IDEAS home Printed from https://ideas.repec.org/a/gam/jeners/v15y2022i24p9499-d1003657.html
   My bibliography  Save this article

Developed Brinkman Model into a Porous Collector for Solar Energy Applications with a Single-Phase Flow

Author

Listed:
  • Mojtaba Rezapour

    (Department of Mechanical Engineering, University of Birjand, Birjand 97175615, Iran)

  • Sayyed Aboozar Fanaee

    (Department of Mechanical Engineering, University of Birjand, Birjand 97175615, Iran)

  • Maryam Ghodrat

    (School of Engineering and Information Technology, University of New South Wales, Canberra, ACT 2612, Australia)

Abstract

In this paper, the effects of the fluid-thermal parameters of a porous medium with different values of porosity and permeability on the fluid flow, heat, and concentration parameters were investigated for solar energy applications. The characteristics of the boundary layer, velocity profiles, pressure drop, and thermal and high heat concentration distribution have been analyzed. A developed Brinkman equation for fluid flow and a power law model for thermal conductivity (considering the porosity and permeability factors) were calculated with constant solar heat flux. The numerical model was developed based on the finite element method by the LU algorithm using the MUMPS solver. The Brinkman equations were solved under steady and unsteady states for velocity, pressure, thermal, and concentration distribution effects, respectively. In a porous medium, the normalized temperature of the presented model had an acceptable agreement with the experimental data, with a maximum error of 3%. At constant permeability, by decreasing the porosity, the velocity profile was extended. This was mainly due to the presence of pores in the collector. With an accelerated flow, the maximum velocity of 2.5 m/s occurred at a porosity of 0.2. It was also found that in the porous collector, the Nusselt number increased where the maximum difference between the porous and the nonporous collectors occurred at the beginning of the collector, with a value of 32%, and the minimum difference was 27%. The results also indicate that in the porous collector, solar energy absorbance was higher and the heat transfer was improved. However, an increase in the pressure drop was noted in the porous collectors.

Suggested Citation

  • Mojtaba Rezapour & Sayyed Aboozar Fanaee & Maryam Ghodrat, 2022. "Developed Brinkman Model into a Porous Collector for Solar Energy Applications with a Single-Phase Flow," Energies, MDPI, vol. 15(24), pages 1-17, December.
    • Handle: RePEc:gam:jeners:v:15:y:2022:i:24:p:9499-:d:1003657
    as

    Download full text from publisher

    File URL: https://www.mdpi.com/1996-1073/15/24/9499/pdf
    Download Restriction: no
    File URL: https://www.mdpi.com/1996-1073/15/24/9499/
    Download Restriction: no
    ---><---

    References listed on IDEAS

    as
    1. Rezapour, Mojtaba & Gholizadeh, Mohammad, 2021. "Analysis of methanol thermochemical reactor with volumetric solar heat flux based on Parabolic Trough Concentrator," Renewable Energy, Elsevier, vol. 180(C), pages 1088-1100.
    2. Yang, S. & Ordonez, J.C., 2019. "3D thermal-hydraulic analysis of a symmetric wavy parabolic trough absorber pipe," Energy, Elsevier, vol. 189(C).
    Full references (including those not matched with items on IDEAS)

    Most related items

    These are the items that most often cite the same works as this one and are cited by the same works as this one.
    1. Amein, Hamza & Akoush, Bassem M. & El-Bakry, M. Medhat & Abubakr, Mohamed & Hassan, Muhammed A., 2022. "Enhancing the energy utilization in parabolic trough concentrators with cracked heat collection elements using a cost-effective rotation mechanism," Renewable Energy, Elsevier, vol. 181(C), pages 250-266.
    2. Osorio, Julian D. & Rivera-Alvarez, Alejandro, 2022. "Influence of the concentration ratio on the thermal and economic performance of parabolic trough collectors," Renewable Energy, Elsevier, vol. 181(C), pages 786-802.
    3. Ravanbakhsh, Mohammad & Gholizadeh, Mohammad & Rezapour, Mojtaba, 2023. "3E thermodynamic modeling and optimization a novel of ARS-CPVT with the effect of inserting a turbulator in the solar collector," Renewable Energy, Elsevier, vol. 209(C), pages 591-607.
    4. Amein, Hamza & Kassem, Mahmoud A. & Ali, Shady & Hassan, Muhammed A., 2021. "Integration of transparent insulation shells in linear solar receivers for enhanced energy and exergy performances," Renewable Energy, Elsevier, vol. 171(C), pages 344-359.
    5. Deymi-Dashtebayaz, Mahdi & Rezapour, Mojtaba & Sheikhani, Hamideh & Afshoun, Hamid Reza & Barzanooni, Vahid, 2023. "Numerical and experimental analyses of a novel natural gas cooking burner with the aim of improving energy efficiency and reducing environmental pollution," Energy, Elsevier, vol. 263(PE).
    6. Mallah, Abdul Rahman & Zubir, M.N.M. & Alawi, Omer A. & Kazi, S.N. & Ahmed, W. & Sadri, R. & Kasaeian, Alibakhsh, 2022. "Experimental study on the effects of multi-resonance plasmonic nanoparticles for improving the solar collector efficiency," Renewable Energy, Elsevier, vol. 187(C), pages 1204-1223.
    7. Liu, Yun & Xie, Ling-tian & Shen, Wen-ran & Xu, Chao & Zhao, Bo-yang, 2023. "Relative flow direction modes and gradual porous parameters for radiation transport and interactions with thermochemical reaction in porous volumetric solar reactor," Renewable Energy, Elsevier, vol. 203(C), pages 612-621.
    8. Zeng, Jia & Xuan, Yimin & Li, Qiang, 2023. "Direct solar-thermal scalable-decomposition of methanol flowing through a nanoparticle-packed bed reactor under outdoor environment," Energy, Elsevier, vol. 280(C).
    9. Oveepsa Chakraborty & Sujit Roy & Biplab K. Debnath & Sushant Negi & Marc A. Rosen & Sadegh Safari & Mamdouh El Haj Assad & Rajat Gupta & Biplab Das, 2024. "Energy, exergy, environment and techno-economic analysis of parabolic trough collector: A comprehensive review," Energy & Environment, , vol. 35(2), pages 1118-1181, March.

    Corrections

    All material on this site has been provided by the respective publishers and authors. You can help correct errors and omissions. When requesting a correction, please mention this item's handle: RePEc:gam:jeners:v:15:y:2022:i:24:p:9499-:d:1003657. See general information about how to correct material in RePEc.

    If you have authored this item and are not yet registered with RePEc, we encourage you to do it here. This allows to link your profile to this item. It also allows you to accept potential citations to this item that we are uncertain about.

    If CitEc recognized a bibliographic reference but did not link an item in RePEc to it, you can help with this form .

    If you know of missing items citing this one, you can help us creating those links by adding the relevant references in the same way as above, for each refering item. If you are a registered author of this item, you may also want to check the "citations" tab in your RePEc Author Service profile, as there may be some citations waiting for confirmation.

    For technical questions regarding this item, or to correct its authors, title, abstract, bibliographic or download information, contact: MDPI Indexing Manager (email available below). General contact details of provider: https://www.mdpi.com .

    Please note that corrections may take a couple of weeks to filter through the various RePEc services.

    IDEAS is a RePEc service. RePEc uses bibliographic data supplied by the respective publishers.