring the unsteady temperature in a small region on the insulated external surface of a pressure component that is easily accessible. Three different procedures for the determination of the heat transfer coefficient on the water-spray surface were presented, with the division of the plate into three or four finite volumes in the normal direction to the plate surface. Calculation and experimental tests were carried out in order to validate the method. The results of the measurements and calculations agreed very well. The computer calculation time is short, so the technique can be used for online stress determination. The proposed method can be applied to monitor thermal stresses in the components of the power unit in thermal power plants, both conventional and nuclear.

Suggested Citation

  • Magdalena Jaremkiewicz & Jan Taler, 2020. "Online Determining Heat Transfer Coefficient for Monitoring Transient Thermal Stresses," Energies, MDPI, vol. 13(3), pages 1-13, February.
  • Handle: RePEc:gam:jeners:v:13:y:2020:i:3:p:704-:d:317178
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/13/3/704/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/13/3/704/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Taler, Jan & Zima, Wiesław & Ocłoń, Paweł & Grądziel, Sławomir & Taler, Dawid & Cebula, Artur & Jaremkiewicz, Magdalena & Korzeń, Anna & Cisek, Piotr & Kaczmarski, Karol & Majewski, Karol, 2019. "Mathematical model of a supercritical power boiler for simulating rapid changes in boiler thermal loading," Energy, Elsevier, vol. 175(C), pages 580-592.
    2. Magdalena Jaremkiewicz & Dawid Taler & Piotr Dzierwa & Jan Taler, 2019. "Determination of Transient Fluid Temperature and Thermal Stresses in Pressure Thick-Walled Elements Using a New Design Thermometer," Energies, MDPI, vol. 12(2), pages 1-21, January.
    3. Jaremkiewicz, Magdalena & Dzierwa, Piotr & Taler, Dawid & Taler, Jan, 2019. "Monitoring of transient thermal stresses in pressure components of steam boilers using an innovative technique for measuring the fluid temperature," Energy, Elsevier, vol. 175(C), pages 139-150.
    4. Luca Riboldi & Lars O. Nord, 2017. "Lifetime Assessment of Combined Cycles for Cogeneration of Power and Heat in Offshore Oil and Gas Installations," Energies, MDPI, vol. 10(6), pages 1-23, May.
    5. Liping Pang & Size Yi & Liqiang Duan & Wenxue Li & Yongping Yang, 2019. "Thermal Stress and Cyclic Stress Analysis of a Vertical Water-Cooled Wall at a Utility Boiler under Flexible Operation," Energies, MDPI, vol. 12(6), pages 1-18, March.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Jerzy Okrajni & Krzysztof Wacławiak & Mariusz Twardawa & Grzegorz Junak, 2022. "The Impact of Conventional Power Block Startup Procedures on the Fatigue Behavior of Drum Materials," Energies, MDPI, vol. 15(10), pages 1-19, May.
    2. Fernanda Mitchelly Vilas Boas & Luiz Eduardo Borges-da-Silva & Helcio Francisco Villa-Nova & Erik Leandro Bonaldi & Levy Ely Lacerda Oliveira & Germano Lambert-Torres & Frederico de Oliveira Assuncao , 2021. "Condition Monitoring of Internal Combustion Engines in Thermal Power Plants Based on Control Charts and Adapted Nelson Rules," Energies, MDPI, vol. 14(16), pages 1-17, August.
    3. Jerzy Okrajni & Mariusz Twardawa & Krzysztof Wacławiak, 2021. "Impact of Heat Transfer on Transient Stress Fields in Power Plant Boiler Components," Energies, MDPI, vol. 14(4), pages 1-19, February.
    4. Taler, Dawid & Dzierwa, Piotr & Kaczmarski, Karol & Taler, Jan, 2021. "Optimisation of heating and cooling of pressure thick-walled components operating in the saturated steam area," Energy, Elsevier, vol. 231(C).
    5. Magda Joachimiak, 2021. "Analysis of Thermodynamic Parameter Variability in a Chamber of a Furnace for Thermo-Chemical Treatment," Energies, MDPI, vol. 14(10), pages 1-18, May.
    6. Taler, Dawid & Dzierwa, Piotr & Kaczmarski, Karol & Taler, Jan, 2022. "Increase the flexibility of steam boilers by optimisation of critical pressure component heating," Energy, Elsevier, vol. 250(C).
    7. Jerzy Okrajni & Krzysztof Wacławiak, 2023. "Heat Transfer in the Components of Power Boilers and Related Technological and Endurance Problems," Energies, MDPI, vol. 16(12), pages 1-4, June.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Taler, Jan & Trojan, Marcin & Dzierwa, Piotr & Kaczmarski, Karol & Węglowski, Bohdan & Taler, Dawid & Zima, Wiesław & Grądziel, Sławomir & Ocłoń, Paweł & Sobota, Tomasz & Rerak, Monika & Jaremkiewicz,, 2023. "The flexible boiler operation in a wide range of load changes with considering the strength and environmental restrictions," Energy, Elsevier, vol. 263(PB).
    2. Taler, Dawid & Dzierwa, Piotr & Kaczmarski, Karol & Taler, Jan, 2022. "Increase the flexibility of steam boilers by optimisation of critical pressure component heating," Energy, Elsevier, vol. 250(C).
