IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v35y2010i12p5374-5379.html
   My bibliography  Save this article

Entropy generation analysis for fully developed laminar convection in hexagonal duct subjected to constant heat flux

Author

Listed:
  • Jarungthammachote, Sompop

Abstract

The entropy generation of a fully developed laminar flow in a hexagonal duct is investigated in this study. A constant heat flux condition was applied in this analysis. Two fluids, water and engine oil, were used to study the effect of fluid properties on the entropy generation. The fluid properties were evaluated using average temperature between inlet and outlet duct sections. The aspect ratio of the hexagonal duct was varied to show its effect on the entropy generation. Attention was also given to the supplied heat flux affecting the entropy generation. Finally, the entropy generation calculated from the hexagonal duct was compared with that from rectangular and circular ducts having the same hydraulic diameter and cross-sectional area.

Suggested Citation

  • Jarungthammachote, Sompop, 2010. "Entropy generation analysis for fully developed laminar convection in hexagonal duct subjected to constant heat flux," Energy, Elsevier, vol. 35(12), pages 5374-5379.
  • Handle: RePEc:eee:energy:v:35:y:2010:i:12:p:5374-5379
    DOI: 10.1016/j.energy.2010.07.020
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544210003841
    Download Restriction: Full text for ScienceDirect subscribers only

