IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v18y2025i7p1765-d1625816.html
   My bibliography  Save this article

A Comparative Study of Methanol and Methane Combustion in a Gas Turbine Combustor

Author

Listed:
  • Jiashuo Cui

    (Institute of Engineering Thermophysics, Chinese Academy of Sciences, Beijing 100190, China
    School of Aeronautics and Astronautics, University of Chinese Academy of Sciences, Beijing 100049, China)

  • Rongguo Yu

    (Institute of Engineering Thermophysics, Chinese Academy of Sciences, Beijing 100190, China)

  • Huishe Wang

    (Institute of Engineering Thermophysics, Chinese Academy of Sciences, Beijing 100190, China
    School of Aeronautics and Astronautics, University of Chinese Academy of Sciences, Beijing 100049, China)

  • Yangen Wang

    (Institute of Engineering Thermophysics, Chinese Academy of Sciences, Beijing 100190, China)

  • Jingze Tong

    (Institute of Engineering Thermophysics, Chinese Academy of Sciences, Beijing 100190, China)

Abstract

To investigate the combustion and emission characteristics of a 20 MW gas turbine combustor following fuel replacement, this study employs numerical simulations to systematically compare the combustion performance of methanol and methane. The focus is on the influence mechanism of the fuel distribution ratio on NOx emissions. As a preliminary numerical investigation, this study aims to provide theoretical guidance for subsequent experimental research, with the results serving to define measurement points in experimental design. It is found that the value of NOx emission from methanol combustion is 40–78% of that of methane under all operating conditions, which is significantly lower than that of methane. And its low NOx emission range is significantly wider than that of methane (methanol: a pilot fuel ratio range of 1–12%; methane: a pilot fuel ratio range from 2 to 4%). Methanol reaches the lowest NOx emission (51.53 ppm) near the pilot fuel ratio of 2%, while methane reaches the lowest NOx emission (93 ppm) near the pilot fuel ratio of 4%. This difference is due to the oxygen content and low calorific value of methanol, which makes it easier to reduce the flame in the main combustion zone to the temperature that inhibits the generation of thermal NOx, so there is no need to allocate more fuel to the pilot to reduce the cooling pressure in the main combustion zone. In addition, the combustor efficiency of methanol is higher and less volatile (99.52–99.89%), which is slightly higher than that of methane (99.33–99.61%). The results show that methanol is suitable as a gas turbine fuel. Its performance in the gas turbine combustor is slightly better than that of methane, and NOx emission is significantly better than that of methane. The better performance of methanol provides greater flexibility for the design of gas turbine combustors and has great feasibility in engineering.

Suggested Citation

  • Jiashuo Cui & Rongguo Yu & Huishe Wang & Yangen Wang & Jingze Tong, 2025. "A Comparative Study of Methanol and Methane Combustion in a Gas Turbine Combustor," Energies, MDPI, vol. 18(7), pages 1-17, April.
  • Handle: RePEc:gam:jeners:v:18:y:2025:i:7:p:1765-:d:1625816
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/18/7/1765/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/18/7/1765/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Ma, Yujia & Liu, Jinfu & Zhu, Linhai & Li, Qi & Guo, Yaqiong & Liu, Huanpeng & Yu, Daren, 2022. "Multi-objective performance optimization and control for gas turbine Part-load operation Energy-saving and NOx emission reduction," Applied Energy, Elsevier, vol. 320(C).
    2. Zhang, Yili & Wang, Jiajun & Liu, Yunpeng & Yan, Yingwen, 2023. "Numerical simulation of the influence of fuel allocation method on regional NOx production in a single sector combustor," Energy, Elsevier, vol. 270(C).
    3. Shen, Wenkai & Liu, Li & Hu, Qiming & Liu, Guichuang & Wang, Jiwei & Zhang, Ning & Wu, Shaohua & Qiu, Penghua & Song, Shaowei, 2021. "Combustion characteristics of ignition processes for lean premixed swirling combustor under visual conditions," Energy, Elsevier, vol. 218(C).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Zong, Chao & Ji, Chenzhen & Cheng, Jiaying & Zhu, Tong & Guo, Desan & Li, Chengqin & Duan, Fei, 2022. "Toward off-design loads: Investigations on combustion and emissions characteristics of a micro gas turbine combustor by external combustion-air adjustments," Energy, Elsevier, vol. 253(C).
    2. Shen, Wenkai & Xing, Chang & Liu, Haiqing & Liu, Li & Hu, Qiming & Wu, Guohua & Yang, Yujia & Wu, Shaohua & Qiu, Penghua, 2022. "Exhaust gas recirculation effects on flame heat release rate distribution and dynamic characteristics in a micro gas turbine," Energy, Elsevier, vol. 249(C).
    3. Guo, Kaifang & Sun, Dechuan & Zeng, Zhuoxiong, 2023. "Numerical study of ignition process in vortex cold wall combustion chamber," Energy, Elsevier, vol. 262(PA).
    4. Penuela, Javier & Ben, Cécile & Boldyrev, Stepan & Gentzbittel, Laurent & Ouerdane, Henni, 2024. "The indoor agriculture industry: A promising player in demand response services," Applied Energy, Elsevier, vol. 372(C).
    5. Li, Zhenghui & Yao, Shunchun & Chen, Da & Li, Longqian & Lu, Zhimin & Liu, Wen & Yu, Zhuliang, 2024. "Multi-parameter co-optimization for NOx emissions control from waste incinerators based on data-driven model and improved particle swarm optimization," Energy, Elsevier, vol. 306(C).
    6. Park, Yeseul & Choi, Minsung & Choi, Gyungmin, 2022. "Fault detection of industrial large-scale gas turbine for fuel distribution characteristics in start-up procedure using artificial neural network method," Energy, Elsevier, vol. 251(C).
    7. Krzywanski, J. & Czakiert, T. & Nowak, W. & Shimizu, T. & Ashraf, Waqar Muhammad & Zylka, A. & Grabowska, K. & Sosnowski, M. & Skrobek, D. & Sztekler, K. & Kijo-Kleczkowska, A. & Iliev, I., 2024. "Towards cleaner energy: An innovative model to minimize NOx emissions in chemical looping and CO2 capture technologies," Energy, Elsevier, vol. 312(C).
    8. Bolegenova, Saltanat & Askarova, Аliya & Georgiev, Aleksandar & Nugymanova, Aizhan & Maximov, Valeriy & Bolegenova, Symbat & Mamedov, Bolat, 2023. "The use of plasma technologies to optimize fuel combustion processes and reduce emissions of harmful substances," Energy, Elsevier, vol. 277(C).
    9. Chen, Mengshi & Zhang, Linyao & Xing, Chang & Bao, Yangyang & Qiu, Penghua & Zhang, Wenda & Sun, Shaozeng & Zhao, Yijun, 2024. "Experimental and numerical simulation study of the effect of mixing on the characteristics of swirl/non-swirl micromix flames," Energy, Elsevier, vol. 307(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:18:y:2025:i:7:p:1765-:d:1625816. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.