IDEAS home Printed from https://ideas.repec.org/a/eee/energy/v221y2021ics0360544221000189.html
   My bibliography  Save this article

Optimum installation of flue gas dryer and additional air heater to increase the efficiency of coal-fired utility boiler

Author

Listed:
  • Chantasiriwan, Somchart

Abstract

Utility boilers are used in thermal power plants. If exhaust flue gas temperature of a boiler is sufficiently high, heat recovery devices may be installed to increase the boiler efficiency. Previous investigations have focused on increasing boiler efficiency by using heat transfer from flue gas to remove moisture from fuel in flue gas dryer. Another method that is equally effective in increasing boiler efficiency is installing additional air heater to increase air temperature before combustion. The main objective of this paper is to determine the optimum sizes of flue gas dryer and additional air heater that minimize the total cost of installing them in an existing boiler. Models of utility boiler and flue gas are developed for this purpose. It is found that the installation of flue gas dryer after additional air heater results in lower total installation cost than the installation of flue gas dryer before additional air heater or the installation of flue gas dryer in parallel with additional air heater. Furthermore, both flue gas dryer and additional air heater should be installed if the ratio of the unit cost of flue gas dryer to the unit cost of air heater is between the lower and upper limits.

Suggested Citation

  • Chantasiriwan, Somchart, 2021. "Optimum installation of flue gas dryer and additional air heater to increase the efficiency of coal-fired utility boiler," Energy, Elsevier, vol. 221(C).
    • Handle: RePEc:eee:energy:v:221:y:2021:i:c:s0360544221000189
    DOI: 10.1016/j.energy.2021.119769
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0360544221000189
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.energy.2021.119769?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Han, Xiaoqu & Liu, Ming & Wu, Kaili & Chen, Weixiong & Xiao, Feng & Yan, Junjie, 2016. "Exergy analysis of the flue gas pre-dried lignite-fired power system based on the boiler with open pulverizing system," Energy, Elsevier, vol. 106(C), pages 285-300.
    2. Han, Xiaoqu & Liu, Ming & Zhai, Mengxu & Chong, Daotong & Yan, Junjie & Xiao, Feng, 2015. "Investigation on the off-design performances of flue gas pre-dried lignite-fired power system integrated with waste heat recovery at variable external working conditions," Energy, Elsevier, vol. 90(P2), pages 1743-1758.
    3. Ma, Youfu & Yuan, Yichao & Jin, Jing & Zhang, Hua & Hu, Xiaohong & Shi, Dengyu, 2013. "An environment friendly and efficient lignite-fired power generation process based on a boiler with an open pulverizing system and the recovery of water from mill-exhaust," Energy, Elsevier, vol. 59(C), pages 105-115.
    4. Liu, Ming & Yan, JunJie & Chong, DaoTong & Liu, JiPing & Wang, JinShi, 2013. "Thermodynamic analysis of pre-drying methods for pre-dried lignite-fired power plant," Energy, Elsevier, vol. 49(C), pages 107-118.
    5. Trojan, Marcin, 2019. "Modeling of a steam boiler operation using the boiler nonlinear mathematical model," Energy, Elsevier, vol. 175(C), pages 1194-1208.
    6. Kljajić, Miroslav & Gvozdenac, Dušan & Vukmirović, Srdjan, 2012. "Use of Neural Networks for modeling and predicting boiler's operating performance," Energy, Elsevier, vol. 45(1), pages 304-311.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Pieter Rousseau & Ryno Laubscher & Brad Travis Rawlins, 2023. "Heat Transfer Analysis Using Thermofluid Network Models for Industrial Biomass and Utility Scale Coal-Fired Boilers," Energies, MDPI, vol. 16(4), pages 1-49, February.
    2. Somchart Chantasiriwan, 2023. "Reduction in Fuel Consumption in Biomass-Fired Power Plant Using Hybrid Drying System," Energies, MDPI, vol. 16(17), pages 1-14, August.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Li, Yong & Wang, Yanhong & Cao, Lihua & Hu, Pengfei & Han, Wei, 2018. "Modeling for the performance evaluation of 600 MW supercritical unit operating No.0 high pressure heater," Energy, Elsevier, vol. 149(C), pages 639-661.
    2. Han, Xiaoqu & Liu, Ming & Wu, Kaili & Chen, Weixiong & Xiao, Feng & Yan, Junjie, 2016. "Exergy analysis of the flue gas pre-dried lignite-fired power system based on the boiler with open pulverizing system," Energy, Elsevier, vol. 106(C), pages 285-300.