    File URL: https://libkey.io/10.1016/j.energy.2010.07.020?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Satapathy, Ashok K., 2009. "Thermodynamic optimization of a coiled tube heat exchanger under constant wall heat flux condition," Energy, Elsevier, vol. 34(9), pages 1122-1126.
    2. Ko, T.H. & Ting, K., 2006. "Optimal Reynolds number for the fully developed laminar forced convection in a helical coiled tube," Energy, Elsevier, vol. 31(12), pages 2142-2152.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Lucia, Umberto, 2014. "Thermodynamic approach to nano-properties of cell membrane," Physica A: Statistical Mechanics and its Applications, Elsevier, vol. 407(C), pages 185-191.
    2. Torabi, Mohsen & Zhang, Kaili & Yang, Guangcheng & Wang, Jun & Wu, Peng, 2014. "Temperature distribution, local and total entropy generation analyses in asymmetric cooling composite geometries with multiple nonlinearities: Effect of imperfect thermal contact," Energy, Elsevier, vol. 78(C), pages 218-234.
    3. Amani, E. & Nobari, M.R.H., 2011. "A numerical investigation of entropy generation in the entrance region of curved pipes at constant wall temperature," Energy, Elsevier, vol. 36(8), pages 4909-4918.
    4. Arjmandi, H.R. & Amani, E., 2015. "A numerical investigation of the entropy generation in and thermodynamic optimization of a combustion chamber," Energy, Elsevier, vol. 81(C), pages 706-718.
    5. Hajmohammadi, M.R. & Eskandari, H. & Saffar-Avval, M. & Campo, A., 2013. "A new configuration of bend tubes for compound optimization of heat and fluid flow," Energy, Elsevier, vol. 62(C), pages 418-424.
    6. Wang, Guangwei & Zhang, Jianliang & Chang, Weiwei & Li, Rongpeng & Li, Yanjiang & Wang, Chuan, 2018. "Structural features and gasification reactivity of biomass chars pyrolyzed in different atmospheres at high temperature," Energy, Elsevier, vol. 147(C), pages 25-35.
    7. Mian, Inamullah & Li, Xian & Dacres, Omar D. & Wang, Jianjiang & Wei, Bo & Jian, Yiming & Zhong, Mei & Liu, Jingmei & Ma, Fengyun & Rahman, Noor, 2020. "Combustion kinetics and mechanism of biomass pellet," Energy, Elsevier, vol. 205(C).
    8. Lucia, Umberto, 2014. "Entropy generation approach to cell systems," Physica A: Statistical Mechanics and its Applications, Elsevier, vol. 406(C), pages 1-11.
    9. Goudarzi, N. & Talebi, S., 2015. "An approach to stability analysis and entropy generation minimization in the single-phase natural circulation loops," Energy, Elsevier, vol. 80(C), pages 213-226.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Ahadi, Mohammad & Abbassi, Abbas, 2015. "Entropy generation analysis of laminar forced convection through uniformly heated helical coils considering effects of high length and heat flux and temperature dependence of thermophysical properties," Energy, Elsevier, vol. 82(C), pages 322-332.
    2. Xu, Mingtian, 2012. "Variational principles in terms of entransy for heat transfer," Energy, Elsevier, vol. 44(1), pages 973-977.
    3. Amani, E. & Nobari, M.R.H., 2011. "A numerical investigation of entropy generation in the entrance region of curved pipes at constant wall temperature," Energy, Elsevier, vol. 36(8), pages 4909-4918.
    4. Hajmohammadi, M.R. & Eskandari, H. & Saffar-Avval, M. & Campo, A., 2013. "A new configuration of bend tubes for compound optimization of heat and fluid flow," Energy, Elsevier, vol. 62(C), pages 418-424.
    5. Bahiraei, Farid & Saray, Rahim Khoshbakhti & Salehzadeh, Aidin, 2011. "Investigation of potential of improvement of helical coils based on avoidable and unavoidable exergy destruction concepts," Energy, Elsevier, vol. 36(5), pages 3113-3119.
    6. Li, Zhouhang & Zhai, Yuling & Bi, Dapeng & Li, Kongzhai & Wang, Hua & Lu, Junfu, 2017. "Orientation effect in helical coils with smooth and rib-roughened wall: Toward improved gas heaters for supercritical carbon dioxide Rankine cycles," Energy, Elsevier, vol. 140(P1), pages 530-545.
    7. Colorado, D. & Ali, M.E. & García-Valladares, O. & Hernández, J.A., 2011. "Heat transfer using a correlation by neural network for natural convection from vertical helical coil in oil and glycerol/water solution," Energy, Elsevier, vol. 36(2), pages 854-863.
    8. Han, Yong & Wang, Xue-sheng & Zhang, Zhao & Zhang, Hao-nan, 2020. "Multi-objective optimization of geometric parameters for the helically coiled tube using Markowitz optimization theory," Energy, Elsevier, vol. 192(C).
    9. Li, Zhouhang & Zhai, Yuling & Li, Kongzhai & Wang, Hua & Lu, Junfu, 2016. "A quantitative study on the interaction between curvature and buoyancy effects in helically coiled heat exchangers of supercritical CO2 Rankine cycles," Energy, Elsevier, vol. 116(P1), pages 661-676.
    10. Sheikholeslami, M. & Ganji, D.D., 2016. "Heat transfer enhancement in an air to water heat exchanger with discontinuous helical turbulators; experimental and numerical studies," Energy, Elsevier, vol. 116(P1), pages 341-352.
    11. Khan, Abid A. & Shahzad, Asim & Hayat, Imran & Miah, Md Salim, 2016. "Recovery of flow conditions for optimum electricity generation through micro hydro turbines," Renewable Energy, Elsevier, vol. 96(PA), pages 940-948.
    12. Kaluri, Ram Satish & Basak, Tanmay, 2011. "Entropy generation due to natural convection in discretely heated porous square cavities," Energy, Elsevier, vol. 36(8), pages 5065-5080.
    13. Heidar Sadeghzadeh & Mehdi Aliehyaei & Marc A. Rosen, 2015. "Optimization of a Finned Shell and Tube Heat Exchanger Using a Multi-Objective Optimization Genetic Algorithm," Sustainability, MDPI, vol. 7(9), pages 1-17, August.
    14. Arjmandi, H.R. & Amani, E., 2015. "A numerical investigation of the entropy generation in and thermodynamic optimization of a combustion chamber," Energy, Elsevier, vol. 81(C), pages 706-718.
    15. San, J.-Y., 2010. "Second-law performance of heat exchangers for waste heat recovery," Energy, Elsevier, vol. 35(5), pages 1936-1945.
    16. Şöhret, Yasin & Dinç, Ali & Karakoç, T. Hikmet, 2015. "Exergy analysis of a turbofan engine for an unmanned aerial vehicle during a surveillance mission," Energy, Elsevier, vol. 93(P1), pages 716-729.
    17. Roy, Monisha & Roy, S. & Basak, Tanmay, 2015. "Role of various moving walls on energy transfer rates via heat flow visualization during mixed convection in square cavities," Energy, Elsevier, vol. 82(C), pages 1-22.
    18. Cheng-Xian Lin & Robel Kiflemariam, 2019. "Numerical Simulation and Validation of Thermoeletric Generator Based Self-Cooling System with Airflow," Energies, MDPI, vol. 12(21), pages 1-21, October.
    19. Yamankaradeniz, Nurettin, 2016. "Thermodynamic performance assessments of a district heating system with geothermal by using advanced exergy analysis," Renewable Energy, Elsevier, vol. 85(C), pages 965-972.
    20. Alawadhi, Esam M., 2011. "Cooling process of water in a horizontal circular enclosure subjected to non-uniform boundary conditions," Energy, Elsevier, vol. 36(1), pages 586-594.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:35:y:2010:i:12:p:5374-5379. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.