IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2023i16p6057-d1220431.html
   My bibliography  Save this article

Investigation of the Proton Exchange Membrane Fuel Cell System Cathode Exhaust Gas Composition Based on Test Bed Measurements

Author

Listed:
  • Peter Reithuber

    (Institute of Thermodynamics and Sustainable Propulsion Systems (ITnA), Graz University of Technology, Inffeldgasse 19, 8010 Graz, Austria)

  • Christian Frühwirth

    (Institute of Thermodynamics and Sustainable Propulsion Systems (ITnA), Graz University of Technology, Inffeldgasse 19, 8010 Graz, Austria)

  • Simon Buchberger

    (Institute of Thermodynamics and Sustainable Propulsion Systems (ITnA), Graz University of Technology, Inffeldgasse 19, 8010 Graz, Austria)

  • Helmut Eichlseder

    (Institute of Thermodynamics and Sustainable Propulsion Systems (ITnA), Graz University of Technology, Inffeldgasse 19, 8010 Graz, Austria)

Abstract

Proton exchange membrane fuel cells are gaining increasing importance in vehicle applications. The exhaust gas composition regarding the water and oxygen content and the mass flow are important parameters in fuel cell research (e.g., for designing the test bed, quantifying the hydrogen loss in the exhaust, performing experiments with air pollutants, and monitoring degradation). The exhaust gas composition is also important for vehicle applications (e.g., ensuring safe hydrogen levels in the exhaust). Performing direct measurements of the exhaust mass flow and the relative humidity is challenging due to the high-humidity environment. This article presents a mathematical thermodynamic model used to calculate the exhaust gas mass flow and relative humidity, validated by balancing the gas species composition between cathode inlet and exhaust and by using data measured at the fuel cell system test bed. Four calculation model variations and their analyses are discussed. Furthermore, the exhaust gas composition throughout the fuel cell system operating range is presented. The results of air pollutant experiments provide comprehensive examples for the application of the calculation model. These results demonstrate the suitability of the model for its application in fuel cell system research.

