IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v57y2013icp641-652.html

Some searches may not work properly. We apologize for the inconvenience.

   My bibliography  Save this article

Diesel engine combustion modeling for hardware in the loop applications: Effects of ignition delay time model

Author

Listed:
  • Maroteaux, Fadila
  • Saad, Charbel

Abstract

This paper deals with the development of a phenomenological combustion single zone model of Diesel engine. The aim of this work is to build a model suitable for HiL (Hardware in the Loop), and thus to be able to run in Real-Time applications. The combustion sub-model estimates the heat release rate by the sum of two algebraic expressions related to premixed and diffusive burning process. The Wiebe correlation has been used to model each algebraic expression of the combustion sub-model. The ignition delay time required by the combustion sub-model has been modeled through an Arrhenius correlation and an algebraic simple correlation. An extensive identification analysis has been performed to express their dependence with respect to engine operating conditions. The global model has been built with the constraints of computational CPU load that characterize the real time simulations. The accuracy of the model in predicting the in cylinder pressure has been tested over a large set of measurements at different engine operating conditions. The comparison of in-cylinder pressure profiles with experimental traces has shown that the Arrhenius expression is less accurate than the simple correlation. However, these two approaches may be used in real time modeling.

Suggested Citation

  • Maroteaux, Fadila & Saad, Charbel, 2013. "Diesel engine combustion modeling for hardware in the loop applications: Effects of ignition delay time model," Energy, Elsevier, vol. 57(C), pages 641-652.
    • Handle: RePEc:eee:energy:v:57:y:2013:i:c:p:641-652
    DOI: 10.1016/j.energy.2013.03.098
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544213004350
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2013.03.098?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Shehata, M.S., 2010. "Cylinder pressure, performance parameters, heat release, specific heats ratio and duration of combustion for spark ignition engine," Energy, Elsevier, vol. 35(12), pages 4710-4725.
    2. Park, Su Han & Cha, Junepyo & Kim, Hyung Jun & Lee, Chang Sik, 2012. "Effect of early injection strategy on spray atomization and emission reduction characteristics in bioethanol blended diesel fueled engine," Energy, Elsevier, vol. 39(1), pages 375-387.
    3. Choi, Seungmok & Park, Wonah & Lee, Sangyul & Min, Kyoungdoug & Choi, Hoimyung, 2011. "Methods for in-cylinder EGR stratification and its effects on combustion and emission characteristics in a diesel engine," Energy, Elsevier, vol. 36(12), pages 6948-6959.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Loganathan, S. & Leenus Jesu Martin, M. & Nagalingam, B. & Prabhu, L., 2018. "Heat release rate and performance simulation of DME fuelled diesel engine using oxygenate correction factor and load correction factor in double Wiebe function," Energy, Elsevier, vol. 150(C), pages 77-91.
    2. Hu, Deng & Wang, Hechun & Wang, Binbin & Shi, Mingwei & Duan, Baoyin & Wang, Yinyan & Yang, Chuanlei, 2022. "Calibration of 0-D combustion model applied to dual-fuel engine," Energy, Elsevier, vol. 261(PB).
    3. Maroteaux, Fadila & Saad, Charbel, 2015. "Combined mean value engine model and crank angle resolved in-cylinder modeling with NOx emissions model for real-time Diesel engine simulations at high engine speed," Energy, Elsevier, vol. 88(C), pages 515-527.
    4. Giglio, Veniero & di Gaeta, Alessandro, 2020. "Novel regression models for wiebe parameters aimed at 0D combustion simulation in spark ignition engines," Energy, Elsevier, vol. 210(C).
    5. Yuanfeng Wang, 2020. "A Novel Two-Zone Thermodynamic Model for Spark-Ignition Engines Based on an Idealized Thermodynamic Process," Energies, MDPI, vol. 13(15), pages 1-27, July.
    6. Vélez Godiño, José Antonio & Torres García, Miguel & Jiménez-Espadafor Aguilar, Francisco José, 2022. "Experimental analysis of late direct injection combustion mode in a compression-ignition engine fuelled with biodiesel/diesel blends," Energy, Elsevier, vol. 239(PA).
    7. Yongming Feng & Haiyan Wang & Ruifeng Gao & Yuanqing Zhu, 2019. "A Zero-Dimensional Mixing Controlled Combustion Model for Real Time Performance Simulation of Marine Two-Stroke Diesel Engines," Energies, MDPI, vol. 12(10), pages 1-19, May.
    8. Sakellaridis, Nikolaos F. & Raptotasios, Spyridon I. & Antonopoulos, Antonis K. & Mavropoulos, Georgios C. & Hountalas, Dimitrios T., 2015. "Development and validation of a new turbocharger simulation methodology for marine two stroke diesel engine modelling and diagnostic applications," Energy, Elsevier, vol. 91(C), pages 952-966.
    9. Doppalapudi, A.T. & Azad, A.K. & Khan, M.M.K., 2023. "Advanced strategies to reduce harmful nitrogen-oxide emissions from biodiesel fueled engine," Renewable and Sustainable Energy Reviews, Elsevier, vol. 174(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Myung, Cha-Lee & Choi, Kwanhee & Kim, Juwon & Lim, Yunsung & Lee, Jongtae & Park, Simsoo, 2012. "Comparative study of regulated and unregulated toxic emissions characteristics from a spark ignition direct injection light-duty vehicle fueled with gasoline and liquid phase LPG (liquefied petroleum ," Energy, Elsevier, vol. 44(1), pages 189-196.
