IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v17y2024i20p5192-d1501702.html
   My bibliography  Save this article

Envelope Deficiencies and Thermo-Hygrometric Challenges in Warehouse-Type Buildings in Subtropical Climates: A Case Study of a Nori Distribution Center

Author

Listed:
  • Yue Xu

    (Department of Architecture, Faculty of Environmental Engineering, The University of Kitakyushu, Kitakyushu 808-0135, Japan)

  • Hiroatsu Fukuda

    (Department of Architecture, Faculty of Environmental Engineering, The University of Kitakyushu, Kitakyushu 808-0135, Japan)

  • Xindong Wei

    (School of International Education, Jilin Jianzhu University, Changchun 130118, China)

  • Tingting Yin

    (Department of Architecture, Faculty of Environmental Engineering, The University of Kitakyushu, Kitakyushu 808-0135, Japan)

Abstract

Enhancing the energy efficiency and climate resilience of existing buildings is crucial amid growing environmental challenges. While extensive research has focused on non-residential buildings, studies on thermo-hygrometric conditions in warehouse-type buildings, particularly in subtropical climates, remain limited. This study investigated the impact of building envelope deficiencies on indoor thermal and moisture regulation at the Nori Distribution Center. Using infrared thermal imaging and long-term environmental monitoring, significant thermo-hygrometric fluctuations were identified, primarily due to design and construction deficiencies. Poor insulation, inadequate sealing, and the lack of moisture barriers contributed to unstable indoor temperature and humidity. Seasonal analysis showed that during summer, the median second-floor air temperature reached 28.8 °C, peaking at 39.2 °C, with relative humidity exceeding 70% for 45% of the time. First-floor relative humidity surpassed 70% for 72% of the time. While condensation risk remains low year-round, it increases significantly with air infiltration through gaps in the building envelope. This study recommends enhancing the sealing of the building envelope, upgrading insulation materials and moisture barriers, particularly in the roof, and optimizing the HVAC system to improve energy efficiency and storage conditions. These findings offer valuable recommendations for retrofitting warehouse-type buildings in subtropical climates to improve energy efficiency and climate resilience.

