IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i22p8509-d972404.html
   My bibliography  Save this article

System COP of Ejector-Based Ground-Source Heat Pumps

Author

Listed:
  • Mouhammad El Hassan

    (Mechanical Engineering Department, Prince Mohammad Bin Fahd University, Al Khobar 34218, Saudi Arabia)

Abstract

Compared to mechanical compressors, ejector-based refrigeration systems can make direct use of many forms of thermal energy, including waste heat, solar thermal, or biogases. It is known that SE systems have a lower thermal efficiency compared to mechanical compressors because of their lower performance at high compression ratios. In the present work, binary fluid ejector heat pumps with high efficiency are presented based on a proper selection of the binary fluids and the ejector geometry for specific operating conditions of a ground-source heat pump cooling system (GSHP). The existing literature on ejector-based refrigeration systems considers the thermal COP and does not account for many energy losses across the system. In the present paper, the system COP of an ejector-based GSHP that accounts for all energy exchange processes is determined. A method for the calculation of the work done by the boiler feed pump, the refrigeration expansion valve, and the ground loop circulation pump is presented. The influence of the condenser temperature on the entrainment process and the system COP is also discussed. The estimated overall system COP for the three top-ranked binary fluid candidates under various operating conditions was found to range from 1.55 to 3.06.

Suggested Citation

  • Mouhammad El Hassan, 2022. "System COP of Ejector-Based Ground-Source Heat Pumps," Energies, MDPI, vol. 15(22), pages 1-14, November.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:22:p:8509-:d:972404
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/22/8509/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/22/8509/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Szabolcs Varga & Pedro S. Lebre & Armando C. Oliveira, 2015. "Readdressing working fluid selection with a view to designing a variable geometry ejector," International Journal of Low-Carbon Technologies, Oxford University Press, vol. 10(3), pages 205-215.
    2. Ramesh, A.S. & Sekhar, S. Joseph, 2018. "Experimental and numerical investigations on the effect of suction chamber angle and nozzle exit position of a steam-jet ejector," Energy, Elsevier, vol. 164(C), pages 1097-1113.
    3. Han, Yu & Wang, Xiaodong & Sun, Hao & Zhang, Guangli & Guo, Lixin & Tu, Jiyuan, 2019. "CFD simulation on the boundary layer separation in the steam ejector and its influence on the pumping performance," Energy, Elsevier, vol. 167(C), pages 469-483.
    4. Wen, Chuang & Rogie, Brice & Kærn, Martin Ryhl & Rothuizen, Erasmus, 2020. "A first study of the potential of integrating an ejector in hydrogen fuelling stations for fuelling high pressure hydrogen vehicles," Applied Energy, Elsevier, vol. 260(C).
    5. Sankarlal, T. & Mani, A., 2007. "Experimental investigations on ejector refrigeration system with ammonia," Renewable Energy, Elsevier, vol. 32(8), pages 1403-1413.
    6. Poirier, Michel & Giguère, Daniel & Sapoundjiev, Hristo, 2018. "Experimental parametric investigation of vapor ejector for refrigeration applications," Energy, Elsevier, vol. 162(C), pages 1287-1300.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Yang, Yan & Karvounis, Nikolas & Walther, Jens Honore & Ding, Hongbing & Wen, Chuang, 2021. "Effect of area ratio of the primary nozzle on steam ejector performance considering nonequilibrium condensations," Energy, Elsevier, vol. 237(C).
    2. Besagni, Giorgio, 2019. "Ejectors on the cutting edge: The past, the present and the perspective," Energy, Elsevier, vol. 170(C), pages 998-1003.
    3. Tang, Yongzhi & Liu, Zhongliang & Li, Yanxia & Huang, Zhifeng & Chua, Kian Jon, 2021. "Study on fundamental link between mixing efficiency and entrainment performance of a steam ejector," Energy, Elsevier, vol. 215(PB).
