IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i19p7363-d935803.html
   My bibliography  Save this article

Co-Gasification of Refuse Derived Fuel and Wood Chips in the Nong Bua Dual Fluidised Bed Gasification Power Plant in Thailand

Author

Listed:
  • Janjira Hongrapipat

    (Güssing Renewable Energy (Thailand) Co., Ltd., Bangkok 10110, Thailand)

  • Reinhard Rauch

    (Engler-Bunte-Institut, Fuel Technology, Karlsruhe Institute of Technology, 76131 Karlsruhe, Germany)

  • Shusheng Pang

    (Department of Chemical and Process Engineering, University of Canterbury, Christchurch 8041, New Zealand)

  • Pansa Liplap

    (School of Agricultural Engineering, Institute of Engineering, Suranaree University of Technology, Nakhon Ratchasima 30000, Thailand)

  • Weerachai Arjharn

    (School of Agricultural Engineering, Institute of Engineering, Suranaree University of Technology, Nakhon Ratchasima 30000, Thailand)

  • Michael Messner

    (Güssing Renewable Energy (Thailand) Co., Ltd., Bangkok 10110, Thailand)

  • Christian Henrich

    (Güssing Renewable Energy (Thailand) Co., Ltd., Bangkok 10110, Thailand)

  • Markus Koch

    (Gussing Renewable Energy International Holding GmbH, 1040 Vienna, Austria)

  • Hermann Hofbauer

    (Institute of Chemical Engineering, Vienna University of Technology, 1060 Vienna, Austria)

Abstract

Co-gasification of refuse derived fuel (RDF) and wood chips was experimented in the Nong Bua dual fluidised bed steam gasifier in Thailand. The effect of the mass of RDF pellets in the feed fuel (R/F ratio) was investigated on the performance of the entire process conditions and the product gas properties. The test results showed that the addition of small mass ratio of RDF pellets up to 30% did not affect the process operation conditions. The concentrations of H 2 , CO, CO 2 , and CH 4 from a binary mixture of RDF pellets and wood chips were in the same ranges as that from pure wood chips. The lower heating value of the product gas was as high as 13.2–13.6 MJ/Nm 3 for all the R/F ratio fuels. It is concluded that binary mixtures of RDF pellets and wood chips with the mass percent of R/F ratio of 10–30% are good feedstocks in the Nong Bua dual fluidised bed gasification process. The tar content, however, from the binary mixtures of RDF pellets and wood chips was higher than that of pure wood chips. The tar must be completely removed before the product gas of the RDF pellets can be utilised in the gas engine.

