IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v74y2014icp950-955.html
   My bibliography  Save this article

Combustion of biodiesel in a large-scale laboratory furnace

Author

Listed:
  • Pereira, Caio
  • Wang, Gongliang
  • Costa, Mário

Abstract

Combustion tests in a large-scale laboratory furnace were carried out to assess the feasibility of using biodiesel as a fuel in industrial furnaces. For comparison purposes, petroleum-based diesel was also used as a fuel. Initially, the performance of the commercial air-assisted atomizer used in the combustion tests was scrutinized under non-reacting conditions. Subsequently, flue gas data, including PM (particulate matter), were obtained for various flame conditions to quantify the effects of the atomization quality and excess air on combustion performance. The combustion data was complemented with in-flame temperature measurements for two representative furnace operating conditions. The results reveal that (i) CO emissions from biodiesel and diesel combustion are rather similar and not affected by the atomization quality; (ii) NOx emissions increase slightly as spray quality improves for both liquid fuels, but NOx emissions from biodiesel combustion are always lower than those from diesel combustion; (iii) CO emissions decrease rapidly for both liquid fuels as the excess air level increases up to an O2 concentration in the flue gas of 2%, beyond which they remain unchanged; (iv) NOx emissions increase with an increase in the excess air level for both liquid fuels; (v) the quality of the atomization has a significant impact on PM emissions, with the diesel combustion yielding significantly higher PM emissions than biodiesel combustion; and (vi) diesel combustion originates PM with elements such as Cr, Na, Ni and Pb, while biodiesel combustion produces PM with elements such as Ca, Mg and Fe.

