Liquefaction of pineapple peel: Pretreatment and process optimization

This study explored the optimization of pretreatment of pineapple peel for biogas generation. Pretreatments were carried out sulfuric acid and alkaline hydrogen peroxide prior to anaerobic digestion while the response surface methodology (RSM) was used for optimization of the pretreatment procedures. The physical, chemical, proximate and structural compositions of the peels were determined prior to and at the end of the pretreatment procedures. The dynamics of microorganisms in the reactors were also evaluated by rapid molecular methods while the Fourier Transform Infra-red (FTIR) spectroscopy was employed in the identification of the chemical changes as a result of pretreatments. The use of H2O2 pretreatment caused enormous lignin solubilization in the pineapple peel. In comparison, biogas production was 67% more in the alkaline pretreated pineapple peel than the biomass treated with acid and also 51% over the untreated samples. The total biogas volume produced from the acidic pretreated, alkaline pretreated, not sifted untreated and sifted untreated samples are 194.2 ± 3.0, 587.5 ± 5.2, 287.8 ± 2.1 and 245.4 ± 3.1 respectively. Thus, the alkaline pretreated experiment used lower retention time to achieve maximum gas production in this study. The use of alkaline H2O2 on lignocelluloses has remained unpopular prior to this study. However, its usage in this study yielded better result than all the conventional treatments in terms of lignin solubilization and improvement in methane yield. Economically, the use of H2O2 for pretreatment is adjudged feasible because the 1504 kWh t−1 TS thermal energy gain obtained from the biogas produced by the alkaline treated peel exceeded the 921 kWh t−1 TS used in the pretreatment. This gives a net thermal energy of 583 kWh t−1 TS. Whereas, the investment into acidic pretreatment of pineapple peel may not be economically justified because the total thermal energy gain of −200 kWh t−1 TS was far lower than the 1236 kWh t−1 TS thermal energy that was consumed during the pretreatment giving a net thermal energy of −1436 kWh t−1 TS. Therefore, the use of mild alkaline pretreatment is advocated in biogas generation from pineapple peel and also for biofertilizer production mostly in localities of mass production.