IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v12y2019i11p2170-d237712.html
   My bibliography  Save this article

Domestic Hot Water Storage Tank Utilizing Phase Change Materials (PCMs): Numerical Approach

Author

Listed:
  • Ayman Bayomy

    (Mechanical and Industrial Engineering Department, Ryerson University, Toronto, ON M5B 2K3, Canada)

  • Stephen Davies

    (Ecologix Heating Technologies Inc., Cambridge, ON N1R 7L2, Canada)

  • Ziad Saghir

    (Mechanical and Industrial Engineering Department, Ryerson University, Toronto, ON M5B 2K3, Canada)

Abstract

Thermal energy storage (TES) is an essential part of a solar thermal/hot water system. It was shown that TES significantly enhances the efficiency and cost effectiveness of solar thermal systems by fulfilling the gap/mismatch between the solar radiation supply during the day and peak demand/load when sun is not available. In the present paper, a three-dimensional numerical model of a water-based thermal storage tank to provide domestic hot water demand is conducted. Phase change material (PCM) was used in the tank as a thermal storage medium and was connected to a photovoltaic thermal collector. The present paper shows the effectiveness of utilizing PCMs in a commercial 30-gallon domestic hot water tank used in buildings. The storage efficiency and the outlet water temperature were predicted to evaluate the storage system performance for different charging flow rates and different numbers of families demands. The results revealed that increases in the hot water supply coming from the solar collector caused increases in the outlet water temperature during the discharge period for one family demand. In such a case, it was observed that the storage efficiency was relatively low. Due to low demand (only one family), the PCMs were not completely crystallized at the end of the discharge period. The results showed that the increases in the family’s demand improve the thermal storage efficiency due to the increases in the portion of the energy that is recovered during the nighttime.