Suggested Citation

  • Janjira Hongrapipat & Reinhard Rauch & Shusheng Pang & Pansa Liplap & Weerachai Arjharn & Michael Messner & Christian Henrich & Markus Koch & Hermann Hofbauer, 2022. "Co-Gasification of Refuse Derived Fuel and Wood Chips in the Nong Bua Dual Fluidised Bed Gasification Power Plant in Thailand," Energies, MDPI, vol. 15(19), pages 1-20, October.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:19:p:7363-:d:935803
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/19/7363/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/19/7363/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Nizami, A.S. & Shahzad, K. & Rehan, M. & Ouda, O.K.M. & Khan, M.Z. & Ismail, I.M.I. & Almeelbi, T. & Basahi, J.M. & Demirbas, A., 2017. "Developing waste biorefinery in Makkah: A way forward to convert urban waste into renewable energy," Applied Energy, Elsevier, vol. 186(P2), pages 189-196.
    2. Reinhard Rauch & Jitka Hrbek & Hermann Hofbauer, 2014. "Biomass gasification for synthesis gas production and applications of the syngas," Wiley Interdisciplinary Reviews: Energy and Environment, Wiley Blackwell, vol. 3(4), pages 343-362, July.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. AlNouss, Ahmed & McKay, Gordon & Al-Ansari, Tareq, 2020. "Enhancing waste to hydrogen production through biomass feedstock blending: A techno-economic-environmental evaluation," Applied Energy, Elsevier, vol. 266(C).
    2. Jun Sheng Teh & Yew Heng Teoh & Heoy Geok How & Thanh Danh Le & Yeoh Jun Jie Jason & Huu Tho Nguyen & Dong Lin Loo, 2021. "The Potential of Sustainable Biomass Producer Gas as a Waste-to-Energy Alternative in Malaysia," Sustainability, MDPI, vol. 13(7), pages 1-31, April.
    3. Gabbrielli, Roberto & Barontini, Federica & Frigo, Stefano & Bressan, Luigi, 2022. "Numerical analysis of bio-methane production from biomass-sewage sludge oxy-steam gasification and methanation process," Applied Energy, Elsevier, vol. 307(C).
    4. Emanuele Di Bisceglie & Alessandro Antonio Papa & Armando Vitale & Umberto Pasqual Laverdura & Andrea Di Carlo & Enrico Bocci, 2025. "Optimization of Biomass to Bio-Syntetic Natural Gas Production: Modeling and Assessment of the AIRE Project Plant Concept," Energies, MDPI, vol. 18(3), pages 1-23, February.
    5. Patuzzi, Francesco & Basso, Daniele & Vakalis, Stergios & Antolini, Daniele & Piazzi, Stefano & Benedetti, Vittoria & Cordioli, Eleonora & Baratieri, Marco, 2021. "State-of-the-art of small-scale biomass gasification systems: An extensive and unique monitoring review," Energy, Elsevier, vol. 223(C).
    6. Dejian Yu & Sun Meng, 2018. "An overview of biomass energy research with bibliometric indicators," Energy & Environment, , vol. 29(4), pages 576-590, June.
    7. Lech Nowicki & Dorota Siuta & Maciej Markowski, 2020. "Pyrolysis of Rapeseed Oil Press Cake and Steam Gasification of Solid Residues," Energies, MDPI, vol. 13(17), pages 1-12, August.
    8. Kuba, Matthias & Kraft, Stephan & Kirnbauer, Friedrich & Maierhans, Frank & Hofbauer, Hermann, 2018. "Influence of controlled handling of solid inorganic materials and design changes on the product gas quality in dual fluid bed gasification of woody biomass," Applied Energy, Elsevier, vol. 210(C), pages 230-240.
    9. Lin, Boqiang & Xu, Bin, 2018. "How to promote the growth of new energy industry at different stages?," Energy Policy, Elsevier, vol. 118(C), pages 390-403.
    10. Fernanda Paula da Costa Assunção & Diogo Oliveira Pereira & Jéssica Cristina Conte da Silva & Jorge Fernando Hungria Ferreira & Kelly Christina Alves Bezerra & Lucas Pinto Bernar & Caio Campos Ferreir, 2022. "A Systematic Approach to Thermochemical Treatment of Municipal Household Solid Waste into Valuable Products: Analysis of Routes, Gravimetric Analysis, Pre-Treatment of Solid Mixtures, Thermochemical P," Energies, MDPI, vol. 15(21), pages 1-30, October.
    11. Konstantinos Chandolias & Enise Pekgenc & Mohammad J. Taherzadeh, 2019. "Floating Membrane Bioreactors with High Gas Hold-Up for Syngas-to-Biomethane Conversion," Energies, MDPI, vol. 12(6), pages 1-14, March.
    12. Ahsanullah Soomro & Shiyi Chen & Shiwei Ma & Wenguo Xiang, 2018. "Catalytic activities of nickel, dolomite, and olivine for tar removal and H2-enriched gas production in biomass gasification process," Energy & Environment, , vol. 29(6), pages 839-867, September.
    13. Ayodele, T.R. & Ogunjuyigbe, A.S.O. & Alao, M.A., 2017. "Life cycle assessment of waste-to-energy (WtE) technologies for electricity generation using municipal solid waste in Nigeria," Applied Energy, Elsevier, vol. 201(C), pages 200-218.
    14. Arranz-Piera, Pol & Kemausuor, Francis & Darkwah, Lawrence & Edjekumhene, Ishmael & Cortés, Joan & Velo, Enrique, 2018. "Mini-grid electricity service based on local agricultural residues: Feasibility study in rural Ghana," Energy, Elsevier, vol. 153(C), pages 443-454.
    15. Jan Macháč & Lenka Zaňková, 2020. "Renewables—To Build or Not? Czech Approach to Impact Assessment of Renewable Energy Sources with an Emphasis on Municipality Perspective," Land, MDPI, vol. 9(12), pages 1-15, December.
    16. Arshid M. Ali & Ayyaz M. Nawaz & Hamad A. Al-Turaif & Khurram Shahzad, 2021. "The economic and environmental analysis of energy production from slaughterhouse waste in Saudi Arabia," Environment, Development and Sustainability: A Multidisciplinary Approach to the Theory and Practice of Sustainable Development, Springer, vol. 23(3), pages 4252-4269, March.
    17. Gaydaa Al Zohbi & Fahad Gallab AlAmri, 2024. "Current Situation of Renewable Energy in Saudi Arabia: Opportunities and Challenges," Journal of Sustainable Development, Canadian Center of Science and Education, vol. 13(2), pages 1-98, July.
    18. Florin Constantin Mihai & Maria-Grazie Gnoni & Christia Meidiana & Chukwunonye Ezeah & Valerio Elia, 2019. "Waste Electrical and Electronic Equipment (WEEE): Flows, Quantities, and Management—A Global Scenario," Post-Print hal-02276468, HAL.
    19. Feng, Hongyu & Cui, Jintao & Xu, Zhang & Hantoko, Dwi & Zhong, Li & Xu, Donghai & Yan, Mi, 2023. "Sewage sludge treatment via hydrothermal carbonization combined with supercritical water gasification: Fuel production and pollution degradation," Renewable Energy, Elsevier, vol. 210(C), pages 822-831.
    20. Justicia, Jéssica & Alberto Baeza, José & de Oliveira, Adriana S. & Calvo, Luisa & Heras, Francisco & Gilarranz, Miguel A., 2022. "Aqueous-phase reforming of water-soluble compounds from pyrolysis bio-oils," Renewable Energy, Elsevier, vol. 199(C), pages 895-907.

    More about this item

    Keywords

    ;
    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:19:p:7363-:d:935803. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.