IDEAS home Printed from https://ideas.repec.org/a/eee/appene/v264y2020ics0306261920301380.html
   My bibliography  Save this article

Low temperature durability and consistency analysis of proton exchange membrane fuel cell stack based on comprehensive characterizations

Author

Listed:
  • Zhong, Di
  • Lin, Rui
  • Jiang, Zhenghua
  • Zhu, Yike
  • Liu, Dengchen
  • Cai, Xin
  • Chen, Liang

Abstract

The cold start is one of the key research fields in proton exchange membrane fuel cell investigation. In this work, a low temperature durability and consistency analysis is performed on a 5-cells stack. After 20 times freezing and thaw cycles, coefficient of variation of individual cell voltage increase significantly. Through the polarization curve test, it is found that the output performance degradation of each individual cell is inconsistent. The No.1 cell which is the nearest from the gas inlets has the maximum performance degradation. Through electrochemical impedance spectroscopy, cyclic voltammetry, scanning electron microscope, segmented current density test and synchrotron radiation X-ray scan 3D image reconstruction, the cracks on the interface of membrane and catalyst layer are observed in situ successfully for the first time. Under the condition in this work, the water content of No.1 cell is the most, and a lot amount of water is frozen at the air inlet area. Due to the frost heave stress, the structure of membrane electrode assembly is damaged. This causes the loss and the agglomeration of catalyst, and even the delamination of catalyst layer. The above structure changes cause a decrease in catalyst activity and an increase in cell resistance, and eventually lead to the inconsistent degradation in output performance. The characterization results in this work are helpful for the optimization and application of membrane electrodes assembly and stacks for vehicle fuel cells.

Suggested Citation

  • Zhong, Di & Lin, Rui & Jiang, Zhenghua & Zhu, Yike & Liu, Dengchen & Cai, Xin & Chen, Liang, 2020. "Low temperature durability and consistency analysis of proton exchange membrane fuel cell stack based on comprehensive characterizations," Applied Energy, Elsevier, vol. 264(C).
    • Handle: RePEc:eee:appene:v:264:y:2020:i:c:s0306261920301380
    DOI: 10.1016/j.apenergy.2020.114626
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0306261920301380
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.apenergy.2020.114626?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to

    for a different version of it.