Suggested Citation

  • Ayman Bayomy & Stephen Davies & Ziad Saghir, 2019. "Domestic Hot Water Storage Tank Utilizing Phase Change Materials (PCMs): Numerical Approach," Energies, MDPI, vol. 12(11), pages 1-11, June.
    • Handle: RePEc:gam:jeners:v:12:y:2019:i:11:p:2170-:d:237712
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/12/11/2170/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/12/11/2170/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Mehling, H. & Cabeza, L.F. & Hippeli, S. & Hiebler, S., 2003. "PCM-module to improve hot water heat stores with stratification," Renewable Energy, Elsevier, vol. 28(5), pages 699-711.
    2. Guarino, Francesco & Athienitis, Andreas & Cellura, Maurizio & Bastien, Diane, 2017. "PCM thermal storage design in buildings: Experimental studies and applications to solaria in cold climates," Applied Energy, Elsevier, vol. 185(P1), pages 95-106.
    3. Enibe, S.O, 2002. "Performance of a natural circulation solar air heating system with phase change material energy storage," Renewable Energy, Elsevier, vol. 27(1), pages 69-86.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Nishant Modi & Xiaolin Wang & Michael Negnevitsky, 2023. "Solar Hot Water Systems Using Latent Heat Thermal Energy Storage: Perspectives and Challenges," Energies, MDPI, vol. 16(4), pages 1-20, February.
    2. Sandra Cunha & Antonella Sarcinella & José Aguiar & Mariaenrica Frigione, 2023. "Perspective on the Development of Energy Storage Technology Using Phase Change Materials in the Construction Industry: A Review," Energies, MDPI, vol. 16(12), pages 1-32, June.
    3. Waleed Zakri & Sofiene Mellouli & Yahya Fageehi, 2022. "Performance Assessment of Three Latent Heat Storage Designs for a Solar Hot Water Tank," Sustainability, MDPI, vol. 15(1), pages 1-16, December.
    4. Ding, Zhixiong & Wu, Wei & Leung, Michael, 2021. "Advanced/hybrid thermal energy storage technology: material, cycle, system and perspective," Renewable and Sustainable Energy Reviews, Elsevier, vol. 145(C).
    5. Mikhail A. Sheremet, 2021. "Numerical Simulation of Convective-Radiative Heat Transfer," Energies, MDPI, vol. 14(17), pages 1-3, August.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Huang, Xiang & Alva, Guruprasad & Jia, Yuting & Fang, Guiyin, 2017. "Morphological characterization and applications of phase change materials in thermal energy storage: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 72(C), pages 128-145.
    2. Sharif, M.K. Anuar & Al-Abidi, A.A. & Mat, S. & Sopian, K. & Ruslan, M.H. & Sulaiman, M.Y. & Rosli, M.A.M., 2015. "Review of the application of phase change material for heating and domestic hot water systems," Renewable and Sustainable Energy Reviews, Elsevier, vol. 42(C), pages 557-568.
    3. Dutil, Yvan & Rousse, Daniel R. & Salah, Nizar Ben & Lassue, Stéphane & Zalewski, Laurent, 2011. "A review on phase-change materials: Mathematical modeling and simulations," Renewable and Sustainable Energy Reviews, Elsevier, vol. 15(1), pages 112-130, January.
    4. Evangelisti, Luca & De Lieto Vollaro, Roberto & Asdrubali, Francesco, 2019. "Latest advances on solar thermal collectors: A comprehensive review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 114(C), pages 1-1.
    5. Randeep Singh & Sadegh Sadeghi & Bahman Shabani, 2018. "Thermal Conductivity Enhancement of Phase Change Materials for Low-Temperature Thermal Energy Storage Applications," Energies, MDPI, vol. 12(1), pages 1-20, December.
    6. Porteiro, Jacobo & Míguez, José Luis & Crespo, Bárbara & López González, Luis María & De Lara, José, 2015. "Experimental investigation of the thermal response of a thermal storage tank partially filled with different PCMs (phase change materials) to a steep demand," Energy, Elsevier, vol. 91(C), pages 202-214.
    7. Giwa, Adewale & Alabi, Adetunji & Yusuf, Ahmed & Olukan, Tuza, 2017. "A comprehensive review on biomass and solar energy for sustainable energy generation in Nigeria," Renewable and Sustainable Energy Reviews, Elsevier, vol. 69(C), pages 620-641.
    8. Wanjiru, Evan M. & Sichilalu, Sam M. & Xia, Xiaohua, 2017. "Model predictive control of heat pump water heater-instantaneous shower powered with integrated renewable-grid energy systems," Applied Energy, Elsevier, vol. 204(C), pages 1333-1346.
    9. Mondol, Jayanta Deb & Smyth, Mervyn & Zacharopoulos, Aggelos, 2011. "Experimental characterisation of a novel heat exchanger for a solar hot water application under indoor and outdoor conditions," Renewable Energy, Elsevier, vol. 36(6), pages 1766-1779.
    10. Saikia, Pranaynil & Pancholi, Marmik & Sood, Divyanshu & Rakshit, Dibakar, 2020. "Dynamic optimization of multi-retrofit building envelope for enhanced energy performance with a case study in hot Indian climate," Energy, Elsevier, vol. 197(C).
    11. Heier, Johan & Bales, Chris & Martin, Viktoria, 2015. "Combining thermal energy storage with buildings – a review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 42(C), pages 1305-1325.
    12. Yasuki Kadohiro & Shuo Cheng & Jeffrey S. Cross, 2020. "All-Day Energy Harvesting Power System Utilizing a Thermoelectric Generator with Water-Based Heat Storage," Sustainability, MDPI, vol. 12(9), pages 1-21, May.
    13. Kutlu, Cagri & Zhang, Yanan & Elmer, Theo & Su, Yuehong & Riffat, Saffa, 2020. "A simulation study on performance improvement of solar assisted heat pump hot water system by novel controllable crystallization of supercooled PCMs," Renewable Energy, Elsevier, vol. 152(C), pages 601-612.
    14. Salunkhe, Pramod B. & Shembekar, Prashant S., 2012. "A review on effect of phase change material encapsulation on the thermal performance of a system," Renewable and Sustainable Energy Reviews, Elsevier, vol. 16(8), pages 5603-5616.
    15. Abdelsalam, M.Y. & Teamah, H.M. & Lightstone, M.F. & Cotton, J.S., 2020. "Hybrid thermal energy storage with phase change materials for solar domestic hot water applications: Direct versus indirect heat exchange systems," Renewable Energy, Elsevier, vol. 147(P1), pages 77-88.
    16. Zukowski, M., 2015. "Experimental investigations of thermal and flow characteristics of a novel microjet air solar heater," Applied Energy, Elsevier, vol. 142(C), pages 10-20.
    17. Mazman, Muhsin & Cabeza, Luisa F. & Mehling, Harald & Nogues, Miquel & Evliya, Hunay & Paksoy, Halime Ö., 2009. "Utilization of phase change materials in solar domestic hot water systems," Renewable Energy, Elsevier, vol. 34(6), pages 1639-1643.
    18. Wanjiru, Evan M. & Sichilalu, Sam M. & Xia, Xiaohua, 2017. "Optimal control of heat pump water heater-instantaneous shower using integrated renewable-grid energy systems," Applied Energy, Elsevier, vol. 201(C), pages 332-342.
    19. Xu, Bin & Gan, Wen-tao & Wang, Yang-liang & Chen, Xing-ni & Fei, Yue & Pei, Gang, 2023. "Thermal performance of a novel Trombe wall integrated with direct absorption solar collector based on phase change slurry in winter," Renewable Energy, Elsevier, vol. 213(C), pages 246-258.
    20. Juan Zhao & Yasheng Ji & Yanping Yuan & Zhaoli Zhang & Jun Lu, 2017. "Seven Operation Modes and Simulation Models of Solar Heating System with PCM Storage Tank," Energies, MDPI, vol. 10(12), pages 1-17, December.

    More about this item

    Keywords

    ;
    ;
    ;
    ;
    ;

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:12:y:2019:i:11:p:2170-:d:237712. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.