IDEAS home Printed from https://ideas.repec.org/a/eee/appene/v310y2022ics0306261922000095.html
   My bibliography  Save this article

In-duct phase change material-based energy storage to enhance building demand flexibility

Author

Listed:
  • Hlanze, Philani
  • Elhefny, Aly
  • Jiang, Zhimin
  • Cai, Jie
  • Shabgard, Hamidreza

Abstract

This paper presents a novel energy storage solution by incorporating phase change material (PCM) panels in supply ducts to increase a building’s thermal storage capacity and demand flexibility. During off-peak hours, the system runs at a supply air temperature (SAT) below the PCM solidification point to charge the storage unit with “cooling” energy. During on-peak hours, a higher SAT is utilized so that the stored “cooling” energy can be discharged into the supply-air as a means to reduce the peak air-conditioning power usage. To evaluate the potentials of peak demand reduction and utility cost savings, a numerical model for a PCM panel prototype and its heat exchange with the air flow in the duct was developed and calibrated using experimental data. Whole building energy simulations were conducted in a co-simulation environment that has integrated the developed PCM model, EnergyPlus Department of Energy (DOE) prototypical model for a medium office building and a calibrated model for variable-speed direct-expansion cooling systems. The simulations covered five cities in different U.S. climate zones over a three-month cooling season and used actual time-of-use (TOU) rate schedules offered by the local electric utility companies. The simulation results have shown the PCM storage could reduce the on-peak energy consumption by 23–32% and the seasonal cooling electricity cost by up to 16%, with a simple rule-based control strategy. A simple payback analysis resulted in payback periods from 7.5 to 27 cooling months.

Suggested Citation

  • Hlanze, Philani & Elhefny, Aly & Jiang, Zhimin & Cai, Jie & Shabgard, Hamidreza, 2022. "In-duct phase change material-based energy storage to enhance building demand flexibility," Applied Energy, Elsevier, vol. 310(C).
    • Handle: RePEc:eee:appene:v:310:y:2022:i:c:s0306261922000095
    DOI: 10.1016/j.apenergy.2022.118520
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0306261922000095
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.apenergy.2022.118520?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Oró, E. & de Gracia, A. & Castell, A. & Farid, M.M. & Cabeza, L.F., 2012. "Review on phase change materials (PCMs) for cold thermal energy storage applications," Applied Energy, Elsevier, vol. 99(C), pages 513-533.
    2. Iten, Muriel & Liu, Shuli & Shukla, Ashish, 2016. "A review on the air-PCM-TES application for free cooling and heating in the buildings," Renewable and Sustainable Energy Reviews, Elsevier, vol. 61(C), pages 175-186.
    3. Yau, Y.H. & Lee, S.K., 2010. "Feasibility study of an ice slurry-cooling coil for HVAC and R systems in a tropical building," Applied Energy, Elsevier, vol. 87(8), pages 2699-2711, August.
    4. Silva, Tiago & Vicente, Romeu & Amaral, Cláudia & Figueiredo, António, 2016. "Thermal performance of a window shutter containing PCM: Numerical validation and experimental analysis," Applied Energy, Elsevier, vol. 179(C), pages 64-84.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Song, Yuguang & Xia, Mingchao & Chen, Qifang & Chen, Fangjian, 2023. "A data-model fusion dispatch strategy for the building energy flexibility based on the digital twin," Applied Energy, Elsevier, vol. 332(C).
    2. Hlanze, Philani & Jiang, Zhimin & Cai, Jie & Shen, Bo, 2023. "Model-based predictive control of multi-stage air-source heat pumps integrated with phase change material-embedded ceilings," Applied Energy, Elsevier, vol. 336(C).
    3. Zhou, Yuekuan, 2022. "Demand response flexibility with synergies on passive PCM walls, BIPVs, and active air-conditioning system in a subtropical climate," Renewable Energy, Elsevier, vol. 199(C), pages 204-225.
    4. Palmer, Ben & Arshad, Adeel & Yang, Yan & Wen, Chuang, 2023. "Energy storage performance improvement of phase change materials-based triplex-tube heat exchanger (TTHX) using liquid–solid interface-informed fin configurations," Applied Energy, Elsevier, vol. 333(C).
    5. Shun-Hsiung Peng & Shang-Lien Lo, 2023. "Hybrid (Optimal) Selection Model for Phase Change Materials Used in the Cold Energy Storage of Air Conditioning Systems," Energies, MDPI, vol. 17(1), pages 1-15, December.
    6. Yang, Yunyun & Cai, Xufu & Kong, Weibo, 2023. "A novel intrinsic photothermal and flexible solid–solid phase change materials with super mechanical toughness and multi-recyclability," Applied Energy, Elsevier, vol. 332(C).