    References listed on IDEAS

    as
    1. Mark K. Debe, 2012. "Electrocatalyst approaches and challenges for automotive fuel cells," Nature, Nature, vol. 486(7401), pages 43-51, June.
    2. Zainoodin, A.M. & Kamarudin, S.K. & Masdar, M.S. & Daud, W.R.W. & Mohamad, A.B. & Sahari, J., 2014. "Investigation of MEA degradation in a passive direct methanol fuel cell under different modes of operation," Applied Energy, Elsevier, vol. 135(C), pages 364-372.
    3. Zhang, Qian & Lin, Rui & Técher, Ludovic & Cui, Xin, 2016. "Experimental study of variable operating parameters effects on overall PEMFC performance and spatial performance distribution," Energy, Elsevier, vol. 115(P1), pages 550-560.
    4. Lin, Rui & Zhu, Yike & Ni, Meng & Jiang, Zhenghua & Lou, Diming & Han, Lihang & Zhong, Di, 2019. "Consistency analysis of polymer electrolyte membrane fuel cell stack during cold start," Applied Energy, Elsevier, vol. 241(C), pages 420-432.
    5. Xu, Xinhai & Xu, Ben & Dong, Jun & Liu, Xiaotong, 2017. "Near-term analysis of a roll-out strategy to introduce fuel cell vehicles and hydrogen stations in Shenzhen China," Applied Energy, Elsevier, vol. 196(C), pages 229-237.
    6. Lin, R. & Ren, Y.S. & Lin, X.W. & Jiang, Z.H. & Yang, Z. & Chang, Y.T., 2017. "Investigation of the internal behavior in segmented PEMFCs of different flow fields during cold start process," Energy, Elsevier, vol. 123(C), pages 367-377.
    7. Kurnia, Jundika C. & Sasmito, Agus P. & Shamim, Tariq, 2017. "Performance evaluation of a PEM fuel cell stack with variable inlet flows under simulated driving cycle conditions," Applied Energy, Elsevier, vol. 206(C), pages 751-764.
    8. Li, Yuehua & Pei, Pucheng & Wu, Ziyao & Ren, Peng & Jia, Xiaoning & Chen, Dongfang & Huang, Shangwei, 2018. "Approaches to avoid flooding in association with pressure drop in proton exchange membrane fuel cells," Applied Energy, Elsevier, vol. 224(C), pages 42-51.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Lin, Rui & Zhong, Di & Lan, Shunbo & Guo, Rong & Ma, Yunyang & Cai, Xin, 2021. "Experimental validation for enhancement of PEMFC cold start performance: Based on the optimization of micro porous layer," Applied Energy, Elsevier, vol. 300(C).
    2. Liu, Dengcheng & Lin, Rui & Feng, Bowen & Han, Lihang & Zhang, Yu & Ni, Meng & Wu, Sai, 2019. "Localised electrochemical impedance spectroscopy investigation of polymer electrolyte membrane fuel cells using Print circuit board based interference-free system," Applied Energy, Elsevier, vol. 254(C).
    3. Akimoto, Yutaro & Shibata, Masumi & Tsuzuki, Yuto & Okajima, Keiichi & Suzuki, Shin-nosuke, 2023. "In-situ on-board evaluation and control of proton exchange membrane fuel cells using magnetic sensors," Applied Energy, Elsevier, vol. 351(C).
    4. Chen, Dongfang & Pei, Pucheng & Ren, Peng & Song, Xin & Wang, He & Zhang, Lu & Wang, Mingkai, 2022. "Analytical methods for the effect of anode nitrogen concentration on performance and voltage consistency of proton exchange membrane fuel cell stack," Energy, Elsevier, vol. 258(C).
    5. Zhao, Junjie & Tu, Zhengkai & Chan, Siew Hwa, 2022. "In-situ measurement of humidity distribution and its effect on the performance of a proton exchange membrane fuel cell," Energy, Elsevier, vol. 239(PD).
    6. Lin, Rui & Zhu, Yike & Ni, Meng & Jiang, Zhenghua & Lou, Diming & Han, Lihang & Zhong, Di, 2019. "Consistency analysis of polymer electrolyte membrane fuel cell stack during cold start," Applied Energy, Elsevier, vol. 241(C), pages 420-432.
    7. Najmi, Aezid-Ul-Hassan & Anyanwu, Ikechukwu S. & Xie, Xu & Liu, Zhi & Jiao, Kui, 2021. "Experimental investigation and optimization of proton exchange membrane fuel cell using different flow fields," Energy, Elsevier, vol. 217(C).
    8. Li, Yuehua & Pei, Pucheng & Wu, Ziyao & Ren, Peng & Jia, Xiaoning & Chen, Dongfang & Huang, Shangwei, 2018. "Approaches to avoid flooding in association with pressure drop in proton exchange membrane fuel cells," Applied Energy, Elsevier, vol. 224(C), pages 42-51.
    9. Liu, Jiaran & Tan, Jinzhu & Yang, Weizhan & Li, Yang & Wang, Chao, 2021. "Better electrochemical performance of PEMFC under a novel pneumatic clamping mechanism," Energy, Elsevier, vol. 229(C).
    10. Li, Linjun & Wang, Shixue & Yue, Like & Wang, Guozhuo, 2019. "Cold-start method for proton-exchange membrane fuel cells based on locally heating the cathode," Applied Energy, Elsevier, vol. 254(C).
    11. Lin, Rui & Diao, Xiaoyu & Ma, Tiancai & Tang, Shenghao & Chen, Liang & Liu, Dengcheng, 2019. "Optimized microporous layer for improving polymer exchange membrane fuel cell performance using orthogonal test design," Applied Energy, Elsevier, vol. 254(C).
    12. Yushuai Sun & Pinliang Du & Miaoqi Bian & He Miao & Hao Hu & Liusheng Xiao, 2025. "Coupling Effects of Microstructure Characteristics on Stress Distribution for Pore-Scale Gas Diffusion Layers," Energies, MDPI, vol. 18(7), pages 1-18, March.
    13. Lv, Ping & Wu, Siyuan & Hou, Ben & Sun, Xin & Wang, Zixuan & Liu, Xueting & Li, Guangwei & Han, Meng & Jiao, Kui & Du, Qing & Xing, Danmin, 2025. "The voltage uniformity analysis of high-power proton exchange membrane fuel cell stack during cold start," Applied Energy, Elsevier, vol. 393(C).
    14. Xiao, Liusheng & Bian, Miaoqi & Sun, Yushuai & Yuan, Jinliang & Wen, Xiaofei, 2024. "Transport properties evaluation of pore-scale GDLs for PEMFC using orthogonal design method," Applied Energy, Elsevier, vol. 357(C).
    15. Yang, Zirong & Jiao, Kui & Wu, Kangcheng & Shi, Weilong & Jiang, Shangfeng & Zhang, Longhai & Du, Qing, 2021. "Numerical investigations of assisted heating cold start strategies for proton exchange membrane fuel cell systems," Energy, Elsevier, vol. 222(C).
    16. Huo, Sen & Jiao, Kui & Park, Jae Wan, 2019. "On the water transport behavior and phase transition mechanisms in cold start operation of PEM fuel cell," Applied Energy, Elsevier, vol. 233, pages 776-788.
    17. Yu, Yongsheng & Zheng, Weibo & Li, Bing & Zhang, Cunman & Ming, Pingwen, 2025. "A comprehensive review of cold start in proton-exchange membrane fuel cells: Challenges, strategies, and prospects," Applied Energy, Elsevier, vol. 390(C).
    18. Li, Yuehua & Pei, Pucheng & Ma, Ze & Ren, Peng & Wu, Ziyao & Chen, Dongfang & Huang, Hao, 2019. "Characteristic analysis in lowering current density based on pressure drop for avoiding flooding in proton exchange membrane fuel cell," Applied Energy, Elsevier, vol. 248(C), pages 321-329.
    19. Liu, Guicheng & Li, Xinyang & Wang, Hui & Liu, Xiuying & Chen, Ming & Woo, Jae Young & Kim, Ji Young & Wang, Xindong & Lee, Joong Kee, 2017. "Design of 3-electrode system for in situ monitoring direct methanol fuel cells during long-time running test at high temperature," Applied Energy, Elsevier, vol. 197(C), pages 163-168.
    20. Chen, Dongfang & Pan, Lyuming & Pei, Pucheng & Huang, Shangwei & Ren, Peng & Song, Xin, 2021. "Carbon-coated oxygen vacancies-rich Co3O4 nanoarrays grow on nickel foam as efficient bifunctional electrocatalysts for rechargeable zinc-air batteries," Energy, Elsevier, vol. 224(C).

    More about this item

    Keywords

    ;
    ;
    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:appene:v:264:y:2020:i:c:s0306261920301380. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/405891/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.