IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v17y2024i3p618-d1327686.html
   My bibliography  Save this article

Evaluation Method and Analysis on Performance of Diffuser in Heat Storage Tank

Author

Listed:
  • Lihua Cao

    (Department of Energy and Power Engineering, Northeast Electric Power University, Jilin 132013, China)

  • Jingwen Yu

    (Department of Energy and Power Engineering, Northeast Electric Power University, Jilin 132013, China
    State Grid Jilin Electric Power Research Institute, Changchun 130021, China)

  • Xifeng Liu

    (Department of Energy and Power Engineering, Northeast Electric Power University, Jilin 132013, China)

  • Zhanzhou Wang

    (Department of Energy and Power Engineering, Northeast Electric Power University, Jilin 132013, China)

Abstract

The diffuser is a critical component in a heat storage tank, and its structure has an important influence on the thermal performance of the heat storage tank. At present, research on the structure of diffusers often focuses on the change of one single parameter, which results in the need for a comprehensive structure analysis of diffusers in heat storage tanks. This paper comprehensively considers the inlet diameter, hole distance, and hole diameter of the diffuser and the inlet conditions of the heat storage tank. Then, a new evaluation index, namely the non-uniformity coefficient of the diffuser, is proposed. The experiments verify the accuracy of numerical calculation, and the related empirical formula is summarized finally. The results show that the diffuser with a small non-uniformity coefficient can achieve thin temperature stratification and higher exergy efficiency. In other words, the non-uniformity coefficient is in good agreement with temperature stratification and the exergy efficiency of the heat storage tank. When the flow rate of the inlet device is 0.5 m/s, the exergy efficiency increases by nearly 30 percentage points and the non-uniformity coefficient of the No. 4 diffuser is 3.39%. In contrast, that of the No. 8 diffuser is 75.17%. This evaluation index is suitable for different diffuser types with high accuracy. It provides the theoretical and experimental basis for the structural design and selection of diffusers for heat storage tanks.

