IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v15y2023i10p7926-d1145178.html
   My bibliography  Save this article

Parabolic Air Collectors with an Evacuated Tube Containing Copper Tube and Spiral Strip, and a New Cavity Receiver: Experimental Performance Analysis

Author

Listed:
  • Ayad K. Khlief

    (Department of Electromechanical Engineering, University of Technology-Iraq, Ministry of Higher Education & Scientific Research, Baghdad 10066, Iraq)

  • Wisam Abed Kattea Al-Maliki

    (Mechanical Engineering Department, University of Technology-Iraq, Baghdad 10066, Iraq
    TU Darmstadt, Institut Energiesysteme und Energietechnik, Otto-Berndt-Straße 2, 64287 Darmstadt, Germany)

  • Hasanain A. Abdul Wahhab

    (Training and Workshop Center, University of Technology-Iraq, Baghdad 10066, Iraq)

  • Falah Alobaid

    (TU Darmstadt, Institut Energiesysteme und Energietechnik, Otto-Berndt-Straße 2, 64287 Darmstadt, Germany)

  • Bernd Epple

    (TU Darmstadt, Institut Energiesysteme und Energietechnik, Otto-Berndt-Straße 2, 64287 Darmstadt, Germany)

  • Akeel A. Abtan

    (Department of Electromechanical Engineering, University of Technology-Iraq, Ministry of Higher Education & Scientific Research, Baghdad 10066, Iraq)

Abstract

Sunray thermal energy is one of the most promising and quickly growing techniques globally. In parabolic trough air collectors (PTAC), receiver design and safety are of paramount importance because of their impact on the overall effectiveness of power plants. However, experimental studies of alternative receivers to improve heat transfer are still to be performed. In this study, a PTAC system was tested experimentally with an evacuated tube: open on one end, containing a copper tube and a spiral strip (case 1), and with a new cavity receiver consisting of several arranged tetragonal pyramidal elements (case 2). Afterward, the results were compared and showed a slightly superior exit air temperature and thermal efficiency performance for case 1. The overall results demonstrate a remarkable convergence of case 2 from case 1 in terms of temperature increase across PTAC, in which the maximum exit air temperature for case 1 is 58.2 °C, a 3.4% increase over case 2 at 0.0105 kg/s mass flow rate. Lastly, the results validate the potential and clarify the specific conclusions of these methods’ application in improving heat exchange in a PTAC.

