IDEAS home Printed from https://ideas.repec.org/a/eee/appene/v204y2017icp1231-1239.html
   My bibliography  Save this article

Heat transfer and thermal performance of two-stage molten salt steam generation system

Author

Listed:
  • He, Canming
  • Lu, Jianfeng
  • Ding, Jing
  • Wang, Weilong
  • Yuan, Yibo

Abstract

Heat transfer and thermal performance of two-stage molten salt steam generation system were experimentally reported and analyzed. The experimental system consisted of primary U-shaped steam generator and secondary shell and tube superheater, and its overall heat transfer coefficient, steam generation rate and thermal efficiency had been studied in detail. According to experimental results, molten salt heat convection, boiling heat transfer and heat loss played important roles in heat transfer of steam generation system. The absorbed heat flux and overall heat transfer coefficient of primary U-shaped steam generator were remarkably higher than those of secondary shell and tube superheater, and the thermal performance of superheater was significantly affected by steam flow rate from steam generator. When inlet molten salt temperature/flow rate rose, overall heat transfer coefficient and steam generation rate first increased for convection enhancement of molten salt with high velocity or low viscosity, and then decreased for the reduction of boiling heat transfer coefficient at high temperature. As inlet molten salt temperature/flow rate rose, thermal efficiency increased firstly and dropped later due to the combination of absorbed heat flow and heat loss. In addition, the optimal inlet molten salt temperature with maximum absorbed heat flow was a little higher than that with maximum thermal efficiency.

