IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v17y2025i3p902-d1574146.html
   My bibliography  Save this article

Integration of Vapor Compression and Thermoelectric Cooling Systems for Enhanced Refrigeration Performance

Author

Listed:
  • Tianqi Wang

    (National Key Laboratory of Automotive Chassis Integration and Bionics, Changchun 130022, China
    College of Automotive Engineering, Jilin University, Changchun 130022, China)

  • Mingjie Lv

    (National Key Laboratory of Automotive Chassis Integration and Bionics, Changchun 130022, China
    College of Automotive Engineering, Jilin University, Changchun 130022, China)

  • Yingai Jin

    (National Key Laboratory of Automotive Chassis Integration and Bionics, Changchun 130022, China
    College of Automotive Engineering, Jilin University, Changchun 130022, China)

  • Firoz Alam

    (School of Engineering (Aerospace, Mechanical and Manufacturing), RMIT University, Melbourne, VIC 3000, Australia)

Abstract

Refrigeration is vital in daily life and industries, traditionally relying on single-system cooling. The two predominant kinds of single-system cooling are vapor compression refrigeration (VCR) and thermoelectric cooling (TEC). Each of these two single systems has its own disadvantages, such as higher input energy requirements and lower efficiency. However, the effect of the integration of VCR and TEC for achieving higher cooling performance with lower energy input has not been well studied and reported in the existing literature. Therefore, the aim of this study is to conduct a thorough investigation into an integrated refrigeration system that combines VCR and TEC. This integration allows switching between systems based on specific requirements, leveraging the high coefficient of performance (COP) of VCR and the benefits of TEC. Three configurations have been studied, and each of them has three operating conditions: VCR alone, TEC alone, and TEC hybrid with VCR. Configuration I corresponds to the results from the individual refrigeration test. In Configuration II, the hot end of the thermoelectric cooling module is installed at the insulation layer between the TEC layer and the VCR compartment. In Configuration III, the cold end of the thermoelectric cooling module is positioned at the insulation layer between the TEC layer and the VCR compartment. Configuration III of the integrated system demonstrated good performance by reducing the time required to reach the target temperature. It took 40 min for TEC alone to reach a temperature of 11.1 °C, 13 min for VCR alone, and only 9.6 min for a hybrid system. The hybrid system shows increased versatility and potential for future applications, providing valuable insight into optimizing advanced cooling technologies. Furthermore, from an economic and sustainability standpoint, the proposed hybrid refrigeration system is advantageous and ambitious as it offers superior cooling capacity and greater efficiency than current refrigeration systems.