Suggested Citation

  • Ayad K. Khlief & Wisam Abed Kattea Al-Maliki & Hasanain A. Abdul Wahhab & Falah Alobaid & Bernd Epple & Akeel A. Abtan, 2023. "Parabolic Air Collectors with an Evacuated Tube Containing Copper Tube and Spiral Strip, and a New Cavity Receiver: Experimental Performance Analysis," Sustainability, MDPI, vol. 15(10), pages 1-17, May.
    • Handle: RePEc:gam:jsusta:v:15:y:2023:i:10:p:7926-:d:1145178
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/15/10/7926/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/15/10/7926/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Fuqiang, Wang & Zhexiang, Tang & Xiangtao, Gong & Jianyu, Tan & Huaizhi, Han & Bingxi, Li, 2016. "Heat transfer performance enhancement and thermal strain restrain of tube receiver for parabolic trough solar collector by using asymmetric outward convex corrugated tube," Energy, Elsevier, vol. 114(C), pages 275-292.
    2. Kim, Yong & Seo, Taebeom, 2007. "Thermal performances comparisons of the glass evacuated tube solar collectors with shapes of absorber tube," Renewable Energy, Elsevier, vol. 32(5), pages 772-795.
    3. Wisam Abed Kattea Al-Maliki & Hayder Q. A. Khafaji & Hasanain A. Abdul Wahhab & Hussein M. H. Al-Khafaji & Falah Alobaid & Bernd Epple, 2022. "Advances in Process Modelling and Simulation of Parabolic Trough Power Plants: A Review," Energies, MDPI, vol. 15(15), pages 1-15, July.
    4. Fernández-García, Aránzazu & Valenzuela, Loreto & Zarza, Eduardo & Rojas, Esther & Pérez, Manuel & Hernández-Escobedo, Quetzalcoatl & Manzano-Agugliaro, Francisco, 2018. "SMALL-SIZED parabolic-trough solar collectors: Development of a test loop and evaluation of testing conditions," Energy, Elsevier, vol. 152(C), pages 401-415.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Yang, Honglun & Wang, Qiliang & Huang, Xiaona & Li, Jing & Pei, Gang, 2018. "Performance study and comparative analysis of traditional and double-selective-coated parabolic trough receivers," Energy, Elsevier, vol. 145(C), pages 206-216.
    2. Kaya, Hüseyin & Arslan, Kamil & Eltugral, Nurettin, 2018. "Experimental investigation of thermal performance of an evacuated U-Tube solar collector with ZnO/Etylene glycol-pure water nanofluids," Renewable Energy, Elsevier, vol. 122(C), pages 329-338.
    3. Bitam, El Wardi & Demagh, Yassine & Hachicha, Ahmed A. & Benmoussa, Hocine & Kabar, Yassine, 2018. "Numerical investigation of a novel sinusoidal tube receiver for parabolic trough technology," Applied Energy, Elsevier, vol. 218(C), pages 494-510.
    4. Naghavi, M.S. & Ong, K.S. & Badruddin, I.A. & Mehrali, Mohammad & Metselaar, H.S.C., 2017. "Thermal performance of a compact design heat pipe solar collector with latent heat storage in charging/discharging modes," Energy, Elsevier, vol. 127(C), pages 101-115.
    5. Evangelisti, Luca & De Lieto Vollaro, Roberto & Asdrubali, Francesco, 2019. "Latest advances on solar thermal collectors: A comprehensive review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 114(C), pages 1-1.
    6. Mwesigye, Aggrey & Meyer, Josua P., 2017. "Optimal thermal and thermodynamic performance of a solar parabolic trough receiver with different nanofluids and at different concentration ratios," Applied Energy, Elsevier, vol. 193(C), pages 393-413.
    7. Shukla, Ruchi & Sumathy, K. & Erickson, Phillip & Gong, Jiawei, 2013. "Recent advances in the solar water heating systems: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 19(C), pages 173-190.
    8. Gang Pei & Guiqiang Li & Xi Zhou & Jie Ji & Yuehong Su, 2012. "Comparative Experimental Analysis of the Thermal Performance of Evacuated Tube Solar Water Heater Systems With and Without a Mini-Compound Parabolic Concentrating (CPC) Reflector( C," Energies, MDPI, vol. 5(4), pages 1-14, April.
    9. Kumaresan, G. & Sudhakar, P. & Santosh, R. & Velraj, R., 2017. "Experimental and numerical studies of thermal performance enhancement in the receiver part of solar parabolic trough collectors," Renewable and Sustainable Energy Reviews, Elsevier, vol. 77(C), pages 1363-1374.
    10. Ju, Xing & Abd El-Samie, Mostafa M. & Xu, Chao & Yu, Hangyu & Pan, Xinyu & Yang, Yongping, 2020. "A fully coupled numerical simulation of a hybrid concentrated photovoltaic/thermal system that employs a therminol VP-1 based nanofluid as a spectral beam filter," Applied Energy, Elsevier, vol. 264(C).
    11. Ajbar, Wassila & Parrales, A. & Huicochea, A. & Hernández, J.A., 2022. "Different ways to improve parabolic trough solar collectors’ performance over the last four decades and their applications: A comprehensive review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 156(C).
    12. Amit K. Bhakta & Nitesh K. Panday & Shailendra N. Singh, 2018. "Performance Study of a Cylindrical Parabolic Concentrating Solar Water Heater with Nail Type Twisted Tape Inserts in the Copper Absorber Tube," Energies, MDPI, vol. 11(1), pages 1-15, January.
    13. Shafieian, Abdellah & Khiadani, Mehdi & Nosrati, Ataollah, 2018. "A review of latest developments, progress, and applications of heat pipe solar collectors," Renewable and Sustainable Energy Reviews, Elsevier, vol. 95(C), pages 273-304.
    14. Tabish Alam & Nagesh Babu Balam & Kishor Sitaram Kulkarni & Md Irfanul Haque Siddiqui & Nishant Raj Kapoor & Chandan Swaroop Meena & Ashok Kumar & Raffaello Cozzolino, 2021. "Performance Augmentation of the Flat Plate Solar Thermal Collector: A Review," Energies, MDPI, vol. 14(19), pages 1-23, September.
    15. Kim, Hyeongmin & Ham, Jeonggyun & Park, Chasik & Cho, Honghyun, 2016. "Theoretical investigation of the efficiency of a U-tube solar collector using various nanofluids," Energy, Elsevier, vol. 94(C), pages 497-507.
    16. Akbarzadeh, Sanaz & Valipour, Mohammad Sadegh, 2020. "Energy and exergy analysis of a parabolic trough collector using helically corrugated absorber tube," Renewable Energy, Elsevier, vol. 155(C), pages 735-747.
    17. Srinivas, Morapakala, 2011. "Domestic solar hot water systems: Developments, evaluations and essentials for “viability” with a special reference to India," Renewable and Sustainable Energy Reviews, Elsevier, vol. 15(8), pages 3850-3861.
    18. Halimi, Mohammed & El Amrani, Aumeur & Messaoudi, Choukri, 2021. "New experimental investigation of the circumferential temperature uniformity for a PTC absorber," Energy, Elsevier, vol. 234(C).
    19. Younus Hamoudi Assaf & Abdulrazzak Akroot & Hasanain A. Abdul Wahhab & Wadah Talal & Mothana Bdaiwi & Mohammed Y. Nawaf, 2023. "Impact of Nano Additives in Heat Exchangers with Twisted Tapes and Rings to Increase Efficiency: A Review," Sustainability, MDPI, vol. 15(10), pages 1-17, May.
    20. Fathabadi, Hassan, 2020. "Novel solar collector: Evaluating the impact of nanoparticles added to the collector’s working fluid, heat transfer fluid temperature and flow rate," Renewable Energy, Elsevier, vol. 148(C), pages 1165-1173.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:15:y:2023:i:10:p:7926-:d:1145178. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.