IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v17y2024i19p4967-d1492162.html
   My bibliography  Save this article

Modeling and Characterization of Li-Ion 18650 Nickel–Cobalt–Alumina Battery Jellyroll Subjected to Static and Dynamic Compression Loading

Author

Listed:
  • Sigit Puji Santosa

    (Faculty of Mechanical and Aerospace Engineering, Institut Teknologi Bandung, Jalan Ganesha No. 10, Bandung 40132, Indonesia
    Center for Industrial Technology, Institut Teknologi Bandung, Jalan Ganesha No. 10, Bandung 40132, Indonesia
    Indonesian Army Corporation (PT.PINDAD), Jalan Gatot Subroto No. 517, Bandung 40284, Indonesia)

  • Hafiz Fadillah

    (Faculty of Mechanical and Aerospace Engineering, Institut Teknologi Bandung, Jalan Ganesha No. 10, Bandung 40132, Indonesia
    Center for Industrial Technology, Institut Teknologi Bandung, Jalan Ganesha No. 10, Bandung 40132, Indonesia)

Abstract

This study presents a comprehensive experimental investigation of the mechanical response of the jellyroll and complete Li-ion 18650 Nickel–Cobalt–Alumina (NCA) battery under axial compression, highlighting the effects of strain rate and state-of-charge (SOC). The jellyroll was subjected to both static (1 mm/min) and dynamic (10–30 m/s) axial compression using a Split-Hopkinson Pressure Bar (SHPB). A key innovation of this work is the investigation of the role of electrolytes under both static and dynamic conditions, revealing their significant impact on stress and strain behavior due to hydrostatic pressure. Additionally, the complete NCA battery was tested under various SOC levels (0–75%) using flat plate compression. The results demonstrate the jellyroll’s sensitivity to strain rate, with increased stress responses at higher loading speeds. Furthermore, the inclusion of electrolytes markedly amplified the stress and strain response. The Fu-Chang model was successfully employed to numerically replicate the observed static and dynamic behaviors. Critically, the full battery tests revealed a negative correlation between voltage cutoff and SOC, with the risk of fire and explosion increasing at higher SOC levels. This research provides novel insights into the safety and mechanical resilience of Li-ion batteries under compression.

Suggested Citation

  • Sigit Puji Santosa & Hafiz Fadillah, 2024. "Modeling and Characterization of Li-Ion 18650 Nickel–Cobalt–Alumina Battery Jellyroll Subjected to Static and Dynamic Compression Loading," Energies, MDPI, vol. 17(19), pages 1-19, October.
    • Handle: RePEc:gam:jeners:v:17:y:2024:i:19:p:4967-:d:1492162
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/17/19/4967/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/17/19/4967/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Jia, Yikai & Yin, Sha & Liu, Binghe & Zhao, Hui & Yu, Huili & Li, Jie & Xu, Jun, 2019. "Unlocking the coupling mechanical-electrochemical behavior of lithium-ion battery upon dynamic mechanical loading," Energy, Elsevier, vol. 166(C), pages 951-960.
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Yiding, Li & Wenwei, Wang & Cheng, Lin & Xiaoguang, Yang & Fenghao, Zuo, 2021. "A safety performance estimation model of lithium-ion batteries for electric vehicles under dynamic compression," Energy, Elsevier, vol. 215(PA).
    2. E, Jiaqiang & Xiao, Hanxu & Tian, Sicheng & Huang, Yuxin, 2024. "A comprehensive review on thermal runaway model of a lithium-ion battery: Mechanism, thermal, mechanical, propagation, gas venting and combustion," Renewable Energy, Elsevier, vol. 229(C).
    3. Richard Beaumont & Iain Masters & Abhishek Das & Steve Lucas & Arunn Thanikachalam & David Williams, 2021. "Methodology for Developing a Macro Finite Element Model of Lithium-Ion Pouch Cells for Predicting Mechanical Behaviour under Multiple Loading Conditions," Energies, MDPI, vol. 14(7), pages 1-21, March.
    4. Sheng Yang & Wenwei Wang & Cheng Lin & Weixiang Shen & Yiding Li, 2019. "Investigation of Internal Short Circuits of Lithium-Ion Batteries under Mechanical Abusive Conditions," Energies, MDPI, vol. 12(10), pages 1-16, May.
    5. Wang, Can & Wang, Renjie & Zhang, Chengming & Yu, Quanqing, 2024. "Coupling effect of state of charge and loading rate on internal short circuit of lithium-ion batteries induced by mechanical abuse," Applied Energy, Elsevier, vol. 375(C).
    6. Wang, Lubing & Li, Jianping & Chen, Jiaying & Duan, Xudong & Li, Binqi & Li, Jiani, 2023. "Revealing the internal short circuit mechanisms in lithium-ion batteries upon dynamic loading based on multiphysics simulation," Applied Energy, Elsevier, vol. 351(C).
    7. Dongchen Qin & Peizhuo Wang & Tingting Wang & Jiangyi Chen, 2023. "Modeling and Dynamic Impact Analysis of Prismatic Lithium-Ion Battery," Sustainability, MDPI, vol. 15(10), pages 1-12, May.
    8. Xu, Dongxin & Pan, Yongjun & Zhang, Xiaoxi & Dai, Wei & Liu, Binghe & Shuai, Qi, 2024. "Data-driven modelling and evaluation of a battery-pack system’s mechanical safety against bottom cone impact," Energy, Elsevier, vol. 290(C).
    9. Alon Ratner & Richard Beaumont & Iain Masters, 2020. "Dynamic Mechanical Compression Impulse of Lithium-Ion Pouch Cells," Energies, MDPI, vol. 13(8), pages 1-13, April.
    10. Yang, Sheng & Wang, Wenwei & Lin, Cheng & Shen, Weixiang & Li, Yiding, 2019. "Improved constitutive model of the jellyroll for cylindrical lithium ion batteries considering microscopic damage," Energy, Elsevier, vol. 185(C), pages 202-212.
    11. Xiao, Feiyu & Xing, Bobin & Kong, Lingzhao & Xia, Yong, 2021. "Impedance-based diagnosis of internal mechanical damage for large-format lithium-ion batteries," Energy, Elsevier, vol. 230(C).
    12. Li, Honggang & Zhou, Dian & Zhang, Meihe & Liu, Binghe & Zhang, Chao, 2023. "Multi-field interpretation of internal short circuit and thermal runaway behavior for lithium-ion batteries under mechanical abuse," Energy, Elsevier, vol. 263(PE).
    13. Genwei Wang & Xuanfu Guo & Jingyi Chen & Pengfei Han & Qiliang Su & Meiqing Guo & Bin Wang & Hui Song, 2023. "Safety Performance and Failure Criteria of Lithium-Ion Batteries under Mechanical Abuse," Energies, MDPI, vol. 16(17), pages 1-25, September.
    14. Liu, Jiong & Ma, Zhichao & Guo, Zixin & Zhao, Wenyang & Wang, Shenghui & Zhao, Hongwei & Ren, Luquan, 2024. "Experimental investigation on mechanical-electrochemical coupling properties of cylindrical lithium-ion batteries," Energy, Elsevier, vol. 293(C).

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:17:y:2024:i:19:p:4967-:d:1492162. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.