IDEAS home Printed from https://ideas.repec.org/a/eee/rensus/v173y2023ics1364032122009959.html
   My bibliography  Save this article

Synergistic analysis of wake effect of two cylinders on energy harvesting characteristics of piezoelectric flag

Author

Listed:
  • Latif, Usman
  • Younis, M. Yamin
  • Idrees, Saad
  • Uddin, Emad
  • Abdelkefi, Abdessattar
  • Munir, Adnan
  • Zhao, Ming

Abstract

In this study, the effect of asymmetric wake flow regime of two side-by-side cylindrical bluff bodies on power output is experimentally examined by using a piezoelectric flag. Different synchronization modes of the flag with wake flow are observed. It is demonstrated that the streamwise gap between the flag and cylinders (Gx), and the center-to-center gap between cylinders have a significant impact on the flag's dynamical behavior that results in a fluctuation in the power output of the piezoelectric flag. The levels of output power are analyzed by varying the Gx and the cross-stream or lateral gap (N/d) between the two cylinders. N/d values from 1.0 to 2.0 for different values of Gx (2.0 ≤ Gx ≤ 4.0) are experimentally tested. The comparison of the flapping response at each point is made to ascertain the impact of the harvester's dynamic behavior on the output energy. The power generated at each point is recorded for all cases and a comparative analysis is made to find the optimal configuration. Limited research is conducted in the past to enhance the energy output by using the bluff body with the improved wake dynamics. Hence, two cylinders are employed in a uniform flow and crosswise gap between cylinders is varied to change the characteristics of the wake region. The cylinder arrangement with N/d = 1.0, shows continuous oscillations and higher output power persisting for 2.0 ≤ Gx ≤ 4.0. The monotonic rise in power output is observed till Gx = 4.0. The stated configurations with N/d = 1.0 gives a significant advantage over a single-cylinder-based energy harvester as a kinetic source of fluid energy harvester from the flowing fluid. The output power became almost doubled with an increase of 95% approximately using side-by-side arrangement.

