IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v13y2020i14p3546-d382633.html
   My bibliography  Save this article

Life Cycle Energy Cost Assessment for Pump Units with Various Types of Line-Start Operating Motors Including Cable Losses

Author

Listed:
  • Vadim Kazakbaev

    (Department of Electrical Engineering and Electric Technology Systems, Ural Federal University, Ekaterinburg 620002, Russia)

  • Vladimir Prakht

    (Department of Electrical Engineering and Electric Technology Systems, Ural Federal University, Ekaterinburg 620002, Russia)

  • Vladimir Dmitrievskii

    (Department of Electrical Engineering and Electric Technology Systems, Ural Federal University, Ekaterinburg 620002, Russia)

  • Safarbek Oshurbekov

    (Department of Electrical Engineering and Electric Technology Systems, Ural Federal University, Ekaterinburg 620002, Russia)

  • Dmitry Golovanov

    (Department of Electrical Engineering, University of Nottingham, Nottingham NG7 2RD, UK)

Abstract

The paper presents a comparative analysis of life-cycle energy consumption for three different types of 4 kW line-start motors used in a pump unit with throttling: the most widely used induction motor with IE3 efficiency class, line start permanent magnet synchronous motor with IE4 efficiency class and line start synchronous reluctance motor with IE4 efficiency class. The operating cycle for pump units with constant flow is considered for the above-mentioned types of motors taking into account not only the losses in the pump and motor, but also in the power supply cable. It is shown that the line start synchronous reluctance motor without magnets has the highest efficiency over the entire considered loading range. However, its power factor is lower than that of the synchronous motor with magnets and therefore it has more significant losses in power supply cable. Despite this disadvantage, the line-start reluctance motor is a good alternative to widespread induction motor since it allows saving of approximately 4000 euro more than the latter during the 20 years life cycle. It also provides similar savings in comparison to the permanent magnet synchronous motor, but unlike it, it does not have costly rare-earth materials in the rotor.