Suggested Citation

  • Lihua Cao & Jingwen Yu & Xifeng Liu & Zhanzhou Wang, 2024. "Evaluation Method and Analysis on Performance of Diffuser in Heat Storage Tank," Energies, MDPI, vol. 17(3), pages 1-15, January.
  • Handle: RePEc:gam:jeners:v:17:y:2024:i:3:p:618-:d:1327686
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/17/3/618/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/17/3/618/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Arkadiusz Szczęśniak & Jarosław Milewski & Olaf Dybiński & Kamil Futyma & Jakub Skibiński & Aliaksandr Martsinchyk & Łukasz Szabłowski, 2023. "Determination of Thermocline Heat Transfer Coefficient by Using CFD Simulation," Energies, MDPI, vol. 16(7), pages 1-14, March.
    2. Szczęśniak, Arkadiusz & Milewski, Jarosław & Dybiński, Olaf & Futyma, Kamil & Skibiński, Jakub & Martsinchyk, Aliaksandr, 2023. "Dynamic simulation of a four tank 200 m3 seasonal thermal energy storage system oriented to air conditioning at a dietary supplements factory," Energy, Elsevier, vol. 264(C).
    3. Hegazy, Adel A., 2007. "Effect of inlet design on the performance of storage-type domestic electrical water heaters," Applied Energy, Elsevier, vol. 84(12), pages 1338-1355, December.
    4. Wang, Zilong & Zhang, Hua & Dou, Binlin & Huang, Huajie & Wu, Weidong & Wang, Zhiyun, 2017. "Experimental and numerical research of thermal stratification with a novel inlet in a dynamic hot water storage tank," Renewable Energy, Elsevier, vol. 111(C), pages 353-371.
    5. Han, Y.M. & Wang, R.Z. & Dai, Y.J., 2009. "Thermal stratification within the water tank," Renewable and Sustainable Energy Reviews, Elsevier, vol. 13(5), pages 1014-1026, June.
    6. Pilotelli, M. & Grassi, B. & Lezzi, A.M. & Beretta, G.P., 2022. "Flow models of perforated manifolds and plates for the design of a large thermal storage tank for district heating with minimal maldistribution and thermocline growth," Applied Energy, Elsevier, vol. 322(C).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Agnieszka Malec & Tomasz Cholewa & Alicja Siuta-Olcha, 2021. "Influence of Cold Water Inlets and Obstacles on the Energy Efficiency of the Hot Water Production Process in a Hot Water Storage Tank," Energies, MDPI, vol. 14(20), pages 1-26, October.
    2. Kicsiny, Richárd, 2018. "Black-box model for solar storage tanks based on multiple linear regression," Renewable Energy, Elsevier, vol. 125(C), pages 857-865.
    3. De la Cruz-Loredo, Iván & Zinsmeister, Daniel & Licklederer, Thomas & Ugalde-Loo, Carlos E. & Morales, Daniel A. & Bastida, Héctor & Perić, Vedran S. & Saleem, Arslan, 2023. "Experimental validation of a hybrid 1-D multi-node model of a hot water thermal energy storage tank," Applied Energy, Elsevier, vol. 332(C).
    4. Yang, Tianrun & Liu, Wen & Kramer, Gert Jan & Sun, Qie, 2021. "Seasonal thermal energy storage: A techno-economic literature review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 139(C).
    5. Mawire, Ashmore, 2013. "Experimental and simulated thermal stratification evaluation of an oil storage tank subjected to heat losses during charging," Applied Energy, Elsevier, vol. 108(C), pages 459-465.
    6. Kurşun, Burak & Ökten, Korhan, 2018. "Effect of rectangular hot water tank position and aspect ratio on thermal stratification enhancement," Renewable Energy, Elsevier, vol. 116(PA), pages 639-646.
    7. Yunshen Zhang & Yun Guo & Jiaao Zhu & Weijian Yuan & Feng Zhao, 2024. "New Advances in Materials, Applications, and Design Optimization of Thermocline Heat Storage: Comprehensive Review," Energies, MDPI, vol. 17(10), pages 1-41, May.
    8. Liang, Haobin & Liu, Liu & Zhong, Ziwen & Gan, Yixiang & Wu, Jian-Yong & Niu, Jianlei, 2022. "Towards idealized thermal stratification in a novel phase change emulsion storage tank," Applied Energy, Elsevier, vol. 310(C).
    9. Li, Qiong & Huang, Xiaoqiao & Tai, Yonghang & Gao, Wenfeng & Wenxian, L. & Liu, Wuming, 2021. "Thermal stratification in a solar hot water storage tank with mantle heat exchanger," Renewable Energy, Elsevier, vol. 173(C), pages 1-11.
    10. Miguel A. Gómez & Sergio Chapela & Joaquín Collazo & José L. Míguez, 2019. "CFD Analysis of a Buffer Tank Redesigned with a Thermosyphon Concentrator Tube," Energies, MDPI, vol. 12(11), pages 1-17, June.
    11. Li, Gang, 2016. "Sensible heat thermal storage energy and exergy performance evaluations," Renewable and Sustainable Energy Reviews, Elsevier, vol. 53(C), pages 897-923.
    12. Mawire, Ashmore & Taole, Simeon H., 2011. "A comparison of experimental thermal stratification parameters for an oil/pebble-bed thermal energy storage (TES) system during charging," Applied Energy, Elsevier, vol. 88(12), pages 4766-4778.
    13. Dahash, Abdulrahman & Ochs, Fabian & Janetti, Michele Bianchi & Streicher, Wolfgang, 2019. "Advances in seasonal thermal energy storage for solar district heating applications: A critical review on large-scale hot-water tank and pit thermal energy storage systems," Applied Energy, Elsevier, vol. 239(C), pages 296-315.
    14. Chandra, Yogender Pal & Matuska, Tomas, 2020. "Numerical prediction of the stratification performance in domestic hot water storage tanks," Renewable Energy, Elsevier, vol. 154(C), pages 1165-1179.
    15. María Gasque & Federico Ibáñez & Pablo González-Altozano, 2021. "Minimum Number of Experimental Data for the Thermal Characterization of a Hot Water Storage Tank," Energies, MDPI, vol. 14(16), pages 1-16, August.
    16. Osorio, J.D. & Rivera-Alvarez, A. & Swain, M. & Ordonez, J.C., 2015. "Exergy analysis of discharging multi-tank thermal energy storage systems with constant heat extraction," Applied Energy, Elsevier, vol. 154(C), pages 333-343.
    17. Saloux, E. & Candanedo, J.A., 2019. "Modelling stratified thermal energy storage tanks using an advanced flowrate distribution of the received flow," Applied Energy, Elsevier, vol. 241(C), pages 34-45.
    18. Gao, Jinshuang & Li, Sheng & Wu, Fan & Jiang, Long & Zhao, Yazhou & Zhang, Xuejun, 2024. "Study on efficient heating method by solar coupled air source heat pump system with phase change heat storage in severe cold region," Applied Energy, Elsevier, vol. 367(C).
    19. Baeten, Brecht & Confrey, Thomas & Pecceu, Sébastien & Rogiers, Frederik & Helsen, Lieve, 2016. "A validated model for mixing and buoyancy in stratified hot water storage tanks for use in building energy simulations," Applied Energy, Elsevier, vol. 172(C), pages 217-229.
    20. Porteiro, Jacobo & Míguez, José Luis & Crespo, Bárbara & López González, Luis María & De Lara, José, 2015. "Experimental investigation of the thermal response of a thermal storage tank partially filled with different PCMs (phase change materials) to a steep demand," Energy, Elsevier, vol. 91(C), pages 202-214.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:17:y:2024:i:3:p:618-:d:1327686. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.