IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v13y2020i11p2846-d366830.html
   My bibliography  Save this article

CFD Analysis of the Fuel–Air Mixture Formation Process in Passive Prechambers for Use in a High-Pressure Direct Injection (HPDI) Two-Stroke Engine

Author

Listed:
  • Marco Ciampolini

    (Department of Industrial Engineering (DIEF), Università degli Studi di Firenze, via di Santa Marta 3, 50139 Firenze, Italy)

  • Simone Bigalli

    (Department of Industrial Engineering (DIEF), Università degli Studi di Firenze, via di Santa Marta 3, 50139 Firenze, Italy)

  • Francesco Balduzzi

    (Department of Industrial Engineering (DIEF), Università degli Studi di Firenze, via di Santa Marta 3, 50139 Firenze, Italy)

  • Alessandro Bianchini

    (Department of Industrial Engineering (DIEF), Università degli Studi di Firenze, via di Santa Marta 3, 50139 Firenze, Italy)

  • Luca Romani

    (Department of Industrial Engineering (DIEF), Università degli Studi di Firenze, via di Santa Marta 3, 50139 Firenze, Italy)

  • Giovanni Ferrara

    (Department of Industrial Engineering (DIEF), Università degli Studi di Firenze, via di Santa Marta 3, 50139 Firenze, Italy)

Abstract

The research on two-stroke engines has been focused lately on the development of direct injection systems for reducing the emissions of hydrocarbons by minimizing the fuel short-circuiting. Low temperature combustion (LTC) may be the next step to further improve emissions and fuel consumption; however, LTC requires unconventional ignition systems. Jet ignition, i.e., the use of prechambers to accelerate the combustion process, turned out to be an effective way to perform LTC. The present work aims at proving the feasibility of adopting passive prechambers in a high-pressure, direct injection, two-stroke engine through non-reactive computational fluid dynamics analyses. The goal of the analysis is the evaluation of the prechamber performance in terms of both scavenging efficiency of burnt gases and fuel/air mixture formation inside the prechamber volume itself, in order to guarantee the mixture ignitability. Two prechamber geometries, featuring different aspect ratios and orifice numbers, were investigated. The analyses were replicated for two different locations of the injection and for three operating conditions of the engine in terms of revolution speed and load. Upon examination of the results, the effectiveness of both prechambers was found to be strongly dependent on the injection setup.

Suggested Citation

  • Marco Ciampolini & Simone Bigalli & Francesco Balduzzi & Alessandro Bianchini & Luca Romani & Giovanni Ferrara, 2020. "CFD Analysis of the Fuel–Air Mixture Formation Process in Passive Prechambers for Use in a High-Pressure Direct Injection (HPDI) Two-Stroke Engine," Energies, MDPI, vol. 13(11), pages 1-25, June.
    • Handle: RePEc:gam:jeners:v:13:y:2020:i:11:p:2846-:d:366830
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/13/11/2846/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/13/11/2846/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Gentz, Gerald & Gholamisheeri, Masumeh & Toulson, Elisa, 2017. "A study of a turbulent jet ignition system fueled with iso-octane: Pressure trace analysis and combustion visualization," Applied Energy, Elsevier, vol. 189(C), pages 385-394.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Viktor Dilber & Momir Sjerić & Rudolf Tomić & Josip Krajnović & Sara Ugrinić & Darko Kozarac, 2022. "Optimization of Pre-Chamber Geometry and Operating Parameters in a Turbulent Jet Ignition Engine," Energies, MDPI, vol. 15(13), pages 1-21, June.
    2. Qinglin Zhang & Zhaoping Xu & Shuangshuang Liu & Liang Liu, 2020. "Effects of Injector Spray Angle on Performance of an Opposed-Piston Free-Piston Engine," Energies, MDPI, vol. 13(14), pages 1-17, July.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Benajes, J. & Novella, R. & Gomez-Soriano, J. & Martinez-Hernandiz, P.J. & Libert, C. & Dabiri, M., 2019. "Evaluation of the passive pre-chamber ignition concept for future high compression ratio turbocharged spark-ignition engines," Applied Energy, Elsevier, vol. 248(C), pages 576-588.
    2. Zheng, Lukai & Cronly, James & Ubogu, Emamode & Ahmed, Ihab & Zhang, Yang & Khandelwal, Bhupendra, 2019. "Experimental investigation on alternative fuel combustion performance using a gas turbine combustor," Applied Energy, Elsevier, vol. 238(C), pages 1530-1542.
    3. Viktor Dilber & Momir Sjerić & Rudolf Tomić & Josip Krajnović & Sara Ugrinić & Darko Kozarac, 2022. "Optimization of Pre-Chamber Geometry and Operating Parameters in a Turbulent Jet Ignition Engine," Energies, MDPI, vol. 15(13), pages 1-21, June.
    4. Nyamsuren Gombosuren & Ogami Yoshifumi & Asada Hiroyuki, 2020. "A Charge Possibility of an Unfueled Prechamber and Its Fluctuating Phenomenon for the Spark Ignited Engine," Energies, MDPI, vol. 13(2), pages 1-17, January.
    5. da Costa, Roberto Berlini Rodrigues & Rodrigues Filho, Fernando Antônio & Moreira, Thiago Augusto Araújo & Baêta, José Guilherme Coelho & Guzzo, Márcio Expedito & de Souza, José Leôncio Fonseca, 2020. "Exploring the lean limit operation and fuel consumption improvement of a homogeneous charge pre-chamber torch ignition system in an SI engine fueled with a gasoline-bioethanol blend," Energy, Elsevier, vol. 197(C).
    6. Xu, Leilei & Bai, Xue-Song & Jia, Ming & Qian, Yong & Qiao, Xinqi & Lu, Xingcai, 2018. "Experimental and modeling study of liquid fuel injection and combustion in diesel engines with a common rail injection system," Applied Energy, Elsevier, vol. 230(C), pages 287-304.
    7. Jung, Dongwon & Sasaki, Kosaku & Iida, Norimasa, 2017. "Effects of increased spark discharge energy and enhanced in-cylinder turbulence level on lean limits and cycle-to-cycle variations of combustion for SI engine operation," Applied Energy, Elsevier, vol. 205(C), pages 1467-1477.
    8. Biswas, Sayan & Qiao, Li, 2018. "Ignition of ultra-lean premixed hydrogen/air by an impinging hot jet," Applied Energy, Elsevier, vol. 228(C), pages 954-964.
    9. Wang, Lei & Zhao, Zhenfeng & Yu, Chuncun & Cui, Huasheng, 2022. "Experimental study of aviation kerosene engine with PJI system," Energy, Elsevier, vol. 248(C).
    10. Xu, Zidan & Zhang, Yahui & Di, Huanyu & Shen, Tielong, 2019. "Combustion variation control strategy with thermal efficiency optimization for lean combustion in spark-ignition engines," Applied Energy, Elsevier, vol. 251(C), pages 1-1.
    11. Hua, Jianxiong & Song, Yuntong & Zhou, Lei & Liu, Fengnian & Wei, Haiqiao, 2021. "Operation strategy optimization of lean combustion using turbulent jet ignition at different engine loads," Applied Energy, Elsevier, vol. 302(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:13:y:2020:i:11:p:2846-:d:366830. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.