Suggested Citation

  • Peter Reithuber & Christian Frühwirth & Simon Buchberger & Helmut Eichlseder, 2023. "Investigation of the Proton Exchange Membrane Fuel Cell System Cathode Exhaust Gas Composition Based on Test Bed Measurements," Energies, MDPI, vol. 16(16), pages 1-20, August.
    • Handle: RePEc:gam:jeners:v:16:y:2023:i:16:p:6057-:d:1220431
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/16/6057/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/16/16/6057/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Abdin, Z. & Webb, C.J. & Gray, E.MacA., 2016. "PEM fuel cell model and simulation in Matlab–Simulink based on physical parameters," Energy, Elsevier, vol. 116(P1), pages 1131-1144.
    2. Peter Reithuber & Florian Poimer & Stefan Brandstätter & Eberhard Schutting & Simon Buchberger & Alexander Trattner & Helmut Eichlseder, 2023. "Experimental Investigation of the Influence of NO on a PEM Fuel Cell System and Voltage Recovery Strategies," Energies, MDPI, vol. 16(9), pages 1-18, April.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Xu, Shuhui & Wang, Yong & Wang, Zhi, 2019. "Parameter estimation of proton exchange membrane fuel cells using eagle strategy based on JAYA algorithm and Nelder-Mead simplex method," Energy, Elsevier, vol. 173(C), pages 457-467.
    2. Zhao, Jian & Ozden, Adnan & Shahgaldi, Samaneh & Alaefour, Ibrahim E. & Li, Xianguo & Hamdullahpur, Feridun, 2018. "Effect of Pt loading and catalyst type on the pore structure of porous electrodes in polymer electrolyte membrane (PEM) fuel cells," Energy, Elsevier, vol. 150(C), pages 69-76.
    3. Zou, Wei & Froning, Dieter & Shi, Yan & Lehnert, Werner, 2021. "Working zone for a least-squares support vector machine for modeling polymer electrolyte fuel cell voltage," Applied Energy, Elsevier, vol. 283(C).
    4. Akira Nishimura & Kyohei Toyoda & Yuya Kojima & Syogo Ito & Eric Hu, 2021. "Numerical Simulation on Impacts of Thickness of Nafion Series Membranes and Relative Humidity on PEMFC Operated at 363 K and 373 K," Energies, MDPI, vol. 14(24), pages 1-24, December.
    5. Arne L. Lazar & Swantje C. Konradt & Hermann Rottengruber, 2019. "Open-Source Dynamic Matlab/Simulink 1D Proton Exchange Membrane Fuel Cell Model," Energies, MDPI, vol. 12(18), pages 1-12, September.
    6. El-Hay, E.A. & El-Hameed, M.A. & El-Fergany, A.A., 2019. "Optimized Parameters of SOFC for steady state and transient simulations using interior search algorithm," Energy, Elsevier, vol. 166(C), pages 451-461.
    7. Yang, Duo & Pan, Rui & Wang, Yujie & Chen, Zonghai, 2019. "Modeling and control of PEMFC air supply system based on T-S fuzzy theory and predictive control," Energy, Elsevier, vol. 188(C).
    8. Tabbi Wilberforce & Oluwatosin Ijaodola & Ahmad Baroutaji & Emmanuel Ogungbemi & Abdul Ghani Olabi, 2022. "Effect of Bipolar Plate Material on Proton Exchange Membrane Fuel Cell Performance," Energies, MDPI, vol. 15(5), pages 1-15, March.
    9. Jinquan, Guo & Hongwen, He & Jianwei, Li & Qingwu, Liu, 2021. "Real-time energy management of fuel cell hybrid electric buses: Fuel cell engines friendly intersection speed planning," Energy, Elsevier, vol. 226(C).
    10. Atyabi, Seyed Ali & Afshari, Ebrahim & Zohravi, Elnaz & Udemu, Chinonyelum M., 2021. "Three-dimensional simulation of different flow fields of proton exchange membrane fuel cell using a multi-phase coupled model with cooling channel," Energy, Elsevier, vol. 234(C).
    11. Sankar, K. & Thakre, Niraj & Singh, Sumit Mohan & Jana, Amiya K., 2017. "Sliding mode observer based nonlinear control of a PEMFC integrated with a methanol reformer," Energy, Elsevier, vol. 139(C), pages 1126-1143.
    12. Kuo, Jenn-Kun & Hsieh, Chun-Yao, 2021. "Numerical investigation into effects of ejector geometry and operating conditions on hydrogen recirculation ratio in 80 kW PEM fuel cell system," Energy, Elsevier, vol. 233(C).
    13. Hong, Po & Xu, Liangfei & Li, Jianqiu & Ouyang, Minggao, 2017. "Modeling of membrane electrode assembly of PEM fuel cell to analyze voltage losses inside," Energy, Elsevier, vol. 139(C), pages 277-288.
    14. Cai, Shanshan & Wang, Wenli & Zou, Yuqi & Li, Song & Tu, Zhengkai, 2023. "Performance and sustainability assessment of PEMFC/solar-driven CCP systems with different energy storage devices," Energy, Elsevier, vol. 278(PB).
    15. Xiao Tang & Chunsheng Wang & Yukun Hu & Zijian Liu & Feiliang Li, 2021. "Adaptive Fuzzy PID Based on Granular Function for Proton Exchange Membrane Fuel Cell Oxygen Excess Ratio Control," Energies, MDPI, vol. 14(4), pages 1-18, February.
    16. Eriksson, E.L.V. & Gray, E.MacA., 2017. "Optimization and integration of hybrid renewable energy hydrogen fuel cell energy systems – A critical review," Applied Energy, Elsevier, vol. 202(C), pages 348-364.
    17. Yasser Diab & Francois Auger & Emmanuel Schaeffer & Stéphane Chevalier & Adib Allahham, 2022. "Real-Time Estimation of PEMFC Parameters Using a Continuous-Discrete Extended Kalman Filter Derived from a Pseudo Two-Dimensional Model," Energies, MDPI, vol. 15(7), pages 1-23, March.
    18. Ijaodola, O.S. & El- Hassan, Zaki & Ogungbemi, E. & Khatib, F.N. & Wilberforce, Tabbi & Thompson, James & Olabi, A.G., 2019. "Energy efficiency improvements by investigating the water flooding management on proton exchange membrane fuel cell (PEMFC)," Energy, Elsevier, vol. 179(C), pages 246-267.
    19. Ogungbemi, Emmanuel & Ijaodola, Oluwatosin & Khatib, F.N. & Wilberforce, Tabbi & El Hassan, Zaki & Thompson, James & Ramadan, Mohamad & Olabi, A.G., 2019. "Fuel cell membranes – Pros and cons," Energy, Elsevier, vol. 172(C), pages 155-172.
    20. Zheng Huang & Laisuo Su & Yunjie Yang & Linsong Gao & Xinyu Liu & Heng Huang & Yubai Li & Yongchen Song, 2023. "Three-Dimensional Simulation on the Effects of Different Parameters and Pt Loading on the Long-Term Performance of Proton Exchange Membrane Fuel Cells," Sustainability, MDPI, vol. 15(4), pages 1-22, February.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2023:i:16:p:6057-:d:1220431. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.