IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i8p3505-d1126191.html
   My bibliography  Save this article

Alternative Internal Configurations for Enhancing Heat Transfer in Telecommunication Cabinets

Author

Listed:
  • Antony Jobby

    (College of Science & Engineering, James Cook University, Townsville, QLD 4811, Australia)

  • Mehdi Khatamifar

    (College of Science & Engineering, James Cook University, Townsville, QLD 4811, Australia)

  • Wenxian Lin

    (College of Science & Engineering, James Cook University, Townsville, QLD 4811, Australia)

Abstract

Telecommunication systems have become a critical part of society which enables connectivity to many essential and trivial services. Consequently, telecommunication equipment is housed in cabinets to protect the electronics from a variety of hazards; one of which is temperature-related failure. Current practices use a notable amount of power for the thermal management of telecommunication cabinets which can be reduced by considering alternative methods of cooling. In this paper, experiments were carried out to investigate the effectiveness of different internal mounting configurations of electronic components on the thermal performance of a telecommunication cabinet. The investigation tested inclinations (0–90°), different staggered offsets (0–50 mm), changing stream-wise spacing (29–108 mm), and fan speed (with a Reynolds number in the range of 1604 to 5539). The experimental study revealed that heat transfer was enhanced by 9.99 % by altering component inclination to 90°, 25.90% by increasing stream-wise spacing from 29 mm to 108 mm, and 36.02% by increasing the Reynolds number from 1604 to 5539. However, the staggered arrangement of internal components decreased N u by 3.26% for the natural convection condition but increased by 5.69% for the forced convection condition over the tested range and increasing the centre offset of the staggered components with respect to the cabinet did not influence N u in any significant manner. Natural convection and forced convection also had notable influence on the heat transfer rate. Hence it was seen that alternative internal configurations positively influence heat transfer in telecommunication cabinets for the cases studied.

