IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i6p2861-d1101958.html
   My bibliography  Save this article

A CFD Study on the Effects of Injection Timing and Spray Inclusion Angle on Performance and Emission Characteristics of a DI Diesel Engine Operating in Diffusion-Controlled and PCCI Modes of Combustion

Author

Listed:
  • Cengizhan Cengiz

    (Ford Otosan A.Ş. Eskişehir R&D Test Centre, 26670 Eskisehir, Türkiye)

  • Salih Ozen Unverdi

    (Department of Mechanical Engineering, Gebze Technical University, 41400 Kocaeli, Türkiye)

Abstract

In three-dimensional (3D) computational fluid dynamics (CFD) simulations, the effects of injection timing and spray inclusion angle (SIA) on performance and emissions of diffusion-controlled and Premixed Charge Compression Ignition (PCCI) combustion in part load for a heavy-duty direct injection (HDDI) diesel engine are studied. The start of injection (SOI) of a 146° SIA injector is varied between −70 and −10 °crank angle (°CA) after top dead center (ATDC). For −50 °CA ATDC SOI with various SIAs between 80° and 146°, PCCI combustion reduces mono-nitrogen oxide (NO x ) emissions significantly compared to conventional diesel combustion (CDC). Due to incomplete combustion in rich zones formed by droplet–cylinder wall interaction, early wide SIA injection deteriorates combustion efficiency (CE) and Indicated Mean Effective Pressure (IMEP) and increases soot and carbon monoxide (CO) emissions. Narrow-angle sprays interacting with the piston bowl elevate CE and IMEP and decrease soot and CO emissions but increases NO x emissions. Optimal combustion is achieved by avoiding fuel droplet–cylinder wall interaction. By spray-targeting at the stepped lip of the piston bowl, 100° SIA and −50 °CA ATDC SOI yield, respectively, the highest CE and IMEP: 97.8% and 3.37 bar and the lowest soot and CO emissions: 33.5 and 2.2 ppm, with acceptable NO x emissions.

