IDEAS home Printed from https://ideas.repec.org/a/gam/jsusta/v10y2018i8p2647-d160367.html

Optimization of the Power Output of a Bare Wind Turbine by the Use of a Plain Conical Diffuser

Author

Listed:
  • Peace-Maker Masukume

    (Department of Physics, University of Fort Hare, Alice 5700, South Africa)

  • Golden Makaka

    (Department of Physics, University of Fort Hare, Alice 5700, South Africa)

  • Patrick Mukumba

    (Department of Physics, University of Fort Hare, Alice 5700, South Africa)

Abstract

A plain conical diffuser is optimized to augment the wind speed at the throat of the diffuser. The diffuser is used in the construction of a diffuser augmented wind turbine (DAWT) to augment the power output of a bare wind turbine (BWT). Experiments with empty conical diffusers were done to determine optimum geometrical parameters for the diffuser to achieve maximum wind speed augmentation. Using the obtained optimum geometrical parameters, an optimized plain conical DAWT was designed, constructed, and field tested. A twin decentralized wind energy system which comprised a BWT and the optimized plain conical DAWT was erected. The electrical power output from these systems was measured and compared. The optimized plain conical DAWT reduced the cut-in wind speed of a BWT from 2.5 m/s to 1.6 m/s. The power output was increased by a factor of 2.5. This power output is comparable to that of flanged diffusers. However, flanged-DAWTs are more inert due to the addition of the flange. Its response to wind speed and direction is slow as compared to plain conical DAWT. Thus, it cannot fully exploit the potential of the wind. Also, the addition of the flange increases its production cost. Therefore, plain conical DAWT can replace flanged-DAWT in wind power augmentation.

