IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v17y2024i10p2370-d1394413.html
   My bibliography  Save this article

Start of Injection Influence on In-Cylinder Fuel Distribution, Engine Performance and Emission Characteristic in a RCCI Marine Engine

Author

Listed:
  • Alireza Kakoee

    (Efficient Powertrain Solutions (EPS), School of Technology and Innovation, University of Vaasa, Yliopistonranta 10, FI-65200 Vaasa, Finland)

  • Maciej Mikulski

    (Efficient Powertrain Solutions (EPS), School of Technology and Innovation, University of Vaasa, Yliopistonranta 10, FI-65200 Vaasa, Finland)

  • Aneesh Vasudev

    (Efficient Powertrain Solutions (EPS), School of Technology and Innovation, University of Vaasa, Yliopistonranta 10, FI-65200 Vaasa, Finland)

  • Martin Axelsson

    (Engine Research and Technology Development at Wärtsilä Marine Solutions, FI-65101 Vaasa, Finland)

  • Jari Hyvönen

    (Engine Research and Technology Development at Wärtsilä Marine Solutions, FI-65101 Vaasa, Finland)

  • Mohammad Mahdi Salahi

    (Machine and Vehicle Design (MVD), Materials and Mechanical Engineering, Faculty of Technology, University of Oulu, FI-90014 Oulu, Finland)

  • Amin Mahmoudzadeh Andwari

    (Machine and Vehicle Design (MVD), Materials and Mechanical Engineering, Faculty of Technology, University of Oulu, FI-90014 Oulu, Finland)

Abstract

Reactivity-controlled compression ignition (RCCI) is a promising new combustion technology for marine applications. It has offered the potential to achieve low NO x emissions and high thermal efficiency, which are both important considerations for marine engines. However, the performance of RCCI engines is sensitive to a number of factors, including the start of injection. This study used computational fluid dynamics (CFD) to investigate the effects of start of ignition (SOI) on the performance of a marine RCCI engine. The CFD model was validated against experimental data, and the results showed that the SOI has a significant impact on the combustion process. In particular, the SOI affected the distribution of fuel and air in the combustion chamber, which in turn affected the rate of heat release and the formation of pollutants. Ten different SOIs were implemented on a validated closed-loop CFD model from 96 to 42 CAD bTDC (crank angle degree before top dead center) at six-degree intervals. A chemical kinetic mechanism of 54 species and 269 reactions tuned and used for simulation of in-cylinder combustion. The results show that in early injection, high-reactivity fuel was distributed close to the liner. This distribution was around the center of late injection angles. A homogeneity study was carried out to investigate the local equivalence ratio. It showed a more homogenous mixture in early injection until 66 CAD bTDC, after which point, earlier injection timing had no effect on homogeneity. Maximum indicated mean effective pressure (IMEP) was achieved at SOI 48 CAD bTDC, and minimum amounts of THC (total hydrocarbons) and NO x were observed with middle injection timing angles around 66 CAD bTDC.