Suggested Citation

  • Vadim Kazakbaev & Vladimir Prakht & Vladimir Dmitrievskii & Safarbek Oshurbekov & Dmitry Golovanov, 2020. "Life Cycle Energy Cost Assessment for Pump Units with Various Types of Line-Start Operating Motors Including Cable Losses," Energies, MDPI, vol. 13(14), pages 1-15, July.
    • Handle: RePEc:gam:jeners:v:13:y:2020:i:14:p:3546-:d:382633
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/13/14/3546/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/13/14/3546/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Sungkyun Ha & Sungho Tae & Rakhyun Kim, 2019. "A Study on the Limitations of South Korea’s National Roadmap for Greenhouse Gas Reduction by 2030 and Suggestions for Improvement," Sustainability, MDPI, vol. 11(14), pages 1-18, July.
    2. Arun Shankar, Vishnu Kalaiselvan & Umashankar, Subramaniam & Paramasivam, Shanmugam & Hanigovszki, Norbert, 2016. "A comprehensive review on energy efficiency enhancement initiatives in centrifugal pumping system," Applied Energy, Elsevier, vol. 181(C), pages 495-513.
    3. Vadim Kazakbaev & Vladimir Prakht & Vladimir Dmitrievskii & Mohamed N. Ibrahim & Safarbek Oshurbekov & Sergey Sarapulov, 2019. "Efficiency Analysis of Low Electric Power Drives Employing Induction and Synchronous Reluctance Motors in Pump Applications," Energies, MDPI, vol. 12(6), pages 1-23, March.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Vladimir Prakht & Mohamed N. Ibrahim & Vadim Kazakbaev, 2023. "Energy Efficiency Improvement of Electric Machines without Rare-Earth Magnets," Energies, MDPI, vol. 16(8), pages 1-3, April.
    2. Vadim Kazakbaev & Safarbek Oshurbekov & Vladimir Prakht & Vladimir Dmitrievskii, 2021. "Feasibility Study of Direct-on-Line Energy-Efficient Motors in a Pumping Unit, Considering Reactive Power Compensation," Mathematics, MDPI, vol. 9(18), pages 1-15, September.
    3. Danilo Ferreira de Souza & Emeli Lalesca Aparecida da Guarda & Ildo Luis Sauer & Hédio Tatizawa, 2021. "Energy Efficiency Indicators for Water Pumping Systems in Multifamily Buildings," Energies, MDPI, vol. 14(21), pages 1-13, November.
    4. Hyunwoo Kim & Yeji Park & Seung-Taek Oh & Hyungkwan Jang & Sung-Hong Won & Yon-Do Chun & Ju Lee, 2020. "A Study on the Rotor Design of Line Start Synchronous Reluctance Motor for IE4 Efficiency and Improving Power Factor," Energies, MDPI, vol. 13(21), pages 1-15, November.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Safarbek Oshurbekov & Vadim Kazakbaev & Vladimir Prakht & Vladimir Dmitrievskii, 2021. "Improving Reliability and Energy Efficiency of Three Parallel Pumps by Selecting Trade-Off Operating Points," Mathematics, MDPI, vol. 9(11), pages 1-19, June.
    2. Victor Goman & Vladimir Prakht & Vadim Kazakbaev & Vladimir Dmitrievskii, 2021. "Comparative Study of Energy Consumption and CO 2 Emissions of Variable-Speed Electric Drives with Induction and Synchronous Reluctance Motors in Pump Units," Mathematics, MDPI, vol. 9(21), pages 1-16, October.
    3. Hye Gi Kim & Sun Sook Kim, 2020. "Occupants’ Awareness of and Satisfaction with Green Building Technologies in a Certified Office Building," Sustainability, MDPI, vol. 12(5), pages 1-16, March.
    4. Fernández Oro, J.M. & Barrio Perotti, R. & Galdo Vega, M. & González, J., 2023. "Effect of the radial gap size on the deterministic flow in a centrifugal pump due to impeller-tongue interactions," Energy, Elsevier, vol. 278(PA).
    5. Johnson, Hilary A. & Simon, Kevin P. & Slocum, Alexander H., 2021. "Data analytics and pump control in a wastewater treatment plant," Applied Energy, Elsevier, vol. 299(C).
    6. Diaz, Cesar & Ruiz, Fredy & Patino, Diego, 2017. "Modeling and control of water booster pressure systems as flexible loads for demand response," Applied Energy, Elsevier, vol. 204(C), pages 106-116.
    7. Xu, Wei & Chen, Genglin & Shi, Huijin & Zhang, Pengcheng & Chen, Xuemei, 2023. "Research on operational characteristics of coal power centrifugal fans at off-design working conditions based on flap-angle adjustment," Energy, Elsevier, vol. 284(C).
    8. Filipe, Jorge & Bessa, Ricardo J. & Reis, Marisa & Alves, Rita & Póvoa, Pedro, 2019. "Data-driven predictive energy optimization in a wastewater pumping station," Applied Energy, Elsevier, vol. 252(C), pages 1-1.
    9. José Ignacio Sarasúa & Guillermo Martínez-Lucas & Carlos A. Platero & José Ángel Sánchez-Fernández, 2018. "Dual Frequency Regulation in Pumping Mode in a Wind–Hydro Isolated System," Energies, MDPI, vol. 11(11), pages 1-17, October.
    10. Gan, Xingcheng & Pavesi, Giorgio & Pei, Ji & Yuan, Shouqi & Wang, Wenjie & Yin, Tingyun, 2022. "Parametric investigation and energy efficiency optimization of the curved inlet pipe with induced vane of an inline pump," Energy, Elsevier, vol. 240(C).
    11. Seongjo Wang & Sungho Tae & Rakhyun Kim, 2019. "Development of a Green Building Materials Integrated Platform Based on Materials and Resources in G-SEED in South Korea," Sustainability, MDPI, vol. 11(23), pages 1-19, November.
    12. Michał Napierała, 2022. "A Study on Improving Economy Efficiency of Pumping Stations Based on Tariff Changes," Energies, MDPI, vol. 15(3), pages 1-17, January.
    13. Giovanni Bucci & Fabrizio Ciancetta & Edoardo Fiorucci & Simone Mari & Maria Anna Segreto, 2019. "The Measurement of Additional Losses in Induction Motors: Discussion about the Actually Achievable Uncertainty," Energies, MDPI, vol. 13(1), pages 1-13, December.
    14. Chengshuo Wu & Jun Yang & Shuai Yang & Peng Wu & Bin Huang & Dazhuan Wu, 2023. "A Review of Fluid-Induced Excitations in Centrifugal Pumps," Mathematics, MDPI, vol. 11(4), pages 1-20, February.
    15. Liu, Jiahong & Wang, Jia & Ding, Xiangyi & Shao, Weiwei & Mei, Chao & Li, Zejin & Wang, Kaibo, 2020. "Assessing the mitigation of greenhouse gas emissions from a green infrastructure-based urban drainage system," Applied Energy, Elsevier, vol. 278(C).
    16. Daqing Zhou & Huixiang Chen & Yuan Zheng & Kan Kan & An Yu & Maxime Binama, 2019. "Development and Numerical Performance Analysis of a Pump Directly Driven by a Hydrokinetic Turbine," Energies, MDPI, vol. 12(22), pages 1-20, November.
    17. Qingchang Li & Seungkook Roh & Jin Won Lee, 2020. "Segmenting the South Korean Public According to Their Preferred Direction for Electricity Mix Reform," Sustainability, MDPI, vol. 12(21), pages 1-17, October.
    18. Xuetao Wang & Qianchuan Zhao & Yifan Wang, 2020. "A Distributed Optimization Method for Energy Saving of Parallel-Connected Pumps in HVAC Systems," Energies, MDPI, vol. 13(15), pages 1-24, July.
    19. Zhang, Liwen & Wang, Xin & Wu, Peng & Huang, Bin & Wu, Dazhuan, 2023. "Optimization of a centrifugal pump to improve hydraulic efficiency and reduce hydro-induced vibration," Energy, Elsevier, vol. 268(C).
    20. V.K. Arun Shankar & Umashankar Subramaniam & Sanjeevikumar Padmanaban & Jens Bo Holm-Nielsen & Frede Blaabjerg & S. Paramasivam, 2019. "Experimental Investigation of Power Signatures for Cavitation and Water Hammer in an Industrial Parallel Pumping System," Energies, MDPI, vol. 12(7), pages 1-14, April.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:13:y:2020:i:14:p:3546-:d:382633. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.