IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v13y2020i1p201-d469595.html
   My bibliography  Save this article

Thermal Performance of Single-Story Air-Welled Terraced House in Malaysia: A Field Measurement Approach

Author

Listed:
  • Pau Chung Leng

    (Faculty of Built Environment & Surveying, Universiti Teknologi Malaysia, Johor 81300, Malaysia)

  • Gabriel Hoh Teck Ling

    (Faculty of Built Environment & Surveying, Universiti Teknologi Malaysia, Johor 81300, Malaysia)

  • Mohd Hamdan Ahmad

    (Faculty of Built Environment & Surveying, Universiti Teknologi Malaysia, Johor 81300, Malaysia)

  • Dilshan Remaz Ossen

    (Department of Architecture Engineering, Kingdom University, Riffa 40434, Bahrain)

  • Eeydzah Aminudin

    (School of Civil Engineering, Faculty of Engineering, University Teknologi Malaysia, Johor 81300, Malaysia)

  • Weng Howe Chan

    (School of Computing, Faculty of Engineering, Universiti Teknologi Malaysia, Johor 81300, Malaysia)

  • Dg Normaswanna Tawasil

    (School of Civil Engineering, Faculty of Engineering, University Teknologi Malaysia, Johor 81300, Malaysia)

Abstract

The provision requirement of 10% openings of the total floor area stated in the Uniform Building By-Law 1984 Malaysia is essential for natural lighting and ventilation purposes. However, focusing on natural ventilation, the effectiveness of thermal performance in landed residential buildings has never been empirically measured and proven, as most of the research emphasized simulation modeling lacking sufficient empirical validation. Therefore, this paper drawing on field measurement investigates natural ventilation performance in terraced housing with an air-well system. The key concern as to what extent the current air-well system serving as a ventilator is effective to provide better thermal performance is to be addressed. By adopting an existing single-story air-welled terrace house, indoor environmental conditions and thermal performance were monitored and measured using HOBO U12 air temperature and humidity, the HOBO U12 anemometer, and the Delta Ohm HD32.3 Wet Bulb Globe Temperature meter for a six-month duration. The results show that the air temperature of the air well ranged from 27.48 °C to 30.92 °C, with a mean relative humidity of 72.67% to 79.25%. The mean air temperature for a test room (single-sided ventilation room) ranged from 28.04 °C to 30.92 °C, with a relative humidity of 70.16% to 76.00%. These empirical findings are of importance, offering novel policy insights and suggestions. Since the minimum provision of 10% openings has been revealed to be less effective to provide desirable thermal performance and comfort, mandatory compliance with and the necessity of the bylaw requirement should be revisited.