    2. Antonio Lecuona & José I. Nogueira & Antonio Famiglietti, 2021. "Open Dual Cycle with Composition Change and Limited Pressure for Prediction of Miller Engines Performance and Its Turbine Temperature," Energies, MDPI, vol. 14(10), pages 1-25, May.
    3. Bodisco, Timothy & Brown, Richard J., 2013. "Inter-cycle variability of in-cylinder pressure parameters in an ethanol fumigated common rail diesel engine," Energy, Elsevier, vol. 52(C), pages 55-65.
    4. Renzi, Massimiliano & Bietresato, Marco & Mazzetto, Fabrizio, 2016. "An experimental evaluation of the performance of a SI internal combustion engine for agricultural purposes fuelled with different bioethanol blends," Energy, Elsevier, vol. 115(P1), pages 1069-1080.
    5. Zhang, Wei & Chen, Zhaohui & Shen, Yinggang & Shu, Gequn & Chen, Guisheng & Xu, Biao & Zhao, Wei, 2013. "Influence of water emulsified diesel & oxygen-enriched air on diesel engine NO-smoke emissions and combustion characteristics," Energy, Elsevier, vol. 55(C), pages 369-377.
    6. Jia, Ming & Li, Yaopeng & Xie, Maozhao & Wang, Tianyou, 2013. "Numerical evaluation of the potential of late intake valve closing strategy for diesel PCCI (premixed charge compression ignition) engine in a wide speed and load range," Energy, Elsevier, vol. 51(C), pages 203-215.
    7. Yu, Wenbin & Yang, Wenming & Mohan, Balaji & Tay, Kun Lin & Zhao, Feiyang, 2017. "Macroscopic spray characteristics of wide distillation fuel (WDF)," Applied Energy, Elsevier, vol. 185(P2), pages 1372-1382.
    8. Zhaojie Shen & Wenzheng Cui & Xiaodong Ju & Zhongchang Liu & Shaohua Wu & Jianguo Yang, 2018. "Numerical Investigation on Effects of Assigned EGR Stratification on a Heavy Duty Diesel Engine with Two-Stage Fuel Injection," Energies, MDPI, vol. 11(3), pages 1-14, February.
    9. EL-Seesy, Ahmed I. & Hassan, Hamdy, 2019. "Investigation of the effect of adding graphene oxide, graphene nanoplatelet, and multiwalled carbon nanotube additives with n-butanol-Jatropha methyl ester on a diesel engine performance," Renewable Energy, Elsevier, vol. 132(C), pages 558-574.
    10. Abdelaal, Mohsen M. & Rabee, Basem A. & Hegab, Abdelrahman H., 2013. "Effect of adding oxygen to the intake air on a dual-fuel engine performance, emissions, and knock tendency," Energy, Elsevier, vol. 61(C), pages 612-620.
    11. Djouadi, Amel & Bentahar, Fatiha, 2016. "Combustion study of a spark-ignition engine from pressure cycles," Energy, Elsevier, vol. 101(C), pages 211-217.
    12. El-Seesy, Ahmed I. & Hassan, Hamdy & Ookawara, S., 2018. "Effects of graphene nanoplatelet addition to jatropha Biodiesel–Diesel mixture on the performance and emission characteristics of a diesel engine," Energy, Elsevier, vol. 147(C), pages 1129-1152.
    13. Wei, Liangjie & Cheung, C.S. & Huang, Zuohua, 2014. "Effect of n-pentanol addition on the combustion, performance and emission characteristics of a direct-injection diesel engine," Energy, Elsevier, vol. 70(C), pages 172-180.
    14. Paul, Abhishek & Bose, Probir Kumar & Panua, Raj Sekhar & Banerjee, Rahul, 2013. "An experimental investigation of performance-emission trade off of a CI engine fueled by diesel–compressed natural gas (CNG) combination and diesel–ethanol blends with CNG enrichment," Energy, Elsevier, vol. 55(C), pages 787-802.
    15. Wei, Jiangjun & He, Chengjun & Lv, Gang & Zhuang, Yuan & Qian, Yejian & Pan, Suozhu, 2021. "The combustion, performance and emissions investigation of a dual-fuel diesel engine using silicon dioxide nanoparticle additives to methanol," Energy, Elsevier, vol. 230(C).
    16. Shameer, P. Mohamed & Ramesh, K., 2018. "Assessment on the consequences of injection timing and injection pressure on combustion characteristics of sustainable biodiesel fuelled engine," Renewable and Sustainable Energy Reviews, Elsevier, vol. 81(P1), pages 45-61.
    17. E, Jiaqiang & Pham, Minhhieu & Zhao, D. & Deng, Yuanwang & Le, DucHieu & Zuo, Wei & Zhu, Hao & Liu, Teng & Peng, Qingguo & Zhang, Zhiqing, 2017. "Effect of different technologies on combustion and emissions of the diesel engine fueled with biodiesel: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 80(C), pages 620-647.
    18. Majumder, Udayan & Chakraborti, Prasun & Banerjee, Rahul & Debbarma, Bishop, 2016. "Experimental study on the role of ethanol on performance emission trade-off and tribological characteristics of a CI engine," Renewable Energy, Elsevier, vol. 86(C), pages 972-984.
    19. Venu, Harish & Raju, V. Dhana & Subramani, Lingesan, 2019. "Combined effect of influence of nano additives, combustion chamber geometry and injection timing in a DI diesel engine fuelled with ternary (diesel-biodiesel-ethanol) blends," Energy, Elsevier, vol. 174(C), pages 386-406.
    20. Mohamed Shameer, P. & Ramesh, K. & Sakthivel, R. & Purnachandran, R., 2017. "Effects of fuel injection parameters on emission characteristics of diesel engines operating on various biodiesel: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 67(C), pages 1267-1281.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:57:y:2013:i:c:p:641-652. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.