IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v235y2021ics0360544221016935.html
   My bibliography  Save this article

Experimental investigation on effect of reservoir conditions on stability and rheology of carbon dioxide foams of nonionic surfactant and polymer: Implications of carbon geo-storage

Author

Listed:
  • Pandey, Anjanay
  • Sinha, A.S.K.
  • Chaturvedi, Krishna Raghav
  • Sharma, Tushar

Abstract

Carbon dioxide (CO2) injection, in form of a viscous foam, is one of the effective techniques to control premature CO2 breakthrough in subsurface carbon storage and utilization (CSU). Polysaccharides are often used in oilfield and its use for developing viscous CO2 foam will make the process reservoir compatible and economic. However, their efficacy should be tested at real conditions to promote better CO2 utilization in oilfield projects. This study aims to quantify the role of subsurface conditions viz., pressure, temperature, and salinity on CO2-foams prepared by non-ionic polymer (guar gum, 4000 ppm) and surfactant (TX-100, 0.25 mM). Salts i.e. potassium chloride (KCl) and magnesium sulfate (MgSO4) of varying concentration (0–8 wt%) were used. Increasing salt concentration were found to significantly affect foam stability (maximum fall of 88.88%) and CO2 molality in surfactant-polymer (SP) solution (by 73.1% at 70 bar pressure). KCl showed a greater reduction (≈8–15%) than MgSO4 (6–12%) however, increasing surfactant amount had negligible impact on CO2 molality. Additionally, microscopic analysis was performed in which initial bubble size (i.e. 40-60 μm) due to coalescence phenomenon was observed to increase to (400–460 μm) after 1 h. CO2 foams exhibited non-Newtonian shear thinning behavior where foam viscosity and elasticity were positively influenced by increase in pressure, which suggested foam potential for enhanced oil recovery (EOR) and carbon storage in subsurface environment. Foam viscosity decreased with increasing salt concentration (fall of maximum 55% when compared to zero salt content) and temperature resulting at 90 °C, foam viscosity reduces to a value of 0.05 Pa s at pressure≈ 70 bar. Finally, dynamic rheological measurements were reported to visualize viscoelastic response of foams. The viscoelastic response of CO2 foams by strain sweep measurements reported a maximum fall of 60% while 40% reduction in case of frequency sweep measurements was observed. Also, foams exhibited both elastic and viscous effects with clear cross-over between G′ and G″ at each test pressure and temperature.

Suggested Citation

  • Pandey, Anjanay & Sinha, A.S.K. & Chaturvedi, Krishna Raghav & Sharma, Tushar, 2021. "Experimental investigation on effect of reservoir conditions on stability and rheology of carbon dioxide foams of nonionic surfactant and polymer: Implications of carbon geo-storage," Energy, Elsevier, vol. 235(C).
  • Handle: RePEc:eee:energy:v:235:y:2021:i:c:s0360544221016935
    DOI: 10.1016/j.energy.2021.121445
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544221016935
    Download Restriction: Full text for ScienceDirect subscribers only