Suggested Citation

  • Yue Xu & Hiroatsu Fukuda & Xindong Wei & Tingting Yin, 2024. "Envelope Deficiencies and Thermo-Hygrometric Challenges in Warehouse-Type Buildings in Subtropical Climates: A Case Study of a Nori Distribution Center," Energies, MDPI, vol. 17(20), pages 1-32, October.
    • Handle: RePEc:gam:jeners:v:17:y:2024:i:20:p:5192-:d:1501702
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/17/20/5192/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/17/20/5192/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Xu, J. & Li, Y. & Wang, R.Z. & Liu, W. & Zhou, P., 2015. "Experimental performance of evaporative cooling pad systems in greenhouses in humid subtropical climates," Applied Energy, Elsevier, vol. 138(C), pages 291-301.
    2. Ma, Zhihao & Cui, Shuang & Chen, Jianli, 2024. "Demand response through ventilation and latent load adjustment for commercial buildings in humid climate zones," Applied Energy, Elsevier, vol. 373(C).
    3. Avanzini, Marcello & Pinheiro, Manuel Duarte & Gomes, Ricardo & Rolim, Catarina, 2022. "Energy retrofit as an answer to public health costs of fuel poverty in Lisbon social housing," Energy Policy, Elsevier, vol. 160(C).
    4. Iole Nardi & Elena Lucchi, 2023. "In Situ Thermal Transmittance Assessment of the Building Envelope: Practical Advice and Outlooks for Standard and Innovative Procedures," Energies, MDPI, vol. 16(8), pages 1-31, April.
    5. Gu, Jinxiang & Goetschalckx, Marc & McGinnis, Leon F., 2010. "Research on warehouse design and performance evaluation: A comprehensive review," European Journal of Operational Research, Elsevier, vol. 203(3), pages 539-549, June.
    6. Gourlis, Georgios & Kovacic, Iva, 2016. "A study on building performance analysis for energy retrofit of existing industrial facilities," Applied Energy, Elsevier, vol. 184(C), pages 1389-1399.
    7. Dawei Xia & Weien Xie & Jialiang Guo & Yukai Zou & Zhuotong Wu & Yini Fan, 2023. "Building Thermal and Energy Performance of Subtropical Terraced Houses under Future Climate Uncertainty," Sustainability, MDPI, vol. 15(16), pages 1-22, August.
    8. Wanghee Cho & Shizuo Iwamoto & Shinsuke Kato, 2016. "Condensation Risk Due to Variations in Airtightness and Thermal Insulation of an Office Building in Warm and Wet Climate," Energies, MDPI, vol. 9(11), pages 1-25, October.
    9. Luca Evangelisti & Leone Barbaro & Claudia Guattari & Edoardo De Cristo & Roberto De Lieto Vollaro & Francesco Asdrubali, 2024. "Comparison between Direct and Indirect Heat Flux Measurement Techniques: Preliminary Laboratory Tests," Energies, MDPI, vol. 17(12), pages 1-16, June.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Julia Reisinger & Patrick Hollinsky & Iva Kovacic, 2021. "Design Guideline for Flexible Industrial Buildings Integrating Industry 4.0 Parameters," Sustainability, MDPI, vol. 13(19), pages 1-24, September.
    2. Sihyun Park & Seung-Yeong Song, 2019. "Evaluation of Alternatives for Improving the Thermal Resistance of Window Glazing Edges," Energies, MDPI, vol. 12(2), pages 1-18, January.
    3. Nilendra Singh Pawar & Subir S. Rao & Gajendra K. Adil, 2024. "Improving Order-Picking Performance in E-Commerce Warehouses through Entropy-Based Hierarchical Scattering," Sustainability, MDPI, vol. 16(14), pages 1-27, July.
    4. Thierry Sauvage & Tony Cragg & Sarrah Chraibi & Oussama El Khalil Houssaini, 2018. "Running the Machine Faster: Acceleration, Humans and Warehousing," Post-Print hal-02905068, HAL.
    5. Janka Saderova & Andrea Rosova & Marian Sofranko & Peter Kacmary, 2021. "Example of Warehouse System Design Based on the Principle of Logistics," Sustainability, MDPI, vol. 13(8), pages 1-16, April.
    6. Nada, S.A. & Elattar, H.F. & Mahmoud, M.A. & Fouda, A., 2020. "Performance enhancement and heat and mass transfer characteristics of direct evaporative building free cooling using corrugated cellulose papers," Energy, Elsevier, vol. 211(C).
    7. Doo-Yong Park & Hyun-Je Lee & Su-In Yun & Sang-Min Choi, 2021. "Simulation Analysis of Daylight Characteristics and Cooling Load Based on Performance Test of Covering Materials Used in Smart Farms," Energies, MDPI, vol. 14(19), pages 1-25, October.
    8. Eva Schito & Elena Lucchi, 2023. "Advances in the Optimization of Energy Use in Buildings," Sustainability, MDPI, vol. 15(18), pages 1-3, September.
    9. Jiang, Min & Leung, K.H. & Lyu, Zhongyuan & Huang, George Q., 2020. "Picking-replenishment synchronization for robotic forward-reserve warehouses," Transportation Research Part E: Logistics and Transportation Review, Elsevier, vol. 144(C).
    10. Alireza Karimi & Mostafa Mohajerani & Niloufar Alinasab & Fateme Akhlaghinezhad, 2024. "Integrating Machine Learning and Genetic Algorithms to Optimize Building Energy and Thermal Efficiency Under Historical and Future Climate Scenarios," Sustainability, MDPI, vol. 16(21), pages 1-30, October.
    11. Derhami, Shahab & Smith, Jeffrey S. & Gue, Kevin R., 2020. "A simulation-based optimization approach to design optimal layouts for block stacking warehouses," International Journal of Production Economics, Elsevier, vol. 223(C).
    12. Katrin Großmann & Helene Oettel & Leona Sandmann, 2024. "At the Intersection of Housing, Energy, and Mobility Poverty: Trapped in Social Exclusion," Energies, MDPI, vol. 17(8), pages 1-25, April.
    13. Tappia, Elena & Roy, Debjit & Melacini, Marco & De Koster, René, 2019. "Integrated storage-order picking systems: Technology, performance models, and design insights," European Journal of Operational Research, Elsevier, vol. 274(3), pages 947-965.
    14. Nils Boysen & Konrad Stephan & Felix Weidinger, 2019. "Manual order consolidation with put walls: the batched order bin sequencing problem," EURO Journal on Transportation and Logistics, Springer;EURO - The Association of European Operational Research Societies, vol. 8(2), pages 169-193, June.
    15. Gong, Xuewen & Li, Xiaoming & Qiu, Rangjian & Bo, Guokui & Ping, Yinglu & Xin, Qingsong & Ge, Jiankun, 2022. "Ventilation and irrigation management strategy for tomato cultivated in greenhouses," Agricultural Water Management, Elsevier, vol. 273(C).
    16. repec:plo:pone00:0239851 is not listed on IDEAS
    17. Yao, Haoyi & Liang, Jingkang & Wang, Yunfeng & Li, Ming & Fan, Fangling & Ma, Xun & Xiao, Xin, 2025. "The influence of photovoltaic modules on the greenhouse micro-environment - A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 210(C).
    18. Edoardo De Cristo & Luca Evangelisti & Leone Barbaro & Roberto De Lieto Vollaro & Francesco Asdrubali, 2025. "A Systematic Review of Green Roofs’ Thermal and Energy Performance in the Mediterranean Region," Energies, MDPI, vol. 18(10), pages 1-38, May.
    19. Gianluca Ruggieri & Francesca Andreolli & Paolo Zangheri, 2023. "A Policy Roadmap for the Energy Renovation of the Residential and Educational Building Stock in Italy," Energies, MDPI, vol. 16(3), pages 1-20, January.
    20. Boysen, Nils & Emde, Simon & Hoeck, Michael & Kauderer, Markus, 2015. "Part logistics in the automotive industry: Decision problems, literature review and research agenda," European Journal of Operational Research, Elsevier, vol. 242(1), pages 107-120.
    21. Shuyu Zhou & Yeming (Yale) Gong & René de Koster, 2016. "Designing self-storage warehouses with customer choice," International Journal of Production Research, Taylor & Francis Journals, vol. 54(10), pages 3080-3104, May.

    More about this item

    Keywords

    ;
    ;
    ;
    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:17:y:2024:i:20:p:5192-:d:1501702. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.