Suggested Citation

  • Cengizhan Cengiz & Salih Ozen Unverdi, 2023. "A CFD Study on the Effects of Injection Timing and Spray Inclusion Angle on Performance and Emission Characteristics of a DI Diesel Engine Operating in Diffusion-Controlled and PCCI Modes of Combustio," Energies, MDPI, vol. 16(6), pages 1-43, March.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:6:p:2861-:d:1101958
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/6/2861/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/6/2861/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Gan, Suyin & Ng, Hoon Kiat & Pang, Kar Mun, 2011. "Homogeneous Charge Compression Ignition (HCCI) combustion: Implementation and effects on pollutants in direct injection diesel engines," Applied Energy, Elsevier, vol. 88(3), pages 559-567, March.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Huabing Wen & Yue Yu & Jingrui Li & Changchun Xu & Haiguo Jing & Jianhua Shen, 2023. "Numerical Investigation on the Influence of Injection Location and Injection Strategy on a High-Pressure Direct Injection Diesel/Methanol Dual-Fuel Engine," Energies, MDPI, vol. 16(11), pages 1-26, June.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Ghazimirsaied, Ahmad & Koch, Charles Robert, 2012. "Controlling cyclic combustion timing variations using a symbol-statistics predictive approach in an HCCI engine," Applied Energy, Elsevier, vol. 92(C), pages 133-146.
    2. Liang, Chen & Ji, Changwei & Liu, Xiaolong, 2011. "Combustion and emissions performance of a DME-enriched spark-ignited methanol engine at idle condition," Applied Energy, Elsevier, vol. 88(11), pages 3704-3711.
    3. Andwari, Amin Mahmoudzadeh & Aziz, Azhar Abdul & Said, Mohd Farid Muhamad & Latiff, Zulkarnain Abdul, 2014. "Experimental investigation of the influence of internal and external EGR on the combustion characteristics of a controlled auto-ignition two-stroke cycle engine," Applied Energy, Elsevier, vol. 134(C), pages 1-10.
    4. Zhu, Mingming & Ma, Yu & Zhang, Dongke, 2012. "Effect of a homogeneous combustion catalyst on the combustion characteristics and fuel efficiency in a diesel engine," Applied Energy, Elsevier, vol. 91(1), pages 166-172.
    5. Li, Zilong & Zhang, Yaoyuan & Huang, Guan & Zhao, Wenbin & He, Zhuoyao & Qian, Yong & Lu, Xingcai, 2020. "Control of intake boundary conditions for enabling clean combustion in variable engine conditions under intelligent charge compression ignition (ICCI) mode," Applied Energy, Elsevier, vol. 274(C).
    6. Yin, Lianhao & Lundgren, Marcus & Wang, Zhenkan & Stamatoglou, Panagiota & Richter, Mattias & Andersson, Öivind & Tunestål, Per, 2019. "High efficient internal combustion engine using partially premixed combustion with multiple injections," Applied Energy, Elsevier, vol. 233, pages 516-523.
    7. Pachiannan, Tamilselvan & Zhong, Wenjun & Rajkumar, Sundararajan & He, Zhixia & Leng, Xianying & Wang, Qian, 2019. "A literature review of fuel effects on performance and emission characteristics of low-temperature combustion strategies," Applied Energy, Elsevier, vol. 251(C), pages 1-1.
    8. Torregrosa, A.J. & Broatch, A. & García, A. & Mónico, L.F., 2013. "Sensitivity of combustion noise and NOx and soot emissions to pilot injection in PCCI Diesel engines," Applied Energy, Elsevier, vol. 104(C), pages 149-157.
    9. Charitha, V. & Thirumalini, S. & Prasad, M. & Srihari, S., 2019. "Investigation on performance and emissions of RCCI dual fuel combustion on diesel - bio diesel in a light duty engine," Renewable Energy, Elsevier, vol. 134(C), pages 1081-1088.
    10. Hung, Nguyen Ba & Lim, Ocktaeck & Iida, Norimasa, 2015. "The effects of key parameters on the transition from SI combustion to HCCI combustion in a two-stroke free piston linear engine," Applied Energy, Elsevier, vol. 137(C), pages 385-401.
    11. Guan, Wei & Gu, Jinkai & Pan, Xiubin & Pan, Mingzhang & Wang, Xinyan & Zhao, Hua & Tan, Dongli & Fu, Changcheng & Pedrozo, Vinícius B. & Zhang, Zhiqing, 2024. "Improvement of the light-load combustion control strategy for a heavy-duty diesel engine fueled with diesel/methonal by RSM-NSGA III," Energy, Elsevier, vol. 297(C).
    12. Fang, Cheng & Yang, Fuyuan & Ouyang, Minggao & Gao, Guojing & Chen, Lin, 2013. "Combustion mode switching control in a HCCI diesel engine," Applied Energy, Elsevier, vol. 110(C), pages 190-200.
    13. Zhao, Wenbin & Mi, Shijie & Wu, Haoqing & Zhang, Yaoyuan & Zhang, Qiankun & He, Zhuoyao & Qian, Yong & Lu, Xingcai, 2022. "Towards a comprehensive understanding of mode transition between biodiesel-biobutanol dual-fuel ICCI low temperature combustion and conventional CI combustion – Part Ⅰ: Characteristics from medium to ," Energy, Elsevier, vol. 246(C).
    14. Thangaraja, J. & Kannan, C., 2016. "Effect of exhaust gas recirculation on advanced diesel combustion and alternate fuels - A review," Applied Energy, Elsevier, vol. 180(C), pages 169-184.
    15. Wu, Horng-Wen & Wang, Ren-Hung & Ou, Dung-Je & Chen, Ying-Chuan & Chen, Teng-yu, 2011. "Reduction of smoke and nitrogen oxides of a partial HCCI engine using premixed gasoline and ethanol with air," Applied Energy, Elsevier, vol. 88(11), pages 3882-3890.
    16. Badra, Jihad & Viollet, Yoann & Elwardany, Ahmed & Im, Hong G. & Chang, Junseok, 2016. "Physical and chemical effects of low octane gasoline fuels on compression ignition combustion," Applied Energy, Elsevier, vol. 183(C), pages 1197-1208.
    17. Zhen, Xudong & Wang, Yang & Xu, Shuaiqing & Zhu, Yongsheng & Tao, Chengjun & Xu, Tao & Song, Mingzhi, 2012. "The engine knock analysis – An overview," Applied Energy, Elsevier, vol. 92(C), pages 628-636.
    18. Yang, Binbin & Yao, Mingfa & Cheng, Wai K. & Li, Yu & Zheng, Zunqing & Li, Shanju, 2014. "Experimental and numerical study on different dual-fuel combustion modes fuelled with gasoline and diesel," Applied Energy, Elsevier, vol. 113(C), pages 722-733.
    19. Jafarmadar, Samad & Nemati, Peyman, 2016. "Exergy analysis of diesel/biodiesel combustion in a homogenous charge compression ignition (HCCI) engine using three-dimensional model," Renewable Energy, Elsevier, vol. 99(C), pages 514-523.
    20. Fathi, Morteza & Saray, R. Khoshbakhti & Checkel, M. David, 2011. "The influence of Exhaust Gas Recirculation (EGR) on combustion and emissions of n-heptane/natural gas fueled Homogeneous Charge Compression Ignition (HCCI) engines," Applied Energy, Elsevier, vol. 88(12), pages 4719-4724.

    More about this item

    Keywords

    ;
    ;
    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:6:p:2861-:d:1101958. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.