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Zhu, Kai & Li, Xueqiang & Campana, Pietro Elia & Li, Hailong & Yan, Jinyue, 2018. "Techno-economic feasibility of integrating energy storage systems in refrigerated warehouses," Applied Energy, Elsevier, vol. 216(C), pages 348-357.
    2. Liu, Shengchun & Hao, Ling & Rao, Zhiming & Zhang, Xingxing, 2017. "Experimental study on crystallization process and prediction for the latent heat of ice slurry generation based sodium chloride solution," Applied Energy, Elsevier, vol. 185(P2), pages 1948-1953.
    3. Du, Kun & Calautit, John & Wang, Zhonghua & Wu, Yupeng & Liu, Hao, 2018. "A review of the applications of phase change materials in cooling, heating and power generation in different temperature ranges," Applied Energy, Elsevier, vol. 220(C), pages 242-273.
    4. Xinghui Zhang & Qili Shi & Lingai Luo & Yilin Fan & Qian Wang & Guanguan Jia, 2021. "Research Progress on the Phase Change Materials for Cold Thermal Energy Storage," Energies, MDPI, vol. 14(24), pages 1-46, December.
    5. Alam, Morshed & Zou, Patrick X.W. & Sanjayan, Jay & Ramakrishnan, Sayanthan, 2019. "Energy saving performance assessment and lessons learned from the operation of an active phase change materials system in a multi-storey building in Melbourne," Applied Energy, Elsevier, vol. 238(C), pages 1582-1595.
    6. López-Navarro, A. & Biosca-Taronger, J. & Corberán, J.M. & Peñalosa, C. & Lázaro, A. & Dolado, P. & Payá, J., 2014. "Performance characterization of a PCM storage tank," Applied Energy, Elsevier, vol. 119(C), pages 151-162.
    7. Ioan Sarbu & Calin Sebarchievici, 2018. "A Comprehensive Review of Thermal Energy Storage," Sustainability, MDPI, vol. 10(1), pages 1-32, January.
    8. Veerakumar, C. & Sreekumar, A., 2020. "Thermo-physical investigation and experimental discharge characteristics of lauryl alcohol as a potential phase change material for thermal management in buildings," Renewable Energy, Elsevier, vol. 148(C), pages 492-503.
    9. Liu, Shengchun & Li, Hailong & Song, Mengjie & Dai, Baomin & Sun, Zhili, 2018. "Impacts on the solidification of water on plate surface for cold energy storage using ice slurry," Applied Energy, Elsevier, vol. 227(C), pages 284-293.
    10. Kousksou, T. & El Rhafiki, T. & Jamil, A. & Bruel, P. & Zeraouli, Y., 2013. "PCMs inside emulsions: Some specific aspects related to DSC (differential scanning calorimeter)-like configurations," Energy, Elsevier, vol. 56(C), pages 175-183.
    11. Yao Lu & Faisal Khaled Aldawood & Wanyu Hu & Yuxin Ma & Mohamed Kchaou & Chengjun Zhang & Xinpeng Yang & Ruitong Yang & Zitong Qi & Dong Li, 2023. "Optimization Strategy for Selecting the Combination Structure of Multilayer Phase Change Material (PCM) Glazing Windows under Different Climate Zones," Sustainability, MDPI, vol. 15(23), pages 1-24, November.
    12. Lukas Hegner & Stefan Krimmel & Rebecca Ravotti & Dominic Festini & Jörg Worlitschek & Anastasia Stamatiou, 2021. "Experimental Feasibility Study of a Direct Contact Latent Heat Storage Using an Ester as a Bio-Based Storage Material," Energies, MDPI, vol. 14(2), pages 1-26, January.
    13. Nassima Radouane, 2022. "A Comprehensive Review of Composite Phase Change Materials (cPCMs) for Thermal Management Applications, Including Manufacturing Processes, Performance, and Applications," Energies, MDPI, vol. 15(21), pages 1-28, November.
    14. Fan, Li-Wu & Fang, Xin & Wang, Xiao & Zeng, Yi & Xiao, Yu-Qi & Yu, Zi-Tao & Xu, Xu & Hu, Ya-Cai & Cen, Ke-Fa, 2013. "Effects of various carbon nanofillers on the thermal conductivity and energy storage properties of paraffin-based nanocomposite phase change materials," Applied Energy, Elsevier, vol. 110(C), pages 163-172.
    15. Anatoliy M. Pavlenko & Karolina Sadko, 2023. "Evaluation of Numerical Methods for Predicting the Energy Performance of Windows," Energies, MDPI, vol. 16(3), pages 1-23, February.
    16. Li, Min & Zhou, Dongyi & Jiang, Yaqing, 2021. "Preparation and thermal storage performance of phase change ceramsite sand and thermal storage light-weight concrete," Renewable Energy, Elsevier, vol. 175(C), pages 143-152.
    17. Liu, Changyu & Wu, Yangyang & Bian, Ji & Li, Dong & Liu, Xiaoyan, 2018. "Influence of PCM design parameters on thermal and optical performance of multi-layer glazed roof," Applied Energy, Elsevier, vol. 212(C), pages 151-161.
    18. Cui, Can & Zhang, Xin & Cai, Wenjian, 2020. "An energy-saving oriented air balancing method for demand controlled ventilation systems with branch and black-box model," Applied Energy, Elsevier, vol. 264(C).
    19. Wang, X.J. & Li, X.F. & Xu, Y.H. & Zhu, D.S., 2014. "Thermal energy storage characteristics of Cu–H2O nanofluids," Energy, Elsevier, vol. 78(C), pages 212-217.
    20. Li, Yanchen & Wang, Beibei & Zhang, Weiye & Zhao, Junqi & Fang, Xiaoyang & Sun, Jingmeng & Xia, Rongqi & Guo, Hongwu & Liu, Yi, 2022. "Processing wood into a phase change material with high solar-thermal conversion efficiency by introducing stable polyethylene glycol-based energy storage polymer," Energy, Elsevier, vol. 254(PA).

    More about this item

    Statistics

    Access and download statistics

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:appene:v:310:y:2022:i:c:s0306261922000095. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/405891/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.