IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v12y2019i22p4272-d285213.html
   My bibliography  Save this article

Optimization of a Cascaded H-Bridge Inverter for Electric Vehicle Applications Including Cost Consideration

Author

Listed:
  • Felix Roemer

    (TUM CREATE Ltd., 1 CREATE Way, #10-02 CREATE Tower, Singapore 138602, Singapore
    Institute of Automotive Technology, Technical University of Munich, Boltzmannstr. 15, 85748 Garching, Germany)

  • Massab Ahmad

    (TUM CREATE Ltd., 1 CREATE Way, #10-02 CREATE Tower, Singapore 138602, Singapore
    Institute of Automotive Technology, Technical University of Munich, Boltzmannstr. 15, 85748 Garching, Germany)

  • Fengqi Chang

    (TUM CREATE Ltd., 1 CREATE Way, #10-02 CREATE Tower, Singapore 138602, Singapore
    Institute of Automotive Technology, Technical University of Munich, Boltzmannstr. 15, 85748 Garching, Germany)

  • Markus Lienkamp

    (Institute of Automotive Technology, Technical University of Munich, Boltzmannstr. 15, 85748 Garching, Germany)

Abstract

This paper presents a method to find the optimal configuration for an electric vehicle energy storage system using a cascaded H-bridge (CHB) inverter. CHB multilevel inverters enable a better utilization of the battery pack, because cells/modules with manufacturing tolerances in terms of capacity can be selectively discharged instead of being passively balanced by discharging them over resistors. The balancing algorithms have been investigated in many studies for the CHB topology. However, it has not yet been investigated to which extend a conventional pack can be modularized in a CHB configuration. Therefore, this paper explores different configurations by simulating different switch models, switch configurations, and number of levels for a CHB inverter along with a reference load model to find the optimal design of the system. The configuration is also considered from an economically point of view, as the most efficient solution might not be cost-effective to be installed in a common production vehicle. It is found that four modules per phase give the best compromise between efficiency and costs. Paralleling smaller switches should be preferred over the usage of fewer, larger switches. Moreover, selecting specific existing components results in higher savings compared to theoretical optimal components.