    3. Dawid Taler & Tomasz Sobota & Magdalena Jaremkiewicz & Jan Taler, 2020. "Influence of the Thermometer Inertia on the Quality of Temperature Control in a Hot Liquid Tank Heated with Electric Energy," Energies, MDPI, vol. 13(15), pages 1-18, August.
    4. Paweł Ziółkowski & Stanisław Głuch & Piotr Józef Ziółkowski & Janusz Badur, 2022. "Compact High Efficiency and Zero-Emission Gas-Fired Power Plant with Oxy-Combustion and Carbon Capture," Energies, MDPI, vol. 15(7), pages 1-39, April.
    5. Boyu Deng & Tuo Zhou & Shuangming Zhang & Haowen Wu & Xiaoguo Jiang & Man Zhang & Hairui Yang, 2022. "Safety Analysis on the Heating Surfaces in the 660 MW Ultra-Supercritical CFB Boiler under Sudden Electricity Failure," Energies, MDPI, vol. 15(21), pages 1-15, October.
    6. Taler, Dawid & Dzierwa, Piotr & Taler, Jan, 2020. "New method for determining the optimum fluid temperature when heating pressure thick-walled components with openings," Energy, Elsevier, vol. 200(C).
    7. Magda Joachimiak, 2021. "Analysis of Thermodynamic Parameter Variability in a Chamber of a Furnace for Thermo-Chemical Treatment," Energies, MDPI, vol. 14(10), pages 1-18, May.
    8. Jia, Xiongjie & Sang, Yichen & Li, Yanjun & Du, Wei & Zhang, Guolei, 2022. "Short-term forecasting for supercharged boiler safety performance based on advanced data-driven modelling framework," Energy, Elsevier, vol. 239(PE).
    9. Luca Riboldi & Steve Völler & Magnus Korpås & Lars O. Nord, 2019. "An Integrated Assessment of the Environmental and Economic Impact of Offshore Oil Platform Electrification," Energies, MDPI, vol. 12(11), pages 1-21, June.
    10. Barbosa, Yuri M. & da Silva, Julio A.M. & Junior, Silvio de O. & Torres, Ednildo A., 2018. "Performance assessment of primary petroleum production cogeneration plants," Energy, Elsevier, vol. 160(C), pages 233-244.
    11. Trojan, Marcin & Taler, Jan & Smaza, Krzysztof & Wróbel, Wojciech & Dzierwa, Piotr & Taler, Dawid & Kaczmarski, Karol, 2022. "A new software program for monitoring the energy distribution in a thermal waste treatment plant system," Renewable Energy, Elsevier, vol. 184(C), pages 1055-1073.
    12. Marcin Trojan & Piotr Dzierwa & Jan Taler & Mariusz Granda & Karol Kaczmarski & Dawid Taler & Tomasz Sobota, 2023. "Analysis of the Causes of the Emergency Shutdown of Natural Gas-Fired Water Peak Boilers at the Large Municipal Combined Heat and Power Plant," Energies, MDPI, vol. 16(17), pages 1-21, August.
    13. Zhang, Zhongxiao & Zhou, Rongcan & Ge, Xueli & Zhang, Jian & Wu, Xiaojiang, 2020. "Perspectives for 700 °C ultra-supercritical power generation: Thermal safety of high-temperature heating surfaces," Energy, Elsevier, vol. 190(C).
    14. Zima, Wiesław & Taler, Jan & Grądziel, Sławomir & Trojan, Marcin & Cebula, Artur & Ocłoń, Paweł & Dzierwa, Piotr & Taler, Dawid & Rerak, Monika & Majdak, Marek & Korzeń, Anna & Skrzyniowska, Dorota, 2022. "Thermal calculations of a natural circulation power boiler operating under a wide range of loads," Energy, Elsevier, vol. 261(PB).
    15. Maciej Masiukiewicz & Stanisław Anweiler, 2021. "Precise Evaluation of Gas–Liquid Two-Phase Flow Pattern in a Narrow Rectangular Channel with Stereology Method," Energies, MDPI, vol. 14(11), pages 1-16, May.
    16. Flórez-Orrego, Daniel & Albuquerque, Cyro & da Silva, Julio A.M. & Freire, Ronaldo Lucas Alkmin & de Oliveira Junior, Silvio, 2021. "Optimal design of power hubs for offshore petroleum platforms," Energy, Elsevier, vol. 235(C).
    17. Bailera, Manuel & Pascual, Sara & Lisbona, Pilar & Romeo, Luis M., 2021. "Modelling calcium looping at industrial scale for energy storage in concentrating solar power plants," Energy, Elsevier, vol. 225(C).
    18. Zima, Wiesław & Grądziel, Sławomir & Cebula, Artur & Rerak, Monika & Kozak-Jagieła, Ewa & Pilarczyk, Marcin, 2023. "Mathematical model of a power boiler operation under rapid thermal load changes," Energy, Elsevier, vol. 263(PC).
    19. Deng, Boyu & Zhang, Man & Lyu, Junfu & Li, Shaohua & Yang, Hairui, 2019. "Safety analysis on the water wall in the 350 MW supercritical CFB boiler under sudden electricity failure," Energy, Elsevier, vol. 189(C).
    20. Jan Taler & Paweł Ocłoń & Marcin Trojan & Abdulmajeed Mohamad, 2019. "Selected Papers from the XI International Conference on Computational Heat, Mass and Momentum Transfer (ICCHMT 2018)," Energies, MDPI, vol. 12(12), pages 1-3, June.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:13:y:2020:i:3:p:704-:d:317178. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.