IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v17y2024i15p3638-d1441790.html
   My bibliography  Save this article

Investigation of a Modified Wells Turbine for Wave Energy Extraction

Author

Listed:
  • Mohammad Nasim Uddin

    (Department of Mechanical Engineering, North Carolina A&T State University, Greensboro, NC 27411, USA)

  • Frimpong Opoku

    (Department of Engineering, Mechanical Engineering Concentration, East Carolina University, E 5th Street, Greenville, NC 27858, USA)

  • Michael Atkinson

    (Air & Missile Defense Sector, Aerothermal Engineering Group, Johns Hopkins Applied Physics Laboratory, Laurel, MD 20723, USA)

Abstract

The Oscillating Water Column (OWC) is the most promising self-rectifying device for power generation from ocean waves; over the past decade, its importance has been rekindled. The bidirectional airflow inside the OWC drives the Wells turbine connected to a generator to harness energy. This study evaluated the aerodynamic performance of two hybrid airfoil (NACA0015 and NACA0025) blade designs with variable chord distribution along the span of a Wells turbine. The present work examines the aerodynamic impact of the variable chord turbine and compares it with one with a constant chord. Ideally, Wells rotor blades with variable chords perform better since they have an even axial velocity distribution on their leading edge. The variable chord rotor blade configurations differ from hub to tip with taper ratios (Chord at Tip/Chord at Hub) of 1.58 and 0.63. The computation is performed in ANSYS™ CFX 2023 R2 by solving three-dimensional, steady-state, incompressible Reynolds Averaged Navier–Stokes (RANS) equations coupled with a k-ω Shear Stress Transport (SST) turbulence model in a non-inertial reference frame rotating with the turbine. The accuracy of the numerical results was achieved by performing a grid independence study. A refined mesh showed good agreement with the available experimental and numerical data in terms of efficiency, torque, and pressure drop at different flow coefficients. A variable chord Wells turbine with a taper ratio of 1.58 had a peak efficiency of 59.6%, as opposed to the one with a taper ratio of 0.63, which had a peak efficiency of 58.2%; the constant chord Wells turbine only had a peak efficiency of 58.5%. Furthermore, the variable chord rotor with the higher taper ratio had a larger operating range than others. There are significant improvements in the aerodynamic performance of the modified Wells turbine, compared to the conventional Wells turbine, which makes it suitable for wave energy harvesting. The flow field investigation around the turbine blades was conducted and analyzed.

Suggested Citation

  • Mohammad Nasim Uddin & Frimpong Opoku & Michael Atkinson, 2024. "Investigation of a Modified Wells Turbine for Wave Energy Extraction," Energies, MDPI, vol. 17(15), pages 1-26, July.
    • Handle: RePEc:gam:jeners:v:17:y:2024:i:15:p:3638-:d:1441790
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/17/15/3638/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/17/15/3638/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Das, Tapas K. & Samad, Abdus, 2020. "Influence of stall fences on the performance of Wells turbine," Energy, Elsevier, vol. 194(C).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Kotb, Ahmed T.M. & Nawar, Mohamed A.A. & Attai, Youssef A. & Mohamed, Mohamed H., 2023. "Performance enhancement of a Wells turbine using CFD-optimization algorithms coupling," Energy, Elsevier, vol. 282(C).
    2. Morais, F.J.F. & Carrelhas, A.A.D. & Gato, L.M.C., 2023. "Biplane-rotor Wells turbine: The influence of solidity, presence of guide vanes and comparison with other configurations," Energy, Elsevier, vol. 276(C).
    3. Mustafa Özden & Mustafa Serdar Genç & Kemal Koca, 2023. "Passive Flow Control Application Using Single and Double Vortex Generator on S809 Wind Turbine Airfoil," Energies, MDPI, vol. 16(14), pages 1-17, July.
    4. Valizadeh, Reza & Abbaspour, Madjid & Rahni, Mohammad Taeibi, 2020. "A low cost Hydrokinetic Wells turbine system for oceanic surface waves energy harvesting," Renewable Energy, Elsevier, vol. 156(C), pages 610-623.
    5. Geng, Kaihe & Yang, Ce & Zhao, Ben & Zhao, Wei & Gao, Jianbing & Hu, Chenxing & Zhang, Hanzhi & Wu, Wangxia, 2023. "Residual circulation budget analysis in a Wells turbine with leading-edge micro-cylinders," Renewable Energy, Elsevier, vol. 216(C).
    6. Liu, Zhen & Xu, Chuanli & Zhang, Xiaoxia & Ning, Dezhi, 2023. "Experimental study on an isolated oscillating water column wave energy converting device in oblique waves," Renewable and Sustainable Energy Reviews, Elsevier, vol. 184(C).
    7. Mohammad Nasim Uddin & Yang Gao & Paul M. Akangah, 2024. "Computational Fluid Dynamics Simulation on Blade Geometry of Novel Axial FlowTurbine for Wave Energy Extraction," Energies, MDPI, vol. 17(14), pages 1-28, July.
    8. Geng, Kaihe & Yang, Ce & Hu, Chenxing & Li, Yanzhao & Yang, Changmao, 2022. "Numerical investigation on the loss audit of Wells turbine with exergy analysis," Renewable Energy, Elsevier, vol. 189(C), pages 273-287.
    9. Liu, Zhen & Xu, Chuanli & Kim, Kilwon & Li, Ming, 2022. "Experimental study on the overall performance of a model OWC system under the free-spinning mode in irregular waves," Energy, Elsevier, vol. 250(C).
    10. Licheri, Fabio & Ghisu, Tiziano & Cambuli, Francesco & Puddu, Pierpaolo, 2024. "Experimental reconstruction of the local flow field in a Wells turbine using a three-dimensional pressure probe," Energy, Elsevier, vol. 296(C).
    11. Ardaneh, Fatemeh & Abdolahifar, Abolfazl & Karimian, S.M.H., 2022. "Numerical analysis of the pitch angle effect on the performance improvement and flow characteristics of the 3-PB Darrieus vertical axis wind turbine," Energy, Elsevier, vol. 239(PD).
    12. Liu, Zhen & Xu, Chuanli & Kim, Kilwon & Choi, Jongsu & Hyun, Beom-soo, 2021. "An integrated numerical model for the chamber-turbine system of an oscillating water column wave energy converter," Renewable and Sustainable Energy Reviews, Elsevier, vol. 149(C).
    13. Kotb, Ahmed T.M. & Nawar, Mohamed A.A. & Attai, Youssef A. & Mohamed, Mohamed H., 2024. "Impact of tapered leading-edge micro-cylinder on the performance of wells turbine for wave energy conversion: CFD-optimization algorithms coupling study," Energy, Elsevier, vol. 293(C).
    14. Mohammad Nasim Uddin & Michael Atkinson & Frimpong Opoku, 2023. "CFD Investigation of a Hybrid Wells Turbine with Passive Flow Control," Energies, MDPI, vol. 16(9), pages 1-28, April.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:17:y:2024:i:15:p:3638-:d:1441790. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.