IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v14y2021i24p8279-d698100.html
   My bibliography  Save this article

Studies on the CO 2 Capture by Coal Fly Ash Zeolites: Process Design and Simulation

Author

Listed:
  • Silviya Boycheva

    (Department of Thermal and Nuclear Power Engineering, Technical University of Sofia, 8 Kl. Ohridsky Blvd., 1000 Sofia, Bulgaria)

  • Ivan Marinov

    (Department of Thermal and Nuclear Power Engineering, Technical University of Sofia, 8 Kl. Ohridsky Blvd., 1000 Sofia, Bulgaria)

  • Denitza Zgureva-Filipova

    (College of Energy and Electronics, Technical University of Sofia, 8 Kl. Ohridsky Blvd., 1000 Sofia, Bulgaria)

Abstract

At present, mitigating carbon emissions from energy production and industrial processes is more relevant than ever to limit climate change. The widespread implementation of carbon capture technologies requires the development of cost-effective and selective adsorbents with high CO 2 capture capacity and low thermal recovery. Coal fly ash has been extensively studied as a raw material for the synthesis of low-cost zeolite-like adsorbents for CO 2 capture. Laboratory tests for CO 2 adsorption onto coal fly ash zeolites (CFAZ) reveal promising results, but detailed computational studies are required to clarify the applicability of these materials as CO 2 adsorbents on a pilot and industrial scale. The present study provides results for the validation of a simulation model for the design of adsorption columns for CO 2 capture on CFAZ based on the experimental equilibrium and dynamic adsorption on a laboratory scale. The simulations were performed using ProSim DAC dynamic adsorption software to study mass transfer and energy balance in the thermal swing adsorption mode and in the most widely operated adsorption unit configuration.

Suggested Citation

  • Silviya Boycheva & Ivan Marinov & Denitza Zgureva-Filipova, 2021. "Studies on the CO 2 Capture by Coal Fly Ash Zeolites: Process Design and Simulation," Energies, MDPI, vol. 14(24), pages 1-15, December.
    • Handle: RePEc:gam:jeners:v:14:y:2021:i:24:p:8279-:d:698100
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/14/24/8279/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/14/24/8279/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Zhao, Ruikai & Liu, Longcheng & Zhao, Li & Deng, Shuai & Li, Shuangjun & Zhang, Yue, 2019. "A comprehensive performance evaluation of temperature swing adsorption for post-combustion carbon dioxide capture," Renewable and Sustainable Energy Reviews, Elsevier, vol. 114(C), pages 1-1.
    2. Azarabadi, Habib & Lackner, Klaus S., 2019. "A sorbent-focused techno-economic analysis of direct air capture," Applied Energy, Elsevier, vol. 250(C), pages 959-975.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Zhu, Xuancan & Ge, Tianshu & Yang, Fan & Wang, Ruzhu, 2021. "Design of steam-assisted temperature vacuum-swing adsorption processes for efficient CO2 capture from ambient air," Renewable and Sustainable Energy Reviews, Elsevier, vol. 137(C).
    2. Qiao, Yuanting & Bailey, Josh J. & Huang, Qi & Ke, Xuebin & Wu, Chunfei, 2022. "Potential photo-switching sorbents for CO2 capture – A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 158(C).
    3. Drechsler, Carsten & Agar, David W., 2020. "Intensified integrated direct air capture - power-to-gas process based on H2O and CO2 from ambient air," Applied Energy, Elsevier, vol. 273(C).
    4. Balint Simon, 2023. "Material flows and embodied energy of direct air capture: A cradle‐to‐gate inventory of selected technologies," Journal of Industrial Ecology, Yale University, vol. 27(3), pages 646-661, June.
    5. Rocio Gonzalez Sanchez & Anatoli Chatzipanagi & Georgia Kakoulaki & Marco Buffi & Sandor Szabo, 2023. "The Role of Direct Air Capture in EU’s Decarbonisation and Associated Carbon Intensity for Synthetic Fuels Production," Energies, MDPI, vol. 16(9), pages 1-28, May.
    6. Jiang, L. & Ji, Y. & Shi, W.K. & Fang, M.X. & Wang, T. & Zhang, X.J., 2023. "Adsorption heat/mass conversion cycle for carbon capture:Concept, thermodynamics and perspective," Energy, Elsevier, vol. 278(PA).
    7. Sina Hoseinpoori & David Pallarès & Filip Johnsson & Henrik Thunman, 2023. "A comparative exergy-based assessment of direct air capture technologies," Mitigation and Adaptation Strategies for Global Change, Springer, vol. 28(7), pages 1-20, October.
    8. Bos, M.J. & Kersten, S.R.A. & Brilman, D.W.F., 2020. "Wind power to methanol: Renewable methanol production using electricity, electrolysis of water and CO2 air capture," Applied Energy, Elsevier, vol. 264(C).
    9. Christiano B. Peres & Pedro M. R. Resende & Leonel J. R. Nunes & Leandro C. de Morais, 2022. "Advances in Carbon Capture and Use (CCU) Technologies: A Comprehensive Review and CO 2 Mitigation Potential Analysis," Clean Technol., MDPI, vol. 4(4), pages 1-15, November.
    10. Yongting Shen & Hongxing Yang, 2022. "Multi-Objective Optimization of Integrated Solar-Driven CO 2 Capture System for an Industrial Building," Sustainability, MDPI, vol. 15(1), pages 1-25, December.
    11. A. G. Olabi & Tabbi Wilberforce & Enas Taha Sayed & Nabila Shehata & Abdul Hai Alami & Hussein M. Maghrabie & Mohammad Ali Abdelkareem, 2022. "Prospect of Post-Combustion Carbon Capture Technology and Its Impact on the Circular Economy," Energies, MDPI, vol. 15(22), pages 1-38, November.
    12. Yuannan Zheng & Qingzhao Li & Guiyun Zhang & Yang Zhao & Xinxin Liu, 2021. "Evaluation of separation effect for CH4 enrichment from coalbed methane (CBM) under the synergistic action of temperature and pressure based on IAST theory," Greenhouse Gases: Science and Technology, Blackwell Publishing, vol. 11(3), pages 590-605, June.
    13. Miriam Navarrete Procopio & Gustavo Urquiza & Laura Castro, 2023. "Analysis of Absorber Packed Height for Power Plants with Post-Combustion CO 2 Capture," Sustainability, MDPI, vol. 15(12), pages 1-17, June.
    14. Deborah Panepinto & Marco Ravina & Mariachiara Zanetti, 2022. "An Overview of Thermal Treatment Emissions with a Particular Focus on CO 2 Parameter," Sustainability, MDPI, vol. 14(23), pages 1-17, November.
    15. Xiaoyang Hou & Shuai Zhong & Jian’an Zhao, 2022. "A Critical Review on Decarbonizing Heating in China: Pathway Exploration for Technology with Multi-Sector Applications," Energies, MDPI, vol. 15(3), pages 1-23, February.
    16. Cheng, Pengfei & Thierry, David M. & Hendrix, Howard & Dombrowski, Katherine D. & Sachde, Darshan J. & Realff, Matthew J. & Scott, Joseph K., 2023. "Modeling and optimization of carbon-negative NGCC plant enabled by modular direct air capture," Applied Energy, Elsevier, vol. 341(C).
    17. Akinola, Toluleke E. & Bonilla Prado, Phebe L. & Wang, Meihong, 2022. "Experimental studies, molecular simulation and process modelling\simulation of adsorption-based post-combustion carbon capture for power plants: A state-of-the-art review," Applied Energy, Elsevier, vol. 317(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:14:y:2021:i:24:p:8279-:d:698100. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.