IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v16y2022i1p145-d1012750.html
   My bibliography  Save this article

Particle Size Distribution and Enrichment of Alkali and Heavy Metals in Fly Ash on Air and Oxy-Fuel Conditions from Sludge Combustion

Author

Listed:
  • Ha-Na Jang

    (Department of Environmental Engineering, Yonsei University, Wonju 26493, Republic of Korea)

  • Heung-Min Yoo

    (Resource Recirculation Research Division, National Institute of Environmental Research, Inchon 22689, Republic of Korea)

  • Hang Seok Choi

    (Department of Environmental Engineering, Yonsei University, Wonju 26493, Republic of Korea)

Abstract

Comparative tests in air and oxy-fuel combustion were conducted in a 30 kW th circulating fluidized bed (CFB) pilot plant for waste sludge combustion. General combustion characteristics of the CFB, such as pressure profiles, temperatures along the bed, and flue gas composition, were different under the air and oxy-fuel conditions. At the bottom and in the fly ash, alkali and heavy metals had different distributions under the air and oxy-fuel combustion conditions. The particle size distribution in fly ash from air combustion was dominated by coarse particles, over 2.5 μm in size, whereas with oxy-fuel combustion, most particles were submicron in size, approximately 0.1 μm, and a smaller quantity of coarse particles, over 2.5 μm in size, formed than with air combustion. Mass fractions of Al, Ca, and K, below 2.5 μm in size, were found in the ashes from oxy-fuel combustion and in higher quantity than those found in air combustion. Submicron particle formation from Cr, Ni, Cu, and Zn in the fly ash occurred more during oxy-fuel combustion than it did in air combustion.

Suggested Citation

  • Ha-Na Jang & Heung-Min Yoo & Hang Seok Choi, 2022. "Particle Size Distribution and Enrichment of Alkali and Heavy Metals in Fly Ash on Air and Oxy-Fuel Conditions from Sludge Combustion," Energies, MDPI, vol. 16(1), pages 1-13, December.
  • Handle: RePEc:gam:jeners:v:16:y:2022:i:1:p:145-:d:1012750
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/16/1/145/pdf
    Download Restriction: no

