IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i23p8846-d981836.html
   My bibliography  Save this article

Impacts of Intake Throttling on the Combustion Characteristics and Emissions of a Light-Duty Diesel Engine under the Idle Mode

Author

Listed:
  • Meng Lyu

    (College of Automotive Engineering, Guangdong Polytechnic of Industry and Commerce, Guangzhou 510510, China
    Department of Mechanical Engineering, University of Texas at Austin, Austin, TX 78712, USA)

  • Yousif Alsulaiman

    (Department of Mechanical Engineering, University of Texas at Austin, Austin, TX 78712, USA)

  • Matthew J. Hall

    (Department of Mechanical Engineering, University of Texas at Austin, Austin, TX 78712, USA)

  • Ronald D. Matthews

    (Department of Mechanical Engineering, University of Texas at Austin, Austin, TX 78712, USA)

Abstract

Intake throttling has been verified as an effective approach to increase the exhaust temperature of diesel engines, which could benefit the catalytic efficiency aftertreatment. To better understand the influence of intake throttling on the combustion characteristics and exhaust emissions of light-duty diesel engines operating under idle mode, a light-duty diesel engine was experimentally investigated. This study is a follow-on to previous studies on the effect of throttling on light-duty diesel engine exhaust temperatures and emissions. Tests were conducted at a fixed idle speed of 1100 rpm, and the throttle position and intake manifold air pressure (MAP) were varied. The in-cylinder pressure, pressure rise rate, heat release rate (HRR), in-cylinder temperature, exhaust temperature, and regular gaseous emissions were analyzed. The results indicated that under the influence of intake throttling, the MAP decreased from 101 kPa under wide-open-throttle (WOT) conditions to 52.5 kPa under the heaviest throttling conditions, and the exhaust temperature increased from 100 °C to 200 °C, with a fuel penalty associated with the increase in the pumping indicated mean effective pressure (IMEP). The in-cylinder pressure continuously declined with decreasing MAP, while the HRR generally increased with increasing MAP. Under WOT conditions, the ignition delay decreased, while the combustion duration decreased under heavier throttling conditions. The in-cylinder temperature with throttling was higher than that under WOT conditions, and after post-injection treatment, the in-cylinder temperature exhibited an increasing trend with decreasing MAP. The CO 2 , CO, NO x , and HC emissions increased with increasing throttling amounts.

