IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v15y2023i12p9696-d1173069.html
   My bibliography  Save this article

Research on Combustion and Emission Characteristics of a N-Butanol Combined Injection SI Engine

Author

Listed:
  • Weiwei Shang

    (College of Automotive Engineering, Jilin University, Changchun 130022, China
    Electronic Information Engineering College, Changchun University, Changchun 130012, China)

  • Xiumin Yu

    (College of Automotive Engineering, Jilin University, Changchun 130022, China)

  • Kehao Miao

    (College of Automotive Engineering, Jilin University, Changchun 130022, China)

  • Zezhou Guo

    (College of Automotive Engineering, Jilin University, Changchun 130022, China)

  • Huiying Liu

    (Electronic Information Engineering College, Changchun University, Changchun 130012, China)

  • Xiaoxue Xing

    (Electronic Information Engineering College, Changchun University, Changchun 130012, China)

Abstract

Using n-butanol as an alternative fuel can effectively alleviate the increasingly prominent problems of fossil resource depletion and environmental pollution. Combined injection technology can effectively improve engine combustion and emission characteristics while applying combined injection technology to n-butanol engines has not been studied yet. Therefore, this study adopted butanol port injection plus butanol direct injection mode. The engine test bench studied the combustion and emission performance under different direct injection ratios (NDIr) and excess air ratios (λ). Results show that with increasing NDIr, the engine torque (Ttq), peak in-cylinder pressure (Pmax), peak in-cylinder temperature (Tmax), and the maximum rate of heat release (dQmax), all rise first and then drop, reaching the maximum value at NDIr = 20%. The θ0-90 and COV IMEP decrease first and then increase as NDIr increases. NDIr = 20% is considered the best injection ratio to obtain the optimal combustion performance. NDIr has little affected on CO emission, and the NDIr corresponding to the lowest HC emissions are concentrated at 40% to 60%, especially at lean burn conditions. NOx emissions increase with increasing NDIr, especially at N20DI, but not by much at NDIr of 40–80%. With the increase in NDIr, the number of nucleation mode particles, accumulation mode particles, and total particle decrease first and then increase. Therefore, the n-butanol combined injection mode with the appropriate NDIr can effectively optimize SI engines’ combustion and emission performance.

