IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i2p1008-d1037978.html
   My bibliography  Save this article

Secondary Atomization of Fuel Oil and Fuel Oil/Water Emulsion through Droplet-Droplet Collisions and Impingement on a Solid Wall

Author

Listed:
  • Anastasia Islamova

    (Heat and Mass Transfer Laboratory, National Research Tomsk Polytechnic University, Tomsk 634050, Russia)

  • Pavel Tkachenko

    (Heat and Mass Transfer Laboratory, National Research Tomsk Polytechnic University, Tomsk 634050, Russia)

  • Nikita Shlegel

    (Heat and Mass Transfer Laboratory, National Research Tomsk Polytechnic University, Tomsk 634050, Russia)

  • Genii Kuznetsov

    (Heat and Mass Transfer Laboratory, National Research Tomsk Polytechnic University, Tomsk 634050, Russia)

Abstract

This paper presents findings from an experimental study investigating the secondary atomization of liquid fuel droplets widely used in the heat and power industry exemplified by fuel oil and environmentally promising fuel oil/water emulsion. The scientific novelty comes from the comparative analysis of the critical conditions and integral characteristics of the secondary atomization of the liquid and composite fuels with the greatest potential for power plants. Here, we used two fuel atomization schemes: droplet–droplet collisions in a gas and droplets impinging on a heated solid wall. The temperature of the liquids under study was 80 °C. The velocities before collision ranged from 0.1 m/s to 7 m/s, while the initial droplet sizes varied from 0.3 mm to 2.7 mm. A copper substrate served as a solid wall; its temperature was varied from 20 °C to 300 °C. The main characteristics of droplet interaction were recorded by a high-speed camera. Regime maps were constructed using the experimental findings. It was established that the critical Weber number was several times lower when water and fuel oil droplets collided than during the collision of fuel oil droplets with 10 vol% of water. The secondary atomization of fuel oil/water emulsion droplets by their impingement on a heated solid wall was found to reduce the typical sizes of liquid fragments by a factor of 40–50. As shown in the paper, even highly viscous fuels can be effectively sprayed using primary and secondary droplet atomization schemes. It was established that the optimal temperature of the fuel oil to be supplied to the droplet collision zone is 80 °C, while the optimal substrate temperature for the atomization of fuel oil/water emulsion droplets approximates 300 °C.