Suggested Citation

  • Meng Lyu & Yousif Alsulaiman & Matthew J. Hall & Ronald D. Matthews, 2022. "Impacts of Intake Throttling on the Combustion Characteristics and Emissions of a Light-Duty Diesel Engine under the Idle Mode," Energies, MDPI, vol. 15(23), pages 1-12, November.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:23:p:8846-:d:981836
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/23/8846/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/23/8846/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Zhang, Wei & Chen, Zhaohui & Li, Weidong & Shu, Gequn & Xu, Biao & Shen, Yinggang, 2013. "Influence of EGR and oxygen-enriched air on diesel engine NO–Smoke emission and combustion characteristic," Applied Energy, Elsevier, vol. 107(C), pages 304-314.
    2. Jiang, Jibing & Li, Dinggen, 2016. "Theoretical analysis and experimental confirmation of exhaust temperature control for diesel vehicle NOx emissions reduction," Applied Energy, Elsevier, vol. 174(C), pages 232-244.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Gang Wu & Guoda Feng & Yuelin Li & Tao Ling & Xuejun Peng & Zhilai Su & Xiaohuan Zhao, 2024. "A Review of Thermal Energy Management of Diesel Exhaust after-Treatment Systems Technology and Efficiency Enhancement Approaches," Energies, MDPI, vol. 17(3), pages 1-32, January.
    2. Jia, Guorui & Wang, Hu & Tong, Laihui & Wang, Xiaofeng & Zheng, Zunqing & Yao, Mingfa, 2017. "Experimental and numerical studies on three gasoline surrogates applied in gasoline compression ignition (GCI) mode," Applied Energy, Elsevier, vol. 192(C), pages 59-70.
    3. Aliyu, Mansur & Abdelhafez, Ahmed & Nemitallah, Medhat A. & Said, Syed A.M. & Habib, Mohamed A., 2022. "Effects of adiabatic flame temperature on flames’ characteristics in a gas-turbine combustor," Energy, Elsevier, vol. 243(C).
    4. Wei, Li & Yan, Fuwu & Hu, Jie & Xi, Guangwei & Liu, Bo & Zeng, Jiawei, 2017. "Nox conversion efficiency optimization based on NSGA-II and state-feedback nonlinear model predictive control of selective catalytic reduction system in diesel engine," Applied Energy, Elsevier, vol. 206(C), pages 959-971.
    5. Mera, Zamir & Fonseca, Natalia & López, José-María & Casanova, Jesús, 2019. "Analysis of the high instantaneous NOx emissions from Euro 6 diesel passenger cars under real driving conditions," Applied Energy, Elsevier, vol. 242(C), pages 1074-1089.
    6. Park, Youngsoo & Bae, Choongsik, 2014. "Experimental study on the effects of high/low pressure EGR proportion in a passenger car diesel engine," Applied Energy, Elsevier, vol. 133(C), pages 308-316.
    7. Fan, Wenguang & Chan, Ka Yan & Zhang, Chengxu & Zhang, Kai & Ning, Zhi & Leung, Michael K.H., 2018. "Solar photocatalytic asphalt for removal of vehicular NOx: A feasibility study," Applied Energy, Elsevier, vol. 225(C), pages 535-541.
    8. Pan, Mingzhang & Zheng, Zeyuan & Huang, Rong & Zhou, Xiaorong & Huang, Haozhong & Pan, Jiaying & Chen, Zhaohui, 2019. "Reduction in PM and NOX of a diesel engine integrated with n-octanol fuel addition and exhaust gas recirculation," Energy, Elsevier, vol. 187(C).
    9. Ba Hung, Nguyen & Lim, Ocktaeck, 2019. "The effects of operating conditions and structural parameters on the dynamic, electric consumption and power generation characteristics of an electric assisted bicycle," Applied Energy, Elsevier, vol. 247(C), pages 285-296.
    10. Ayhan, Vezir & Ece, Yılmaz Mert, 2020. "New application to reduce NOx emissions of diesel engines: Electronically controlled direct water injection at compression stroke," Applied Energy, Elsevier, vol. 260(C).
    11. Hazar, Hanbey & Tekdogan, Remziye & Sevinc, Huseyin, 2021. "Determination of the effects of oxygen-enriched air with the help of zeolites on the exhaust emission and performance of a diesel engine," Energy, Elsevier, vol. 236(C).
    12. Li, Xiangrong & Gao, Haobu & Zhao, Luming & Zhang, Zheng & He, Xu & Liu, Fushui, 2016. "Combustion and emission performance of a split injection diesel engine in a double swirl combustion system," Energy, Elsevier, vol. 114(C), pages 1135-1146.
    13. Wang, Zhaowen & Shi, Shuguo & Huang, Sheng & Tang, Jie & Du, Tao & Cheng, Xiaobei & Huang, Ronghua & Chen, Jyh-Yuan, 2018. "Effects of water content on evaporation and combustion characteristics of water emulsified diesel spray," Applied Energy, Elsevier, vol. 226(C), pages 397-407.
    14. Li, Jun & Huang, Hongyu & Kobayashi, Noriyuki & Wang, Chenguang & Yuan, Haoran, 2017. "Numerical study on laminar burning velocity and ignition delay time of ammonia flame with hydrogen addition," Energy, Elsevier, vol. 126(C), pages 796-809.
    15. Zhang, Bin & E, Jiaqiang & Gong, Jinke & Yuan, Wenhua & Zuo, Wei & Li, Yu & Fu, Jun, 2016. "Multidisciplinary design optimization of the diesel particulate filter in the composite regeneration process," Applied Energy, Elsevier, vol. 181(C), pages 14-28.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:23:p:8846-:d:981836. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.