IDEAS home Printed from https://ideas.repec.org/a/eee/appene/v105y2013icp8-16.html
   My bibliography  Save this article

Experimental and numerical investigation on the jet characteristics of spark ignition direct injection gaseous injector

Author

Listed:
  • Chitsaz, Iman
  • Saidi, Mohammad Hassan
  • Mozafari, Ali Asghar
  • Hajialimohammadi, Alireza

Abstract

Natural gas has widely been used as a fuel in conventional Diesel and spark ignition engines. The better understanding of injector parameters on the jet structure is helpful for the combustion optimization. This paper presents an experimental and numerical study on the jet structure of gaseous fuel injector in spark ignition direct injection engine by Schlieren technique and numerical procedure. Helium was injected through a gaseous injector at the different pressure ratios and nozzle diameters to understand the effects of nozzle geometry and pressure ratio for a dedicated correlation of CNG–SIDI injector. It was found that higher pressure ratio and exit nozzle diameter led to more tip penetration except the initial stages of jet development. Numerical simulation at the initial stage of jet development was not in exact agreement with experimental data due to transient effects of the needle lift within the injector tip and experimental errors while reliable results was observed after 1ms from the start of injection. It is also notable that tip angle of the jet did not have a specific trend when jet develops.

Suggested Citation

  • Chitsaz, Iman & Saidi, Mohammad Hassan & Mozafari, Ali Asghar & Hajialimohammadi, Alireza, 2013. "Experimental and numerical investigation on the jet characteristics of spark ignition direct injection gaseous injector," Applied Energy, Elsevier, vol. 105(C), pages 8-16.
    • Handle: RePEc:eee:appene:v:105:y:2013:i:c:p:8-16
    DOI: 10.1016/j.apenergy.2012.11.023
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0306261912008161
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.apenergy.2012.11.023?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Sen, Asok K. & Zheng, Jianjun & Huang, Zuohua, 2011. "Dynamics of cycle-to-cycle variations in a natural gas direct-injection spark-ignition engine," Applied Energy, Elsevier, vol. 88(7), pages 2324-2334, July.
    2. Park, Su Han & Yoon, Seung Hyun & Lee, Chang Sik, 2011. "Effects of multiple-injection strategies on overall spray behavior, combustion, and emissions reduction characteristics of biodiesel fuel," Applied Energy, Elsevier, vol. 88(1), pages 88-98, January.
    3. Ma, Xiao & He, Xu & Wang, Jian-xin & Shuai, Shijin, 2011. "Co-evaporative multi-component fuel design for in-cylinder PLIF measurement and application in gasoline direct injection research," Applied Energy, Elsevier, vol. 88(8), pages 2617-2627, August.
    4. Bai, Yun-long & Wang, Zhi & Wang, Jian-xin, 2010. "Part-load characteristics of direct injection spark ignition engine using exhaust gas trap," Applied Energy, Elsevier, vol. 87(8), pages 2640-2646, August.
    5. Kalam, M.A. & Masjuki, H.H., 2011. "An experimental investigation of high performance natural gas engine with direct injection," Energy, Elsevier, vol. 36(5), pages 3563-3571.
    6. Banapurmath, N.R. & Tewari, P.G. & Hosmath, R.S., 2008. "Experimental investigations of a four-stroke single cylinder direct injection diesel engine operated on dual fuel mode with producer gas as inducted fuel and Honge oil and its methyl ester (HOME) as i," Renewable Energy, Elsevier, vol. 33(9), pages 2007-2018.
    7. Carlucci, A.P. & de Risi, A. & Laforgia, D. & Naccarato, F., 2008. "Experimental investigation and combustion analysis of a direct injection dual-fuel diesel–natural gas engine," Energy, Elsevier, vol. 33(2), pages 256-263.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Zhang, Qiang & Li, Menghan & Shao, Sidong, 2015. "Combustion process and emissions of a heavy-duty engine fueled with directly injected natural gas and pilot diesel," Applied Energy, Elsevier, vol. 157(C), pages 217-228.
    2. Costa, M. & Sorge, U. & Merola, S. & Irimescu, A. & La Villetta, M. & Rocco, V., 2016. "Split injection in a homogeneous stratified gasoline direct injection engine for high combustion efficiency and low pollutants emission," Energy, Elsevier, vol. 117(P2), pages 405-415.
    3. Wang, Qiang & Tang, Fei & Zhou, Zheng & Liu, Huan & Palacios, Adriana, 2017. "Flame height of axisymmetric gaseous fuel jets restricted by parallel sidewalls: Experiments and theoretical analysis," Applied Energy, Elsevier, vol. 208(C), pages 1519-1526.
    4. Sun, Yao & Yu, Xiumin & Dong, Wei & Chen, Hong & Hu, Yunfeng, 2018. "Effect of split injection on particle number (PN) emissions in GDI engine at fast-idle through integrated analysis of optics and mechanics," Energy, Elsevier, vol. 165(PB), pages 55-67.
    5. Biswas, Sayan & Qiao, Li, 2018. "Ignition of ultra-lean premixed hydrogen/air by an impinging hot jet," Applied Energy, Elsevier, vol. 228(C), pages 954-964.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Amba Prasad Rao, G. & Kaleemuddin, Syed, 2011. "Development of variable timing fuel injection cam for effective abatement of diesel engine emissions," Applied Energy, Elsevier, vol. 88(8), pages 2653-2662, August.