Suggested Citation

  • Antony Jobby & Mehdi Khatamifar & Wenxian Lin, 2023. "Alternative Internal Configurations for Enhancing Heat Transfer in Telecommunication Cabinets," Energies, MDPI, vol. 16(8), pages 1-19, April.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:8:p:3505-:d:1126191
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/8/3505/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/8/3505/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Jouhara, H. & Chauhan, A. & Nannou, T. & Almahmoud, S. & Delpech, B. & Wrobel, L.C., 2017. "Heat pipe based systems - Advances and applications," Energy, Elsevier, vol. 128(C), pages 729-754.
    2. Lubritto, C. & Petraglia, A. & Vetromile, C. & Curcuruto, S. & Logorelli, M. & Marsico, G. & D’Onofrio, A., 2011. "Energy and environmental aspects of mobile communication systems," Energy, Elsevier, vol. 36(2), pages 1109-1114.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Eui-Hyeok Song & Kye-Bock Lee & Seok-Ho Rhi & Kibum Kim, 2020. "Thermal and Flow Characteristics in a Concentric Annular Heat Pipe Heat Sink," Energies, MDPI, vol. 13(20), pages 1-15, October.
    2. Kravanja, Gregor & Zajc, Gašper & Knez, Željko & Škerget, Mojca & Marčič, Simon & Knez, Maša H., 2018. "Heat transfer performance of CO2, ethane and their azeotropic mixture under supercritical conditions," Energy, Elsevier, vol. 152(C), pages 190-201.
    3. Pei, Wansheng & Zhang, Mingyi & Li, Shuangyang & Lai, Yuanming & Dong, Yuanhong & Jin, Long, 2019. "Laboratory investigation of the efficiency optimization of an inclined two-phase closed thermosyphon in ambient cool energy utilization," Renewable Energy, Elsevier, vol. 133(C), pages 1178-1187.
    4. Liangyu Wu & Yingying Chen & Suchen Wu & Mengchen Zhang & Weibo Yang & Fangping Tang, 2018. "Visualization Study of Startup Modes and Operating States of a Flat Two-Phase Micro Thermosyphon," Energies, MDPI, vol. 11(9), pages 1-15, August.
    5. Shafieian, Abdellah & Khiadani, Mehdi & Nosrati, Ataollah, 2018. "A review of latest developments, progress, and applications of heat pipe solar collectors," Renewable and Sustainable Energy Reviews, Elsevier, vol. 95(C), pages 273-304.
    6. Sun, Xiaoqin & Zhang, Quan & Medina, Mario A. & Liao, Shuguang, 2015. "Performance of a free-air cooling system for telecommunications base stations using phase change materials (PCMs): In-situ tests," Applied Energy, Elsevier, vol. 147(C), pages 325-334.
    7. Sun, Hongli & Duan, Mengfan & Wu, Yifan & Lin, Borong & Yang, Zixu & Zhao, Haitian, 2021. "Thermal performance investigation of a novel heating terminal integrated with flat heat pipe and heat transfer enhancement," Energy, Elsevier, vol. 236(C).
    8. Xu, Yanyan & Xue, Yanqin & Qi, Hong & Cai, Weihua, 2021. "An updated review on working fluids, operation mechanisms, and applications of pulsating heat pipes," Renewable and Sustainable Energy Reviews, Elsevier, vol. 144(C).
    9. Hei, Yong Qiang & Zhang, Cong & Shi, Guang Ming, 2018. "Trade-off optimization between energy efficiency and spectral efficiency in large scale MIMO systems," Energy, Elsevier, vol. 145(C), pages 747-753.
    10. Cesare Caputo & Ondřej Mašek, 2021. "SPEAR (Solar Pyrolysis Energy Access Reactor): Theoretical Design and Evaluation of a Small-Scale Low-Cost Pyrolysis Unit for Implementation in Rural Communities," Energies, MDPI, vol. 14(8), pages 1-27, April.
    11. Spagnuolo, Antonio & Petraglia, Antonio & Vetromile, Carmela & Formosi, Roberto & Lubritto, Carmine, 2015. "Monitoring and optimization of energy consumption of base transceiver stations," Energy, Elsevier, vol. 81(C), pages 286-293.
    12. Jouhara, Hussam & Almahmoud, Sulaiman & Chauhan, Amisha & Delpech, Bertrand & Bianchi, Giuseppe & Tassou, Savvas A. & Llera, Rocio & Lago, Francisco & Arribas, Juan José, 2017. "Experimental and theoretical investigation of a flat heat pipe heat exchanger for waste heat recovery in the steel industry," Energy, Elsevier, vol. 141(C), pages 1928-1939.
    13. Meng, Fanxi & Zhang, Quan & Lin, Yaolin & Zou, Sikai & Fu, Jiyao & Liu, Baochang & Wang, Wei & Ma, Xiaowei & Du, Sheng, 2022. "Field study on the performance of a thermosyphon and mechanical refrigeration hybrid cooling system in a 5G telecommunication base station," Energy, Elsevier, vol. 252(C).
    14. Llera, Rocio & Vigil, Miguel & Díaz-Díaz, Sara & Martínez Huerta, Gemma Marta, 2022. "Prospective environmental and techno-economic assessment of steam production by means of heat pipes in the steel industry," Energy, Elsevier, vol. 239(PD).
    15. Bonilla-Campos, Iñigo & Nieto, Nerea & del Portillo-Valdes, Luis & Manzanedo, Jaio & Gaztañaga, Haizea, 2020. "Energy efficiency optimisation in industrial processes: Integral decision support tool," Energy, Elsevier, vol. 191(C).
    16. Zhang, Yaxi & Zhu, Na & Zhao, Xudong & Luo, Zhenyu & Hu, Pingfang & Lei, Fei, 2023. "Energy performance and enviroeconomic analysis of a novel PV-MCHP-TEG system," Energy, Elsevier, vol. 274(C).
    17. Eva Masero & Luis A. Fletscher & José M. Maestre, 2020. "A Coalitional Model Predictive Control for the Energy Efficiency of Next-Generation Cellular Networks," Energies, MDPI, vol. 13(24), pages 1-19, December.
    18. Yanfei Liu & Xiaotian Han & Chaoqun Shen & Feng Yao & Mengchen Zhang, 2018. "Experimental Study on the Evaporation and Condensation Heat Transfer Characteristics of a Vapor Chamber," Energies, MDPI, vol. 12(1), pages 1-13, December.
    19. Delpech, Bertrand & Axcell, Brian & Jouhara, Hussam, 2019. "Experimental investigation of a radiative heat pipe for waste heat recovery in a ceramics kiln," Energy, Elsevier, vol. 170(C), pages 636-651.
    20. Malinauskaite, J. & Jouhara, H., 2019. "The trilemma of waste-to-energy: A multi-purpose solution," Energy Policy, Elsevier, vol. 129(C), pages 636-645.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:8:p:3505-:d:1126191. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.