IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v9y2016i10p846-d80971.html
   My bibliography  Save this article

Use of a Pre-Drilled Hole for Implementing Thermal Needle Probe Method for Soils and Rocks

Author

Listed:
  • So-Jung Lee

    (Department of Civil and Environmental Engineering, Korea Advanced Institute of Science and Technology (KAIST), Daejeon 34141, Korea)

  • Jung-Chan Choi

    (Norwegian Geotechnical Institute (NGI), Oslo N-0806, Norway)

  • Seunghun Baek

    (Department of Civil and Environmental Engineering, Korea Advanced Institute of Science and Technology (KAIST), Daejeon 34141, Korea)

  • Tae-Hyuk Kwon

    (Department of Civil and Environmental Engineering, Korea Advanced Institute of Science and Technology (KAIST), Daejeon 34141, Korea)

  • Hee-Hwan Ryu

    (Power Transmission Laboratory, Korea Electric Power Research Institute, Daejeon 34056, Korea)

  • Ki-Il Song

    (Department of Civil Engineering, Inha University, Incheon 22212, Korea)

Abstract

The thermal needle probe method, which is widely used for measuring the thermal conductivity λ of soils, deploys a long and thin metallic probe that houses a line heater and a temperature sensor. However, inserting such probes into consolidated or densely compacted soils or rocks is difficult, frequently causing buckling of the probe and severe disturbance to the surrounding ground, leading to unreliable measurements. We found that the use of a pre-drilled hole filled with thermally conductive grease for installing a thermal needle probe was feasible to overcome such challenges, and still yielded reliable measurements of thermal conductivity. The proposed method, i.e., the pre-drilling thermal needle probe method, was verified by finite element calculations and laboratory experiments by varying various parameters, such as the pre-drilled hole diameter, probe diameter, and thermal conductivity of thermal grease. It was observed that increases in the pre-drilled hole diameter and probe diameter and a decrease in the thermal conductivity of the thermal grease caused delays in temperature increase owing to the slowed heat transfer. Nevertheless, all the estimated λ values agreed well with the reference λ values with acceptable errors. Thus, the proposed method yields reliable measurements and can be applied for a wide range of soils from compacted soils to hard rocks.

Suggested Citation

  • So-Jung Lee & Jung-Chan Choi & Seunghun Baek & Tae-Hyuk Kwon & Hee-Hwan Ryu & Ki-Il Song, 2016. "Use of a Pre-Drilled Hole for Implementing Thermal Needle Probe Method for Soils and Rocks," Energies, MDPI, vol. 9(10), pages 1-10, October.
    • Handle: RePEc:gam:jeners:v:9:y:2016:i:10:p:846-:d:80971
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/9/10/846/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/9/10/846/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Yoon, Seok & Lee, Seung-Rae & Go, Gyu-Hyun, 2014. "A numerical and experimental approach to the estimation of borehole thermal resistance in ground heat exchangers," Energy, Elsevier, vol. 71(C), pages 547-555.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Linlin Zhang & Zhonghua Shi & Tianhao Yuan, 2020. "Study on the Coupled Heat Transfer Model Based on Groundwater Advection and Axial Heat Conduction for the Double U-Tube Vertical Borehole Heat Exchanger," Sustainability, MDPI, vol. 12(18), pages 1-19, September.
    2. Bi, Yuehong & Lyu, Tianli & Wang, Hongyan & Sun, Ruirui & Yu, Meize, 2019. "Parameter analysis of single U-tube GHE and dynamic simulation of underground temperature field round one year for GSHP," Energy, Elsevier, vol. 174(C), pages 138-147.
    3. Hu, Jinzhong, 2017. "An improved analytical model for vertical borehole ground heat exchanger with multiple-layer substrates and groundwater flow," Applied Energy, Elsevier, vol. 202(C), pages 537-549.
    4. Zhang, Changxing & Lu, Jiahui & Wang, Xinjie & Xu, Hang & Sun, Shicai, 2022. "Effect of geological stratification on estimated accuracy of ground thermal parameters in thermal response test," Renewable Energy, Elsevier, vol. 186(C), pages 585-595.
    5. Zhang, Changxing & Song, Wei & Sun, Shicai & Peng, Donggen, 2015. "Parameter estimation of in-situ thermal response test with unstable heat rate," Energy, Elsevier, vol. 88(C), pages 497-505.
    6. Zhang, Changxing & Xu, Hang & Fan, Jianhua & Sun, Pengkun & Sun, Shicai & Kong, Xiangqiang, 2020. "The coupled two-step parameter estimation procedure for borehole thermal resistance in thermal response test," Renewable Energy, Elsevier, vol. 154(C), pages 672-683.
    7. Habibi, Mohammad & Aligolzadeh, Farid & Hakkaki-Fard, Ali, 2020. "A techno-economic analysis of geothermal ejector cooling system," Energy, Elsevier, vol. 193(C).
    8. Yoon, Seok & Lee, Seung-Rae & Kim, Min-Jun & Kim, Woo-Jin & Kim, Geon-Young & Kim, Kyungsu, 2016. "Evaluation of stainless steel pipe performance as a ground heat exchanger in ground-source heat-pump system," Energy, Elsevier, vol. 113(C), pages 328-337.
    9. Dai, L.H. & Shang, Y. & Li, X.L. & Li, S.F., 2016. "Analysis on the transient heat transfer process inside and outside the borehole for a vertical U-tube ground heat exchanger under short-term heat storage," Renewable Energy, Elsevier, vol. 87(P3), pages 1121-1129.
    10. Zhang, Xueping & Han, Zongwei & Ji, Qiang & Zhang, Hongzhi & Li, Xiuming, 2021. "Thermal response tests for the identification of soil thermal parameters: A review," Renewable Energy, Elsevier, vol. 173(C), pages 1123-1135.
    11. Javadi, Hossein & Mousavi Ajarostaghi, Seyed Soheil & Rosen, Marc A. & Pourfallah, Mohsen, 2019. "Performance of ground heat exchangers: A comprehensive review of recent advances," Energy, Elsevier, vol. 178(C), pages 207-233.
    12. Go, Gyu-Hyun & Lee, Seung-Rae & N.V., Nikhil & Yoon, Seok, 2015. "A new performance evaluation algorithm for horizontal GCHPs (ground coupled heat pump systems) that considers rainfall infiltration," Energy, Elsevier, vol. 83(C), pages 766-777.
    13. Choi, Wonjun & Kikumoto, Hideki & Ooka, Ryozo, 2022. "Probabilistic uncertainty quantification of borehole thermal resistance in real-world scenarios," Energy, Elsevier, vol. 254(PC).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:9:y:2016:i:10:p:846-:d:80971. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.