    2. Kalam, M.A. & Masjuki, H.H., 2011. "An experimental investigation of high performance natural gas engine with direct injection," Energy, Elsevier, vol. 36(5), pages 3563-3571.
    3. Zhang, Zhifei & Li, Tie & Shi, Weiquan, 2019. "Ambient Tracer-LIF for 2-D quantitative measurement of fuel concentration in gas jets," Energy, Elsevier, vol. 171(C), pages 372-384.
    4. Babu, D. & Karvembu, R. & Anand, R., 2018. "Impact of split injection strategy on combustion, performance and emissions characteristics of biodiesel fuelled common rail direct injection assisted diesel engine," Energy, Elsevier, vol. 165(PB), pages 577-592.
    5. Ghazimirsaied, Ahmad & Koch, Charles Robert, 2012. "Controlling cyclic combustion timing variations using a symbol-statistics predictive approach in an HCCI engine," Applied Energy, Elsevier, vol. 92(C), pages 133-146.
    6. Bodisco, Timothy & Brown, Richard J., 2013. "Inter-cycle variability of in-cylinder pressure parameters in an ethanol fumigated common rail diesel engine," Energy, Elsevier, vol. 52(C), pages 55-65.
    7. Li, Weifeng & Liu, Zhongchang & Wang, Zhongshu, 2016. "Experimental and theoretical analysis of the combustion process at low loads of a diesel natural gas dual-fuel engine," Energy, Elsevier, vol. 94(C), pages 728-741.
    8. Andwari, Amin Mahmoudzadeh & Aziz, Azhar Abdul & Said, Mohd Farid Muhamad & Latiff, Zulkarnain Abdul, 2014. "Experimental investigation of the influence of internal and external EGR on the combustion characteristics of a controlled auto-ignition two-stroke cycle engine," Applied Energy, Elsevier, vol. 134(C), pages 1-10.
    9. Shu, Jun & Fu, Jianqin & Liu, Jingping & Ma, Yinjie & Wang, Shuqian & Deng, Banglin & Zeng, Dongjian, 2019. "Effects of injector spray angle on combustion and emissions characteristics of a natural gas (NG)-diesel dual fuel engine based on CFD coupled with reduced chemical kinetic model," Applied Energy, Elsevier, vol. 233, pages 182-195.
    10. Yaliwal, V.S. & Banapurmath, N.R. & Gireesh, N.M. & Tewari, P.G., 2014. "Production and utilization of renewable and sustainable gaseous fuel for power generation applications: A review of literature," Renewable and Sustainable Energy Reviews, Elsevier, vol. 34(C), pages 608-627.
    11. Fan, Baowei & Pan, Jianfeng & Yang, Wenming & Chen, Wei & Bani, Stephen, 2017. "The influence of injection strategy on mixture formation and combustion process in a direct injection natural gas rotary engine," Applied Energy, Elsevier, vol. 187(C), pages 663-674.
    12. Krzysztof Biernat & Izabela Samson-Bręk & Zdzisław Chłopek & Marlena Owczuk & Anna Matuszewska, 2021. "Assessment of the Environmental Impact of Using Methane Fuels to Supply Internal Combustion Engines," Energies, MDPI, vol. 14(11), pages 1-19, June.
    13. Yaliwal, V.S. & Banapurmath, N.R. & Gireesh, N.M. & Hosmath, R.S. & Donateo, Teresa & Tewari, P.G., 2016. "Effect of nozzle and combustion chamber geometry on the performance of a diesel engine operated on dual fuel mode using renewable fuels," Renewable Energy, Elsevier, vol. 93(C), pages 483-501.
    14. Lotfan, S. & Ghiasi, R. Akbarpour & Fallah, M. & Sadeghi, M.H., 2016. "ANN-based modeling and reducing dual-fuel engine’s challenging emissions by multi-objective evolutionary algorithm NSGA-II," Applied Energy, Elsevier, vol. 175(C), pages 91-99.
    15. Chen, Zheng & Liu, Jingping & Han, Zhiyu & Du, Biao & Liu, Yun & Lee, Chiafon, 2013. "Study on performance and emissions of a passenger-car diesel engine fueled with butanol–diesel blends," Energy, Elsevier, vol. 55(C), pages 638-646.
    16. Shim, Euijoon & Park, Hyunwook & Bae, Choongsik, 2018. "Intake air strategy for low HC and CO emissions in dual-fuel (CNG-diesel) premixed charge compression ignition engine," Applied Energy, Elsevier, vol. 225(C), pages 1068-1077.
    17. E, Jiaqiang & Pham, Minhhieu & Zhao, D. & Deng, Yuanwang & Le, DucHieu & Zuo, Wei & Zhu, Hao & Liu, Teng & Peng, Qingguo & Zhang, Zhiqing, 2017. "Effect of different technologies on combustion and emissions of the diesel engine fueled with biodiesel: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 80(C), pages 620-647.
    18. Shahir, V.K. & Jawahar, C.P. & Suresh, P.R., 2015. "Comparative study of diesel and biodiesel on CI engine with emphasis to emissions—A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 45(C), pages 686-697.
    19. Xuan, Tiemin & Cao, Jiawei & He, Zhixia & Wang, Qian & Zhong, Wenjun & Leng, Xianyin & Li, Da & Shang, Weiwei, 2018. "A study of soot quantification in diesel flame with hydrogenated catalytic biodiesel in a constant volume combustion chamber," Energy, Elsevier, vol. 145(C), pages 691-699.
    20. Park, Cheolwoong & Kim, Changgi & Lee, Sangho & Lee, Sunyoup & Lee, Janghee, 2019. "Comparative evaluation of performance and emissions of CNG engine for heavy-duty vehicles fueled with various caloric natural gases," Energy, Elsevier, vol. 174(C), pages 1-9.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:appene:v:105:y:2013:i:c:p:8-16. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/405891/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.