Suggested Citation

  • Tianqi Wang & Mingjie Lv & Yingai Jin & Firoz Alam, 2025. "Integration of Vapor Compression and Thermoelectric Cooling Systems for Enhanced Refrigeration Performance," Sustainability, MDPI, vol. 17(3), pages 1-28, January.
    • Handle: RePEc:gam:jsusta:v:17:y:2025:i:3:p:902-:d:1574146
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/17/3/902/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/17/3/902/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Meng, Fankai & Chen, Lingen & Feng, Yuanli & Xiong, Bing, 2017. "Thermoelectric generator for industrial gas phase waste heat recovery," Energy, Elsevier, vol. 135(C), pages 83-90.
    2. Pourkiaei, Seyed Mohsen & Ahmadi, Mohammad Hossein & Sadeghzadeh, Milad & Moosavi, Soroush & Pourfayaz, Fathollah & Chen, Lingen & Pour Yazdi, Mohammad Arab & Kumar, Ravinder, 2019. "Thermoelectric cooler and thermoelectric generator devices: A review of present and potential applications, modeling and materials," Energy, Elsevier, vol. 186(C).
    3. Kadam, Sambhaji T. & Kyriakides, Alexios-Spyridon & Khan, Muhammad Saad & Shehabi, Mohammad & Papadopoulos, Athanasios I. & Hassan, Ibrahim & Rahman, Mohammad Azizur & Seferlis, Panos, 2022. "Thermo-economic and environmental assessment of hybrid vapor compression-absorption refrigeration systems for district cooling," Energy, Elsevier, vol. 243(C).
    4. Li, Guoliang & Han, Youhua & Li, Ming & Luo, Xi & Xu, Yongfeng & Wang, Yunfeng & Zhang, Ying, 2021. "Study on matching characteristics of photovoltaic disturbance and refrigeration compressor in solar photovoltaic direct-drive air conditioning system," Renewable Energy, Elsevier, vol. 172(C), pages 1145-1153.
    5. Umberto Lucia & Giulia Grisolia, 2024. "Magnetocaloric Refrigeration in the Context of Sustainability: A Review of Thermodynamic Bases, the State of the Art, and Future Prospects," Energies, MDPI, vol. 17(14), pages 1-25, July.
    6. Hu, Zheng & Zhang, Chengbin & Chen, Yongping, 2024. "Experimental study of an absorption-based refrigeration driven by ocean thermal energy," Renewable Energy, Elsevier, vol. 236(C).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. F. P. Brito & João Silva Peixoto & Jorge Martins & António P. Gonçalves & Loucas Louca & Nikolaos Vlachos & Theodora Kyratsi, 2021. "Analysis and Design of a Silicide-Tetrahedrite Thermoelectric Generator Concept Suitable for Large-Scale Industrial Waste Heat Recovery," Energies, MDPI, vol. 14(18), pages 1-21, September.
    2. Chen, Lingen & Lorenzini, Giulio, 2023. "Heating load, COP and exergetic efficiency optimizations for TEG-TEH combined thermoelectric device with Thomson effect and external heat transfer," Energy, Elsevier, vol. 270(C).
    3. Song Lv & Zuoqin Qian & Dengyun Hu & Xiaoyuan Li & Wei He, 2020. "A Comprehensive Review of Strategies and Approaches for Enhancing the Performance of Thermoelectric Module," Energies, MDPI, vol. 13(12), pages 1-24, June.
    4. Fatih Selimefendigil & Hakan F. Oztop & Mikhail A. Sheremet, 2021. "Thermoelectric Generation with Impinging Nano-Jets," Energies, MDPI, vol. 14(2), pages 1-24, January.
    5. Ramadan, Mohamad & Murr, Rabih & Khaled, Mahmoud & Olabi, Abdul Ghani, 2018. "Mixed numerical - Experimental approach to enhance the heat pump performance by drain water heat recovery," Energy, Elsevier, vol. 149(C), pages 1010-1021.
    6. Duan, Mengfan & Sun, Hongli & Lin, Borong & Wu, Yifan, 2021. "Evaluation on the applicability of thermoelectric air cooling systems for buildings with thermoelectric material optimization," Energy, Elsevier, vol. 221(C).
    7. Chen, Lingen & Yang, Bo & Feng, Huijun & Ge, Yanlin & Xia, Shaojun, 2020. "Performance optimization of an open simple-cycle gas turbine combined cooling, heating and power plant driven by basic oxygen furnace gas in China's steelmaking plants," Energy, Elsevier, vol. 203(C).
    8. Zhang, Nan & Lu, Yiji & Kadam, Sambhaji & Yu, Zhibin, 2023. "A fuel cell range extender integrating with heat pump for cabin heat and power generation," Applied Energy, Elsevier, vol. 348(C).
    9. Maleki, Yaser & Pourfayaz, Fathollah & Mehrpooya, Mehdi, 2022. "Experimental study of a novel hybrid photovoltaic/thermal and thermoelectric generators system with dual phase change materials," Renewable Energy, Elsevier, vol. 201(P2), pages 202-215.
    10. Ahmed, Hossam A. & Megahed, Tamer F. & Mori, Shinsuke & Nada, Sameh & Hassan, Hamdy, 2023. "Novel design of thermo-electric air conditioning system integrated with PV panel for electric vehicles: Performance evaluation," Applied Energy, Elsevier, vol. 349(C).
    11. Liu, Haowen & Li, Guiqiang & Zhao, Xudong & Ma, Xiaoli & Shen, Chao, 2023. "Investigation of the impact of the thermoelectric geometry on the cooling performance and thermal—mechanic characteristics in a thermoelectric cooler," Energy, Elsevier, vol. 267(C).
    12. Yang, Kairan & Guo, Weimin & Zhang, Peng, 2024. "Cold energy transport and release characteristics of CO2+TBAB hydrate slurry flow with hydrate dissociation," Energy, Elsevier, vol. 294(C).
    13. Beltrán-Pitarch, Braulio & Maassen, Jesse & García-Cañadas, Jorge, 2021. "Comprehensive impedance spectroscopy equivalent circuit of a thermoelectric device which includes the internal thermal contact resistances," Applied Energy, Elsevier, vol. 299(C).
    14. Zhaochun Shi & Guohua Wang & Chunli Liu & Qiang Lv & Baoli Gong & Yingchao Zhang & Yuying Yan, 2023. "Optimizing the Transient Performance of Thermoelectric Generator with PCM by Taguchi Method," Energies, MDPI, vol. 16(2), pages 1-16, January.
    15. He, Junjie & Chu, Wenxiao & Wang, Qiuwang, 2025. "Applications of low melting point alloy for electronic thermal management: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 210(C).
    16. Rui Quan & Tao Li & Yousheng Yue & Yufang Chang & Baohua Tan, 2020. "Experimental Study on a Thermoelectric Generator for Industrial Waste Heat Recovery Based on a Hexagonal Heat Exchanger," Energies, MDPI, vol. 13(12), pages 1-14, June.
    17. Jian Li & Qingfeng Song & Ruiheng Liu & Hongliang Dong & Qihao Zhang & Xun Shi & Shengqiang Bai & Lidong Chen, 2022. "Thermoelectric Performance Optimization of n-Type La 3− x Sm x Te 4 /Ni Composites via Sm Doping," Energies, MDPI, vol. 15(7), pages 1-9, March.
    18. Miao, Zhuang & Meng, Xiangning & Zhou, Sen & Zhu, Miaoyong, 2020. "Thermo-mechanical analysis on thermoelectric legs arrangement of thermoelectric modules," Renewable Energy, Elsevier, vol. 147(P1), pages 2272-2278.
    19. Weng, Zebin & Liu, Furong & Zhu, Wenchao & Li, Yang & Xie, Changjun & Deng, Jian & Huang, Liang, 2022. "Performance improvement of variable-angle annular thermoelectric generators considering different boundary conditions," Applied Energy, Elsevier, vol. 306(PA).
    20. João Luiz de Medeiros Neto & Ronelly José De Souza & Carlos Antônio Cabral dos Santos & Jeane Batista de Carvalho & Daniel Nicolau Lima Alves, 2024. "Life Cycle Assessment and Exergoenvironmental Analysis of a Double-Effect Vapor Absorption Chiller Using Green Hydrogen, Natural Gas, and Biomethane," Sustainability, MDPI, vol. 17(1), pages 1-28, December.

    More about this item

    Keywords

    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:17:y:2025:i:3:p:902-:d:1574146. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.