    3. Li, Zixiang & Miao, Zhengqing & Shen, Xusheng & Li, Jiangtao, 2018. "Prevention of boiler performance degradation under large primary air ratio scenario in a 660 MW brown coal boiler," Energy, Elsevier, vol. 155(C), pages 474-483.
    4. Andrea Aquino & Pietro Poesio, 2021. "Off-Design Exergy Analysis of Convective Drying Using a Two-Phase Multispecies Model," Energies, MDPI, vol. 14(1), pages 1-36, January.
    5. Han, Xiaoqu & Liu, Ming & Zhai, Mengxu & Chong, Daotong & Yan, Junjie & Xiao, Feng, 2015. "Investigation on the off-design performances of flue gas pre-dried lignite-fired power system integrated with waste heat recovery at variable external working conditions," Energy, Elsevier, vol. 90(P2), pages 1743-1758.
    6. Han, Xiaoqu & Liu, Ming & Wang, Jinshi & Yan, Junjie & Liu, Jiping & Xiao, Feng, 2014. "Simulation study on lignite-fired power system integrated with flue gas drying and waste heat recovery – Performances under variable power loads coupled with off-design parameters," Energy, Elsevier, vol. 76(C), pages 406-418.
    7. Jiayou Liu & Xiaoyun Gong & Wenhua Zhang & Fengzhong Sun & Qingbiao Wang, 2020. "Experimental Study on a Flue Gas Waste Heat Cascade Recovery System under Variable Working Conditions," Energies, MDPI, vol. 13(2), pages 1-19, January.
    8. Liu, Yinhe & Li, Qinlun & Duan, Xiaoli & Zhang, Yun & Yang, Zhen & Che, Defu, 2018. "Thermodynamic analysis of a modified system for a 1000 MW single reheat ultra-supercritical thermal power plant," Energy, Elsevier, vol. 145(C), pages 25-37.
    9. Liu, Rongtang & Liu, Ming & Fan, Peipei & Zhao, Yongliang & Yan, Junjie, 2018. "Thermodynamic study on a novel lignite poly-generation system of electricity-gas-tar integrated with pre-drying and pyrolysis," Energy, Elsevier, vol. 165(PB), pages 140-152.
    10. Ma, Youfu & Zhang, Hua & Yuan, Yichao & Wang, Zhiyun, 2015. "Optimization of a lignite-fired open pulverizing system boiler process based on variations in the drying agent composition," Energy, Elsevier, vol. 81(C), pages 304-316.
    11. Liu, Ming & Wu, Dongyin & Xiao, Feng & Yan, JunJie, 2015. "A novel lignite-fired power plant integrated with a vacuum dryer: System design and thermodynamic analysis," Energy, Elsevier, vol. 82(C), pages 968-975.
    12. Wang, Yanhong & Cao, Lihua & Hu, Pengfei & Li, Bo & Li, Yong, 2019. "Model establishment and performance evaluation of a modified regenerative system for a 660 MW supercritical unit running at the IPT-setting mode," Energy, Elsevier, vol. 179(C), pages 890-915.
    13. Li, Zixiang & Miao, Zhengqing & Zhou, Yan & Wen, Shurong & Li, Jiangtao, 2018. "Influence of increased primary air ratio on boiler performance in a 660 MW brown coal boiler," Energy, Elsevier, vol. 152(C), pages 804-817.
    14. Xu, Cheng & Xu, Gang & Zhao, Shifei & Zhou, Luyao & Yang, Yongping & Zhang, Dongke, 2015. "An improved configuration of lignite pre-drying using a supplementary steam cycle in a lignite fired supercritical power plant," Applied Energy, Elsevier, vol. 160(C), pages 882-891.
    15. Zbigniew Plutecki & Paweł Sattler & Krystian Ryszczyk & Anna Duczkowska & Stanisław Anweiler, 2020. "Thermokinetics of Brown Coal during a Fluidized Drying Process," Energies, MDPI, vol. 13(3), pages 1-16, February.
    16. Heydar Maddah & Milad Sadeghzadeh & Mohammad Hossein Ahmadi & Ravinder Kumar & Shahaboddin Shamshirband, 2019. "Modeling and Efficiency Optimization of Steam Boilers by Employing Neural Networks and Response-Surface Method (RSM)," Mathematics, MDPI, vol. 7(7), pages 1-17, July.
    17. Majdak, Marek & Grądziel, Sławomir, 2020. "Influence of thermal and flow conditions on the thermal stresses distribution in the evaporator tubes," Energy, Elsevier, vol. 209(C).
    18. Chauhan, Shivendra Singh & Khanam, Shabina, 2019. "Enhancement of efficiency for steam cycle of thermal power plants using process integration," Energy, Elsevier, vol. 173(C), pages 364-373.
    19. Sulpan Kuskarbekova & Konstantin Osintsev & Sergei Aliukov, 2022. "Novel Hydraulic and Aerodynamic Schemes of Coil Type Steam Generator: A Mathematical Model and Experimental Data," Energies, MDPI, vol. 15(21), pages 1-15, November.
    20. Janusz Kotowicz & Sebastian Michalski & Mateusz Brzęczek, 2019. "The Characteristics of a Modern Oxy-Fuel Power Plant," Energies, MDPI, vol. 12(17), pages 1-34, September.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:energy:v:221:y:2021:i:c:s0360544221000189. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.journals.elsevier.com/energy .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.