Suggested Citation

  • Pau Chung Leng & Gabriel Hoh Teck Ling & Mohd Hamdan Ahmad & Dilshan Remaz Ossen & Eeydzah Aminudin & Weng Howe Chan & Dg Normaswanna Tawasil, 2020. "Thermal Performance of Single-Story Air-Welled Terraced House in Malaysia: A Field Measurement Approach," Sustainability, MDPI, vol. 13(1), pages 1-23, December.
    • Handle: RePEc:gam:jsusta:v:13:y:2020:i:1:p:201-:d:469595
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/13/1/201/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/13/1/201/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Punyasompun, Sompop & Hirunlabh, Jongjit & Khedari, Joseph & Zeghmati, Belkacem, 2009. "Investigation on the application of solar chimney for multi-storey buildings," Renewable Energy, Elsevier, vol. 34(12), pages 2545-2561.
    2. Mahlia, T. M. I. & Masjuki, H. H. & Saidur, R. & Amalina, M. A., 2004. "Cost-benefit analysis of implementing minimum energy efficiency standards for household refrigerator-freezers in Malaysia," Energy Policy, Elsevier, vol. 32(16), pages 1819-1824, November.
    3. Pau Chung Leng & Mohd Hamdan Ahmad & Dilshan Remaz Ossen & Gabriel H.T. Ling & Samsiah Abdullah & Eeydzah Aminudin & Wai Loan Liew & Weng Howe Chan, 2019. "The Impact of Air Well Geometry in a Malaysian Single Storey Terraced House," Sustainability, MDPI, vol. 11(20), pages 1-35, October.
    4. Zhang, Lili & Hou, Yuyao & Liu, Zu’an & Du, Junfei & Xu, Long & Zhang, Guomin & Shi, Long, 2020. "Trombe wall for a residential building in Sichuan-Tibet alpine valley – A case study," Renewable Energy, Elsevier, vol. 156(C), pages 31-46.
    5. Khosravi, Mohsen & Fazelpour, Farivar & Rosen, Marc A., 2019. "Improved application of a solar chimney concept in a two-story building: An enhanced geometry through a numerical approach," Renewable Energy, Elsevier, vol. 143(C), pages 569-585.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Dariusz Bajno & Łukasz Bednarz & Agnieszka Grzybowska, 2021. "The Role and Place of Traditional Chimney System Solutions in Environmental Progress and in Reducing Energy Consumption," Energies, MDPI, vol. 14(16), pages 1-32, August.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Zhang, Haihua & Yang, Dong & Tam, Vivian W.Y. & Tao, Yao & Zhang, Guomin & Setunge, Sujeeva & Shi, Long, 2021. "A critical review of combined natural ventilation techniques in sustainable buildings," Renewable and Sustainable Energy Reviews, Elsevier, vol. 141(C).
    2. Xie, Xing & Xu, Bin & Cheng, Yuan-xia & Pei, Gang, 2023. "New method of integrating experiment for maintaining low indoor temperature into numerical modelling: A feasibility demonstration in reduced-scale building model," Energy, Elsevier, vol. 284(C).
    3. Azmi, W.H. & Sharif, M.Z. & Yusof, T.M. & Mamat, Rizalman & Redhwan, A.A.M., 2017. "Potential of nanorefrigerant and nanolubricant on energy saving in refrigeration system – A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 69(C), pages 415-428.
    4. Thirugnanasambandam, M. & Hasanuzzaman, M. & Saidur, R. & Ali, M.B. & Rajakarunakaran, S. & Devaraj, D. & Rahim, N.A., 2011. "Analysis of electrical motors load factors and energy savings in an Indian cement industry," Energy, Elsevier, vol. 36(7), pages 4307-4314.
    5. Jiawen Hou & Tao Zhang & Zu’an Liu & Lili Zhang & Hiroatsu Fukuda, 2022. "Application evaluation of passive energy-saving strategies in exterior envelopes for rural traditional dwellings in northeast of Sichuan hills, China [A review on research and development of passiv," International Journal of Low-Carbon Technologies, Oxford University Press, vol. 17, pages 342-355.
    6. Hasanuzzaman, M. & Saidur, R. & Masjuki, H.H., 2009. "Effects of operating variables on heat transfer and energy consumption of a household refrigerator-freezer during closed door operation," Energy, Elsevier, vol. 34(2), pages 196-198.
    7. Askari, Minoo & Jahangir, Mohammad Hossein, 2023. "Evaluation of thermal performance and energy efficiency of a Trombe wall improved with dual phase change materials," Energy, Elsevier, vol. 284(C).
    8. Shekarchian, M. & Moghavvemi, M. & Motasemi, F. & Mahlia, T.M.I., 2011. "Energy savings and cost-benefit analysis of using compression and absorption chillers for air conditioners in Iran," Renewable and Sustainable Energy Reviews, Elsevier, vol. 15(4), pages 1950-1960, May.
    9. Bevilacqua, Piero & Benevento, Federica & Bruno, Roberto & Arcuri, Natale, 2019. "Are Trombe walls suitable passive systems for the reduction of the yearly building energy requirements?," Energy, Elsevier, vol. 185(C), pages 554-566.
    10. Lean, Hooi Hooi & Smyth, Russell, 2010. "Multivariate Granger causality between electricity generation, exports, prices and GDP in Malaysia," Energy, Elsevier, vol. 35(9), pages 3640-3648.
    11. Al-Mofleh, Anwar & Taib, Soib & Mujeebu, M. Abdul & Salah, Wael, 2009. "Analysis of sectoral energy conservation in Malaysia," Energy, Elsevier, vol. 34(6), pages 733-739.
    12. Zhang, Haihua & Tao, Yao & Zhang, Guomin & Li, Jie & Setunge, Sujeeva & Shi, Long, 2022. "Impacts of storey number of buildings on solar chimney performance: A theoretical and numerical approach," Energy, Elsevier, vol. 261(PA).
    13. Sengupta, Ayan & Mishra, Dipti Prasad & Sarangi, Shailesh Kumar, 2022. "Computational performance analysis of a solar chimney using surface modifications of the absorber plate," Renewable Energy, Elsevier, vol. 185(C), pages 1095-1109.
    14. Pau Chung Leng & Mohd Hamdan Ahmad & Dilshan Remaz Ossen & Gabriel H.T. Ling & Samsiah Abdullah & Eeydzah Aminudin & Wai Loan Liew & Weng Howe Chan, 2019. "The Impact of Air Well Geometry in a Malaysian Single Storey Terraced House," Sustainability, MDPI, vol. 11(20), pages 1-35, October.
    15. Xiaowei Ma & Mei Wang & Chuandong Li, 2019. "A Summary on Research of Household Energy Consumption: A Bibliometric Analysis," Sustainability, MDPI, vol. 12(1), pages 1-17, December.
    16. Quesada, Guillermo & Rousse, Daniel & Dutil, Yvan & Badache, Messaoud & Hallé, Stéphane, 2012. "A comprehensive review of solar facades. Opaque solar facades," Renewable and Sustainable Energy Reviews, Elsevier, vol. 16(5), pages 2820-2832.
    17. Saidur, R. & Mahlia, T.M.I., 2010. "Energy, economic and environmental benefits of using high-efficiency motors to replace standard motors for the Malaysian industries," Energy Policy, Elsevier, vol. 38(8), pages 4617-4625, August.
    18. Ren, Xiu-Hong & Wang, Lei & Liu, Run-Zhe & Wang, Lin & Zhao, Fu-Yun, 2021. "Thermal stack airflows inside the solar chimney with discrete heat sources: Reversal flow regime defined by chimney inclination and thermal Rayleigh number," Renewable Energy, Elsevier, vol. 163(C), pages 342-356.
    19. Vargas-López, R. & Xamán, J. & Hernández-Pérez, I. & Arce, J. & Zavala-Guillén, I. & Jiménez, M.J. & Heras, M.R., 2019. "Mathematical models of solar chimneys with a phase change material for ventilation of buildings: A review using global energy balance," Energy, Elsevier, vol. 170(C), pages 683-708.
    20. Ihwan Ghazali & Salwa Hanim Abdul-Rashid & Siti Zawiah Md Dawal & Nurul Huda & Amir Husni Mohd Shariff & Safarudin Gazali Herawan & Fu Haw Ho & Novita Sakundarini, 2021. "Guidelines for Designing Green Products Considering Customers’ Cultural Preferences," Sustainability, MDPI, vol. 13(2), pages 1-27, January.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:13:y:2020:i:1:p:201-:d:469595. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.