Suggested Citation

  • Alireza Kakoee & Maciej Mikulski & Aneesh Vasudev & Martin Axelsson & Jari Hyvönen & Mohammad Mahdi Salahi & Amin Mahmoudzadeh Andwari, 2024. "Start of Injection Influence on In-Cylinder Fuel Distribution, Engine Performance and Emission Characteristic in a RCCI Marine Engine," Energies, MDPI, vol. 17(10), pages 1-25, May.
    • Handle: RePEc:gam:jeners:v:17:y:2024:i:10:p:2370-:d:1394413
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/17/10/2370/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/17/10/2370/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Nazemi, M. & Shahbakhti, M., 2016. "Modeling and analysis of fuel injection parameters for combustion and performance of an RCCI engine," Applied Energy, Elsevier, vol. 165(C), pages 135-150.
    2. Molina, S. & García, A. & Pastor, J.M. & Belarte, E. & Balloul, I., 2015. "Operating range extension of RCCI combustion concept from low to full load in a heavy-duty engine," Applied Energy, Elsevier, vol. 143(C), pages 211-227.
    3. Ma, Shuaiying & Zheng, Zunqing & Liu, Haifeng & Zhang, Quanchang & Yao, Mingfa, 2013. "Experimental investigation of the effects of diesel injection strategy on gasoline/diesel dual-fuel combustion," Applied Energy, Elsevier, vol. 109(C), pages 202-212.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Li, Zilong & Zhang, Yaoyuan & Huang, Guan & Zhao, Wenbin & He, Zhuoyao & Qian, Yong & Lu, Xingcai, 2020. "Control of intake boundary conditions for enabling clean combustion in variable engine conditions under intelligent charge compression ignition (ICCI) mode," Applied Energy, Elsevier, vol. 274(C).
    2. Han, Weiqiang & Li, Bolun & Pan, Suozhu & Lu, Yao & Li, Xin, 2018. "Combined effect of inlet pressure, total cycle energy, and start of injection on low load reactivity controlled compression ignition combustion and emission characteristics in a multi-cylinder heavy-d," Energy, Elsevier, vol. 165(PB), pages 846-858.
    3. Liu, Xinlei & Wang, Hu & Wang, Xiaofeng & Zheng, Zunqing & Yao, Mingfa, 2017. "Experimental and modelling investigations of the diesel surrogate fuels in direct injection compression ignition combustion," Applied Energy, Elsevier, vol. 189(C), pages 187-200.
    4. Pachiannan, Tamilselvan & Zhong, Wenjun & Rajkumar, Sundararajan & He, Zhixia & Leng, Xianying & Wang, Qian, 2019. "A literature review of fuel effects on performance and emission characteristics of low-temperature combustion strategies," Applied Energy, Elsevier, vol. 251(C), pages 1-1.
    5. Raza, Mohsin & Wang, Hu & Yao, Mingfa, 2019. "Numerical investigation of reactivity controlled compression ignition (RCCI) using different multi-component surrogate combinations of diesel and gasoline," Applied Energy, Elsevier, vol. 242(C), pages 462-479.
    6. Jia, Guorui & Wang, Hu & Tong, Laihui & Wang, Xiaofeng & Zheng, Zunqing & Yao, Mingfa, 2017. "Experimental and numerical studies on three gasoline surrogates applied in gasoline compression ignition (GCI) mode," Applied Energy, Elsevier, vol. 192(C), pages 59-70.
    7. Wang, Yang & Wei, Lixia & Yao, Mingfa, 2016. "A theoretical investigation of the effects of the low-temperature reforming products on the combustion of n-heptane in an HCCI engine and a constant volume vessel," Applied Energy, Elsevier, vol. 181(C), pages 132-139.
    8. Enrico Mattarelli & Carlo Alberto Rinaldini & Luca Marmorini & Stefano Caprioli & Francesco Legrottaglie & Francesco Scrignoli, 2022. "2-Stroke RCCI Engines for Passenger Cars," Energies, MDPI, vol. 15(3), pages 1-20, February.
    9. Li, Jing & Yang, Wenming & Zhou, Dezhi, 2017. "Review on the management of RCCI engines," Renewable and Sustainable Energy Reviews, Elsevier, vol. 69(C), pages 65-79.
    10. Zheng, Zunqing & Xia, Mingtao & Liu, Haifeng & Wang, Xiaofeng & Yao, Mingfa, 2018. "Experimental study on combustion and emissions of dual fuel RCCI mode fueled with biodiesel/n-butanol, biodiesel/2,5-dimethylfuran and biodiesel/ethanol," Energy, Elsevier, vol. 148(C), pages 824-838.
    11. Li, Jing & Ling, Xiang & Liu, Deng & Yang, Wenming & Zhou, Dezhi, 2018. "Numerical study on double injection techniques in a gasoline and biodiesel fueled RCCI (reactivity controlled compression ignition) engine," Applied Energy, Elsevier, vol. 211(C), pages 382-392.
    12. Wei Tian & Hongchuan Zhang & Lenian Wang & Zhiqiang Han & Wenbin Yu, 2020. "Effect of Premixed n-Butanol Ratio on the Initial Stage of Combustion in a Light-Duty Butanol/Diesel Dual-Fuel Engine," Energies, MDPI, vol. 13(17), pages 1-10, August.
    13. Yang, Hongqiang & Wang, Zhi & Shuai, Shijin & Wang, Jianxin & Xu, Hongming & Wang, Buyu, 2015. "Temporally and spatially distributed combustion in low-octane gasoline multiple premixed compression ignition mode," Applied Energy, Elsevier, vol. 150(C), pages 150-160.
    14. Mikulski, Maciej & Balakrishnan, Praveen Ramanujam & Hunicz, Jacek, 2019. "Natural gas-diesel reactivity controlled compression ignition with negative valve overlap and in-cylinder fuel reforming," Applied Energy, Elsevier, vol. 254(C).
    15. Huang, Haozhong & Zhou, Chengzhong & Liu, Qingsheng & Wang, Qingxin & Wang, Xueqiang, 2016. "An experimental study on the combustion and emission characteristics of a diesel engine under low temperature combustion of diesel/gasoline/n-butanol blends," Applied Energy, Elsevier, vol. 170(C), pages 219-231.
    16. Pan, Suozhu & Cai, Kai & Cai, Min & Du, Chenbo & Li, Xin & Han, Weiqiang & Wang, Xin & Liu, Daming & Wei, Jiangjun & Fang, Jia & Bao, Xiuchao, 2021. "Experimental study on the cyclic variations of ethanol/diesel reactivity controlled compression ignition (RCCI) combustion in a heavy-duty diesel engine," Energy, Elsevier, vol. 237(C).
    17. Fang, Cheng & Ouyang, Minggao & Tunestal, Per & Yang, Fuyuan & Yang, Xiaofan, 2018. "Closed-loop combustion phase control for multiple combustion modes by multiple injections in a compression ignition engine fueled by gasoline-diesel mixture," Applied Energy, Elsevier, vol. 231(C), pages 816-825.
    18. Wang, Xinyan & Zhao, Hua & Xie, Hui, 2016. "Effect of dilution strategies and direct injection ratios on stratified flame ignition (SFI) hybrid combustion in a PFI/DI gasoline engine," Applied Energy, Elsevier, vol. 165(C), pages 801-814.
    19. Wang, Yifeng & Yao, Mingfa & Li, Tie & Zhang, Weijing & Zheng, Zunqing, 2016. "A parametric study for enabling reactivity controlled compression ignition (RCCI) operation in diesel engines at various engine loads," Applied Energy, Elsevier, vol. 175(C), pages 389-402.
    20. Fan, Baowei & Pan, Jianfeng & Yang, Wenming & Chen, Wei & Bani, Stephen, 2017. "The influence of injection strategy on mixture formation and combustion process in a direct injection natural gas rotary engine," Applied Energy, Elsevier, vol. 187(C), pages 663-674.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:17:y:2024:i:10:p:2370-:d:1394413. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.