IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v13y2020i6p1310-d331367.html
   My bibliography  Save this article

Numerical Study of the Winter–Kennedy Flow Measurement Method in Transient Flows

Author

Listed:
  • Binaya Baidar

    (Division of Fluid and Experimental Mechanics, Luleå University of Technology, SE-97187 Luleå, Sweden)

  • Jonathan Nicolle

    (Institut de recherche d’Hydro-Québec (IREQ), Varennes, QC J3X 1S1, Canada)

  • Bhupendra K. Gandhi

    (Department of Mechanical and Industrial Engineering, Indian Institute of Technology, Roorkee, Uttarakhand 247667, India)

  • Michel J. Cervantes

    (Division of Fluid and Experimental Mechanics, Luleå University of Technology, SE-97187 Luleå, Sweden)

Abstract

This paper explores the possibility of using the Winter–Kennedy (WK) method for transient flow rate measurement in hydraulic turbines. Computational fluid dynamic (CFD) analysis of a numerical model of an axial turbine was carried out for accelerating and decelerating flows. Those were obtained by linearly opening and closing of the guide vanes, respectively, while retaining the inlet pressure constant during the simulations. The behavior of several WK configurations on a cross-sectional plane and along the azimuthal direction of the spiral casing was studied during the transients. The study showed that there are certain WK configurations that are more stable than others. The physical mechanism behind the stability (or instability) of the WK method during transients is presented. Using the steady WK coefficient obtained at the best efficiency point (BEP), the WK method could estimate the transient flow rate with a deviation of about 7.5% and 3.5%, for accelerating and decelerating flow, respectively.

