IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v14y2021i10p2776-d553039.html
   My bibliography  Save this article

Improvements in Energy Saving and Thermal Environment after Retrofitting with Interior Insulation in Intermittently Cooled Residences in Hot-Summer/Cold-Winter Zone of China: A Case Study in Chengdu

Author

Listed:
  • Xin Ye

    (School of Architecture and Civil Engineering, Chengdu University, Chengdu 610106, China
    Department of Architecture, The University of Kitakyushu, Kitakyushu 808-0135, Japan)

  • Jun Lu

    (School of Architecture and Civil Engineering, Chengdu University, Chengdu 610106, China)

  • Tao Zhang

    (Innovation Institute for Sustainable Maritime Architecture Research and Technology, Qingdao University of Technology, Qingdao 266033, China)

  • Yupeng Wang

    (School of Human Settlements and Civil Engineering, Xi’an Jiaotong University, Xi’an 710000, China)

  • Hiroatsu Fukuda

    (Department of Architecture, The University of Kitakyushu, Kitakyushu 808-0135, Japan)

Abstract

Space cooling is currently the fastest-growing end-user in buildings. The global warming trend combined with increased population and economic development will lead to accelerated growth in space cooling in the future, especially in China. The hot summer and cold winter (HSCW) zone is the most densely populated and economically developed region in China, but with the worst indoor thermal environment. Relatively few studies have been conducted on the actual measurements in the optimization of insulation design under typical intermittent cooling modes in this region. This case study was conducted in Chengdu—the two residences selected were identical in design, but the south bedroom of the case study residence had interior insulation (inside insulation on all opaque interior surfaces of a space) retrofitted in the bedroom area in 2017. In August 2019, a comparative on-site measurement was done to investigate the effect of the retrofit work under three typical intermittent cooling patterns in the real-life scenario. The experimental result shows that interior insulation provides a significant improvement in energy-saving and the indoor thermal environment. The average energy savings in daily cooling energy consumption of the south bedroom is 42.09%, with the maximum reaching 48.91%. In the bedroom with interior insulation retrofit, the indoor temperature is closer to the set temperature and the vertical temperature difference is smaller during the cooling period; when the air conditioner is off, the room remains a comfortable temperature for a slightly longer time.

