IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v277y2023ics036054422301085x.html
   My bibliography  Save this article

Thermodynamic study on throttling process of Joule-Thomson cooler to improve helium liquefaction performance between 2 K and 4 K

Author

Listed:
  • Wu, Shiguang
  • Zhao, Bangjian
  • Tan, Jun
  • Zhao, Yongjiang
  • Zhai, Yujia
  • Xue, Renjun
  • Tan, Han
  • Ma, Dong
  • Wu, Dirui
  • Dang, Haizheng

Abstract

The Joule-Thomson cooler (JTC) is a key component of the hybrid cryocooler dedicated to achieving and maintaining the operating temperature of around 2–4 K extensively used in quantum computing and communications. To clarify the energy conversion mechanism during the throttling process of the JTC and to improve throttling performance at 2–4 K, a numerical model is developed in which the effect of the complex real physical properties of liquid helium is considered, and the modified Lee phase change model is proposed to meet the operating conditions from supercritical to saturation. The results show that the phase change causes the cooling effect during the throttling process. The larger total energy loss in orifice leads to a higher liquefaction ratio. The liquefaction ratio increases with the increasing orifice thickness and the decreasing orifice diameter and inlet pressure. Given a constant inlet and refrigeration temperature difference, the liquefaction ratio increases with the increase of inlet temperatures. The maximum liquefaction ratio of 93.80% is achieved with orifice thickness of 0.8 mm, orifice diameter of 30 μm, and inlet pressure of 0.32 MPa, assuming an inlet temperature of 4 K and a refrigeration temperature of 3.43 K.

