IDEAS home Printed from https://ideas.repec.org/a/eee/appene/v257y2020ics0306261919316721.html
   My bibliography  Save this article

Extreme-scale load-aligning rotor: To hinge or not to hinge?

Author

Listed:
  • Noyes, Carlos
  • Loth, Eric
  • Martin, Dana
  • Johnson, Kathryn
  • Ananda, Gavin
  • Selig, Michael

Abstract

Load alignment, balancing the thrust moment with the centrifugal moment, is a promising innovation for extreme-scale wind turbines. Load alignment allows for longer blades, capturing more power, while maintaining similar blade moments. As blades lengthen, larger coning angles are required to balance increasing thrust moments with centrifugal moments. This yields a key question for such extreme-scale load-aligned rotors: should the blades hinge to actively vary coning or simply be fixed at a single coning angle? To answer this, steady and turbulent FAST simulations were conducted on a variety of downwind rotors with different blade lengths and coning angles. The longest rotor without a hinge increased the energy production by 13.4% compared to shortest rotor without an increase in peak blade moments. However, in turbulent wind there was an approximately 100% increase in fatigue loads. When the coning angle was allowed to change slowly as a function of wind speed (by means of a morphing hinge), the power increased by 19% and the peak moments increased under turbulent wind conditions, but only by 40%. Inclusion of teeter with the hinge decreased both the peak flapwise moments and the fatigue damage equivalent loads back to near baseline values while maintaining 12% power production increase. The results show that load alignment can be achieved with a fixed coning angle (pre-alignment) or by a morphing hinge. By enabling a larger swept area at lower wind speeds, a morphing hinge allows for up to a 4.6% power increase compared with a fixed coning angle.

Suggested Citation

  • Noyes, Carlos & Loth, Eric & Martin, Dana & Johnson, Kathryn & Ananda, Gavin & Selig, Michael, 2020. "Extreme-scale load-aligning rotor: To hinge or not to hinge?," Applied Energy, Elsevier, vol. 257(C).
    • Handle: RePEc:eee:appene:v:257:y:2020:i:c:s0306261919316721
    DOI: 10.1016/j.apenergy.2019.113985
    as

    Download full text from publisher

    File URL: http://www.sciencedirect.com/science/article/pii/S0306261919316721
    Download Restriction: Full text for ScienceDirect subscribers only
    File URL: https://libkey.io/10.1016/j.apenergy.2019.113985?utm_source=ideas
    LibKey link: if access is restricted and if your library uses this service, LibKey will redirect you to where you can use your library subscription to access this item
    ---><---

    As the access to this document is restricted, you may want to search for a different version of it.

    References listed on IDEAS

    as
    1. Arias-Rosales, Andrés & Osorio-Gómez, Gilberto, 2018. "Wind turbine selection method based on the statistical analysis of nominal specifications for estimating the cost of energy," Applied Energy, Elsevier, vol. 228(C), pages 980-998.
    2. Chen, Jincheng & Wang, Feng & Stelson, Kim A., 2018. "A mathematical approach to minimizing the cost of energy for large utility wind turbines," Applied Energy, Elsevier, vol. 228(C), pages 1413-1422.
    3. Zhang, Mingming & Tan, Bin & Xu, Jianzhong, 2016. "Smart fatigue load control on the large-scale wind turbine blades using different sensing signals," Renewable Energy, Elsevier, vol. 87(P1), pages 111-119.
    4. Civelek, Zafer & Lüy, Murat & Çam, Ertuğrul & Mamur, Hayati, 2017. "A new fuzzy logic proportional controller approach applied to individual pitch angle for wind turbine load mitigation," Renewable Energy, Elsevier, vol. 111(C), pages 708-717.
    5. Chehouri, Adam & Younes, Rafic & Ilinca, Adrian & Perron, Jean, 2015. "Review of performance optimization techniques applied to wind turbines," Applied Energy, Elsevier, vol. 142(C), pages 361-388.
    6. Krogstad, Per-Åge & Eriksen, Pål Egil, 2013. "“Blind test” calculations of the performance and wake development for a model wind turbine," Renewable Energy, Elsevier, vol. 50(C), pages 325-333.
    7. Esteban, Miguel & Leary, David, 2012. "Current developments and future prospects of offshore wind and ocean energy," Applied Energy, Elsevier, vol. 90(1), pages 128-136.
    8. Noyes, Carlos & Qin, Chao & Loth, Eric, 2018. "Pre-aligned downwind rotor for a 13.2 MW wind turbine," Renewable Energy, Elsevier, vol. 116(PA), pages 749-754.
    Full references (including those not matched with items on IDEAS)

    Citations

    Citations are extracted by the CitEc Project, subscribe to its RSS feed for this item.
    as


    Cited by:

    1. Zhenye Sun & Wei Jun Zhu & Wen Zhong Shen & Wei Zhong & Jiufa Cao & Qiuhan Tao, 2020. "Aerodynamic Analysis of Coning Effects on the DTU 10 MW Wind Turbine Rotor," Energies, MDPI, vol. 13(21), pages 1-19, November.