    4. Chen, Hongjie & Zhu, Jiahua & Ge, Jing & Lu, Wei & Zheng, Lixing, 2020. "A cylindrical mixing chamber ejector analysis model to predict the optimal nozzle exit position," Energy, Elsevier, vol. 208(C).
    5. Hafiz Ali Muhammad & Hafiz Muhammad Abdullah & Zabdur Rehman & Beomjoon Lee & Young-Jin Baik & Jongjae Cho & Muhammad Imran & Manzar Masud & Mohsin Saleem & Muhammad Shoaib Butt, 2020. "Numerical Modeling of Ejector and Development of Improved Methods for the Design of Ejector-Assisted Refrigeration System," Energies, MDPI, vol. 13(21), pages 1-19, November.
    6. Yan, Jia & Cai, Wenjian & Zhao, Lei & Li, Yanzhong & Lin, Chen, 2013. "Performance evaluation of a combined ejector-vapor compression cycle," Renewable Energy, Elsevier, vol. 55(C), pages 331-337.
    7. Ramesh, A.S. & Sekhar, S. Joseph, 2018. "Experimental and numerical investigations on the effect of suction chamber angle and nozzle exit position of a steam-jet ejector," Energy, Elsevier, vol. 164(C), pages 1097-1113.
    8. Fatong Jia & Dazhang Yang & Jing Xie, 2021. "Numerical Investigation on the Performance of Two-Throat Nozzle Ejectors with Different Mixing Chamber Structural Parameters," Energies, MDPI, vol. 14(21), pages 1-16, October.
    9. Llorenç Macia & Robert Castilla & Pedro Javier Gamez-Montero & Gustavo Raush, 2022. "Multi-Factor Design for a Vacuum Ejector Improvement by In-Depth Analysis of Construction Parameters," Sustainability, MDPI, vol. 14(16), pages 1-16, August.
    10. Lucian-Ioan Dulău, 2023. "CO 2 Emissions of Battery Electric Vehicles and Hydrogen Fuel Cell Vehicles," Clean Technol., MDPI, vol. 5(2), pages 1-17, June.
    11. Aliabadi, Mohammad Ali Faghih & Lakzian, Esmail & Khazaei, Iman & Jahangiri, Ali, 2020. "A comprehensive investigation of finding the best location for hot steam injection into the wet steam turbine blade cascade," Energy, Elsevier, vol. 190(C).
    12. Yan, Jia & Cai, Wenjian & Li, Yanzhong, 2012. "Geometry parameters effect for air-cooled ejector cooling systems with R134a refrigerant," Renewable Energy, Elsevier, vol. 46(C), pages 155-163.
    13. Zhang, Guojie & Dykas, Sławomir & Li, Pan & Li, Hang & Wang, Junlei, 2020. "Accurate condensing steam flow modeling in the ejector of the solar-driven refrigeration system," Energy, Elsevier, vol. 212(C).
    14. Lixing Zheng & Hongwei Hu & Weibo Wang & Yiyan Zhang & Lingmei Wang, 2022. "Study on Flow Distribution and Structure Optimization in a Mix Chamber and Diffuser of a CO 2 Two-Phase Ejector," Mathematics, MDPI, vol. 10(5), pages 1-16, February.
    15. Yiqiao Li & Shengqiang Shen & Chao Niu & Yali Guo & Liuyang Zhang, 2022. "The Effect of Different Pressure Conditions on Shock Waves in a Supersonic Steam Ejector," Energies, MDPI, vol. 15(8), pages 1-15, April.
    16. Wang, Jiangfeng & Dai, Yiping & Gao, Lin & Ma, Shaolin, 2009. "A new combined cooling, heating and power system driven by solar energy," Renewable Energy, Elsevier, vol. 34(12), pages 2780-2788.
    17. Zhang, Kun & Chen, Xue & Markides, Christos N. & Yang, Yong & Shen, Shengqiang, 2016. "Evaluation of ejector performance for an organic Rankine cycle combined power and cooling system," Applied Energy, Elsevier, vol. 184(C), pages 404-412.
    18. Jiajie Zhang & Yun Liu & Yumeng Guo & Jingxian Zhang & Suxia Ma, 2023. "Numerical Study on Flow and Noise Characteristics of High-Temperature and High-Pressure Steam Ejector," Energies, MDPI, vol. 16(10), pages 1-24, May.
    19. Yang, Yan & Zhu, Xiaowei & Yan, Yuying & Ding, Hongbing & Wen, Chuang, 2019. "Performance of supersonic steam ejectors considering the nonequilibrium condensation phenomenon for efficient energy utilisation," Applied Energy, Elsevier, vol. 242(C), pages 157-167.
    20. Luca Viscito & Gianluca Lillo & Giovanni Napoli & Alfonso William Mauro, 2021. "Waste Heat Driven Multi-Ejector Cooling Systems: Optimization of Design at Partial Load; Seasonal Performance and Cost Evaluation," Energies, MDPI, vol. 14(18), pages 1-25, September.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:22:p:8509-:d:972404. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.