Suggested Citation

  • Wu, Shiguang & Zhao, Bangjian & Tan, Jun & Zhao, Yongjiang & Zhai, Yujia & Xue, Renjun & Tan, Han & Ma, Dong & Wu, Dirui & Dang, Haizheng, 2023. "Thermodynamic study on throttling process of Joule-Thomson cooler to improve helium liquefaction performance between 2 K and 4 K," Energy, Elsevier, vol. 277(C).
    • Handle: RePEc:eee:energy:v:277:y:2023:i:c:s036054422301085x
    DOI: 10.1016/j.energy.2023.127691
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S036054422301085X
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2023.127691?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Hua, Lingji & Wang, Ruzhu, 2022. "An exergy analysis and parameter optimization of solid desiccant heat pumps recovering the condensation heat for desiccant regeneration and heat transfer enhancement," Energy, Elsevier, vol. 238(PB).
    2. Changjun Li & Wenlong Jia & Xia Wu, 2012. "Temperature Prediction for High Pressure High Temperature Condensate Gas Flow Through Chokes," Energies, MDPI, vol. 5(3), pages 1-13, March.
    3. Bian, Jiang & Cao, Xuewen & Yang, Wen & Edem, Mawugbe Ayivi & Yin, Pengbo & Jiang, Wenming, 2018. "Supersonic liquefaction properties of natural gas in the Laval nozzle," Energy, Elsevier, vol. 159(C), pages 706-715.
    4. Liang, Kun & Stone, Richard & Davies, Gareth & Dadd, Mike & Bailey, Paul, 2014. "Modelling and measurement of a moving magnet linear compressor performance," Energy, Elsevier, vol. 66(C), pages 487-495.
    5. Chen, Hui & Liu, Ying-wen, 2021. "A new optimization concept of the recuperator based on Hampson-type miniature cryocoolers," Energy, Elsevier, vol. 224(C).
    6. Thomas, Rijo Jacob & Ghosh, Parthasarathi & Chowdhury, Kanchan, 2012. "Application of exergy analysis in designing helium liquefiers," Energy, Elsevier, vol. 37(1), pages 207-219.
    7. Bi, Yujing & Ju, Yonglin, 2022. "Design and analysis of an efficient hydrogen liquefaction process based on helium reverse Brayton cycle integrating with steam methane reforming and liquefied natural gas cold energy utilization," Energy, Elsevier, vol. 252(C).
    8. Guo, Hao & Tang, Qixiong & Gong, Maoqiong & Cheng, Kuiwei, 2018. "Optimization of a novel liquefaction process based on Joule–Thomson cycle utilizing high-pressure natural gas exergy by genetic algorithm," Energy, Elsevier, vol. 151(C), pages 696-706.
    9. Giacomelli, Francesco & Mazzelli, Federico & Milazzo, Adriano, 2018. "A novel CFD approach for the computation of R744 flashing nozzles in compressible and metastable conditions," Energy, Elsevier, vol. 162(C), pages 1092-1105.
    10. Li, Zhuoran & Zhang, Caigong & Li, Changjun & Jia, Wenlong, 2022. "Thermodynamic study on the natural gas condensation in the throttle valve for the efficiency of the natural gas transport system," Applied Energy, Elsevier, vol. 322(C).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Xue, Renjun & Tan, Jun & Zhao, Bangjian & Zhao, Yongjiang & Tan, Han & Wu, Shiguang & Zhai, Yujia & Ma, Dong & Wu, Dirui & Dang, Haizheng, 2023. "Thermodynamic characteristics of a single-stage stirling-type pulse tube cryocooler capable of 1220 W at 77 K with two cold fingers driven by one linear compressor," Energy, Elsevier, vol. 278(PB).
    2. Li, Zhuoran & Zhang, Caigong & Li, Changjun & Jia, Wenlong, 2022. "Thermodynamic study on the natural gas condensation in the throttle valve for the efficiency of the natural gas transport system," Applied Energy, Elsevier, vol. 322(C).
    3. Wang, Shiwei & Wang, Chao & Ding, Hongbing & Zhang, Yu & Dong, Yuanyuan & Wen, Chuang, 2023. "Joule-Thomson effect and flow behavior for energy-efficient dehydration of high-pressure natural gas in supersonic separator," Energy, Elsevier, vol. 279(C).
    4. Tang, Yongzhi & Liu, Zhongliang & Li, Yanxia & Huang, Zhifeng & Chua, Kian Jon, 2021. "Study on fundamental link between mixing efficiency and entrainment performance of a steam ejector," Energy, Elsevier, vol. 215(PB).
    5. Dara, Satyadileep & Abdulqader, Haytham & Al Wahedi, Yasser & Berrouk, Abdallah S., 2020. "Countrywide optimization of natural gas supply chain: From wells to consumers," Energy, Elsevier, vol. 196(C).
    6. Hao Shen & Zhaohua Li & Kun Liang & Xinwen Chen, 2022. "Numerical modeling of a novel two-stage linear refrigeration compressor [Linear compressors for electronics cooling: energy recovery and its benefits]," International Journal of Low-Carbon Technologies, Oxford University Press, vol. 17, pages 436-445.
    7. Kochunni, Sarun Kumar & Joy, Jubil & Chowdhury, Kanchan, 2019. "LNG boil-off gas reliquefaction by Brayton refrigeration system – Part 2: Improvements over basic configuration," Energy, Elsevier, vol. 176(C), pages 861-873.
    8. Knut Emil Ringstad & Krzysztof Banasiak & Åsmund Ervik & Armin Hafner, 2022. "Swirl-Bypass Nozzle for CO 2 Two-Phase Ejectors: Numerical Design Exploration," Energies, MDPI, vol. 15(18), pages 1-30, September.
    9. Ding, Hongbing & Zhang, Yu & Sun, Chunqian & Yang, Yan & Wen, Chuang, 2022. "Numerical simulation of supersonic condensation flows using Eulerian-Lagrangian and Eulerian wall film models," Energy, Elsevier, vol. 258(C).
    10. Lixing Zheng & Yiyan Zhang & Lifen Hao & Haojie Lian & Jianqiang Deng & Wei Lu, 2022. "Modelling, Optimization, and Experimental Studies of Refrigeration CO 2 Ejectors: A Review," Mathematics, MDPI, vol. 10(22), pages 1-23, November.
    11. Feng, Y.H. & Dai, Y.J. & Wang, R.Z. & Ge, T.S., 2022. "Insights into desiccant-based internally-cooled dehumidification using porous sorbents: From a modeling viewpoint," Applied Energy, Elsevier, vol. 311(C).
    12. Jia-Xin Li & Yun-Ze Li & Ben-Yuan Cai & En-Hui Li, 2019. "Experimental Investigation on Heat Transfer Mechanism of Air-Blast-Spray-Cooling System with a Two-Phase Ejector Loop for Aeronautical Application," Energies, MDPI, vol. 12(20), pages 1-20, October.
    13. Besagni, Giorgio, 2019. "Ejectors on the cutting edge: The past, the present and the perspective," Energy, Elsevier, vol. 170(C), pages 998-1003.
    14. Golrokh Sani, Ahmad & Najafi, Hamidreza & Azimi, Seyedeh Shakiba, 2022. "Dynamic thermal modeling of the refrigerated liquified CO2 tanker in carbon capture, utilization, and storage chain: A truck transport case study," Applied Energy, Elsevier, vol. 326(C).
    15. Chen, Shuhang & Liu, Dongli & Li, Sizhuo & Gan, Zhihua & Qiu, Min, 2022. "Multi-objective thermo-economic optimization of Collins cycle," Energy, Elsevier, vol. 239(PD).
    16. Guo, Dan & Cao, Xuewen & Zhang, Pan & Ding, Gaoya & Liu, Yang & Cao, Hengguang & Bian, Jiang, 2022. "Heterogeneous condensation mechanism of methane-hexane binary mixture," Energy, Elsevier, vol. 256(C).
    17. Bian, Jiang & Guo, Dan & Li, Yuxuan & Cai, Weihua & Hua, Yihuai & Cao, Xuewen, 2022. "Homogeneous nucleation and condensation mechanism of methane gas: A molecular simulation perspective," Energy, Elsevier, vol. 249(C).
    18. Teng, Junjie & Wang, Kai & Zhu, Shaolong & Bao, Shiran & Zhi, Xiaoqin & Zhang, Xiaobin & Qiu, Limin, 2023. "Comparative study on thermodynamic performance of hydrogen liquefaction processes with various ortho-para hydrogen conversion methods," Energy, Elsevier, vol. 271(C).
    19. Chen, Hui & Wei, Chen-xi & Ding, Wen-hao & Liu, Ying-wen, 2023. "Optimization of miniature Joule-Thomson cryocooler with non-isometric recuperator on transient characteristics," Energy, Elsevier, vol. 267(C).
    20. Qiu, Guoyi & Zhu, Shaolong & Wang, Kai & Wang, Weibo & Hu, Junhui & Hu, Yun & Zhi, Xiaoqin & Qiu, Limin, 2023. "Numerical study on the dynamic process of reciprocating liquid hydrogen pumps for hydrogen refueling stations," Energy, Elsevier, vol. 281(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:277:y:2023:i:c:s036054422301085x. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.