IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v17y2024i22p5781-d1524627.html
   My bibliography  Save this article

Electrical Tortuosities of Porous Structures Based on Triply Periodic Minimal Surfaces and Honeycombs for Power-to-Heat Systems

Author

Listed:
  • Thorsten Ott

    (Institute of Engineering Thermodynamics, German Aerospace Center, 70569 Stuttgart, Germany)

  • Volker Dreißigacker

    (Institute of Engineering Thermodynamics, German Aerospace Center, 70569 Stuttgart, Germany)

Abstract

Power-to-heat (P2H) systems offer an efficient solution for decarbonization by facilitating the integration of renewable energy into the industrial, heating, and transport sectors. Its key requirements include high thermal efficiency and an appropriate electrical resistivity to meet application-specific electrical needs. When designing P2H systems, materials and electrical boundary conditions are often limited by application-specific requirements, whereas geometric structures offer high degrees of freedom. While thermal design calculations are often straightforward due to a variety of available Nusselt and pressure loss correlations, simplified design pathways, particularly for porous structures, are lacking in electrical design. Given the wide range of geometric degrees of freedom for porous structures and the fact that detailed modeling involves substantial computational effort, this work employed electrical tortuosity to capture and correlate the geometry-dependent impacts on the effective electrical resistance in a compact way. Honeycomb and triply periodic minimal surface (TPMS)-based structures were selected for this purpose, as they are characterized by high specific surfaces, allowing for high total heat transfer coefficients. The results show that the effective electrical resistance of both TPMS and honeycomb structures can be adjusted by the geometric structure. It was found that the electrical tortuosities of the investigated TPMS structures are nearly identical, while honeycomb structures show slightly higher values. Furthermore, the electrical tortuosity is mainly a function of the void fraction and does not change with the specific surface when the void fraction is kept constant. Finally, correlations for electrical tortuosity depending on geometric parameters with a mean error below 5% are derived for the first time, thereby providing a basis for simplified and computationally efficient electrical design calculations for P2H systems.

