IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v11y2018i6p1342-d148928.html
   My bibliography  Save this article

Experimental Investigation into the Effect of Oil Injection on the Performance of a Variable Speed Twin-Screw Compressor

Author

Listed:
  • Zhilong He

    (School of Energy and Power Engineering, Xi’an Jiaotong University, Xi’an 710049, China)

  • Tao Wang

    (School of Energy and Power Engineering, Xi’an Jiaotong University, Xi’an 710049, China
    School of Energy and Power Engineering, Zhengzhou University of Light Industry, Zhengzhou 450000, China)

  • Xiaolin Wang

    (School of Engineering & ICT, University of Tasmania, Private Bag 65, Hobart TAS 7001, Australia)

  • Xueyuan Peng

    (School of Energy and Power Engineering, Xi’an Jiaotong University, Xi’an 710049, China)

  • Ziwen Xing

    (School of Energy and Power Engineering, Xi’an Jiaotong University, Xi’an 710049, China)

Abstract

In this paper, the effect of oil injection flow rate on the performance of a variable speed twin-screw compressor was investigated experimentally. Comprehensive experiments were conducted at different compressor rotational speeds and oil injection flow rates. As the rotational speed increased from 1000 to 3000 rpm, the compressor volumetric and adiabatic efficiencies increased while the specific power consumption decreased. However, the oil injection flow rate showed different influences on the compressor performance. As the oil injection flow rate increased from 27 to 50 L/min, the adiabatic and volumetric efficiencies increased while the compressor discharge temperature and specific power decreased. Further increases in the oil injection flow rate had little effect on compressor performance at flow rates above 50 L/min. The analysis indicated that the oil injection flow rate was limited by the discharge temperature at low compressor rotational speeds and was a trade-off among two efficiencies and specific power consumption at high rotational speeds.