Suggested Citation

  • Peace-Maker Masukume & Golden Makaka & Patrick Mukumba, 2018. "Optimization of the Power Output of a Bare Wind Turbine by the Use of a Plain Conical Diffuser," Sustainability, MDPI, vol. 10(8), pages 1-7, July.
    • Handle: RePEc:gam:jsusta:v:10:y:2018:i:8:p:2647-:d:160367
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/2071-1050/10/8/2647/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/2071-1050/10/8/2647/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Yuji Ohya & Takashi Karasudani, 2010. "A Shrouded Wind Turbine Generating High Output Power with Wind-lens Technology," Energies, MDPI, vol. 3(4), pages 1-16, March.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Nunes, Matheus M. & Brasil Junior, Antonio C.P. & Oliveira, Taygoara F., 2020. "Systematic review of diffuser-augmented horizontal-axis turbines," Renewable and Sustainable Energy Reviews, Elsevier, vol. 133(C).
    2. Debela Alema Teklemariyem & Nasir Hussain Razvi Syed & Phong Ba Dao, 2025. "CFD-Driven Design Optimization of Corrugated-Flange Diffuser-Integrated Wind Turbines for Enhanced Performance," Energies, MDPI, vol. 18(17), pages 1-33, August.
    3. Jose Alberto Moleón Baca & Antonio Jesús Expósito González & Candido Gutiérrez Montes, 2020. "Analysis of the Patent of a Protective Cover for Vertical-Axis Wind Turbines (VAWTs): Simulations of Wind Flow," Sustainability, MDPI, vol. 12(18), pages 1-17, September.
    4. Yasemin Ayaz Atalan & Mete Tayanç & Kamil Erkan & Abdulkadir Atalan, 2020. "Development of Nonlinear Optimization Models for Wind Power Plants Using Box-Behnken Design of Experiment: A Case Study for Turkey," Sustainability, MDPI, vol. 12(15), pages 1-17, July.
    5. Ciprian Sorandaru & Sorin Musuroi & Flaviu Mihai Frigura-Iliasa & Doru Vatau & Marian Dordescu, 2019. "Analysis of the Wind System Operation in the Optimal Energetic Area at Variable Wind Speed over Time," Sustainability, MDPI, vol. 11(5), pages 1-16, February.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Sidaard Gunasekaran & Madison Peyton & Neal Novotny, 2022. "Aerodynamic Interactions of Wind Lenses at Close Proximities," Energies, MDPI, vol. 15(13), pages 1-17, June.
    2. Saleem, Arslan & Kim, Man-Hoe, 2020. "Aerodynamic performance optimization of an airfoil-based airborne wind turbine using genetic algorithm," Energy, Elsevier, vol. 203(C).
    3. N. Aravindhan & M. P. Natarajan & S. Ponnuvel & P.K. Devan, 2023. "Recent developments and issues of small-scale wind turbines in urban residential buildings- A review," Energy & Environment, , vol. 34(4), pages 1142-1169, June.
    4. Ahmad Fazlizan & Wen Tong Chong & Sook Yee Yip & Wooi Ping Hew & Sin Chew Poh, 2015. "Design and Experimental Analysis of an Exhaust Air Energy Recovery Wind Turbine Generator," Energies, MDPI, vol. 8(7), pages 1-19, June.
    5. Chong, W.T. & Gwani, M. & Shamshirband, S. & Muzammil, W.K. & Tan, C.J. & Fazlizan, A. & Poh, S.C. & Petković, Dalibor & Wong, K.H., 2016. "Application of adaptive neuro-fuzzy methodology for performance investigation of a power-augmented vertical axis wind turbine," Energy, Elsevier, vol. 102(C), pages 630-636.
    6. Ye, Jianjun & Cheng, Yanglin & Xie, Junlong & Huang, Xiaohong & Zhang, Yuan & Hu, Siyao & Salem, Shehab & Wu, Jiejun, 2020. "Effects of divergent angle on the flow behaviors in low speed wind accelerating ducts," Renewable Energy, Elsevier, vol. 152(C), pages 1292-1301.
    7. Silva, Paulo A.S.F. & Tsoutsanis, Panagiotis & Vaz, Jerson R.P. & Macias, Marianela M., 2024. "A comprehensive CFD investigation of tip vortex trajectory in shrouded wind turbines using compressible RANS solver," Energy, Elsevier, vol. 294(C).
    8. Rahmatian, Mohammad Ali & Hashemi Tari, Pooyan & Mojaddam, Mohammad & Majidi, Sahand, 2022. "Numerical and experimental study of the ducted diffuser effect on improving the aerodynamic performance of a micro horizontal axis wind turbine," Energy, Elsevier, vol. 245(C).
    9. Søren Hjort & Helgi Larsen, 2015. "Rotor Design for Diffuser Augmented Wind Turbines," Energies, MDPI, vol. 8(10), pages 1-39, September.
    10. Khamlaj, Tariq Abdulsalam & Rumpfkeil, Markus Peer, 2018. "Analysis and optimization of ducted wind turbines," Energy, Elsevier, vol. 162(C), pages 1234-1252.
    11. Keramat Siavash, Nemat & Najafi, G. & Tavakkoli Hashjin, Teymour & Ghobadian, Barat & Mahmoodi, Esmail, 2020. "Mathematical modeling of a horizontal axis shrouded wind turbine," Renewable Energy, Elsevier, vol. 146(C), pages 856-866.
    12. Leloudas, Stavros N. & Lygidakis, Georgios N. & Eskantar, Alexandros I. & Nikolos, Ioannis K., 2020. "A robust methodology for the design optimization of diffuser augmented wind turbine shrouds," Renewable Energy, Elsevier, vol. 150(C), pages 722-742.
    13. Liu, Jie & Song, Mengxuan & Chen, Kai & Wu, Bingheng & Zhang, Xing, 2016. "An optimization methodology for wind lens profile using Computational Fluid Dynamics simulation," Energy, Elsevier, vol. 109(C), pages 602-611.
    14. Göltenbott, Uli & Ohya, Yuji & Yoshida, Shigeo & Jamieson, Peter, 2017. "Aerodynamic interaction of diffuser augmented wind turbines in multi-rotor systems," Renewable Energy, Elsevier, vol. 112(C), pages 25-34.
    15. Dessoky, Amgad & Bangga, Galih & Lutz, Thorsten & Krämer, Ewald, 2019. "Aerodynamic and aeroacoustic performance assessment of H-rotor darrieus VAWT equipped with wind-lens technology," Energy, Elsevier, vol. 175(C), pages 76-97.
    16. Xu, Bin & Ma, Qiyu & Huang, Diangui, 2021. "Research on energy harvesting properties of a diffuser-augmented flapping wing," Renewable Energy, Elsevier, vol. 180(C), pages 271-280.
    17. Vaz, Jerson R.P. & Wood, David H., 2018. "Effect of the diffuser efficiency on wind turbine performance," Renewable Energy, Elsevier, vol. 126(C), pages 969-977.
    18. Sridhar, Surya & Zuber, Mohammad & B., Satish Shenoy & Kumar, Amit & Ng, Eddie Y.K. & Radhakrishnan, Jayakrishnan, 2022. "Aerodynamic comparison of slotted and non-slotted diffuser casings for Diffuser Augmented Wind Turbines (DAWT)," Renewable and Sustainable Energy Reviews, Elsevier, vol. 161(C).
    19. Seyedsaeed Tabatabaeikia & Nik Nazri Bin Nik-Ghazali & Wen Tong Chong & Behzad Shahizare & Ahmad Fazlizan & Alireza Esmaeilzadeh & Nima Izadyar, 2016. "A Comparative Computational Fluid Dynamics Study on an Innovative Exhaust Air Energy Recovery Wind Turbine Generator," Energies, MDPI, vol. 9(5), pages 1-19, May.
    20. Ben Hamida, Imen & Salah, Saoussen Brini & Msahli, Faouzi & Mimouni, Mohamed Faouzi, 2018. "Optimal network reconfiguration and renewable DG integration considering time sequence variation in load and DGs," Renewable Energy, Elsevier, vol. 121(C), pages 66-80.

    More about this item

    Keywords

    ;
    ;
    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jsusta:v:10:y:2018:i:8:p:2647-:d:160367. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.