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Longfu Luo & Xiaofeng Zhang & Dongran Song & Weiyi Tang & Jian Yang & Li Li & Xiaoyu Tian & Wu Wen, 2018. "Optimal Design of Rated Wind Speed and Rotor Radius to Minimizing the Cost of Energy for Offshore Wind Turbines," Energies, MDPI, vol. 11(10), pages 1-17, October.
    2. Song, Dongran & Yang, Yinggang & Zheng, Songyue & Tang, Weiyi & Yang, Jian & Su, Mei & Yang, Xuebing & Joo, Young Hoon, 2019. "Capacity factor estimation of variable-speed wind turbines considering the coupled influence of the QN-curve and the air density," Energy, Elsevier, vol. 183(C), pages 1049-1060.
    3. Momeni, Farhang & Sabzpoushan, Seyedali & Valizadeh, Reza & Morad, Mohammad Reza & Liu, Xun & Ni, Jun, 2019. "Plant leaf-mimetic smart wind turbine blades by 4D printing," Renewable Energy, Elsevier, vol. 130(C), pages 329-351.
    4. Song, Dongran & Liu, Junbo & Yang, Jian & Su, Mei & Wang, Yun & Yang, Xuebing & Huang, Lingxiang & Joo, Young Hoon, 2020. "Optimal design of wind turbines on high-altitude sites based on improved Yin-Yang pair optimization," Energy, Elsevier, vol. 193(C).
    5. Li, Qingan & Cai, Chang & Maeda, Takao & Kamada, Yasunari & Shimizu, Kento & Dong, Yehong & Zhang, Fanghong & Xu, Jianzhong, 2021. "Visualization of aerodynamic forces and flow field on a straight-bladed vertical axis wind turbine by wind tunnel experiments and panel method," Energy, Elsevier, vol. 225(C).
    6. Noyes, Carlos & Qin, Chao & Loth, Eric, 2018. "Pre-aligned downwind rotor for a 13.2 MW wind turbine," Renewable Energy, Elsevier, vol. 116(PA), pages 749-754.
    7. Veisi, Amin Allah & Shafiei Mayam, Mohammad Hossein, 2017. "Effects of blade rotation direction in the wake region of two in-line turbines using Large Eddy Simulation," Applied Energy, Elsevier, vol. 197(C), pages 375-392.
    8. Thé, Jesse & Yu, Hesheng, 2017. "A critical review on the simulations of wind turbine aerodynamics focusing on hybrid RANS-LES methods," Energy, Elsevier, vol. 138(C), pages 257-289.
    9. Zi Lin & Xiaolei Liu, 2020. "Assessment of Wind Turbine Aero-Hydro-Servo-Elastic Modelling on the Effects of Mooring Line Tension via Deep Learning," Energies, MDPI, vol. 13(9), pages 1-21, May.
    10. Golnary, Farshad & Moradi, Hamed, 2018. "Design and comparison of quasi continuous sliding mode control with feedback linearization for a large scale wind turbine with wind speed estimation," Renewable Energy, Elsevier, vol. 127(C), pages 495-508.
    11. Gentils, Theo & Wang, Lin & Kolios, Athanasios, 2017. "Integrated structural optimisation of offshore wind turbine support structures based on finite element analysis and genetic algorithm," Applied Energy, Elsevier, vol. 199(C), pages 187-204.
    12. Ochoa, Danny & Martinez, Sergio, 2018. "Frequency dependent strategy for mitigating wind power fluctuations of a doubly-fed induction generator wind turbine based on virtual inertia control and blade pitch angle regulation," Renewable Energy, Elsevier, vol. 128(PA), pages 108-124.
    13. Meng, Hang & Lien, Fue-Sang & Yee, Eugene & Shen, Jingfang, 2020. "Modelling of anisotropic beam for rotating composite wind turbine blade by using finite-difference time-domain (FDTD) method," Renewable Energy, Elsevier, vol. 162(C), pages 2361-2379.
    14. Sales-Setién, Ester & Peñarrocha-Alós, Ignacio, 2020. "Robust estimation and diagnosis of wind turbine pitch misalignments at a wind farm level," Renewable Energy, Elsevier, vol. 146(C), pages 1746-1765.
    15. Margielewicz, Jerzy & Gąska, Damian & Litak, Grzegorz & Wolszczak, Piotr & Yurchenko, Daniil, 2022. "Nonlinear dynamics of a new energy harvesting system with quasi-zero stiffness," Applied Energy, Elsevier, vol. 307(C).
    16. Meng, Haoran & Ma, Zhe & Dou, Bingzheng & Zeng, Pan & Lei, Liping, 2020. "Investigation on the performance of a novel forward-folding rotor used in a downwind horizontal-axis turbine," Energy, Elsevier, vol. 190(C).
    17. Sun, Alexander Y., 2020. "Optimal carbon storage reservoir management through deep reinforcement learning," Applied Energy, Elsevier, vol. 278(C).
    18. Mauro, S. & Lanzafame, R. & Messina, M. & Brusca, S., 2023. "On the importance of the root-to-hub adapter effects on HAWT performance: A CFD-BEM numerical investigation," Energy, Elsevier, vol. 275(C).
    19. Ayman Al-Quraan & Bashar Al-Mhairat, 2022. "Intelligent Optimized Wind Turbine Cost Analysis for Different Wind Sites in Jordan," Sustainability, MDPI, vol. 14(5), pages 1-24, March.
    20. Hammar, Linus & Ehnberg, Jimmy & Mavume, Alberto & Cuamba, Boaventura C. & Molander, Sverker, 2012. "Renewable ocean energy in the Western Indian Ocean," Renewable and Sustainable Energy Reviews, Elsevier, vol. 16(7), pages 4938-4950.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:eee:appene:v:257:y:2020:i:c:s0306261919316721. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: Catherine Liu (email available below). General contact details of provider: http://www.elsevier.com/wps/find/journaldescription.cws_home/405891/description#description .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.