Suggested Citation

  • Zhilong He & Tao Wang & Xiaolin Wang & Xueyuan Peng & Ziwen Xing, 2018. "Experimental Investigation into the Effect of Oil Injection on the Performance of a Variable Speed Twin-Screw Compressor," Energies, MDPI, vol. 11(6), pages 1-14, May.
    • Handle: RePEc:gam:jeners:v:11:y:2018:i:6:p:1342-:d:148928
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/11/6/1342/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/11/6/1342/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Sun-Seok Byeon & Jae-Young Lee & Youn-Jea Kim, 2017. "Performance Characteristics of a 4 × 6 Oil-Free Twin-Screw Compressor," Energies, MDPI, vol. 10(7), pages 1-16, July.
    2. Guoqiang Li & Yuting Wu & Yeqiang Zhang & Ruiping Zhi & Jingfu Wang & Chongfang Ma, 2016. "Performance Study on a Single-Screw Expander for a Small-Scale Pressure Recovery System," Energies, MDPI, vol. 10(1), pages 1-14, December.
    3. Tian, Yafen & Xing, Ziwen & He, Zhilong & Wu, Huagen, 2017. "Modeling and performance analysis of twin-screw steam expander under fluctuating operating conditions in steam pipeline pressure energy recovery applications," Energy, Elsevier, vol. 141(C), pages 692-701.
    4. Kai Yang & Hongguang Zhang & Songsong Song & Jian Zhang & Yuting Wu & Yeqiang Zhang & Hongjin Wang & Ying Chang & Chen Bei, 2014. "Performance Analysis of the Vehicle Diesel Engine-ORC Combined System Based on a Screw Expander," Energies, MDPI, vol. 7(5), pages 1-20, May.
    5. Liu, Zhijian & Xu, Wei & Zhai, Xue & Qian, Cheng & Chen, Xi, 2017. "Feasibility and performance study of the hybrid ground-source heat pump system for one office building in Chinese heating dominated areas," Renewable Energy, Elsevier, vol. 101(C), pages 1131-1140.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Qing Guo & Kai Luo & Daijin Li & Chuang Huang & Kan Qin, 2021. "Effect of Operating Conditions on the Performance of Gas–Liquid Mixture Roots Pumps," Energies, MDPI, vol. 14(17), pages 1-23, August.
    2. Tao Wang & Qiang Qi & Wei Zhang & Dengyi Zhan, 2023. "Research on Optimization of Profile Parameters in Screw Compressor Based on BP Neural Network and Genetic Algorithm," Energies, MDPI, vol. 16(9), pages 1-17, April.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Xiong, Yaxuan & Zhang, Aitonglu & Peng, Xiaodong & Yao, Chenhua & Wang, Nan & Wu, Yuting & Xu, Qian & Ma, Chongfang, 2023. "Investigation of a sole gas expander for gas pressure regulation and energy recovery," Energy, Elsevier, vol. 281(C).
    2. Zhao, Zhaorui & Zhang, Jingyu & Wang, Gaofeng & Yuan, Hao & Tian, Yafen, 2024. "Research and clearance analysis on of steam twin-screw expander employed in indutrial waste heat recovery," Energy, Elsevier, vol. 312(C).
    3. Zhang, Sheng & Lin, Zhang & Ai, Zhengtao & Huan, Chao & Cheng, Yong & Wang, Fenghao, 2019. "Multi-criteria performance optimization for operation of stratum ventilation under heating mode," Applied Energy, Elsevier, vol. 239(C), pages 969-980.
    4. Tian, Yafen & Xing, Ziwen & He, Zhilong & Wu, Huagen, 2017. "Modeling and performance analysis of twin-screw steam expander under fluctuating operating conditions in steam pipeline pressure energy recovery applications," Energy, Elsevier, vol. 141(C), pages 692-701.
    5. Li, Guoqiang & Lei, Biao & Wu, Yuting & Zhi, Ruiping & Zhao, Yingkun & Guo, Zhiyu & Liu, Guangyu & Ma, Chongfang, 2018. "Influence of inlet pressure and rotational speed on the performance of high pressure single screw expander prototype," Energy, Elsevier, vol. 147(C), pages 279-285.
    6. Cruz-Peragón, F. & Gómez-de la Cruz, F.J. & Palomar-Carnicero, J.M. & López-García, R., 2022. "Optimal design of a hybrid ground source heat pump for an official building with thermal load imbalance and limited space for the ground heat exchanger," Renewable Energy, Elsevier, vol. 195(C), pages 381-394.
    7. Li, Hui & Ni, Long & Liu, Guang & Zhao, Zisang & Yao, Yang, 2019. "Feasibility study on applications of an Earth-air Heat Exchanger (EAHE) for preheating fresh air in severe cold regions," Renewable Energy, Elsevier, vol. 133(C), pages 1268-1284.
    8. Zhang, Yali & Li, Wenqi & Wu, Feng, 2020. "Does energy transition improve air quality? Evidence derived from China’s Winter Clean Heating Pilot (WCHP) project," Energy, Elsevier, vol. 206(C).
    9. Guo, Zhiyu & Zhang, Cancan & Wu, Yuting & Lei, Biao & Yan, Dong & Zhi, Ruiping & Shen, Lili, 2020. "Numerical optimization of intake and exhaust structure and experimental verification on single-screw expander for small-scale ORC applications," Energy, Elsevier, vol. 199(C).
    10. Piero Danieli & Gianluca Carraro & Andrea Lazzaretto, 2020. "Thermodynamic and Economic Feasibility of Energy Recovery from Pressure Reduction Stations in Natural Gas Distribution Networks," Energies, MDPI, vol. 13(17), pages 1-19, August.
    11. Marco Francesconi & Arianna Baldinelli & Luca Sani & Marco Antonelli, 2025. "Experimental Characterization of Reversible Oil-Flooded Twin-Screw Compressor/Dry Expander for a Micro-Scale Compressed Air Energy Storage System," Energies, MDPI, vol. 18(2), pages 1-33, January.
    12. Naili, Nabiha & Kooli, Sami, 2021. "Solar-assisted ground source heat pump system operated in heating mode: A case study in Tunisia," Renewable and Sustainable Energy Reviews, Elsevier, vol. 145(C).
    13. Ming, Bo & Liu, Pan & Guo, Shenglian & Cheng, Lei & Zhou, Yanlai & Gao, Shida & Li, He, 2018. "Robust hydroelectric unit commitment considering integration of large-scale photovoltaic power: A case study in China," Applied Energy, Elsevier, vol. 228(C), pages 1341-1352.
    14. Liu, Zhengguang & Wang, Wene & Chen, Yuntian & Wang, Lili & Guo, Zhiling & Yang, Xiaohu & Yan, Jinyue, 2023. "Solar harvest: Enhancing carbon sequestration and energy efficiency in solar greenhouses with PVT and GSHP systems," Renewable Energy, Elsevier, vol. 211(C), pages 112-125.
    15. Ali Saleh Bairq, Zain & Gao, Hongxia & Huang, Yufei & Zhang, Haiyan & Liang, Zhiwu, 2019. "Enhancing CO2 desorption performance in rich MEA solution by addition of SO42−/ZrO2/SiO2 bifunctional catalyst," Applied Energy, Elsevier, vol. 252(C), pages 1-1.
    16. Ying Zhu & Quanling Tong & Xueting Zeng & Xiaxia Yan & Yongping Li & Guohe Huang, 2019. "Optimal Design of a Distributed Energy System Using the Functional Interval Model That Allows Reduced Carbon Emissions in Guanzhong, a Rural Area of China," Sustainability, MDPI, vol. 11(7), pages 1-22, April.
    17. Wang, Chuang & Xing, Ziwen & Sun, Shizhong & He, Zhilong, 2020. "Loss analysis of oil-free twin-screw expanders for recovering energy in fuel cell systems by means of p-θ diagrams," Energy, Elsevier, vol. 201(C).
    18. Yu, Bendong & Hou, Jingxin & He, Wei & Liu, Shanshan & Hu, Zhongting & Ji, Jie & Chen, Hongbing & Xu, Gang, 2018. "Study on a high-performance photocatalytic-Trombe wall system for space heating and air purification," Applied Energy, Elsevier, vol. 226(C), pages 365-380.
    19. Chintala, Venkateswarlu & Kumar, Suresh & Pandey, Jitendra K., 2018. "A technical review on waste heat recovery from compression ignition engines using organic Rankine cycle," Renewable and Sustainable Energy Reviews, Elsevier, vol. 81(P1), pages 493-509.
    20. Markus Preißinger & Dieter Brüggemann, 2016. "Thermal Stability of Hexamethyldisiloxane (MM) for High-Temperature Organic Rankine Cycle (ORC)," Energies, MDPI, vol. 9(3), pages 1-11, March.

    More about this item

    Keywords

    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:11:y:2018:i:6:p:1342-:d:148928. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.