Comprehensive analysis of thermal performance and low-grade energy charging efficiency of pipe-embedded building envelopes enhanced with single-level tree-shaped fin structures

Pipe-embedded walls (CnPWs) are structural and energy composite building components that can resist external disturbances by forming stealth thermal shielding layers. To tackle the mismatch between the heat charging rate and heat diffusion rate during energy charging processes, as well as the unsatisfactory robustness of stealth thermal shielding layers, the single-level tree-shaped metal finnd pipe-embedded walls (TfPWs) are proposed. To verify the effectiveness of TfPWs and obtain dynamic performances, a simulation study is conducted on 8 risk variables in 4 pairs through the validated numerical model. Results showed that the improved design was effective in obtaining more robust thermal shielding layers in auxiliary energy supply mode, the effect gained prominence as both the injection temperature and pipe spacing were augmented. In room heat load reduction mode, favorable benefits arise when pipe spacing exceeds 400 mm. The maximum increase rate of total injected energy under different reduction ratios of external insulation layer was 11.83%–31.91 %, while the maximum extra total heat loss was 5.33 %. Secondly, the trunk fins and branch fins played different roles in minimizing the excessive heat accumulation surrounding pipes, and the vertical and horizontal sizes of heat accumulation region mainly increased with the increase in trunk fin size and branch fin size respectively. Meanwhile, the utilization efficiency of fin material was higher when trunk fin size was smaller, and parameter combinations with trunk fin size of 0.2b and branch fin size of 0.4a/0.6a could achieve a better balance between material input and performance increase. Thirdly, the improvement effect of single left branch fin schemes was close to that of double branch fin schemes and significantly better than that of single right branch fin schemes. It was recommended to use single left branch fin schemes with an inclination angle of 60°. Finally, even if the reduction ratio of external insulation layer in different cities increased to 80 %, the inside surface temperature of TfPWs was still greater than room air. Taking CnPWs with standard external insulation layer as references, the TfPWs applied in Harbin, Beijing, and Shanghai could achieve similar or better results even when the reduction ratio of external insulation layer increased to 60 %, while TfPWs applied in Guangzhou could exhibit better performance even when the reduction ratio of external insulation layer increases to 80 %.