Suggested Citation

  • He, Canming & Lu, Jianfeng & Ding, Jing & Wang, Weilong & Yuan, Yibo, 2017. "Heat transfer and thermal performance of two-stage molten salt steam generation system," Applied Energy, Elsevier, vol. 204(C), pages 1231-1239.
    • Handle: RePEc:eee:appene:v:204:y:2017:i:c:p:1231-1239
    DOI: 10.1016/j.apenergy.2017.04.010
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0306261917303823
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.apenergy.2017.04.010?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Suárez, Christian & Iranzo, Alfredo & Pino, F.J. & Guerra, J., 2015. "Transient analysis of the cooling process of molten salt thermal storage tanks due to standby heat loss," Applied Energy, Elsevier, vol. 142(C), pages 56-65.
    2. Pirasaci, Tolga & Goswami, D. Yogi, 2016. "Influence of design on performance of a latent heat storage system for a direct steam generation power plant," Applied Energy, Elsevier, vol. 162(C), pages 644-652.
    3. Yang, Minlin & Yang, Xiaoxi & Yang, Xiaoping & Ding, Jing, 2010. "Heat transfer enhancement and performance of the molten salt receiver of a solar power tower," Applied Energy, Elsevier, vol. 87(9), pages 2808-2811, September.
    4. Wu, Ming & Xu, Chao & He, Ya-Ling, 2014. "Dynamic thermal performance analysis of a molten-salt packed-bed thermal energy storage system using PCM capsules," Applied Energy, Elsevier, vol. 121(C), pages 184-195.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Li, Xiaolei & Xu, Ershu & Ma, Linrui & Song, Shuang & Xu, Li, 2019. "Modeling and dynamic simulation of a steam generation system for a parabolic trough solar power plant," Renewable Energy, Elsevier, vol. 132(C), pages 998-1017.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Mostafavi Tehrani, S. Saeed & Shoraka, Yashar & Nithyanandam, Karthik & Taylor, Robert A., 2019. "Shell-and-tube or packed bed thermal energy storage systems integrated with a concentrated solar power: A techno-economic comparison of sensible and latent heat systems," Applied Energy, Elsevier, vol. 238(C), pages 887-910.
    2. Li, Yantong & Huang, Gongsheng & Xu, Tao & Liu, Xiaoping & Wu, Huijun, 2018. "Optimal design of PCM thermal storage tank and its application for winter available open-air swimming pool," Applied Energy, Elsevier, vol. 209(C), pages 224-235.
    3. Xu, Yang & Li, Ming-Jia & Zheng, Zhang-Jing & Xue, Xiao-Dai, 2018. "Melting performance enhancement of phase change material by a limited amount of metal foam: Configurational optimization and economic assessment," Applied Energy, Elsevier, vol. 212(C), pages 868-880.
    4. Xu, Yang & Ren, Qinlong & Zheng, Zhang-Jing & He, Ya-Ling, 2017. "Evaluation and optimization of melting performance for a latent heat thermal energy storage unit partially filled with porous media," Applied Energy, Elsevier, vol. 193(C), pages 84-95.
    5. Luo, Xianglong & Yi, Zhitong & Zhang, Bingjian & Mo, Songping & Wang, Chao & Song, Mengjie & Chen, Ying, 2017. "Mathematical modelling and optimization of the liquid separation condenser used in organic Rankine cycle," Applied Energy, Elsevier, vol. 185(P2), pages 1309-1323.
    6. Mostafavi Tehrani, S. Saeed & Taylor, Robert A., 2016. "Off-design simulation and performance of molten salt cavity receivers in solar tower plants under realistic operational modes and control strategies," Applied Energy, Elsevier, vol. 179(C), pages 698-715.
    7. Al-Shannaq, Refat & Young, Brent & Farid, Mohammed, 2019. "Cold energy storage in a packed bed of novel graphite/PCM composite spheres," Energy, Elsevier, vol. 171(C), pages 296-305.
    8. Mao, Qianjun & Zhang, Yamei, 2020. "Thermal energy storage performance of a three-PCM cascade tank in a high-temperature packed bed system," Renewable Energy, Elsevier, vol. 152(C), pages 110-119.
    9. Li, Chuan & Li, Qi & Ding, Yulong, 2019. "Investigation on the thermal performance of a high temperature packed bed thermal energy storage system containing carbonate salt based composite phase change materials," Applied Energy, Elsevier, vol. 247(C), pages 374-388.
    10. Xu, Tianhao & Humire, Emma Nyholm & Trevisan, Silvia & Ignatowicz, Monika & Sawalha, Samer & Chiu, Justin NW., 2022. "Experimental and numerical investigation of a latent heat thermal energy storage unit with ellipsoidal macro-encapsulation," Energy, Elsevier, vol. 238(PB).
    11. Fernandes, D. & Pitié, F. & Cáceres, G. & Baeyens, J., 2012. "Thermal energy storage: “How previous findings determine current research priorities”," Energy, Elsevier, vol. 39(1), pages 246-257.
    12. Zhang, Qiangqiang & Li, Xin & Wang, Zhifeng & Li, Zhi & Liu, Hong, 2018. "Function testing and failure analysis of control system for molten salt receiver system," Renewable Energy, Elsevier, vol. 115(C), pages 260-268.
    13. Odenthal, Christian & Steinmann, Wolf-Dieter & Zunft, Stefan, 2020. "Analysis of a horizontal flow closed loop thermal energy storage system in pilot scale for high temperature applications – Part II: Numerical investigation," Applied Energy, Elsevier, vol. 263(C).
    14. Le Brun, N. & Hewitt, G.F. & Markides, C.N., 2017. "Transient freezing of molten salts in pipe-flow systems: Application to the direct reactor auxiliary cooling system (DRACS)," Applied Energy, Elsevier, vol. 186(P1), pages 56-67.
    15. Ma, Zhao & Li, Ming-Jia & Zhang, K. Max & Yuan, Fan, 2021. "Novel designs of hybrid thermal energy storage system and operation strategies for concentrated solar power plant," Energy, Elsevier, vol. 216(C).
    16. Li, Jing & Gao, Guangtao & Kutlu, Cagri & Liu, Keliang & Pei, Gang & Su, Yuehong & Ji, Jie & Riffat, Saffa, 2019. "A novel approach to thermal storage of direct steam generation solar power systems through two-step heat discharge," Applied Energy, Elsevier, vol. 236(C), pages 81-100.
    17. Wang, Yang & Li, Heping & Ortega-Fernández, Iñigo & Huang, Xuefeng & Jiang, Bo & Bielsa, Daniel & Palomo, Elena, 2021. "The time-varying radiation applied in the temperature-sensitive reaction system stabilized with heat storage technology," Applied Energy, Elsevier, vol. 283(C).
    18. de Gracia, Alvaro & Cabeza, Luisa F., 2017. "Numerical simulation of a PCM packed bed system: A review," Renewable and Sustainable Energy Reviews, Elsevier, vol. 69(C), pages 1055-1063.
    19. Conroy, Tim & Collins, Maurice N. & Grimes, Ronan, 2020. "A review of steady-state thermal and mechanical modelling on tubular solar receivers," Renewable and Sustainable Energy Reviews, Elsevier, vol. 119(C).
    20. Peng, Hao & Li, Rui & Ling, Xiang & Dong, Huihua, 2015. "Modeling on heat storage performance of compressed air in a packed bed system," Applied Energy, Elsevier, vol. 160(C), pages 1-9.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:appene:v:204:y:2017:i:c:p:1231-1239. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/405891/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.