Suggested Citation

  • Binaya Baidar & Jonathan Nicolle & Bhupendra K. Gandhi & Michel J. Cervantes, 2020. "Numerical Study of the Winter–Kennedy Flow Measurement Method in Transient Flows," Energies, MDPI, vol. 13(6), pages 1-22, March.
    • Handle: RePEc:gam:jeners:v:13:y:2020:i:6:p:1310-:d:331367
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/13/6/1310/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/13/6/1310/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Huixiang Chen & Daqing Zhou & Yuan Zheng & Shengwen Jiang & An Yu & You Guo, 2018. "Load Rejection Transient Process Simulation of a Kaplan Turbine Model by Co-Adjusting Guide Vanes and Runner Blades," Energies, MDPI, vol. 11(12), pages 1-18, November.
    2. Iliev, Igor & Trivedi, Chirag & Dahlhaug, Ole Gunnar, 2019. "Variable-speed operation of Francis turbines: A review of the perspectives and challenges," Renewable and Sustainable Energy Reviews, Elsevier, vol. 103(C), pages 109-121.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Damian Liszka & Zbigniew Krzemianowski & Tomasz Węgiel & Dariusz Borkowski & Andrzej Polniak & Konrad Wawrzykowski & Artur Cebula, 2022. "Alternative Solutions for Small Hydropower Plants," Energies, MDPI, vol. 15(4), pages 1-31, February.
    2. Huang, Yifan & Yang, Weijia & Zhao, Zhigao & Han, Wenfu & Li, Yulan & Yang, Jiandong, 2023. "Dynamic modeling and favorable speed command of variable-speed pumped-storage unit during power regulation," Renewable Energy, Elsevier, vol. 206(C), pages 769-783.
    3. Eva Bílková & Jiří Souček & Martin Kantor & Roman Kubíček & Petr Nowak, 2023. "Variable-Speed Propeller Turbine for Small Hydropower Applications," Energies, MDPI, vol. 16(9), pages 1-14, April.
    4. Peng Guan & Yan-Ting Ai & Cheng-Wei Fei, 2019. "An Enhanced Flow-Thermo-Structural Modeling and Validation for the Integrated Analysis of a Film Cooling Nozzle Guide Vane," Energies, MDPI, vol. 12(14), pages 1-20, July.
    5. Krzemianowski, Zbigniew & Steller, Janusz, 2021. "High specific speed Francis turbine for small hydro purposes - Design methodology based on solving the inverse problem in fluid mechanics and the cavitation test experience," Renewable Energy, Elsevier, vol. 169(C), pages 1210-1228.
    6. Zheming Tong & Zhongqin Yang & Qing Huang & Qiang Yao, 2022. "Numerical Modeling of the Hydrodynamic Performance of Slanted Axial-Flow Urban Drainage Pumps at Shut-Off Condition," Energies, MDPI, vol. 15(5), pages 1-17, March.
    7. Fang Dao & Yun Zeng & Yidong Zou & Xiang Li & Jing Qian, 2021. "Acoustic Vibration Approach for Detecting Faults in Hydroelectric Units: A Review," Energies, MDPI, vol. 14(23), pages 1-16, November.
    8. Chirag Trivedi & Igor Iliev & Ole Gunnar Dahlhaug, 2020. "Numerical Study of a Francis Turbine over Wide Operating Range: Some Practical Aspects of Verification," Sustainability, MDPI, vol. 12(10), pages 1-10, May.
    9. Grzegorz Peczkis & Piotr Wiśniewski & Andriy Zahorulko, 2021. "Experimental and Numerical Studies on the Influence of Blade Number in a Small Water Turbine," Energies, MDPI, vol. 14(9), pages 1-15, May.
    10. Chen, Huixiang & Zhou, Daqing & Kan, Kan & Guo, Junxun & Zheng, Yuan & Binama, Maxime & Xu, Zhe & Feng, Jiangang, 2021. "Transient characteristics during the co-closing guide vanes and runner blades of a bulb turbine in load rejection process," Renewable Energy, Elsevier, vol. 165(P2), pages 28-41.
    11. Kougias, Ioannis & Aggidis, George & Avellan, François & Deniz, Sabri & Lundin, Urban & Moro, Alberto & Muntean, Sebastian & Novara, Daniele & Pérez-Díaz, Juan Ignacio & Quaranta, Emanuele & Schild, P, 2019. "Analysis of emerging technologies in the hydropower sector," Renewable and Sustainable Energy Reviews, Elsevier, vol. 113(C), pages 1-1.
    12. Fu, Shifeng & Zheng, Yuan & Kan, Kan & Chen, Huixiang & Han, Xingxing & Liang, Xiaoling & Liu, Huiwen & Tian, Xiaoqing, 2020. "Numerical simulation and experimental study of transient characteristics in an axial flow pump during start-up," Renewable Energy, Elsevier, vol. 146(C), pages 1879-1887.
    13. Trivedi, Chirag & Iliev, Igor & Dahlhaug, Ole Gunnar & Markov, Zoran & Engstrom, Fredrik & Lysaker, Henning, 2020. "Investigation of a Francis turbine during speed variation: Inception of cavitation," Renewable Energy, Elsevier, vol. 166(C), pages 147-162.
    14. Alessandro Morabito & Jan Spriet & Elena Vagnoni & Patrick Hendrick, 2020. "Underground Pumped Storage Hydropower Case Studies in Belgium: Perspectives and Challenges," Energies, MDPI, vol. 13(15), pages 1-24, August.
    15. Filip Stojkovski & Marija Lazarevikj & Zoran Markov & Igor Iliev & Ole Gunnar Dahlhaug, 2021. "Constraints of Parametrically Defined Guide Vanes for a High-Head Francis Turbine," Energies, MDPI, vol. 14(9), pages 1-13, May.
    16. Ke Liu & Feng Yang & Zhiyan Yang & Yunxian Zhu & Yongguang Cheng, 2019. "Runner Lifting-Up during Load Rejection Transients of a Kaplan Turbine: Flow Mechanism and Solution," Energies, MDPI, vol. 12(24), pages 1-15, December.
    17. Sha Li & Zezhou Cao & Kuangqing Hu & Diyi Chen, 2023. "Performance Assessment for Primary Frequency Regulation of Variable-Speed Pumped Storage Plant in Isolated Power Systems," Energies, MDPI, vol. 16(3), pages 1-16, January.
    18. Kan, Kan & Chen, Huixiang & Zheng, Yuan & Zhou, Daqing & Binama, Maxime & Dai, Jing, 2021. "Transient characteristics during power-off process in a shaft extension tubular pump by using a suitable numerical model," Renewable Energy, Elsevier, vol. 164(C), pages 109-121.
    19. Mercier, Thomas & Olivier, Mathieu & De Jaeger, Emmanuel, 2023. "The value of electricity storage arbitrage on day-ahead markets across Europe," Energy Economics, Elsevier, vol. 123(C).
    20. Kan, Kan & Zheng, Yuan & Chen, Huixiang & Zhou, Daqing & Dai, Jing & Binama, Maxime & Yu, An, 2020. "Numerical simulation of transient flow in a shaft extension tubular pump unit during runaway process caused by power failure," Renewable Energy, Elsevier, vol. 154(C), pages 1153-1164.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:13:y:2020:i:6:p:1310-:d:331367. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.