    File URL: https://libkey.io/10.1016/j.energy.2021.121445?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Saraf, Shubham & Bera, Achinta, 2021. "A review on pore-scale modeling and CT scan technique to characterize the trapped carbon dioxide in impermeable reservoir rocks during sequestration," Renewable and Sustainable Energy Reviews, Elsevier, vol. 144(C).
    2. Chaturvedi, Krishna Raghav & Trivedi, Japan & Sharma, Tushar, 2020. "Single-step silica nanofluid for improved carbon dioxide flow and reduced formation damage in porous media for carbon utilization," Energy, Elsevier, vol. 197(C).
    3. Ali Telmadarreie & Japan J Trivedi, 2020. "CO 2 Foam and CO 2 Polymer Enhanced Foam for Heavy Oil Recovery and CO 2 Storage," Energies, MDPI, vol. 13(21), pages 1-15, November.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Hou, Lei & Elsworth, Derek & Zhang, Fengshou & Wang, Zhiyuan & Zhang, Jianbo, 2023. "Evaluation of proppant injection based on a data-driven approach integrating numerical and ensemble learning models," Energy, Elsevier, vol. 264(C).
    2. Ayomikun Bello & Anastasia Ivanova & Alexey Cheremisin, 2023. "A Comprehensive Review of the Role of CO 2 Foam EOR in the Reduction of Carbon Footprint in the Petroleum Industry," Energies, MDPI, vol. 16(3), pages 1-20, January.
    3. Tian, Chang & Zhao, Jinlong & Yang, Junhui & Zhang, Jianping & Yang, Rui, 2023. "Preparation and characterization of fire-extinguishing efficiency of novel gel-protein foam for liquid pool fires," Energy, Elsevier, vol. 263(PC).
    4. Ayomikun Bello & Anastasia Ivanova & Alexey Cheremisin, 2023. "Foam EOR as an Optimization Technique for Gas EOR: A Comprehensive Review of Laboratory and Field Implementations," Energies, MDPI, vol. 16(2), pages 1-52, January.
    5. Singh, Alpana & Sharma, Tushar, 2023. "Implications of sand mobilization on stability and rheological properties of carbon dioxide foam and its transport mechanism in unconsolidated sandstone," Energy, Elsevier, vol. 263(PB).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Singh, Alpana & Sharma, Tushar, 2023. "Implications of sand mobilization on stability and rheological properties of carbon dioxide foam and its transport mechanism in unconsolidated sandstone," Energy, Elsevier, vol. 263(PB).
    2. Hou, Lei & Elsworth, Derek & Zhang, Fengshou & Wang, Zhiyuan & Zhang, Jianbo, 2023. "Evaluation of proppant injection based on a data-driven approach integrating numerical and ensemble learning models," Energy, Elsevier, vol. 264(C).
    3. Liu, Ang & Liu, Shimin, 2022. "Mechanical property alterations across coal matrix due to water-CO2 treatments: A micro-to-nano scale experimental study," Energy, Elsevier, vol. 248(C).
    4. Le Wang & Haowen Wu & Zhourong Cao & Shijie Fang & Shiyu Duan & Yishuo Wang, 2023. "Influence of Different Redevelopment Measures on Water–Oil Immiscible Displacement and Mechanism Analysis," Energies, MDPI, vol. 16(13), pages 1-19, June.
    5. Niu, Daming & Sun, Pingchang & Ma, Lin & Zhao, Kang'an & Ding, Cong, 2023. "Porosity evolution of Minhe oil shale under an open rapid heating system and the carbon storage potentials," Renewable Energy, Elsevier, vol. 205(C), pages 783-799.
    6. Ping Yue & Feng Liu & Kai Yang & Chunshuo Han & Chao Ren & Jiangtang Zhou & Xiukun Wang & Quantang Fang & Xinxin Li & Liangbin Dou, 2022. "Micro-Displacement and Storage Mechanism of CO 2 in Tight Sandstone Reservoirs Based on CT Scanning," Energies, MDPI, vol. 15(17), pages 1-16, August.
    7. Chaturvedi, Krishna Raghav & Narukulla, Ramesh & Amani, Mahmood & Sharma, Tushar, 2021. "Experimental investigations to evaluate surfactant role on absorption capacity of nanofluid for CO2 utilization in sustainable crude mobilization," Energy, Elsevier, vol. 225(C).
    8. Liang, Fachun & He, Zhennan & Meng, Jia & Zhao, Jingwen & Yu, Chao, 2023. "Effects of microfracture parameters on adaptive pumping in fractured porous media: Pore-scale simulation," Energy, Elsevier, vol. 263(PC).
    9. Chen, Hao & Liu, Xiliang & Zhang, Chao & Tan, Xianhong & Yang, Ran & Yang, Shenglai & Yang, Jin, 2022. "Effects of miscible degree and pore scale on seepage characteristics of unconventional reservoirs fluids due to supercritical CO2 injection," Energy, Elsevier, vol. 239(PC).
    10. Ting Chen & Laiming Song & Xueying Zhang & Yawen Yang & Huifang Fan & Bin Pan, 2023. "A Review of Mineral and Rock Wettability Changes Induced by Reaction: Implications for CO 2 Storage in Saline Reservoirs," Energies, MDPI, vol. 16(8), pages 1-17, April.
    11. Ali Telmadarreie & Japan J Trivedi, 2020. "CO 2 Foam and CO 2 Polymer Enhanced Foam for Heavy Oil Recovery and CO 2 Storage," Energies, MDPI, vol. 13(21), pages 1-15, November.

    More about this item

    Keywords

    Carbon storage; CO2 foams; Polysaccharide; Rheology; Salt; Temperature;
    All these keywords.

    JEL classification:

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:235:y:2021:i:c:s0360544221016935. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.