Suggested Citation

  • Anastasia Islamova & Pavel Tkachenko & Nikita Shlegel & Genii Kuznetsov, 2023. "Secondary Atomization of Fuel Oil and Fuel Oil/Water Emulsion through Droplet-Droplet Collisions and Impingement on a Solid Wall," Energies, MDPI, vol. 16(2), pages 1-27, January.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:2:p:1008-:d:1037978
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/2/1008/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/2/1008/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Liu Wang & Yue Ding & Yinan Qiu & Yunxing Yu & Junlong Xie & Jianye Chen, 2022. "Numerical Study on Spreading and Vaporization Process of Liquid Nitrogen Droplet Impinging on Heated Wall," Energies, MDPI, vol. 15(22), pages 1-20, November.
    2. Darbandi, Masoud & Fatin, Ali & Bordbar, Hadi, 2020. "Numerical study on NOx reduction in a large-scale heavy fuel oil-fired boiler using suitable burner adjustments," Energy, Elsevier, vol. 199(C).
    3. Bin Huang & Xiaohan Nan & Cheng Fu & Weibo Liu & Wei Guo & Siqi Wang & Lu Zhang, 2022. "Probing the Coalescence Mechanism of Oil Droplets in Fluids Produced by Oil Wells and the Microscopic Interaction between Molecules in Oil Films," Energies, MDPI, vol. 15(12), pages 1-17, June.
    4. Changchun Xu & Haengmuk Cho, 2021. "Effect of Methanol/Water Mixed Fuel Compound Injection on Engine Combustion and Emissions," Energies, MDPI, vol. 14(15), pages 1-14, July.
    5. Zhang, Xiaoqing & Li, Tie & Wang, Bin & Wei, Yijie, 2018. "Superheat limit and micro-explosion in droplets of hydrous ethanol-diesel emulsions at atmospheric pressure and diesel-like conditions," Energy, Elsevier, vol. 154(C), pages 535-543.
    6. Peter K. H. Ho & Ji-Seon Kim & Jeremy H. Burroughes & Heinrich Becker & Sam F. Y. Li & Thomas M. Brown & Franco Cacialli & Richard H. Friend, 2000. "Molecular-scale interface engineering for polymer light-emitting diodes," Nature, Nature, vol. 404(6777), pages 481-484, March.
    7. Dmitry Antonov & Jérôme Bellettre & Dominique Tarlet & Patrizio Massoli & Olga Vysokomornaya & Maxim Piskunov, 2018. "Impact of Holder Materials on the Heating and Explosive Breakup of Two-Component Droplets," Energies, MDPI, vol. 11(12), pages 1-17, November.
    8. M. Mukhtar N. A. & Abd Rashid Abd Aziz & Ftwi Y. Hagos & M. M. Noor & Kumaran Kadirgama & Rizalman Mamat & A. Adam Abdullah, 2019. "The Influence of Formulation Ratio and Emulsifying Settings on Tri-Fuel (Diesel–Ethanol–Biodiesel) Emulsion Properties," Energies, MDPI, vol. 12(9), pages 1-24, May.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Rosli, Mohd A.F. & Aziz, A. Rashid A. & Ismael, Mhadi A. & Elbashir, Nimir O. & Zainal A., Ezrann Z. & Baharom, Masri & Mohammed, Salah E., 2021. "Experimental study of micro-explosion and puffing of gas-to-liquid (GTL) fuel blends by suspended droplet method," Energy, Elsevier, vol. 218(C).
    2. Huang, Xiaoyu & Wang, Jigang & Wang, Yuxin & Qiao, Xinqi & Ju, Dehao & Sun, Chunhua & Zhang, Qibin, 2020. "Experimental study on evaporation and micro-explosion characteristics of biodiesel/n-propanol blended droplet," Energy, Elsevier, vol. 205(C).
    3. Wang, Jigang & Qiao, Xinqi & Ju, Dehao & Wang, Lintao & Sun, Chunhua, 2019. "Experimental study on the evaporation and micro-explosion characteristics of nanofuel droplet at dilute concentrations," Energy, Elsevier, vol. 183(C), pages 149-159.
    4. Maxim Belonogov & Vadim Dorokhov & Dmitrii Glushkov & Daria Kuznechenkova & Daniil Romanov, 2023. "Combustion Characteristics of Coal-Water Slurry Droplets in High-Temperature Air with the Addition of Syngas," Energies, MDPI, vol. 16(8), pages 1-17, April.
    5. Wang, Zhaowen & Yuan, Bo & Cao, Junhui & Huang, Yuhan & Cheng, Xiaobei & Wang, Yuzhou & Zhang, Xinhua & Liu, Hao, 2022. "A new shift mechanism for micro-explosion of water-diesel emulsion droplets at different ambient temperatures," Applied Energy, Elsevier, vol. 323(C).
    6. Ismael, Mhadi A. & A. Aziz, A. Rashid & Mohammed, Salah E. & Zainal A, Ezrann Z. & Baharom, Masri B. & Hagos, Ftwi Yohaness, 2021. "Macroscopic and microscopic spray structure of water-in-diesel emulsions," Energy, Elsevier, vol. 223(C).
    7. Dmitrii V. Antonov & Roman M. Fedorenko & Leonid S. Yanovskiy & Pavel A. Strizhak, 2023. "Physical and Mathematical Models of Micro-Explosions: Achievements and Directions of Improvement," Energies, MDPI, vol. 16(16), pages 1-16, August.
    8. Jiamao Luo & Shengfang Huang & Shunhua Yang & Wanzhou Zhang & Zhongqiang Mu, 2022. "Effect of Water Injection on Turbine Inlet under Different Flight Conditions," Energies, MDPI, vol. 15(19), pages 1-16, October.
    9. Dmitrii V. Antonov & Roman M. Fedorenko & Pavel A. Strizhak, 2022. "Micro-Explosion Phenomenon: Conditions and Benefits," Energies, MDPI, vol. 15(20), pages 1-19, October.
    10. Won, Jonghan & Baek, Seung Wook & Kim, Hyemin, 2018. "Autoignition and combustion behavior of emulsion droplet under elevated temperature and pressure conditions," Energy, Elsevier, vol. 163(C), pages 800-810.
    11. Jonghan Won & Seung Wook Baek & Hyemin Kim & Hookyung Lee, 2019. "The Viscosity and Combustion Characteristics of Single-Droplet Water-Diesel Emulsion," Energies, MDPI, vol. 12(10), pages 1-12, May.
    12. Zhang, Yu & Huang, Ronghua & Huang, Sheng & Zhou, Pei & Rao, Xiaoxuan & Zhang, Guojun & Qiu, Liang, 2021. "Experimental study on puffing, auto-ignition and combustion characteristics of an n-pentanol-diesel droplet," Energy, Elsevier, vol. 223(C).
    13. Huabing Wen & Yue Yu & Jingrui Li & Changchun Xu & Haiguo Jing & Jianhua Shen, 2023. "Numerical Investigation on the Influence of Injection Location and Injection Strategy on a High-Pressure Direct Injection Diesel/Methanol Dual-Fuel Engine," Energies, MDPI, vol. 16(11), pages 1-26, June.
    14. Mukhtar, M.N.A. & Hagos, Ftwi Y. & Noor, M.M. & Mamat, Rizalman & Abdullah, A. Adam & Abd Aziz, Abd Rashid, 2019. "Tri-fuel emulsion with secondary atomization attributes for greener diesel engine – A critical review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 111(C), pages 490-506.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:2:p:1008-:d:1037978. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.