Suggested Citation

  • Felix Roemer & Massab Ahmad & Fengqi Chang & Markus Lienkamp, 2019. "Optimization of a Cascaded H-Bridge Inverter for Electric Vehicle Applications Including Cost Consideration," Energies, MDPI, vol. 12(22), pages 1-19, November.
    • Handle: RePEc:gam:jeners:v:12:y:2019:i:22:p:4272-:d:285213
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/12/22/4272/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/12/22/4272/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Muxuan Xiao & Qianming Xu & Honglin Ouyang, 2017. "An Improved Modulation Strategy Combining Phase Shifted PWM and Phase Disposition PWM for Cascaded H-Bridge Inverters," Energies, MDPI, vol. 10(9), pages 1-14, September.
    2. Pavlovic, J. & Ciuffo, B. & Fontaras, G. & Valverde, V. & Marotta, A., 2018. "How much difference in type-approval CO2 emissions from passenger cars in Europe can be expected from changing to the new test procedure (NEDC vs. WLTP)?," Transportation Research Part A: Policy and Practice, Elsevier, vol. 111(C), pages 136-147.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Vijayaraja Loganathan & Ganesh Kumar Srinivasan & Marco Rivera, 2020. "Realization of 485 Level Inverter Using Tri-State Architecture for Renewable Energy Systems," Energies, MDPI, vol. 13(24), pages 1-29, December.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Baek, Seungju & Lee, Hyeonjik & Lee, Kihyung, 2021. "Fuel efficiency and exhaust characteristics of turbocharged diesel engine equipped with an electric supercharger," Energy, Elsevier, vol. 214(C).
    2. Xinglong Liu & Fuquan Zhao & Han Hao & Kangda Chen & Zongwei Liu & Hassan Babiker & Amer Ahmad Amer, 2020. "From NEDC to WLTP: Effect on the Energy Consumption, NEV Credits, and Subsidies Policies of PHEV in the Chinese Market," Sustainability, MDPI, vol. 12(14), pages 1-19, July.
    3. José I. Huertas & Michael Giraldo & Luis F. Quirama & Jenny Díaz, 2018. "Driving Cycles Based on Fuel Consumption," Energies, MDPI, vol. 11(11), pages 1-13, November.
    4. Stefan Tabacu & Dragos Popa, 2023. "Backward-Facing Analysis for the Preliminary Estimation of the Vehicle Fuel Consumption," Sustainability, MDPI, vol. 15(6), pages 1-19, March.
    5. Salvo, Orlando de & Vaz de Almeida, Flávio G., 2019. "Influence of technologies on energy efficiency results of official Brazilian tests of vehicle energy consumption," Applied Energy, Elsevier, vol. 241(C), pages 98-112.
    6. Dolatabadi, N. & Forder, M. & Morris, N. & Rahmani, R. & Rahnejat, H. & Howell-Smith, S., 2020. "Influence of advanced cylinder coatings on vehicular fuel economy and emissions in piston compression ring conjunction," Applied Energy, Elsevier, vol. 259(C).
    7. García, Antonio & Monsalve-Serrano, Javier & Martínez-Boggio, Santiago & Wittek, Karsten, 2020. "Potential of hybrid powertrains in a variable compression ratio downsized turbocharged VVA Spark Ignition engine," Energy, Elsevier, vol. 195(C).
    8. Karol Tucki & Olga Orynycz & Remigiusz Mruk & Antoni Świć & Katarzyna Botwińska, 2019. "Modeling of Biofuel’s Emissivity for Fuel Choice Management," Sustainability, MDPI, vol. 11(23), pages 1-22, December.
    9. Galindo, José & Serrano, José Ramón & De la Morena, Joaquín & Gómez-Vilanova, Alejandro, 2022. "Physical-based variable geometry turbines predictive control to enhance new hybrid powertrains’ transient response," Energy, Elsevier, vol. 261(PB).
    10. Fan, Pengfei & Yin, Hang & Lu, Hongyu & Wu, Yizheng & Zhai, Zhiqiang & Yu, Lei & Song, Guohua, 2023. "Which factor contributes more to the fuel consumption gap between in-laboratory vs. real-world driving conditions? An independent component analysis," Energy Policy, Elsevier, vol. 182(C).
    11. Lorenzo Nicoletti & Andrea Romano & Adrian König & Peter Köhler & Maximilian Heinrich & Markus Lienkamp, 2021. "An Estimation of the Lightweight Potential of Battery Electric Vehicles," Energies, MDPI, vol. 14(15), pages 1-29, July.
    12. Mei Su & Chao Luo & Xiaochao Hou & Wenbin Yuan & Zhangjie Liu & Hua Han & Josep M. Guerrero, 2018. "A Communication-Free Decentralized Control for Grid-Connected Cascaded PV Inverters," Energies, MDPI, vol. 11(6), pages 1-18, May.
    13. Alberini, Anna & Horvath, Marco & Vance, Colin, 2021. "Drive less, drive better, or both? Behavioral adjustments to fuel price changes in Germany," Ruhr Economic Papers 892, RWI - Leibniz-Institut für Wirtschaftsforschung, Ruhr-University Bochum, TU Dortmund University, University of Duisburg-Essen.
    14. Alberini, Anna & Horvath, Marco & Vance, Colin, 2022. "Drive less, drive better, or both? Behavioral adjustments to fuel price changes in Germany," Resource and Energy Economics, Elsevier, vol. 68(C).
    15. Hyeonjik Lee & Kihyung Lee, 2020. "Comparative Evaluation of the Effect of Vehicle Parameters on Fuel Consumption under NEDC and WLTP," Energies, MDPI, vol. 13(16), pages 1-19, August.
    16. Agarwal, Avinash Kumar & Mustafi, Nirendra Nath, 2021. "Real-world automotive emissions: Monitoring methodologies, and control measures," Renewable and Sustainable Energy Reviews, Elsevier, vol. 137(C).
    17. Arminda Almeida & Nuno Sousa & João Coutinho-Rodrigues, 2019. "Quest for Sustainability: Life-Cycle Emissions Assessment of Electric Vehicles Considering Newer Li-Ion Batteries," Sustainability, MDPI, vol. 11(8), pages 1-19, April.
    18. Barouch Giechaskiel & Dimitrios Komnos & Georgios Fontaras, 2021. "Impacts of Extreme Ambient Temperatures and Road Gradient on Energy Consumption and CO 2 Emissions of a Euro 6d-Temp Gasoline Vehicle," Energies, MDPI, vol. 14(19), pages 1-20, September.
    19. Kangda Chen & Fuquan Zhao & Xinglong Liu & Han Hao & Zongwei Liu, 2021. "Impacts of the New Worldwide Light-Duty Test Procedure on Technology Effectiveness and China’s Passenger Vehicle Fuel Consumption Regulations," IJERPH, MDPI, vol. 18(6), pages 1-20, March.
    20. Song, Jingeun & Cha, Junepyo, 2022. "Development of prediction methodology for CO2 emissions and fuel economy of light duty vehicle," Energy, Elsevier, vol. 244(PB).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:12:y:2019:i:22:p:4272-:d:285213. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.