    File URL: https://www.mdpi.com/1996-1073/16/1/145/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Wu, Yinghai & Wang, Chunbo & Tan, Yewen & Jia, Lufei & Anthony, Edward J., 2011. "Characterization of ashes from a 100kWth pilot-scale circulating fluidized bed with oxy-fuel combustion," Applied Energy, Elsevier, vol. 88(9), pages 2940-2948.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Li, Shiyuan & Li, Haoyu & Li, Wei & Xu, Mingxin & Eddings, Eric G. & Ren, Qiangqiang & Lu, Qinggang, 2017. "Coal combustion emission and ash formation characteristics at high oxygen concentration in a 1MWth pilot-scale oxy-fuel circulating fluidized bed," Applied Energy, Elsevier, vol. 197(C), pages 203-211.
    2. Oboirien, B.O. & Thulari, V. & North, B.C., 2014. "Major and trace elements in coal bottom ash at different oxy coal combustion conditions," Applied Energy, Elsevier, vol. 129(C), pages 207-216.
    3. Lupiáñez, Carlos & Carmen Mayoral, M. & Díez, Luis I. & Pueyo, Eloy & Espatolero, Sergio & Manuel Andrés, J., 2016. "The role of limestone during fluidized bed oxy-combustion of coal and biomass," Applied Energy, Elsevier, vol. 184(C), pages 670-680.
    4. Chi, Chung-Cheng & Lin, Ta-Hui, 2013. "Oxy-oil combustion characteristics of an existing furnace," Applied Energy, Elsevier, vol. 102(C), pages 923-930.
    5. Duan, Lunbo & Liu, Daoyin & Chen, Xiaoping & Zhao, Changsui, 2012. "Fly ash recirculation by bottom feeding on a circulating fluidized bed boiler co-burning coal sludge and coal," Applied Energy, Elsevier, vol. 95(C), pages 295-299.
    6. Seddighi, Sadegh, 2017. "Design of large scale oxy-fuel fluidized bed boilers: Constant thermal power and constant furnace size scenarios," Energy, Elsevier, vol. 118(C), pages 1286-1294.
    7. Nguyen, Hoang Khoi & Moon, Ji-Hong & Jo, Sung-Ho & Park, Sung Jin & Seo, Myung Won & Ra, Ho Won & Yoon, Sang-Jun & Yoon, Sung-Min & Song, Byungho & Lee, Uendo & Yang, Chang Won & Mun, Tae-Young & Lee,, 2020. "Oxy-combustion characteristics as a function of oxygen concentration and biomass co-firing ratio in a 0.1 MWth circulating fluidized bed combustion test-rig," Energy, Elsevier, vol. 196(C).
    8. Xu, Mingxin & Li, Shiyuan & Wu, Yinghai & Jia, Lufei & Lu, Qinggang, 2017. "The characteristics of recycled NO reduction over char during oxy-fuel fluidized bed combustion," Applied Energy, Elsevier, vol. 190(C), pages 553-562.
    9. Jiang, Binfan & Xia, Dehong & Zhang, Huili & Pei, Hao & Liu, Xiangjun, 2020. "Effective waste heat recovery from industrial high-temperature granules: A Moving Bed Indirect Heat Exchanger with embedded agitation," Energy, Elsevier, vol. 208(C).
    10. Guo, Zhihang & Wang, Qinhui & Fang, Mengxiang & Luo, Zhongyang & Cen, Kefa, 2014. "Thermodynamic and economic analysis of polygeneration system integrating atmospheric pressure coal pyrolysis technology with circulating fluidized bed power plant," Applied Energy, Elsevier, vol. 113(C), pages 1301-1314.
    11. Hnydiuk-Stefan, Anna & Składzień, Jan, 2017. "Analysis of supercritical coal fired oxy combustion power plant with cryogenic oxygen unit and turbo-compressor," Energy, Elsevier, vol. 128(C), pages 271-283.
    12. Xu, Mingxin & Li, Shiyuan & Wu, Yinghai & Jia, Lufei, 2017. "Reduction of recycled NO over char during oxy-fuel fluidized bed combustion: Effects of operating parameters," Applied Energy, Elsevier, vol. 199(C), pages 310-322.
    13. Wee, Jung-Ho, 2013. "A review on carbon dioxide capture and storage technology using coal fly ash," Applied Energy, Elsevier, vol. 106(C), pages 143-151.
    14. Bu, Changsheng & Liu, Daoyin & Chen, Xiaoping & Pallarès, David & Gómez-Barea, Alberto, 2014. "Ignition behavior of single coal particle in a fluidized bed under O2/CO2 and O2/N2 atmospheres: A combination of visual image and particle temperature," Applied Energy, Elsevier, vol. 115(C), pages 301-308.
    15. Lee, Jaehee & Han, Sang-Jun & Wee, Jung-Ho, 2014. "Synthesis of dry sorbents for carbon dioxide capture using coal fly ash and its performance," Applied Energy, Elsevier, vol. 131(C), pages 40-47.
    16. Seddighi, Sadegh & Clough, Peter T. & Anthony, Edward J. & Hughes, Robin W. & Lu, Ping, 2018. "Scale-up challenges and opportunities for carbon capture by oxy-fuel circulating fluidized beds," Applied Energy, Elsevier, vol. 232(C), pages 527-542.
    17. Bolea, Irene & Romeo, Luis M. & Pallarés, David, 2012. "The role of external heat exchangers in oxy-fuel circulating fluidized bed," Applied Energy, Elsevier, vol. 94(C), pages 215-223.
    18. Wang, Chang’an & Zhang, Xiaoming & Liu, Yinhe & Che, Defu, 2012. "Pyrolysis and combustion characteristics of coals in oxyfuel combustion," Applied Energy, Elsevier, vol. 97(C), pages 264-273.
    19. Oboirien, B.O. & North, B.C. & Kleyn, T., 2014. "Techno-economic assessments of oxy-fuel technology for South African coal-fired power stations," Energy, Elsevier, vol. 66(C), pages 550-555.
    20. Duan, Lunbo & Jiang, Zhongxiao & Chen, Xiaoping & Zhao, Changsui, 2013. "Investigation on water vapor effect on direct sulfation during wet-recycle oxy-coal combustion," Applied Energy, Elsevier, vol. 108(C), pages 121-127.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:16:y:2022:i:1:p:145-:d:1012750. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.