Suggested Citation

  • Latif, Usman & Younis, M. Yamin & Idrees, Saad & Uddin, Emad & Abdelkefi, Abdessattar & Munir, Adnan & Zhao, Ming, 2023. "Synergistic analysis of wake effect of two cylinders on energy harvesting characteristics of piezoelectric flag," Renewable and Sustainable Energy Reviews, Elsevier, vol. 173(C).
    • Handle: RePEc:eee:rensus:v:173:y:2023:i:c:s1364032122009959
    DOI: 10.1016/j.rser.2022.113114
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S1364032122009959
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.rser.2022.113114?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Zahid Kausar, A.S.M. & Reza, Ahmed Wasif & Saleh, Mashad Uddin & Ramiah, Harikrishnan, 2014. "Energizing wireless sensor networks by energy harvesting systems: Scopes, challenges and approaches," Renewable and Sustainable Energy Reviews, Elsevier, vol. 38(C), pages 973-989.
    2. Latif, U. & Uddin, E. & Younis, M.Y. & Aslam, J. & Ali, Z. & Sajid, M. & Abdelkefi, A., 2021. "Experimental electro-hydrodynamic investigation of flag-based energy harvesting in the wake of inverted C-shape cylinder," Energy, Elsevier, vol. 215(PB).
    3. Wei, Chongfeng & Jing, Xingjian, 2017. "A comprehensive review on vibration energy harvesting: Modelling and realization," Renewable and Sustainable Energy Reviews, Elsevier, vol. 74(C), pages 1-18.
    4. Mujtaba, A. & Latif, U. & Uddin, E. & Younis, M.Y. & Sajid, M. & Ali, Z. & Abdelkefi, A., 2021. "Hydrodynamic energy harvesting analysis of two piezoelectric tandem flags under influence of upstream body’s wakes," Applied Energy, Elsevier, vol. 282(PA).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Zou, Donglin & Liu, Gaoyu & Rao, Zhushi & Cao, Junyi & Liao, Wei-Hsin, 2022. "Design of a high-performance piecewise bi-stable piezoelectric energy harvester," Energy, Elsevier, vol. 241(C).
    2. Shan, Xiaobiao & Sui, Guangdong & Tian, Haigang & Min, Zhaowei & Feng, Ju & Xie, Tao, 2022. "Numerical analysis and experiments of an underwater magnetic nonlinear energy harvester based on vortex-induced vibration," Energy, Elsevier, vol. 241(C).
    3. Ebrahimian, Fariba & Kabirian, Zohre & Younesian, Davood & Eghbali, Pezhman, 2021. "Auxetic clamped-clamped resonators for high-efficiency vibration energy harvesting at low-frequency excitation," Applied Energy, Elsevier, vol. 295(C).
    4. Kim, Ki Jong & Kim, Junyoung & Kim, Daegyoum, 2023. "Slosh-induced piezoelectric energy harvesting in a liquid tank," Renewable Energy, Elsevier, vol. 206(C), pages 409-417.
    5. Liu, Mengzhou & Zhang, Yuan & Fu, Hailing & Qin, Yong & Ding, Ao & Yeatman, Eric M., 2023. "A seesaw-inspired bistable energy harvester with adjustable potential wells for self-powered internet of train monitoring," Applied Energy, Elsevier, vol. 337(C).
    6. Abdelkareem, Mohamed A.A. & Xu, Lin & Ali, Mohamed Kamal Ahmed & El-Daly, Abdel-Rahman B.M. & Hassan, Mohamed A. & Elagouz, Ahmed & Bo, Yang, 2019. "Analysis of the prospective vibrational energy harvesting of heavy-duty truck suspensions: A simulation approach," Energy, Elsevier, vol. 173(C), pages 332-351.
    7. Luo, Rongkang & Yu, Zhihao & Wu, Peibao & Hou, Zhichao, 2023. "Analytical solutions of the energy harvesting potential from vehicle vertical vibration based on statistical energy conservation," Energy, Elsevier, vol. 264(C).
    8. Eswaran, U. & Ramiah, H. & Kanesan, J. & Reza, A.W., 2015. "Energy saving power amplifier design methodologies for mobile wireless communications," Renewable and Sustainable Energy Reviews, Elsevier, vol. 51(C), pages 1721-1727.
    9. Huguet, Thomas & Badel, Adrien & Druet, Olivier & Lallart, Mickaël, 2018. "Drastic bandwidth enhancement of bistable energy harvesters: Study of subharmonic behaviors and their stability robustness," Applied Energy, Elsevier, vol. 226(C), pages 607-617.
    10. Zhang, L.B. & Dai, H.L. & Abdelkefi, A. & Lin, S.X. & Wang, L., 2019. "Theoretical modeling, wind tunnel measurements, and realistic environment testing of galloping-based electromagnetic energy harvesters," Applied Energy, Elsevier, vol. 254(C).
    11. Shan, Xiaobiao & Li, Hongliang & Yang, Yuancai & Feng, Ju & Wang, Yicong & Xie, Tao, 2019. "Enhancing the performance of an underwater piezoelectric energy harvester based on flow-induced vibration," Energy, Elsevier, vol. 172(C), pages 134-140.
    12. Wei, Chongfeng & Jing, Xingjian, 2017. "A comprehensive review on vibration energy harvesting: Modelling and realization," Renewable and Sustainable Energy Reviews, Elsevier, vol. 74(C), pages 1-18.
    13. David Omooria Masara & Hassan El Gamal & Ossama Mokhiamar, 2021. "Split Cantilever Multi-Resonant Piezoelectric Energy Harvester for Low-Frequency Application," Energies, MDPI, vol. 14(16), pages 1-15, August.
    14. Quan Wang & Kyung-Bum Kim & Sang-Bum Woo & Yooseob Song & Tae-Hyun Sung, 2021. "A Magneto-Mechanical Piezoelectric Energy Harvester Designed to Scavenge AC Magnetic Field from Thermal Power Plant with Power-Line Cables," Energies, MDPI, vol. 14(9), pages 1-12, April.
    15. Liu, Zhen & Qu, Hengliang & Song, Xinyu & Chen, Zhengshou & Ni, Heqiang, 2023. "Energy-harvesting performance of tandem coupled-pitching hydrofoils under the semi-activated mode: An experimental study," Energy, Elsevier, vol. 279(C).
    16. M׳boungui, G. & Adendorff, K. & Naidoo, R. & Jimoh, A.A. & Okojie, D.E., 2015. "A hybrid piezoelectric micro-power generator for use in low power applications," Renewable and Sustainable Energy Reviews, Elsevier, vol. 49(C), pages 1136-1144.
    17. Kaiyuan Zhao & Qichang Zhang & Wei Wang, 2019. "Optimization of Galloping Piezoelectric Energy Harvester with V-Shaped Groove in Low Wind Speed," Energies, MDPI, vol. 12(24), pages 1-18, December.
    18. He, Lipeng & Wang, Shuangjian & Zheng, Xiaotian & Liu, Lei & Tian, Xiaochao & Sun, Baoyu, 2022. "Research-based on a low-frequency non-contact magnetic coupling piezoelectric energy harvester," Energy, Elsevier, vol. 258(C).
    19. Mahdi Zareei & Cesar Vargas-Rosales & Mohammad Hossein Anisi & Leila Musavian & Rafaela Villalpando-Hernandez & Shidrokh Goudarzi & Ehab Mahmoud Mohamed, 2019. "Enhancing the Performance of Energy Harvesting Sensor Networks for Environmental Monitoring Applications," Energies, MDPI, vol. 12(14), pages 1-14, July.
    20. Siriyothai, Patcharakon & Kittichaikarn, Chawalit, 2023. "Performance enhancement of a galloping-based energy harvester with different groove depths on square bluff body," Renewable Energy, Elsevier, vol. 210(C), pages 148-158.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:rensus:v:173:y:2023:i:c:s1364032122009959. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/600126/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.