Suggested Citation

  • Xin Ye & Jun Lu & Tao Zhang & Yupeng Wang & Hiroatsu Fukuda, 2021. "Improvements in Energy Saving and Thermal Environment after Retrofitting with Interior Insulation in Intermittently Cooled Residences in Hot-Summer/Cold-Winter Zone of China: A Case Study in Chengdu," Energies, MDPI, vol. 14(10), pages 1-20, May.
    • Handle: RePEc:gam:jeners:v:14:y:2021:i:10:p:2776-:d:553039
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/14/10/2776/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/14/10/2776/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Jihui Yuan, 2018. "Impact of Insulation Type and Thickness on the Dynamic Thermal Characteristics of an External Wall Structure," Sustainability, MDPI, vol. 10(8), pages 1-14, August.
    2. Shekarchian, M. & Moghavvemi, M. & Rismanchi, B. & Mahlia, T.M.I. & Olofsson, T., 2012. "The cost benefit analysis and potential emission reduction evaluation of applying wall insulation for buildings in Malaysia," Renewable and Sustainable Energy Reviews, Elsevier, vol. 16(7), pages 4708-4718.
    3. Xu, Luyi & Liu, Junjie & Pei, Jingjing & Han, Xu, 2013. "Building energy saving potential in Hot Summer and Cold Winter (HSCW) Zone, China—Influence of building energy efficiency standards and implications," Energy Policy, Elsevier, vol. 57(C), pages 253-262.
    4. Yu, Jinghua & Yang, Changzhi & Tian, Liwei & Liao, Dan, 2009. "Evaluation on energy and thermal performance for residential envelopes in hot summer and cold winter zone of China," Applied Energy, Elsevier, vol. 86(10), pages 1970-1985, October.
    5. Mirco Andreotti & Dario Bottino-Leone & Marta Calzolari & Pietromaria Davoli & Luisa Dias Pereira & Elena Lucchi & Alexandra Troi, 2020. "Applied Research of the Hygrothermal Behaviour of an Internally Insulated Historic Wall without Vapour Barrier: In Situ Measurements and Dynamic Simulations," Energies, MDPI, vol. 13(13), pages 1-22, July.
    6. Huang, Kuo-Tsang & Hwang, Ruey-Lung, 2016. "Future trends of residential building cooling energy and passive adaptation measures to counteract climate change: The case of Taiwan," Applied Energy, Elsevier, vol. 184(C), pages 1230-1240.
    7. Yupeng Wang & Hiroatsu Fukuda, 2019. "The Influence of Insulation Styles on the Building Energy Consumption and Indoor Thermal Comfort of Multi-Family Residences," Sustainability, MDPI, vol. 11(1), pages 1-14, January.
    8. N. Arnell & S. Brown & S. Gosling & P. Gottschalk & J. Hinkel & C. Huntingford & B. Lloyd-Hughes & J. Lowe & R. Nicholls & T. Osborn & T. Osborne & G. Rose & P. Smith & T. Wheeler & P. Zelazowski, 2016. "The impacts of climate change across the globe: A multi-sectoral assessment," Climatic Change, Springer, vol. 134(3), pages 457-474, February.
    9. Enescu, Diana, 2017. "A review of thermal comfort models and indicators for indoor environments," Renewable and Sustainable Energy Reviews, Elsevier, vol. 79(C), pages 1353-1379.
    10. Yu, Jinghua & Yang, Changzhi & Tian, Liwei & Liao, Dan, 2009. "A study on optimum insulation thicknesses of external walls in hot summer and cold winter zone of China," Applied Energy, Elsevier, vol. 86(11), pages 2520-2529, November.
    11. Florides, G. A. & Tassou, S. A. & Kalogirou, S. A. & Wrobel, L. C., 2002. "Measures used to lower building energy consumption and their cost effectiveness," Applied Energy, Elsevier, vol. 73(3-4), pages 299-328, November.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. De Boeck, L. & Verbeke, S. & Audenaert, A. & De Mesmaeker, L., 2015. "Improving the energy performance of residential buildings: A literature review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 52(C), pages 960-975.
    2. Freire, Roberto Zanetti & Mazuroski, Walter & Abadie, Marc Olivier & Mendes, Nathan, 2011. "Capacitive effect on the heat transfer through building glazing systems," Applied Energy, Elsevier, vol. 88(12), pages 4310-4319.
    3. Xiaojun Liu & Xin Chen & Mehdi Shahrestani, 2020. "Optimization of Insulation Thickness of External Walls of Residential Buildings in Hot Summer and Cold Winter Zone of China," Sustainability, MDPI, vol. 12(4), pages 1-21, February.
    4. Hu, Shan & Yan, Da & Cui, Ying & Guo, Siyue, 2016. "Urban residential heating in hot summer and cold winter zones of China—Status, modeling, and scenarios to 2030," Energy Policy, Elsevier, vol. 92(C), pages 158-170.
    5. Bai, Lujian & Wang, Shusheng, 2019. "Definition of new thermal climate zones for building energy efficiency response to the climate change during the past decades in China," Energy, Elsevier, vol. 170(C), pages 709-719.
    6. Liting Yuan & Zhiyi Wang & Yanyan Huang & Xiaolong Wang, 2020. "Comparative Analysis on Load Characteristic of Intermittently Conditioned Buildings for Different Wall Insulation Forms," Energies, MDPI, vol. 13(18), pages 1-15, September.
    7. Yao, Jian, 2012. "Energy optimization of building design for different housing units in apartment buildings," Applied Energy, Elsevier, vol. 94(C), pages 330-337.
    8. Wan, Kevin K.W. & Li, Danny H.W. & Pan, Wenyan & Lam, Joseph C., 2012. "Impact of climate change on building energy use in different climate zones and mitigation and adaptation implications," Applied Energy, Elsevier, vol. 97(C), pages 274-282.
    9. Axaopoulos, Ioannis & Axaopoulos, Petros & Panayiotou, Gregoris & Kalogirou, Soteris & Gelegenis, John, 2015. "Optimal economic thickness of various insulation materials for different orientations of external walls considering the wind characteristics," Energy, Elsevier, vol. 90(P1), pages 939-952.
    10. Jung Ho Kim & Young Il Kim, 2021. "Optimal Combination of External Wall Insulation Thickness and Surface Solar Reflectivity of Non-Residential Buildings in the Korean Peninsula," Sustainability, MDPI, vol. 13(6), pages 1-24, March.
    11. Li, Danny H.W. & Yang, Liu & Lam, Joseph C., 2013. "Zero energy buildings and sustainable development implications – A review," Energy, Elsevier, vol. 54(C), pages 1-10.
    12. Yu, Jia & Kang, Yanming & Li, He & Zhong, Ke & Zhai, Zhiqiang (John), 2020. "Influence of ventilation-behavior during off-periods on energy-consumption for an intermittently heated room of dormitory buildings," Energy, Elsevier, vol. 197(C).
    13. Samuel Asumadu Sarkodie & Maruf Yakubu Ahmed & Phebe Asantewaa Owusu, 2022. "Global adaptation readiness and income mitigate sectoral climate change vulnerabilities," Palgrave Communications, Palgrave Macmillan, vol. 9(1), pages 1-17, December.
    14. Villa-Arrieta, Manuel & Sumper, Andreas, 2018. "A model for an economic evaluation of energy systems using TRNSYS," Applied Energy, Elsevier, vol. 215(C), pages 765-777.
    15. Ismail, M.S. & Moghavvemi, M. & Mahlia, T.M.I., 2013. "Energy trends in Palestinian territories of West Bank and Gaza Strip: Possibilities for reducing the reliance on external energy sources," Renewable and Sustainable Energy Reviews, Elsevier, vol. 28(C), pages 117-129.
    16. Bell, N.O. & Bilbao, J.I. & Kay, M. & Sproul, A.B., 2022. "Future climate scenarios and their impact on heating, ventilation and air-conditioning system design and performance for commercial buildings for 2050," Renewable and Sustainable Energy Reviews, Elsevier, vol. 162(C).
    17. Ma, Jun & Cheng, Jack C.P., 2016. "Identifying the influential features on the regional energy use intensity of residential buildings based on Random Forests," Applied Energy, Elsevier, vol. 183(C), pages 193-201.
    18. Jian Yao, 2014. "A Multi-Objective (Energy, Economic and Environmental Performance) Life Cycle Analysis for Better Building Design," Sustainability, MDPI, vol. 6(2), pages 1-13, January.
    19. Ascione, Fabrizio & De Masi, Rosa Francesca & de Rossi, Filippo & Ruggiero, Silvia & Vanoli, Giuseppe Peter, 2016. "Optimization of building envelope design for nZEBs in Mediterranean climate: Performance analysis of residential case study," Applied Energy, Elsevier, vol. 183(C), pages 938-957.
    20. Leccese, Francesco & Salvadori, Giacomo & Asdrubali, Francesco & Gori, Paola, 2018. "Passive thermal behaviour of buildings: Performance of external multi-layered walls and influence of internal walls," Applied Energy, Elsevier, vol. 225(C), pages 1078-1089.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:14:y:2021:i:10:p:2776-:d:553039. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.