Suggested Citation

  • Pereira, Caio & Wang, Gongliang & Costa, Mário, 2014. "Combustion of biodiesel in a large-scale laboratory furnace," Energy, Elsevier, vol. 74(C), pages 950-955.
    • Handle: RePEc:eee:energy:v:74:y:2014:i:c:p:950-955
    DOI: 10.1016/j.energy.2014.07.077
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544214008998
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2014.07.077?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Hájek, Martin & Skopal, František & Čapek, Libor & Černoch, Michal & Kutálek, Petr, 2012. "Ethanolysis of rapeseed oil by KOH as homogeneous and as heterogeneous catalyst supported on alumina and CaO," Energy, Elsevier, vol. 48(1), pages 392-397.
    2. Lee, H.V. & Taufiq-Yap, Y.H. & Hussein, M.Z. & Yunus, R., 2013. "Transesterification of jatropha oil with methanol over Mg–Zn mixed metal oxide catalysts," Energy, Elsevier, vol. 49(C), pages 12-18.
    3. Ghorbani, Afshin & Bazooyar, Bahamin & Shariati, Ahmad & Jokar, Seyyed Mohammad & Ajami, Hadi & Naderi, Ali, 2011. "A comparative study of combustion performance and emission of biodiesel blends and diesel in an experimental boiler," Applied Energy, Elsevier, vol. 88(12), pages 4725-4732.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Oh, Jeongseog & Noh, Dongsoon, 2015. "Flame characteristics of a non-premixed oxy-fuel jet in a lab-scale furnace," Energy, Elsevier, vol. 81(C), pages 328-343.
    2. Orati, Edson & Veríssimo, Anton S. & Rocha, Ana Maura A. & Costa, Fernando S. & Carvalho, João A., 2022. "Experimental investigation of flameless combustion of biodiesel," Energy, Elsevier, vol. 255(C).
    3. Bazooyar, Bahamin & Hosseini, Seyyed Yaghoob & Moradi Ghoje Begloo, Solat & Shariati, Ahmad & Hashemabadi, Seyed Hassan & Shaahmadi, Fariborz, 2018. "Mixed modified Fe2O3-WO3 as new fuel borne catalyst (FBC) for biodiesel fuel," Energy, Elsevier, vol. 149(C), pages 438-453.
    4. Julio San José & Yolanda Arroyo & María Ascensión Sanz-Tejedor, 2019. "Descriptive Statistical Analysis of Vegetable Oil Combustion in a Commercial Burner to Establish Optimal Operating Conditions," Energies, MDPI, vol. 12(12), pages 1-11, June.
    5. Kurji, H. & Valera-Medina, A. & Runyon, J. & Giles, A. & Pugh, D. & Marsh, R. & Cerone, N. & Zimbardi, F. & Valerio, V., 2016. "Combustion characteristics of biodiesel saturated with pyrolysis oil for power generation in gas turbines," Renewable Energy, Elsevier, vol. 99(C), pages 443-451.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Ng, Wendy Pei Qin & Lam, Hon Loong & Yusup, Suzana, 2013. "Supply network synthesis on rubber seed oil utilisation as potential biofuel feedstock," Energy, Elsevier, vol. 55(C), pages 82-88.
    2. Liang, Xuezheng, 2013. "Synthesis of biodiesel from waste oil under mild conditions using novel acidic ionic liquid immobilization on poly divinylbenzene," Energy, Elsevier, vol. 63(C), pages 103-108.
    3. Niu, Shengli & Zhou, Yan & Li, Hui & Lu, Chunmei & Liu, Li, 2015. "An investigation on the catalytic capability of the modified white mud after activation in transesterification and kinetic calculation," Energy, Elsevier, vol. 89(C), pages 982-989.
    4. Xue, Bao-jin & Luo, Jia & Zhang, Fan & Fang, Zhen, 2014. "Biodiesel production from soybean and Jatropha oils by magnetic CaFe2O4–Ca2Fe2O5-based catalyst," Energy, Elsevier, vol. 68(C), pages 584-591.
    5. Veiga, Paula Moraes & Luna, Aderval Severino & de Figueiredo Portilho, Marcio & de Oliveira Veloso, Cláudia & Henriques, Cristiane Assumpção, 2014. "Zn,Al-catalysts for heterogeneous biodiesel production: Basicity and process optimization," Energy, Elsevier, vol. 75(C), pages 453-462.
    6. Bazooyar, Bahamin & Hosseini, Seyyed Yaghoob & Moradi Ghoje Begloo, Solat & Shariati, Ahmad & Hashemabadi, Seyed Hassan & Shaahmadi, Fariborz, 2018. "Mixed modified Fe2O3-WO3 as new fuel borne catalyst (FBC) for biodiesel fuel," Energy, Elsevier, vol. 149(C), pages 438-453.
    7. Banerjee, Madhuchanda & Dey, Binita & Talukdar, Jayanta & Chandra Kalita, Mohan, 2014. "Production of biodiesel from sunflower oil using highly catalytic bimetallic gold–silver core–shell nanoparticle," Energy, Elsevier, vol. 69(C), pages 695-699.
    8. Wang, Yi-Tong & Yang, Xing-Xia & Xu, Jie & Wang, Hong-Li & Wang, Zi-Bing & Zhang, Lei & Wang, Shao-Long & Liang, Jing-Long, 2019. "Biodiesel production from esterification of oleic acid by a sulfonated magnetic solid acid catalyst," Renewable Energy, Elsevier, vol. 139(C), pages 688-695.
    9. Sánchez, Marcos & Navas, Marisa & Ruggera, José F. & Casella, Mónica L. & Aracil, José & Martínez, Mercedes, 2014. "Biodiesel production optimization using γAl2O3 based catalysts," Energy, Elsevier, vol. 73(C), pages 661-669.
    10. Enagi, Ibrahim I. & Al-attab, K.A. & Zainal, Z.A., 2018. "Liquid biofuels utilization for gas turbines: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 90(C), pages 43-55.
    11. Julio San José & Yolanda Arroyo & María Ascensión Sanz-Tejedor, 2019. "Descriptive Statistical Analysis of Vegetable Oil Combustion in a Commercial Burner to Establish Optimal Operating Conditions," Energies, MDPI, vol. 12(12), pages 1-11, June.
    12. Hwei Voon Lee & Joon Ching Juan & Taufiq-Yap Yun Hin & Hwai Chyuan Ong, 2016. "Environment-Friendly Heterogeneous Alkaline-Based Mixed Metal Oxide Catalysts for Biodiesel Production," Energies, MDPI, vol. 9(8), pages 1-12, August.
    13. Lim, Steven & Lee, Keat Teong, 2014. "Investigation of impurity tolerance and thermal stability for biodiesel production from Jatropha curcas L. seeds using supercritical reactive extraction," Energy, Elsevier, vol. 68(C), pages 71-79.
    14. Mardhiah, H. Haziratul & Ong, Hwai Chyuan & Masjuki, H.H. & Lim, Steven & Lee, H.V., 2017. "A review on latest developments and future prospects of heterogeneous catalyst in biodiesel production from non-edible oils," Renewable and Sustainable Energy Reviews, Elsevier, vol. 67(C), pages 1225-1236.
    15. Syazwani, Osman Nur & Rashid, Umer & Mastuli, Mohd Sufri & Taufiq-Yap, Yun Hin, 2019. "Esterification of palm fatty acid distillate (PFAD) to biodiesel using Bi-functional catalyst synthesized from waste angel wing shell (Cyrtopleura costata)," Renewable Energy, Elsevier, vol. 131(C), pages 187-196.
    16. Ling, Jiayin & Nip, Saiwa & de Toledo, Renata Alves & Tian, Yuan & Shim, Hojae, 2016. "Evaluation of specific lipid production and nutrients removal from wastewater by Rhodosporidium toruloides and biodiesel production from wet biomass via microwave irradiation," Energy, Elsevier, vol. 108(C), pages 185-194.
    17. Seraç, Mehmet Reşit & Aydın, Selman & Yılmaz, Adem & Şevik, Seyfi, 2020. "Evaluation of comparative combustion, performance, and emission of soybean-based alternative biodiesel fuel blends in a CI engine," Renewable Energy, Elsevier, vol. 148(C), pages 1065-1073.
    18. Vadery, Vinu & Narayanan, Binitha N. & Ramakrishnan, Resmi M. & Cherikkallinmel, Sudha Kochiyil & Sugunan, Sankaran & Narayanan, Divya P. & Sasidharan, Sreenikesh, 2014. "Room temperature production of jatropha biodiesel over coconut husk ash," Energy, Elsevier, vol. 70(C), pages 588-594.
    19. Ma, Yingqun & Wang, Qunhui & Gao, Zhen & Sun, Xiaohong & Wang, Nan & Niu, Ruxuan & Ma, Hongzhi, 2016. "Transesterification of waste cooking oil using FeCl3-modified resin catalyst and the research of catalytic mechanism," Renewable Energy, Elsevier, vol. 86(C), pages 643-650.
    20. Qian, Kun & Shen, Xiang & Wang, Yanxin & Gao, Qiang & Ding, Hongwei, 2015. "In-situ transesterification of Jatropha oil over an efficient solid alkali using low leaching component supported on industrial silica gel," Energy, Elsevier, vol. 93(P2), pages 2251-2257.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:74:y:2014:i:c:p:950-955. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.