Suggested Citation

  • Thorsten Ott & Volker Dreißigacker, 2024. "Electrical Tortuosities of Porous Structures Based on Triply Periodic Minimal Surfaces and Honeycombs for Power-to-Heat Systems," Energies, MDPI, vol. 17(22), pages 1-15, November.
    • Handle: RePEc:gam:jeners:v:17:y:2024:i:22:p:5781-:d:1524627
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/17/22/5781/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/17/22/5781/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Benato, Alberto, 2017. "Performance and cost evaluation of an innovative Pumped Thermal Electricity Storage power system," Energy, Elsevier, vol. 138(C), pages 419-436.
    2. Jian Liu & David Cheng & Khin Oo & Wang Pan & Ty-Liyiah McCrimmon & Shuang Bai, 2024. "Optimization of Triply Periodic Minimal Surface Heat Exchanger to Achieve Compactness, High Efficiency, and Low-Pressure Drop," Energies, MDPI, vol. 17(20), pages 1-21, October.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Ameen, Muhammad Tahir & Ma, Zhiwei & Smallbone, Andrew & Norman, Rose & Roskilly, Anthony Paul, 2023. "Demonstration system of pumped heat energy storage (PHES) and its round-trip efficiency," Applied Energy, Elsevier, vol. 333(C).
    2. Zhao, Yongliang & Song, Jian & Liu, Ming & Zhao, Yao & Olympios, Andreas V. & Sapin, Paul & Yan, Junjie & Markides, Christos N., 2022. "Thermo-economic assessments of pumped-thermal electricity storage systems employing sensible heat storage materials," Renewable Energy, Elsevier, vol. 186(C), pages 431-456.
    3. Lai, Chun Sing & Locatelli, Giorgio, 2021. "Economic and financial appraisal of novel large-scale energy storage technologies," Energy, Elsevier, vol. 214(C).
    4. Vladan Durković & Željko Đurišić, 2017. "Analysis of the Potential for Use of Floating PV Power Plant on the Skadar Lake for Electricity Supply of Aluminium Plant in Montenegro," Energies, MDPI, vol. 10(10), pages 1-23, September.
    5. Guccione, Salvatore & Guedez, Rafael, 2024. "Techno-economic analysis of power-to-heat-to-power plants: Mapping optimal combinations of thermal energy storage and power cycles," Energy, Elsevier, vol. 312(C).
    6. Tassenoy, Robin & Couvreur, Kenny & Beyne, Wim & De Paepe, Michel & Lecompte, Steven, 2022. "Techno-economic assessment of Carnot batteries for load-shifting of solar PV production of an office building," Renewable Energy, Elsevier, vol. 199(C), pages 1133-1144.
    7. Dong Zhao & Shuyan Sun & Hosein Alavi, 2022. "Simulation and optimization of a Carnot battery process including a heat pump/organic Rankine cycle with considering the role of the regenerator [Robust multi-objective optimal design of islanded h," International Journal of Low-Carbon Technologies, Oxford University Press, vol. 17, pages 870-878.
    8. Georgiou, Solomos & Shah, Nilay & Markides, Christos N., 2018. "A thermo-economic analysis and comparison of pumped-thermal and liquid-air electricity storage systems," Applied Energy, Elsevier, vol. 226(C), pages 1119-1133.
    9. Alberto Benato & Francesco De Vanna & Anna Stoppato, 2022. "Levelling the Photovoltaic Power Profile with the Integrated Energy Storage System," Energies, MDPI, vol. 15(24), pages 1-21, December.
    10. Alberto Benato & Anna Stoppato, 2019. "An Experimental Investigation of a Novel Low-Cost Photovoltaic Panel Active Cooling System," Energies, MDPI, vol. 12(8), pages 1-24, April.
    11. Xiaoyu Zhou & Xinxing Lin & Wen Su & Ruochen Ding & Yaran Liang, 2025. "Thermo-Economic Potential of Carnot Batteries for the Waste Heat Recovery of Liquid-Cooled Data Centers with Different Combinations of Heat Pumps and Organic Rankine Cycles," Energies, MDPI, vol. 18(6), pages 1-28, March.
    12. Frate, Guido Francesco & Ferrari, Lorenzo & Desideri, Umberto, 2021. "Energy storage for grid-scale applications: Technology review and economic feasibility analysis," Renewable Energy, Elsevier, vol. 163(C), pages 1754-1772.
    13. Albert, Max & Ma, Zhiwei & Bao, Huashan & Roskilly, Anthony Paul, 2022. "Operation and performance of Brayton Pumped Thermal Energy Storage with additional latent storage," Applied Energy, Elsevier, vol. 312(C).
    14. Hu, Aowei & Wang, Liang & Lin, Xipeng & Ai, Wei & Bai, Yakai & Lin, Lin & Zhang, Chi & Qi, Zhicheng & Chen, Haisheng, 2025. "Performance analysis of recuperated Brayton pumped thermal electricity storage with staged compressors," Energy, Elsevier, vol. 316(C).
    15. Roskosch, Dennis & Venzik, Valerius & Atakan, Burak, 2020. "Potential analysis of pumped heat electricity storages regarding thermodynamic efficiency," Renewable Energy, Elsevier, vol. 147(P3), pages 2865-2873.
    16. Ge, Y.Q. & Zhao, Y. & Zhao, C.Y., 2021. "Transient simulation and thermodynamic analysis of pumped thermal electricity storage based on packed-bed latent heat/cold stores," Renewable Energy, Elsevier, vol. 174(C), pages 939-951.
    17. Zhang, Yanchao & Xie, Zhenzhen, 2022. "Thermodynamic efficiency and bounds of pumped thermal electricity storage under whole process ecological optimization," Renewable Energy, Elsevier, vol. 188(C), pages 711-720.
    18. Zhang, Zhi & Zhou, Ming & Chen, Yanbo & Li, Gengyin, 2023. "Exploiting the operational flexibility of AA-CAES in energy and reserve optimization scheduling by a linear reserve model," Energy, Elsevier, vol. 263(PE).
    19. Zhang, Han & Wang, Liang & Lin, Xipeng & Chen, Haisheng, 2020. "Combined cooling, heating, and power generation performance of pumped thermal electricity storage system based on Brayton cycle," Applied Energy, Elsevier, vol. 278(C).
    20. Violeta Sánchez-Canales & Jorge Payá & José M. Corberán & Abdelrahman H. Hassan, 2020. "Dynamic Modelling and Techno-Economic Assessment of a Compressed Heat Energy Storage System: Application in a 26-MW Wind Farm in Spain," Energies, MDPI, vol. 13(18), pages 1-18, September.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:17:y:2024:i:22:p:5781-:d:1524627. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.