Suggested Citation

  • Weiwei Shang & Xiumin Yu & Kehao Miao & Zezhou Guo & Huiying Liu & Xiaoxue Xing, 2023. "Research on Combustion and Emission Characteristics of a N-Butanol Combined Injection SI Engine," Sustainability, MDPI, vol. 15(12), pages 1-19, June.
    • Handle: RePEc:gam:jsusta:v:15:y:2023:i:12:p:9696-:d:1173069
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/15/12/9696/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/15/12/9696/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Sattar Jabbar Murad Algayyim & Andrew P. Wandel, 2020. "Comparative Assessment of Spray Behavior, Combustion and Engine Performance of ABE-Biodiesel/Diesel as Fuel in DI Diesel Engine," Energies, MDPI, vol. 13(24), pages 1-12, December.
    2. Awad, Omar I. & Mamat, R. & Ali, Obed M. & Sidik, N.A.C. & Yusaf, T. & Kadirgama, K. & Kettner, Maurice, 2018. "Alcohol and ether as alternative fuels in spark ignition engine: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 82(P3), pages 2586-2605.
    3. Roussos G. Papagiannakis & Dimitrios C. Rakopoulos & Constantine D. Rakopoulos, 2017. "Theoretical Study of the Effects of Spark Timing on the Performance and Emissions of a Light-Duty Spark Ignited Engine Running under Either Gasoline or Ethanol or Butanol Fuel Operating Modes," Energies, MDPI, vol. 10(8), pages 1-21, August.
    4. Tian, Zhi & Zhen, Xudong & Wang, Yang & Liu, Daming & Li, Xiaoyan, 2020. "Combustion and emission characteristics of n-butanol-gasoline blends in SI direct injection gasoline engine," Renewable Energy, Elsevier, vol. 146(C), pages 267-279.
    5. Haifeng Liu & Xichang Wang & Diping Zhang & Fang Dong & Xinlu Liu & Yong Yang & Haozhong Huang & Yang Wang & Qianlong Wang & Zunqing Zheng, 2019. "Investigation on Blending Effects of Gasoline Fuel with N-Butanol, DMF, and Ethanol on the Fuel Consumption and Harmful Emissions in a GDI Vehicle," Energies, MDPI, vol. 12(10), pages 1-21, May.
    6. Thangavel, Venugopal & Momula, Sai Yashwanth & Gosala, Dheeraj Bharadwaj & Asvathanarayanan, Ramesh, 2016. "Experimental studies on simultaneous injection of ethanol–gasoline and n-butanol–gasoline in the intake port of a four stroke SI engine," Renewable Energy, Elsevier, vol. 91(C), pages 347-360.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Cristian Sandu & Constantin Pana & Niculae Negurescu & Gheorghe Lazaroiu & Alexandru Cernat & Rares Georgescu & Cristian Nutu, 2023. "The Influence of N-Butanol Addition in Gasoline on the Combustion in the Spark Ignition Engine," Sustainability, MDPI, vol. 15(18), pages 1-20, September.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Yaman, Hayri & Yesilyurt, Murat Kadir & Uslu, Samet, 2022. "Simultaneous optimization of multiple engine parameters of a 1-heptanol / gasoline fuel blends operated a port-fuel injection spark-ignition engine using response surface methodology approach," Energy, Elsevier, vol. 238(PC).
    2. Huang, Yuhan & Surawski, Nic C. & Zhuang, Yuan & Zhou, John L. & Hong, Guang, 2021. "Dual injection: An effective and efficient technology to use renewable fuels in spark ignition engines," Renewable and Sustainable Energy Reviews, Elsevier, vol. 143(C).
    3. Kumar, T. Sathish & Ashok, B., 2021. "Critical review on combustion phenomena of low carbon alcohols in SI engine with its challenges and future directions," Renewable and Sustainable Energy Reviews, Elsevier, vol. 152(C).
    4. Stančin, H. & Mikulčić, H. & Wang, X. & Duić, N., 2020. "A review on alternative fuels in future energy system," Renewable and Sustainable Energy Reviews, Elsevier, vol. 128(C).
    5. Shen, Kai & Xu, Zishun & Zhu, Zhongpan & Yang, Linsen, 2022. "Combined effects of electric supercharger and LP-EGR on performance of turbocharged engine," Energy, Elsevier, vol. 244(PB).
    6. Manju Dhakad Tanwar & Felipe Andrade Torres & Ali Mubarak Alqahtani & Pankaj Kumar Tanwar & Yashas Bhand & Omid Doustdar, 2023. "Promising Bioalcohols for Low-Emission Vehicles," Energies, MDPI, vol. 16(2), pages 1-22, January.
    7. Süleyman Şimşek & Hasan Saygın & Bülent Özdalyan, 2020. "Improvement of Fusel Oil Features and Effect of Its Use in Different Compression Ratios for an SI Engine on Performance and Emission," Energies, MDPI, vol. 13(7), pages 1-14, April.
    8. Shang, Zhen & Yu, Xiumin & Ren, Lei & Wei, Guowu & Li, Guanting & Li, Decheng & Li, Yinan, 2020. "Comparative study on effects of injection mode on combustion and emission characteristics of a combined injection n-butanol/gasoline SI engine with hydrogen direct injection," Energy, Elsevier, vol. 213(C).
    9. Aniza, Ria & Chen, Wei-Hsin & Lin, Yu-Ying & Tran, Khanh-Quang & Chang, Jo-Shu & Lam, Su Shiung & Park, Young-Kwon & Kwon, Eilhann E. & Tabatabaei, Meisam, 2021. "Independent parallel pyrolysis kinetics of extracted proteins and lipids as well as model carbohydrates in microalgae," Applied Energy, Elsevier, vol. 300(C).
    10. Muteeb Ul Haq & Ali Turab Jafry & Saad Ahmad & Taqi Ahmad Cheema & Munib Qasim Ansari & Naseem Abbas, 2022. "Recent Advances in Fuel Additives and Their Spray Characteristics for Diesel-Based Blends," Energies, MDPI, vol. 15(19), pages 1-30, October.
    11. Lee, Ziyoung & Park, Sungwook, 2020. "Particulate and gaseous emissions from a direct-injection spark ignition engine fueled with bioethanol and gasoline blends at ultra-high injection pressure," Renewable Energy, Elsevier, vol. 149(C), pages 80-90.
    12. Chakrapani Nagappan Kowthaman & S. M. Ashrafur Rahman & I. M. R. Fattah, 2023. "Exploring the Potential of Lignocellulosic Biomass-Derived Polyoxymethylene Dimethyl Ether as a Sustainable Fuel for Internal Combustion Engines," Energies, MDPI, vol. 16(12), pages 1-18, June.
    13. Biswal, Abinash & Kale, Rakesh & Balusamy, Saravanan & Banerjee, Raja & Kolhe, Pankaj, 2019. "Lemon peel oil as an alternative fuel for GDI engines: A spray characterization perspective," Renewable Energy, Elsevier, vol. 142(C), pages 249-263.
    14. Mourad, M. & Mahmoud, K., 2019. "Investigation into SI engine performance characteristics and emissions fuelled with ethanol/butanol-gasoline blends," Renewable Energy, Elsevier, vol. 143(C), pages 762-771.
    15. Li, Xiaoyan & Zhen, Xudong & Wang, Yang & Tian, Zhi, 2022. "Numerical comparative study on performance and emissions characteristics fueled with methanol, ethanol and methane in high compression spark ignition engine," Energy, Elsevier, vol. 254(PA).
    16. Stanislaw Szwaja & Michal Gruca & Michal Pyrc & Romualdas Juknelevičius, 2021. "Performance and Exhaust Emissions of a Spark Ignition Internal Combustion Engine Fed with Butanol–Glycerol Blend," Energies, MDPI, vol. 14(20), pages 1-15, October.
    17. Eduardo J. C. Cavalcanti & Daniel R. S. da Silva & Monica Carvalho, 2022. "Life Cycle and Exergoenvironmental Analyses of Ethanol: Performance of a Flex-Fuel Spark-Ignition Engine at Wide-Open Throttle Conditions," Energies, MDPI, vol. 15(4), pages 1-19, February.
    18. Mao, Dongxu & Ghadikolaei, Meisam Ahmadi & Cheung, Chun Shun & Shen, Zhaojie & Cui, Wenzheng & Wong, Pak Kin, 2020. "Influence of alternative fuels on the particulate matter micro and nano-structures, volatility and oxidation reactivity in a compression ignition engine," Renewable and Sustainable Energy Reviews, Elsevier, vol. 132(C).
    19. Sathish Kumar, T. & Ashok, B. & Saravanan, B., 2023. "Calibration of flex-fuel operating parameters using grey relational analysis to enhance the output characteristics of ethanol powered direct injection SI engine," Energy, Elsevier, vol. 281(C).
    20. Evangelos G. Giakoumis, 2017. "Diesel and Spark Ignition Engines Emissions and After-Treatment Control: Research and Advancements," Energies, MDPI, vol. 10(11), pages 1-4, November.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:15:y:2023:i:12:p:9696-:d:1173069. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.